Tengfei Nie
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Tengfei Nie has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
Qiang Xu
Jiangxi Provincial Key Laboratory of Particle Technology
4 shared publicationsLiejin Guo
State Key Laboratory of Multiphase Flow in Power Engineering
3 shared publications- Mengsha Wang
State Key Laboratory of Multiphase Flow in Power Engineering
3 shared publications - Dengwei Jing
State Key Laboratory of Multiphase Flow in Power Engineering, Xi’an Jiaotong University, Xi’an, China
2 shared publications Lijing Ma
2 shared publications- Xiaoping Li
State Key Laboratory of Multiphase Flow in Power Engineering and International Research Center for Renewable Energy, School of Energy and Power Engineering, Xi'an Jiaotong University, Xi'an, Shaanxi 710049, China
2 shared publications
Latest Publications
- 28 April 2025
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 41 (17) , 10797-10807
Effect of Surfactant Concentration on the Behavior of Single Oxygen Bubble in Photoelectrochemical Water Splitting
The control of bubble growth and departure during the process of photoelectrochemical water splitting is crucial for enhancing gas production efficiency. By introducing varying concentrations of surfactants into the electrolyte and using a synchronous measurement system, we examined how the change in surfactant concentration affects bubble nucleation and growth characteristics. The results indicate that bubbles' critical nucleation potentials initially decrease and subsequently increase with increasing surfactant concentration, reaching a minimum value when the concentration is 1 × 10-7 M. In contrast, bubble growth periods and departure diameters reach their maximum values. Further analysis shows that the gas production rate and the average gas evolution efficiency reach their maximum when the surfactant concentration is 1 × 10-7 M, indicating that adding an appropriate amount of surfactant is advantageous for gas production. In addition, a force equilibrium model incorporating the Marangoni force at various surfactant concentrations was developed to predict oxygen bubbles' departure diameter. The predicted values exhibit excellent concurrence with the experimental data. The solutal Marangoni force is the primary determinant that affects bubble departure diameter when the surfactant concentrations are below approximately 4 × 10-6 M, while the thermal Marangoni force assumes precedence when concentrations exceed about 4 × 10-6 M.
- 28 April 2025
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 41 (17) , 10797-10807
Effect of Surfactant Concentration on the Behavior of Single Oxygen Bubble in Photoelectrochemical Water Splitting
The control of bubble growth and departure during the process of photoelectrochemical water splitting is crucial for enhancing gas production efficiency. By introducing varying concentrations of surfactants into the electrolyte and using a synchronous measurement system, we examined how the change in surfactant concentration affects bubble nucleation and growth characteristics. The results indicate that bubbles' critical nucleation potentials initially decrease and subsequently increase with increasing surfactant concentration, reaching a minimum value when the concentration is 1 × 10-7 M. In contrast, bubble growth periods and departure diameters reach their maximum values. Further analysis shows that the gas production rate and the average gas evolution efficiency reach their maximum when the surfactant concentration is 1 × 10-7 M, indicating that adding an appropriate amount of surfactant is advantageous for gas production. In addition, a force equilibrium model incorporating the Marangoni force at various surfactant concentrations was developed to predict oxygen bubbles' departure diameter. The predicted values exhibit excellent concurrence with the experimental data. The solutal Marangoni force is the primary determinant that affects bubble departure diameter when the surfactant concentrations are below approximately 4 × 10-6 M, while the thermal Marangoni force assumes precedence when concentrations exceed about 4 × 10-6 M.
