Boris Manevich
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Boris Manevich has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Evgeniy Titov
All-Russian Dairy Research Institute
2 shared publicationsAll-Russian Dairy Research Institute
1 shared publicationE. Burykina
All-Russian Dairy Research Institute
1 shared publication- Elena Aleksandrovna Burykina1 shared publication
Elena Burykina
All-Russian Dairy Research Institute
1 shared publication- Nikita S. Golowan
All-Russian Dairy Research Institute
1 shared publication
Latest Publications
- Open Access
- 24 October 2025
- Published by Kemerovo State University in Dairy Industry
- No. 4,p. 68-76
Antimicrobial Properties of Electrochemically Activated Solutions of Carboxylic Acid Salts vs. Sodium Chloride
Alternative disinfection methods involve no chlorine-containing solutions, which, despite their effectiveness, generate toxic by-products. This research compared the physicochemical and antimicrobial properties of electrolytic sodium chloride with electrochemically activated solutions of carboxylic acid salts (sodium acetate, citrate, lactate). The focus was on safety and sustainability. Unsing an electrolysis unit with a diaphragm electrochemical module and electrochemically activated 1% salt solutions, the authors studied the redox potential, the hydrogen ion activity index (pH), the oxidant content (active chlorine equivalent), and the in-vitro bactericidal efficacy against Pseudomonas aeruginosa (strains ATCC 25668, resistant pc 47, 10 min exposure). The sodium lactate provided microbial reduction by 4–6 lg CFU/cm3 while sodium acetate and citrate solutions were less effective (3.9–4.9 and 3.4–4.0 lg CFU/cm3, respectively). In case of sodium chloride, the reduction was as high as 8 lg CFU/cm3, the initial titers being 8.0 and 8.2 lg CFU/cm3. The electrolytic monosolutions of carboxylic acid salts (Kolbe reaction) demonstrated low results in bactericidal agents, pH, and oxidation-reduction potential. Carboxylic acid salts combined with sodium chloride could synergistically enhance the antimicrobial effect while reducing toxic by-products. If optimized, such electrolysis parameters as voltage, current strength, and initial solutions may increase the disinfection efficiency. The results obtained can be used to develop environmentally safe disinfectants for the food industry.
- 24 October 2025
- Published by Kemerovo State University in Dairy Industry
- No. 4,p. 68-76
Open AccessAntimicrobial Properties of Electrochemically Activated Solutions of Carboxylic Acid Salts vs. Sodium Chloride
Alternative disinfection methods involve no chlorine-containing solutions, which, despite their effectiveness, generate toxic by-products. This research compared the physicochemical and antimicrobial properties of electrolytic sodium chloride with electrochemically activated solutions of carboxylic acid salts (sodium acetate, citrate, lactate). The focus was on safety and sustainability. Unsing an electrolysis unit with a diaphragm electrochemical module and electrochemically activated 1% salt solutions, the authors studied the redox potential, the hydrogen ion activity index (pH), the oxidant content (active chlorine equivalent), and the in-vitro bactericidal efficacy against Pseudomonas aeruginosa (strains ATCC 25668, resistant pc 47, 10 min exposure). The sodium lactate provided microbial reduction by 4–6 lg CFU/cm3 while sodium acetate and citrate solutions were less effective (3.9–4.9 and 3.4–4.0 lg CFU/cm3, respectively). In case of sodium chloride, the reduction was as high as 8 lg CFU/cm3, the initial titers being 8.0 and 8.2 lg CFU/cm3. The electrolytic monosolutions of carboxylic acid salts (Kolbe reaction) demonstrated low results in bactericidal agents, pH, and oxidation-reduction potential. Carboxylic acid salts combined with sodium chloride could synergistically enhance the antimicrobial effect while reducing toxic by-products. If optimized, such electrolysis parameters as voltage, current strength, and initial solutions may increase the disinfection efficiency. The results obtained can be used to develop environmentally safe disinfectants for the food industry.
