Seohyun Kim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Seohyun Kim has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Juhyuk Moon
Department of Civil and Environmental Engineering, Seoul National University, Seoul, Republic of Korea
9 shared publications - Jingwei Yang
Department of Civil and Environmental Engineering Seoul National University Seoul Republic of Korea
3 shared publications - Ahyeon Lim
Seoul Natl Univ, Dept Civil & Environm Engn, Seoul 08826, South Korea
2 shared publications Chi Sun Poon
2 shared publications- Dongho Jeon
Department of Civil Engineering, Dong-A University, Busan, 49315, Republic of Korea
2 shared publications - Hyunuk Kang
Department of Civil and Environmental Engineering University of California Berkeley California USA
2 shared publications
Latest Publications
- Open Access
- 31 August 2026
- Published by Elsevier in SSRN Electronic Journal
Expanding the applicability of partially calcined limestone-based clinker-free binders using calcined clay under thermal activation
Reducing clinker content through supplementary cementitious materials (SCMs) effectively mitigates embodied CO2, but excessive replacement often causes strength loss. Alkali activation using NaOH or sodium silicate can promote SCM reactions even under calcium-deficient conditions, but the required high dosages increase cost. Calcium-based activators can supply reactive calcium for SCM reactions; however, conventional CaO and Ca(OH)2 require limestone decarbonation and substantial fuel consumption. Partially calcined limestone (PCL), produced under milder conditions than conventional lime, can reduce this burden, but its higher CO2 emissions than conventional SCMs may limit its benefit when used merely as an additional clinker substitute. Therefore, this study proposes a clinker-free binder composed only of PCL and calcined clay, without additional external activators. Thermal activation was applied to ensure strength development, and the resulting strength, hydration kinetics, phase evolution, and optimal binder formulation were investigated. Finally, environmental performance was evaluated and compared with that of an LC3-50 system. This comprehensive analysis provides insight into the design of clinker-free systems for substantial CO2 mitigation.
- 31 August 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessExpanding the applicability of partially calcined limestone-based clinker-free binders using calcined clay under thermal activation
Reducing clinker content through supplementary cementitious materials (SCMs) effectively mitigates embodied CO2, but excessive replacement often causes strength loss. Alkali activation using NaOH or sodium silicate can promote SCM reactions even under calcium-deficient conditions, but the required high dosages increase cost. Calcium-based activators can supply reactive calcium for SCM reactions; however, conventional CaO and Ca(OH)2 require limestone decarbonation and substantial fuel consumption. Partially calcined limestone (PCL), produced under milder conditions than conventional lime, can reduce this burden, but its higher CO2 emissions than conventional SCMs may limit its benefit when used merely as an additional clinker substitute. Therefore, this study proposes a clinker-free binder composed only of PCL and calcined clay, without additional external activators. Thermal activation was applied to ensure strength development, and the resulting strength, hydration kinetics, phase evolution, and optimal binder formulation were investigated. Finally, environmental performance was evaluated and compared with that of an LC3-50 system. This comprehensive analysis provides insight into the design of clinker-free systems for substantial CO2 mitigation.
- 18 January 2025
- Published by Elsevier in Journal of Building Engineering
- Vol. 101
Impact of triethanolamine on grinding and hydration performance of BOF steel slag blended cement
- 18 January 2025
- Published by Elsevier in Journal of Building Engineering
- Vol. 101
Impact of triethanolamine on grinding and hydration performance of BOF steel slag blended cement
- 5 December 2024
- Published by Elsevier in Cement and Concrete Composites
- Vol. 157
Enhancement of fly ash reactivity through triethanolamine addition and CO2 curing
- 5 December 2024
- Published by Elsevier in Cement and Concrete Composites
- Vol. 157
Enhancement of fly ash reactivity through triethanolamine addition and CO2 curing
- 4 April 2024
- Published by Elsevier in Cement and Concrete Composites
- Vol. 149, 105532
Enhanced mechanical property of steel slag through glycine-assisted hydration and carbonation curing
- 4 April 2024
- Published by Elsevier in Cement and Concrete Composites
- Vol. 149, 105532
Enhanced mechanical property of steel slag through glycine-assisted hydration and carbonation curing
- 13 December 2023
- Published by Elsevier in Construction and Building Materials
- Vol. 411
Mechanochemical activation for transforming bottom ash to reactive supplementary cementitious material
- 13 December 2023
- Published by Elsevier in Construction and Building Materials
- Vol. 411
Mechanochemical activation for transforming bottom ash to reactive supplementary cementitious material
- 10 October 2023
- Published by Elsevier in Cement and Concrete Composites
- Vol. 145
Mechanochemical effect of alkanolamines on the C4AF: Crystal structure, hydration behavior, and strength enhancement
- 10 October 2023
- Published by Elsevier in Cement and Concrete Composites
- Vol. 145
Mechanochemical effect of alkanolamines on the C4AF: Crystal structure, hydration behavior, and strength enhancement