- 6 March 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 129 (11) , 5369-5382
Vibration Promotes Mass Transfer of Products in Photoelectrochemical Water Splitting by Enhancing Forced Convection
- 6 March 2025
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 129 (11) , 5369-5382
Vibration Promotes Mass Transfer of Products in Photoelectrochemical Water Splitting by Enhancing Forced Convection
- 1 December 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (12)
Effect of pressurization on bubble dynamics of photoelectrochemical water splitting
Energy consumption of hydrogen production significantly restricts the practical application of photoelectrochemical (PEC) water splitting technology for hydrogen production, despite its vital role in addressing the energy crisis. The direct high-pressure hydrogen production technology holds promise for reducing production costs and streamlining the overall process. This paper delved into the study of bubble dynamic characteristics of PEC water splitting reaction under elevated pressure operations by coupling a photoelectrochemical system with a high-speed microscopic camera. The results prove that the bubble growth behaviors are pressure-dependent. Pressurization leads to the simultaneous evolution of multiple bubbles along with bubble slip and coalescence on the photoelectrode surface. And the bubble detachment diameter and growth period are significantly reduced, suggesting that increasing pressure is conducive to promoting bubble detachment. Analysis of the results of linear sweep voltammetry and Tafel slope shows that elevated pressure leads to more challenging bubble nucleation. Furthermore, the time coefficient and growth coefficient of the bubble growth stage are computed, revealing that the diffusion-controlled stage dominates the bubble growth process post-pressurization. A force balance model is constructed in the initial process of bubble rising, and it is found that the terminal rise velocity of bubbles decreases when pressure increases. The effect of pressure on gas density was considered to calculate the gas production rate by bubble volume and growth period, discovering that the proportion of gas products in the form of dissolved oxygen in the liquid increases significantly under high pressure.
- 1 December 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (12)
Effect of pressurization on bubble dynamics of photoelectrochemical water splitting
Energy consumption of hydrogen production significantly restricts the practical application of photoelectrochemical (PEC) water splitting technology for hydrogen production, despite its vital role in addressing the energy crisis. The direct high-pressure hydrogen production technology holds promise for reducing production costs and streamlining the overall process. This paper delved into the study of bubble dynamic characteristics of PEC water splitting reaction under elevated pressure operations by coupling a photoelectrochemical system with a high-speed microscopic camera. The results prove that the bubble growth behaviors are pressure-dependent. Pressurization leads to the simultaneous evolution of multiple bubbles along with bubble slip and coalescence on the photoelectrode surface. And the bubble detachment diameter and growth period are significantly reduced, suggesting that increasing pressure is conducive to promoting bubble detachment. Analysis of the results of linear sweep voltammetry and Tafel slope shows that elevated pressure leads to more challenging bubble nucleation. Furthermore, the time coefficient and growth coefficient of the bubble growth stage are computed, revealing that the diffusion-controlled stage dominates the bubble growth process post-pressurization. A force balance model is constructed in the initial process of bubble rising, and it is found that the terminal rise velocity of bubbles decreases when pressure increases. The effect of pressure on gas density was considered to calculate the gas production rate by bubble volume and growth period, discovering that the proportion of gas products in the form of dissolved oxygen in the liquid increases significantly under high pressure.
- 25 November 2024
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 9 (11)
Bubble oscillation and effects of dynamic behaviors on forces and mass transfer in photoelectrochemical water splitting
- 25 November 2024
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 9 (11)
Bubble oscillation and effects of dynamic behaviors on forces and mass transfer in photoelectrochemical water splitting
- Open Access
- 1 January 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (1)
Enhancing hydrogen bubble release from a microelectrode through precise tuning of Marangoni forces with nonionic surfactant
Understanding and controlling hydrogen bubble growth and detachment during water electrolysis is crucial for improving its efficiency. This study investigates bubble dynamics for hydrogen evolution on a platinum microelectrode in an acidic electrolyte with different gas/electrolyte surface tensions by adding varying surfactant concentrations. Three hydrogen bubble evolution patterns were observed: periodic detachment of individual bubbles at low surfactant concentrations of 0 and 1 × 10−7 M, respectively; one or two small bubbles are formed at the foot of the bubble during the evolution of single main bubble at intermediate surfactant concentrations of 1 × 10−6 and 1 × 10−5 M; and periodic detachment of large bubbles with aperiodic release of tiny bubbles at higher surfactant concentrations of 1 × 10−4 M. The concentration Marangoni force on individual H2 bubbles decreases significantly with surfactant concentration. This results in shorter evolution cycles from 138.12 to 6.98 s at −0.6 V vs the saturated calomel electrode, reduced detachment radii from 765.95 to 359.54 μm at −0.6 VSCE, and accelerated hydrogen bubble growth. This finding offers a new way to control bubble dynamics during electrochemical bubble formation.
