Levent Altaş
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Levent Altaş has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Alper Alver
Department of Environmental Protection and Technologies, Technical Sciences Vocational School, Aksaray University, Aksaray, Turkey
4 shared publications - Ayşe Kuleyin2 shared publications
- Feryal Akbal
Department of Environmental Engineering, Ondokuz Mayıs Üniversitesi, Samsun, Turkey
2 shared publications - Merve Dönmez Öztel2 shared publications
- Emine Baştürk
Department of Environmental Protection Technologies, Technical Sciences Vocational School, Aksaray University, Aksaray, Turkey
1 shared publication - Hanife Buyukgungor
Retired, from Ondokuz Mayıs University, Engineering Faculty, Dept. of Environmental Eng., Samsun, Turkey
1 shared publication
Latest Publications
- 30 April 2026
- Published by Elsevier in Journal of Environmental Management
- Vol. 406, 129818
From composition to performance: Evaluating the effect of emulsion liquid membrane components on lead removal from water
- 30 April 2026
- Published by Elsevier in Journal of Environmental Management
- Vol. 406, 129818
From composition to performance: Evaluating the effect of emulsion liquid membrane components on lead removal from water
- Open Access
- 4 February 2026
- Published by Elsevier in SSRN Electronic Journal
From Composition to Performance: Evaluating the Effect of Emulsion Liquid Membrane Components on Lead Removal from Water
Lead (Pb2+) is a toxic heavy metal commonly present in industrial wastewater. This study presents the development and optimization of an emulsion liquid membrane (ELM) system for rapid and efficient Pb2+ removal from aqueous solutions. The effects of solvent type, extractants, stripping agents, and surfactant amounts on lead removal efficiency were systematically evaluated. The optimized 22 mL membrane phase consisted of a mineral oil-toluene mixture (1:1, v/v) containing 3% sorbitan monooleate (SPAN80) and 5% di(2-ethylhexyl) phosphoric acid (D2EHPA), while the 18 mL internal phase contained 2.4 N sulfuric acid. The optimum emulsification speed and time were 10000 rpm and 1 min, and the reactor stirring speed for mixing the 40 mL emulsion phase with a 250 mL external aqueous phase containing approximately 1000 mg L-1 Pb2+ was 300 rpm. Under these conditions, the system achieved Pb2+ removal efficiencies exceeding 99% within 20 min, reducing the final concentrations to below 1 mg L-1 while maintaining high emulsion stability and reproducibility. The optimized parameters provide critical insight into the chemical and physical design of ELM systems, highlighting their potential for industrial-scale heavy metal removal. Additionally, considerations such as external phase pH reduction and potential membrane phase leakage are identified as important for scale-up and post-treatment processes. The findings demonstrate that the optimized ELM system offers a highly effective, rapid, and scalable strategy for lead removal or extraction from aqueous streams and effluents.
- 4 February 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessFrom Composition to Performance: Evaluating the Effect of Emulsion Liquid Membrane Components on Lead Removal from Water
Lead (Pb2+) is a toxic heavy metal commonly present in industrial wastewater. This study presents the development and optimization of an emulsion liquid membrane (ELM) system for rapid and efficient Pb2+ removal from aqueous solutions. The effects of solvent type, extractants, stripping agents, and surfactant amounts on lead removal efficiency were systematically evaluated. The optimized 22 mL membrane phase consisted of a mineral oil-toluene mixture (1:1, v/v) containing 3% sorbitan monooleate (SPAN80) and 5% di(2-ethylhexyl) phosphoric acid (D2EHPA), while the 18 mL internal phase contained 2.4 N sulfuric acid. The optimum emulsification speed and time were 10000 rpm and 1 min, and the reactor stirring speed for mixing the 40 mL emulsion phase with a 250 mL external aqueous phase containing approximately 1000 mg L-1 Pb2+ was 300 rpm. Under these conditions, the system achieved Pb2+ removal efficiencies exceeding 99% within 20 min, reducing the final concentrations to below 1 mg L-1 while maintaining high emulsion stability and reproducibility. The optimized parameters provide critical insight into the chemical and physical design of ELM systems, highlighting their potential for industrial-scale heavy metal removal. Additionally, considerations such as external phase pH reduction and potential membrane phase leakage are identified as important for scale-up and post-treatment processes. The findings demonstrate that the optimized ELM system offers a highly effective, rapid, and scalable strategy for lead removal or extraction from aqueous streams and effluents.
- 23 September 2025
- Published by Elsevier in Surfaces and Interfaces
- Vol. 74
Sustainable arsenic removal using iron-oxide-coated natural minerals: Integrating adsorption, machine learning, and process optimization
- 23 September 2025
- Published by Elsevier in Surfaces and Interfaces
- Vol. 74
Sustainable arsenic removal using iron-oxide-coated natural minerals: Integrating adsorption, machine learning, and process optimization
- 12 October 2023
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 21 (2) , 2035-2048
The water footprint assessment for advanced biological wastewater treatment plant
- 12 October 2023
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 21 (2) , 2035-2048
The water footprint assessment for advanced biological wastewater treatment plant
- Open Access
- 8 July 2022
- Published by Elsevier in Desalination and Water Treatment
- Vol. 252, 300-318
A solution of taste and odor problem with activated carbon adsorption in drinking water: detailed kinetics and isotherms
- 8 July 2022
- Published by Elsevier in Desalination and Water Treatment
- Vol. 252, 300-318
Open AccessA solution of taste and odor problem with activated carbon adsorption in drinking water: detailed kinetics and isotherms
- 11 April 2017
- Published by Springer Nature in International Journal of Environmental Research
- Vol. 11 (2) , 111-123
Pb(II) Removal from Aqueous Solution and Industrial Wastewater by Raw and Lime-Conditioned Phosphogypsum
- 11 April 2017
- Published by Springer Nature in International Journal of Environmental Research
- Vol. 11 (2) , 111-123
Pb(II) Removal from Aqueous Solution and Industrial Wastewater by Raw and Lime-Conditioned Phosphogypsum