KZKaituo Zhang

Kaituo Zhang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Kaituo Zhang has a total of 9 co-authors. Here are the top co-authors by number of shared publications:

  • Tiantian Li

    Engineering Technology Education Center, Henan Institute of Technology, Xinxiang 453003, China

    2 shared publications
  • Yuan Xu

    School of Materials Science and Engineering Henan Institute of Technology Xinxiang China

    2 shared publications
  • Fachuang Li

    School of Materials Science and Engineering, Henan Institute of Technology, Xinxiang 453003, China

    1 shared publication
  • Fengli Liu

    Fujian Key Laboratory of Photoelectric Functional Materials, College of Materials Science & Engineering, Huaqiao University, Xiamen 361021, China

    1 shared publication
  • Ke Xu

    Henan Key Laboratory of Advanced Cable Materials and Intelligent Manufacturing, School of Cable Engineering, Henan Institute of Technology, Xinxiang 453003, China

    1 shared publication
  • Pengju Guo

    Xinxiang Engineering Research Center for Advanced Energy Storage Batteries and Materials, School of Materials Science and Engineering, Henan Institute of Technology, Xinxiang 453003, China

    1 shared publication

Latest Publications

  • Open Access

    Na+-Intercalated Two-Dimensional Vermiculite-Modified TiO2 Electron Transport Layer for Enhanced CsPbI2Br Perovskite Solar Cells

    by Yuan Xu, Yaxuan Chai, Kaituo Zhang, Fengli Liu, Tiantian Li, Ke Xu, Xian Hua, Pengju Guo, Fachuang Li, Lan Zhang

    Interface engineering of the electron transport layer (ETL) is an effective strategy for enhancing the performance and stability of all-inorganic perovskite solar cells (PSCs). Herein, Na+-intercalated vermiculite nanosheets were introduced as a low-cost natural interfacial modifier for the TiO2 ETL in CsPbI2Br PSCs. The nanosheets were prepared via an aqueous-phase exfoliation process and deposited onto the TiO2 surface to regulate the buried TiO2/CsPbI2Br interface. Morphological and spectroscopic characterizations revealed that vermiculite modification reduced the surface roughness of TiO2, altered its surface chemical/electronic environment and was associated with improved interfacial energy-level alignment. As a result, the quality of the CsPbI2Br film was significantly improved, leading to larger grains, enhanced crystallinity, a lower apparent trap-state density, and more efficient interfacial charge-transfer behavior. Electrical characterizations further confirmed enhanced charge extraction, reduced carrier recombination, and an increased built-in potential in the modified devices. Consequently, the vermiculite-modified devices exhibited simultaneous improvements in power conversion efficiency (PCE), open-circuit voltage, and short-circuit current density, with the best-performing device reaching a PCE of 13.94%. In addition, the modified device retained 84.51% of its initial PCE after storage in air for 35 days, significantly higher than the 71.1% retained by the control device. These findings highlight the potential of Na+-intercalated vermiculite nanosheets as low-cost natural modifiers for TiO2/CsPbI2Br buried-interface engineering in efficient and stable all-inorganic PSCs.

  • Open Access

    Effect of A- or B-Site Sc Doping on Sintering Temperature, Crystal Structure, Microstructure, and Properties of BaZrxTi1−xO3 Ceramics

    by Kaituo Zhang, Tiantian Li, Yuan Xu

    BaZrxTi1−xO3 (BZT) ceramics with different concentrations of Sc ions were prepared, and the effect of doping concentration on the crystal substitution type of BZT was studied. The substitution position of the Sc ion in BZT was related to its concentration. When the concentration of Sc ions was low (<1.0 mol %), it showed B-site substitution; otherwise, Sc ions showed A-site substitution. In addition, the effects of the Sc ion concentration on the sintering temperature, crystal structure, microstructure, and properties of BZT were also studied. The results showed that the introduction of Sc ions can reduce the sintering temperature to 1250 °C. When the concentration of Sc ions was 1.0 mol % and 2.0 mol %, the high dielectric constants of BZT were 14,273 and 12,747, respectively.