- Open Access
- 10 October 2024
- Published by All-Russian Dairy Research Institute in FOOD METAENGINEERING
- Vol. 2 (3) , 41-53
The Impact of Storage Conditions on the Physicochemical Properties of Electrochemically Activated Solutions
Физико-химические изменения в электрохимически активированных растворах анолитов при различных условиях хранения
- 10 October 2024
- Published by All-Russian Dairy Research Institute in FOOD METAENGINEERING
- Vol. 2 (3) , 41-53
Open AccessThe Impact of Storage Conditions on the Physicochemical Properties of Electrochemically Activated Solutions
Физико-химические изменения в электрохимически активированных растворах анолитов при различных условиях хранения
- 1 September 2024
- Published by National Organization of Disinfectionists in Disinfection affairs
- No. 3
Aspects of safe use of modern disinfectants in dairy enterprises
The article analyzes the main aspects of safe application of chemical disinfectants widely used at dairy enterprises. Effective disinfection at dairy enterprises is directly related to the production of high-quality, safe and competitive food products. When selecting a disinfectant for use at a dairy enterprise, a comprehensive evaluation is necessary not only for effectiveness, but also a multilateral consideration of its safe use. Increasing requirements to ecologization of milk processing enterprises dictate the search for new combinations of functional components in the formulations of chemical sanitizers. The article shows the necessity of consideration of adhesion properties of disinfectants, their corrosive activity and indifference to various materials used at food processing enterprises. It is suggested to control working chloroactive disinfectant solutions, first of all, obtained by electrolysis method, not only by the content of active chlorine, but also by the value of redox potential. The relevance of research aimed at studying the inhibitory properties of active substances and residual quantities of disinfectants on starter microflora and the importance of a systematic approach to the integrated assessment of all elements of safe use of disinfectants at dairy enterprises is formulated. Keywords: disinfectants, toxicity and hazard, effect on human body, environmental safety, redox potential, corrosivity, chemical contamination, inhibition.
- 1 September 2024
- Published by National Organization of Disinfectionists in Disinfection affairs
- No. 3
Aspects of safe use of modern disinfectants in dairy enterprises
The article analyzes the main aspects of safe application of chemical disinfectants widely used at dairy enterprises. Effective disinfection at dairy enterprises is directly related to the production of high-quality, safe and competitive food products. When selecting a disinfectant for use at a dairy enterprise, a comprehensive evaluation is necessary not only for effectiveness, but also a multilateral consideration of its safe use. Increasing requirements to ecologization of milk processing enterprises dictate the search for new combinations of functional components in the formulations of chemical sanitizers. The article shows the necessity of consideration of adhesion properties of disinfectants, their corrosive activity and indifference to various materials used at food processing enterprises. It is suggested to control working chloroactive disinfectant solutions, first of all, obtained by electrolysis method, not only by the content of active chlorine, but also by the value of redox potential. The relevance of research aimed at studying the inhibitory properties of active substances and residual quantities of disinfectants on starter microflora and the importance of a systematic approach to the integrated assessment of all elements of safe use of disinfectants at dairy enterprises is formulated. Keywords: disinfectants, toxicity and hazard, effect on human body, environmental safety, redox potential, corrosivity, chemical contamination, inhibition.
- Open Access
- 13 June 2024
- Published by Kemerovo State University in Dairy Industry
- No. 3,p. 87-94
Acid Anolytes in Food Sanitation
- 13 June 2024
- Published by Kemerovo State University in Dairy Industry
- No. 3,p. 87-94
Open AccessAcid Anolytes in Food Sanitation
- Open Access
- 19 February 2024
- Published by Kemerovo State University in Dairy Industry
- No. 1,p. 60-63
Electrolysis Solutions in Sanitation: Past and Present
Борис Владиленович Маневич, канд. техн
- 19 February 2024
- Published by Kemerovo State University in Dairy Industry
- No. 1,p. 60-63
Open AccessElectrolysis Solutions in Sanitation: Past and Present
Борис Владиленович Маневич, канд. техн
- Open Access
- 10 October 2023
- Published by Kemerovo State University in Dairy Industry
- No. 5,p. 108-110
Peculiarities of hydrogen peroxide use in dairy enterprises
Борис Владиленович Маневич, канд
- 10 October 2023
- Published by Kemerovo State University in Dairy Industry
- No. 5,p. 108-110
Open AccessPeculiarities of hydrogen peroxide use in dairy enterprises
Борис Владиленович Маневич, канд
- Open Access
- 30 September 2023
- Published by All-Russian Dairy Research Institute in FOOD METAENGINEERING
- Vol. 1 (2)
Evaluation of hydrogen peroxide wetting properties in the context of safe application in aseptic milk filling
