Marlon José Zanotto
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Marlon José Zanotto has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Aleksandro Schafer da Silva
Departamento de Zootecnia, Universidade do Estado de Santa Catarina, Chapecó 89815-630, Brazil
1 shared publication - Alicia Dal Santo
Universidade do Oeste de Santa Catarina
1 shared publication - Arele Arlindo Calderano
Universidade Federal de Viçosa
1 shared publication Diovani Paiano
Universidade do Estado de Santa Catarina
1 shared publication- Diovani Paiano
Universidade do Estado de Santa Catarina
1 shared publication - Felipe Leite
Universidade do Oeste de Santa Catarina, Brazil
1 shared publication
Latest Publications
- Open Access
- 23 October 2023
- Published by Revista Brasileira de Zootecnia in Revista Brasileira de Zootecnia
- Vol. 52
Addition of capsaicin in the diet of turkeys: Effects on growth performance and antioxidant and oxidant status in serum and in meat
The objective of this study was to evaluate whether the addition of different levels of capsaicin in the diet of female turkeys has beneficial effects on growth performance and the antioxidant and oxidant status in serum and meat. A total of 150 female turkeys were distributed in a completely randomized design with three treatments with five replicates per treatment and ten birds per experimental unit. Treatments were identified as control (without additive); T400 – basal diet containing 400 mg/kg [...] ABSTRACT The objective of this study was to evaluate whether the addition of different levels of capsaicin in the diet of female turkeys has beneficial effects on growth performance and the antioxidant and oxidant status in serum and meat. A total of 150 female turkeys were distributed in a completely randomized design with three treatments with five replicates per treatment and ten birds per experimental unit. Treatments were identified as control (without additive); T400 – basal diet containing 400 mg/kg
- 23 October 2023
- Published by Revista Brasileira de Zootecnia in Revista Brasileira de Zootecnia
- Vol. 52
Open AccessAddition of capsaicin in the diet of turkeys: Effects on growth performance and antioxidant and oxidant status in serum and in meat
The objective of this study was to evaluate whether the addition of different levels of capsaicin in the diet of female turkeys has beneficial effects on growth performance and the antioxidant and oxidant status in serum and meat. A total of 150 female turkeys were distributed in a completely randomized design with three treatments with five replicates per treatment and ten birds per experimental unit. Treatments were identified as control (without additive); T400 – basal diet containing 400 mg/kg [...] ABSTRACT The objective of this study was to evaluate whether the addition of different levels of capsaicin in the diet of female turkeys has beneficial effects on growth performance and the antioxidant and oxidant status in serum and meat. A total of 150 female turkeys were distributed in a completely randomized design with three treatments with five replicates per treatment and ten birds per experimental unit. Treatments were identified as control (without additive); T400 – basal diet containing 400 mg/kg
- Open Access
- 18 October 2023
- Published by Universidade Estadual de Maringa in Acta Scientiarum. Animal Sciences
- Vol. 46, e56847
Corn physical characteristics on piglet performance
This study aimed to correlate the physical characteristics of ground corn, at different crushing intensities, with the zootechnical performance of piglets in the nursery phase. Forty piglets (20 castrated males and 20 females) with an initial average weight of 15.7±1.98 kg and final weight of 32.5±3.27 kg were used. They were subjected to the same type of experimental diet (4% of commercial premix for the phase, 29% of soybean meal, and 67% of ground corn), with the only difference being the corn grinding process. The corn used was fractionated into five portions, and each one of them was crushed in a hammermill equipped with a different screen hole diameter (2; 2.5; 3; 3.5 and 4 mm). Which resulted in ground corn with the following particle sizes (PS): 518, 580, 628, 706 and 740 μm, and the following corn geometric standard deviations (GSD): 1.72, 1.71, 1.75, 1.80 and 1.90, respectively. The piglets were distributed in a completely randomized design with five treatments and four replications, with the experimental units being formed by pens with two piglets each. There was no effect (p > 0.10) from grinding intensities on daily feed intake (DFI) and daily weight gain (DWG). Conversely, there was an effect (p < 0.10) from different grinding intensities on feed conversion (FC). The PS and GSD of both the corn and diet, as well as the corn fractions retained on the 4-, 2- and 1.2-mm test sieves showed positive correlations with FC (p < 0.05). On the other hand, the corn fractions retained on the 0.6-, 0.3- and 0.15-mm teste sieves showed negative correlations with FC (p < 0.05). The linear model was the one that fitted the estimated data into the data observed for FC. A corn PS reduction from 740 to 580 μm promoted a linear improvement in FC. The use of corn fractions, retained on the 1-, 2- and 0.3-mm test sieves, and the use of corn GSD and diet GSD as independent variables showed a higher R² than that obtained with the use of corn PS as an independent variable in linear equations for estimating FC.
- 18 October 2023
- Published by Universidade Estadual de Maringa in Acta Scientiarum. Animal Sciences
- Vol. 46, e56847
Open AccessCorn physical characteristics on piglet performance
This study aimed to correlate the physical characteristics of ground corn, at different crushing intensities, with the zootechnical performance of piglets in the nursery phase. Forty piglets (20 castrated males and 20 females) with an initial average weight of 15.7±1.98 kg and final weight of 32.5±3.27 kg were used. They were subjected to the same type of experimental diet (4% of commercial premix for the phase, 29% of soybean meal, and 67% of ground corn), with the only difference being the corn grinding process. The corn used was fractionated into five portions, and each one of them was crushed in a hammermill equipped with a different screen hole diameter (2; 2.5; 3; 3.5 and 4 mm). Which resulted in ground corn with the following particle sizes (PS): 518, 580, 628, 706 and 740 μm, and the following corn geometric standard deviations (GSD): 1.72, 1.71, 1.75, 1.80 and 1.90, respectively. The piglets were distributed in a completely randomized design with five treatments and four replications, with the experimental units being formed by pens with two piglets each. There was no effect (p > 0.10) from grinding intensities on daily feed intake (DFI) and daily weight gain (DWG). Conversely, there was an effect (p < 0.10) from different grinding intensities on feed conversion (FC). The PS and GSD of both the corn and diet, as well as the corn fractions retained on the 4-, 2- and 1.2-mm test sieves showed positive correlations with FC (p < 0.05). On the other hand, the corn fractions retained on the 0.6-, 0.3- and 0.15-mm teste sieves showed negative correlations with FC (p < 0.05). The linear model was the one that fitted the estimated data into the data observed for FC. A corn PS reduction from 740 to 580 μm promoted a linear improvement in FC. The use of corn fractions, retained on the 1-, 2- and 0.3-mm test sieves, and the use of corn GSD and diet GSD as independent variables showed a higher R² than that obtained with the use of corn PS as an independent variable in linear equations for estimating FC.