Shijie Zhang
Research Subjects
Shijie Zhang has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Chaohong Guo
Institute of Engineering Thermophysics, Chinese Academy of Sciences, No. 11, Beisihuanxi Road, Beijing 100190, People's Republic of China; University of Chinese Academy of Sciences, Beijing 100049, People's Republic of China
3 shared publications - Fengxiong Lu3 shared publications
- Xiang Xu3 shared publications
- Buze Chen2 shared publications
Bo Wang
1 shared publication- Shiqiang Liang
Institute of Engineering Thermophysics, Chinese Academy of Sciences, Beijing 100190, China
1 shared publication
Latest Publications
- 1 March 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (3)
Initial position of Taylor vortices in supercritical carbon dioxide Taylor–Couette–Poiseuille flow
Supercritical carbon dioxide (sCO2) exhibits a characteristic Taylor–Couette–Poiseuille (T–C–P) flow within the narrow gap between the turbine rotor and stator, where the spatial distribution and variation of Taylor vortices significantly influence the performance of the turbine rotor. To predict the spatial variation and the initial position of Taylor vortices in this system, this study employs computational fluid dynamics (CFD) simulations to systematically investigate the effects of heat flux, pressure, Taylor number, axial Reynolds number, aspect ratio, and radius ratio on the initial Taylor vortex position. Based on the CFD results, a predictive model for the initial position of Taylor vortices in sCO2 T–C–P flow was developed. The results reveal that under high heat flux and elevated pressure conditions, the Taylor vortices form closer to the inlet of the axial flow. Increasing the mass flow rate, reducing the rotation speed, and reducing the radius ratio can suppress the formation of the Taylor vortex of sCO2 in the turbine rotor–stator gap. The predictive accuracy of the neural network model for determining the Taylor vortex initiation position is within a margin of ±10%, outperforming the nonlinear regression model. At the design point, the Reynolds number, Taylor number, radius ratio, and aspect ratio are 9000, 6×109, 0.1, and 30, respectively. The variation range is ±5%; the parameter priority in influencing the Taylor vortex is as follows: aspect ratio, radius ratio, Reynolds number, and Taylor number.
- 1 March 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (3)
Initial position of Taylor vortices in supercritical carbon dioxide Taylor–Couette–Poiseuille flow
Supercritical carbon dioxide (sCO2) exhibits a characteristic Taylor–Couette–Poiseuille (T–C–P) flow within the narrow gap between the turbine rotor and stator, where the spatial distribution and variation of Taylor vortices significantly influence the performance of the turbine rotor. To predict the spatial variation and the initial position of Taylor vortices in this system, this study employs computational fluid dynamics (CFD) simulations to systematically investigate the effects of heat flux, pressure, Taylor number, axial Reynolds number, aspect ratio, and radius ratio on the initial Taylor vortex position. Based on the CFD results, a predictive model for the initial position of Taylor vortices in sCO2 T–C–P flow was developed. The results reveal that under high heat flux and elevated pressure conditions, the Taylor vortices form closer to the inlet of the axial flow. Increasing the mass flow rate, reducing the rotation speed, and reducing the radius ratio can suppress the formation of the Taylor vortex of sCO2 in the turbine rotor–stator gap. The predictive accuracy of the neural network model for determining the Taylor vortex initiation position is within a margin of ±10%, outperforming the nonlinear regression model. At the design point, the Reynolds number, Taylor number, radius ratio, and aspect ratio are 9000, 6×109, 0.1, and 30, respectively. The variation range is ±5%; the parameter priority in influencing the Taylor vortex is as follows: aspect ratio, radius ratio, Reynolds number, and Taylor number.
- Open Access
- 1 December 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (12)
Erratum: “Numerical investigation of the flow characteristics of supercritical carbon dioxide in a high-speed rotating annular gap” [Phys. Fluids 35, 102010 (2023)]
Changes are required in Fig. 14 at z/L = 0.80 and Fig. 28 at Rea = 17 144 of the original published paper,1 because there were inaccuracies in these two figures
- 1 December 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (12)
Open AccessErratum: “Numerical investigation of the flow characteristics of supercritical carbon dioxide in a high-speed rotating annular gap” [Phys. Fluids 35, 102010 (2023)]
Changes are required in Fig. 14 at z/L = 0.80 and Fig. 28 at Rea = 17 144 of the original published paper,1 because there were inaccuracies in these two figures
- Open Access
- 1 October 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (10)
Numerical investigation of the flow characteristics of supercritical carbon dioxide in a high-speed rotating annular gap
The flow characteristics of Taylor–Couette–Poiseuille flow induced by supercritical carbon dioxide in an annular gap play a pivotal role in determining the overall performance of the rotating machinery. To accurately design the structural components of rotating machinery and enhance its efficiency, this study employs the large eddy simulation method to investigate the flow behavior of Taylor–Couette–Poiseuille flow with supercritical carbon dioxide within an annular gap. The results reveal that vortices are predominantly generated near the inner wall. Initially, the flow exhibits small swirl vortices, spiral ring vortices, and annular vortices along the flow direction. As the flow progresses, these small vortices at the inlet region transition into hairpin swirl vortices. Finally, turbulent flow disturbances lead to the fragmentation and merging of spiral and annular vortices, resulting in a flow field characterized by high-frequency hairpin swirl vortices and small vortices with strong randomness. An increase in the swirl number causes the initial position of the Taylor vortex to shift toward the inlet, while the turbulent kinetic energy is more active on the outer wall side than the inner wall side. Along the flow direction, the vortices experience a developmental process involving stabilization, diffusion, and mixing. Varying the radius ratio affects the magnitude of vorticity, reduces velocity fluctuations in a regular pattern, and alters the distribution of helicity bands from wide and sparse to compact and dense groupings. As the axial Reynolds number increases, the magnitude of vortices grows, leading to more severe velocity fluctuations and the transformation of the helicity bands from a regular annular pattern to fluctuating vortices bands, accompanied by a decrease in helicity.
- 1 October 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (10)
Open AccessNumerical investigation of the flow characteristics of supercritical carbon dioxide in a high-speed rotating annular gap
The flow characteristics of Taylor–Couette–Poiseuille flow induced by supercritical carbon dioxide in an annular gap play a pivotal role in determining the overall performance of the rotating machinery. To accurately design the structural components of rotating machinery and enhance its efficiency, this study employs the large eddy simulation method to investigate the flow behavior of Taylor–Couette–Poiseuille flow with supercritical carbon dioxide within an annular gap. The results reveal that vortices are predominantly generated near the inner wall. Initially, the flow exhibits small swirl vortices, spiral ring vortices, and annular vortices along the flow direction. As the flow progresses, these small vortices at the inlet region transition into hairpin swirl vortices. Finally, turbulent flow disturbances lead to the fragmentation and merging of spiral and annular vortices, resulting in a flow field characterized by high-frequency hairpin swirl vortices and small vortices with strong randomness. An increase in the swirl number causes the initial position of the Taylor vortex to shift toward the inlet, while the turbulent kinetic energy is more active on the outer wall side than the inner wall side. Along the flow direction, the vortices experience a developmental process involving stabilization, diffusion, and mixing. Varying the radius ratio affects the magnitude of vorticity, reduces velocity fluctuations in a regular pattern, and alters the distribution of helicity bands from wide and sparse to compact and dense groupings. As the axial Reynolds number increases, the magnitude of vortices grows, leading to more severe velocity fluctuations and the transformation of the helicity bands from a regular annular pattern to fluctuating vortices bands, accompanied by a decrease in helicity.