Introduction: In aseptic filling systems, packaging materials are sterilized using various methods to eliminate microorganisms. One of the most popular methods for sterilizing packaging materials is the use of hydrogen peroxide. The wetting property of the surface plays a crucial role in ensuring effective inactivation of microorganisms and uniform treatment of the aseptic packaging. Improving the wetting properties of hydrogen peroxide solutions by adding surfactants will enhance the contact of the sterilant with the lyophobic multilayer packaging material's treated surface, providing the necessary sterilizing ability and disinfectant action during the aseptic filling of milk and dairy products.Purpose: To study the wetting properties of concentrated hydrogen peroxide solutions on various substrates and the possibility of their correction with surfactants to ensure better packaging wetting and safe disinfection processes.Materials and Methods: The objects of the study included the disinfecting substance and sterilant - hydrogen peroxide, surfactants used as technological aids in the food industry, and combined multilayer packaging materials based on paper, cardboard, aluminum foil, and polymer materials used in aseptic milk filling processes. Wetting ability was evaluated by the contact angle in a 3-phase system: adhesive (hydrogen peroxide, water, surfactant solutions) - substrate (packaging material, steel plate, glass) - air using the drop shape analysis based on the Young-Laplace method; surface tension was determined by the optical drop shape analysis using the DSA25S device; surface tension of solutions at temperatures ranging from 30 to 70 °C was determined using the maximum bubble pressure method. The presence of residual amounts of the surfactant polysorbate on the sterilized packaging material was analyzed by HPLC.Results: The Tetra Brik®Aseptic packaging material exhibits pronounced lyophobic properties. The introduction of 0.1% polysorbate surfactant into the hydrogen peroxide solution (~35% w/w) reduced the contact angle by more than 50%, from 93.75° to 40.99°, and significantly decreased the surface tension (45-48%).Conclusion: Improving the wetting properties of hydrogen peroxide solutions will enhance the contact of the sterilant with the treated surface of the lyophobic multilayer packaging material by adding a surfactant, ensuring the necessary sterilizing ability and disinfectant action during the aseptic filling of milk and dairy products. The application conditions of hydrogen peroxide solutions with the addition of 0.1% nonionic surfactant polysorbate in aseptic filling, considering both effectiveness in disinfecting packaging material and safety related to the removal of its residual amounts, allow considering it as a technological aid.
- 30 September 2023
- Published by All-Russian Dairy Research Institute in FOOD METAENGINEERING
- Vol. 1 (2)
Open AccessEvaluation of hydrogen peroxide wetting properties in the context of safe application in aseptic milk filling
Introduction: In aseptic filling systems, packaging materials are sterilized using various methods to eliminate microorganisms. One of the most popular methods for sterilizing packaging materials is the use of hydrogen peroxide. The wetting property of the surface plays a crucial role in ensuring effective inactivation of microorganisms and uniform treatment of the aseptic packaging. Improving the wetting properties of hydrogen peroxide solutions by adding surfactants will enhance the contact of the sterilant with the lyophobic multilayer packaging material's treated surface, providing the necessary sterilizing ability and disinfectant action during the aseptic filling of milk and dairy products.Purpose: To study the wetting properties of concentrated hydrogen peroxide solutions on various substrates and the possibility of their correction with surfactants to ensure better packaging wetting and safe disinfection processes.Materials and Methods: The objects of the study included the disinfecting substance and sterilant - hydrogen peroxide, surfactants used as technological aids in the food industry, and combined multilayer packaging materials based on paper, cardboard, aluminum foil, and polymer materials used in aseptic milk filling processes. Wetting ability was evaluated by the contact angle in a 3-phase system: adhesive (hydrogen peroxide, water, surfactant solutions) - substrate (packaging material, steel plate, glass) - air using the drop shape analysis based on the Young-Laplace method; surface tension was determined by the optical drop shape analysis using the DSA25S device; surface tension of solutions at temperatures ranging from 30 to 70 °C was determined using the maximum bubble pressure method. The presence of residual amounts of the surfactant polysorbate on the sterilized packaging material was analyzed by HPLC.Results: The Tetra Brik®Aseptic packaging material exhibits pronounced lyophobic properties. The introduction of 0.1% polysorbate surfactant into the hydrogen peroxide solution (~35% w/w) reduced the contact angle by more than 50%, from 93.75° to 40.99°, and significantly decreased the surface tension (45-48%).Conclusion: Improving the wetting properties of hydrogen peroxide solutions will enhance the contact of the sterilant with the treated surface of the lyophobic multilayer packaging material by adding a surfactant, ensuring the necessary sterilizing ability and disinfectant action during the aseptic filling of milk and dairy products. The application conditions of hydrogen peroxide solutions with the addition of 0.1% nonionic surfactant polysorbate in aseptic filling, considering both effectiveness in disinfecting packaging material and safety related to the removal of its residual amounts, allow considering it as a technological aid.