- 1 January 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (1)
Open AccessEnhancing hydrogen bubble release from a microelectrode through precise tuning of Marangoni forces with nonionic surfactant
Understanding and controlling hydrogen bubble growth and detachment during water electrolysis is crucial for improving its efficiency. This study investigates bubble dynamics for hydrogen evolution on a platinum microelectrode in an acidic electrolyte with different gas/electrolyte surface tensions by adding varying surfactant concentrations. Three hydrogen bubble evolution patterns were observed: periodic detachment of individual bubbles at low surfactant concentrations of 0 and 1 × 10−7 M, respectively; one or two small bubbles are formed at the foot of the bubble during the evolution of single main bubble at intermediate surfactant concentrations of 1 × 10−6 and 1 × 10−5 M; and periodic detachment of large bubbles with aperiodic release of tiny bubbles at higher surfactant concentrations of 1 × 10−4 M. The concentration Marangoni force on individual H2 bubbles decreases significantly with surfactant concentration. This results in shorter evolution cycles from 138.12 to 6.98 s at −0.6 V vs the saturated calomel electrode, reduced detachment radii from 765.95 to 359.54 μm at −0.6 VSCE, and accelerated hydrogen bubble growth. This finding offers a new way to control bubble dynamics during electrochemical bubble formation.
- Open Access
- 1 October 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (10)
Insight into pH-controlled bubble dynamics on a Pt electrode during electrochemical water splitting
Bubbles adhering to the electrode surface are the major factors causing the decreased efficiency of water electrolysis. In this work, the dynamic behaviors of oxygen bubbles on vertical platinum sheet electrodes were investigated by a high-speed camera and their corresponding current densities were measured simultaneously using an electrochemical workstation. The impact of wide range of electrolyte pH values (i.e., 1–13) on both the bubble nucleation number and the dynamics behaviors of bubbles was investigated under different applied voltages. When the applied voltage was increased from 1.6 to 1.7 V vs the saturated calomel electrode, the radius of bubbles upon detachment increased in acidic environments (pH = 1–7) and decreased in alkaline environments (pH = 7–13). In an alkaline environment, the Marangoni force plays an essential role here. Furthermore, the bubble detachment radius predicted by the force balance model is well matched with our experimental results. Our results demonstrate that bubble detachment is not favorable in a strongly acidic environment, whereas oxygen bubbles exhibit rapid detachment from the electrode surface in a strongly alkaline environment.
- 1 October 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (10)
Open AccessInsight into pH-controlled bubble dynamics on a Pt electrode during electrochemical water splitting
Bubbles adhering to the electrode surface are the major factors causing the decreased efficiency of water electrolysis. In this work, the dynamic behaviors of oxygen bubbles on vertical platinum sheet electrodes were investigated by a high-speed camera and their corresponding current densities were measured simultaneously using an electrochemical workstation. The impact of wide range of electrolyte pH values (i.e., 1–13) on both the bubble nucleation number and the dynamics behaviors of bubbles was investigated under different applied voltages. When the applied voltage was increased from 1.6 to 1.7 V vs the saturated calomel electrode, the radius of bubbles upon detachment increased in acidic environments (pH = 1–7) and decreased in alkaline environments (pH = 7–13). In an alkaline environment, the Marangoni force plays an essential role here. Furthermore, the bubble detachment radius predicted by the force balance model is well matched with our experimental results. Our results demonstrate that bubble detachment is not favorable in a strongly acidic environment, whereas oxygen bubbles exhibit rapid detachment from the electrode surface in a strongly alkaline environment.