Jiacong Qiu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jiacong Qiu has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Junrui Liang
ShanghaiTech University
6 shared publications - Haoyu Wang
ShanghaiTech University
3 shared publications - Minfan Fu
ShanghaiTech University
3 shared publications - Bao Zhao
School of Information Science and Technology, ShanghaiTech University, Shanghai, China
1 shared publication - Jintao Meng
ShanghaiTech University
1 shared publication - Yilin Wang
ShanghaiTech University
1 shared publication
Latest Publications
- 1 November 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- Vol. 13 (22) , 52713-52727
Synergizing Hardware and Software Energy Management for Reliable Start-Up and Operation of Battery-Free Electronic Devices
- 1 November 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- Vol. 13 (22) , 52713-52727
Synergizing Hardware and Software Energy Management for Reliable Start-Up and Operation of Battery-Free Electronic Devices
- 11 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 41 (4) , 7103-7117
A Single-Stage Synchronized Switch Interface Circuit for Power Enhancement and Voltage Regulation in Electromagnetic Energy Harvesting
Synchronized switch interface circuits demonstrate good performance for electromagnetic energy harvesting applications, but lack adaptability in terms of harvested power. This article introduces an additional control degree of freedom by proposing two power control methods and implementing them in a synchronous current inversion and energy extraction (SCIEE) circuit. Theoretical analysis indicates that the single-stage system achieves higher efficiency for approximately 41.3% of the supported load range compared to using a commercial dc–dc regulator. In the load transient experiments, the proposed system maintains the output voltage well-regulated, with undershoot and overshoot below 0.2 V. The output voltage ripple is 0.15 V at an 18 mA load current. The proposed system is compared to three other options: a direct ac–dc harvesting circuit, the synchronous switch energy extraction (SSEE) circuit, and a two-stage harvesting system using a commercial dc–dc regulator and an open-loop SCIEE circuit. The proposed system supports a maximum load current of 29.47 mA, the highest among these options. In a field test, the proposed system supports successful integrated circuit long range (LoRa) packet transmissions and exhibits a broader supported load range than the SSEE or direct ac–dc harvest scheme.
- 11 November 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 41 (4) , 7103-7117
A Single-Stage Synchronized Switch Interface Circuit for Power Enhancement and Voltage Regulation in Electromagnetic Energy Harvesting
Synchronized switch interface circuits demonstrate good performance for electromagnetic energy harvesting applications, but lack adaptability in terms of harvested power. This article introduces an additional control degree of freedom by proposing two power control methods and implementing them in a synchronous current inversion and energy extraction (SCIEE) circuit. Theoretical analysis indicates that the single-stage system achieves higher efficiency for approximately 41.3% of the supported load range compared to using a commercial dc–dc regulator. In the load transient experiments, the proposed system maintains the output voltage well-regulated, with undershoot and overshoot below 0.2 V. The output voltage ripple is 0.15 V at an 18 mA load current. The proposed system is compared to three other options: a direct ac–dc harvesting circuit, the synchronous switch energy extraction (SSEE) circuit, and a two-stage harvesting system using a commercial dc–dc regulator and an open-loop SCIEE circuit. The proposed system supports a maximum load current of 29.47 mA, the highest among these options. In a field test, the proposed system supports successful integrated circuit long range (LoRa) packet transmissions and exhibits a broader supported load range than the SSEE or direct ac–dc harvest scheme.
- Open Access
- 5 August 2025
- Published by IOP Publishing in Smart Materials and Structures
- Vol. 34 (8)
Self-powered solution of synchronous current inversion and energy extraction (SCIEE) for electromagnetic energy harvesting enhancement
Self-powered and self-start issues are essential for the standalone applications of switched-mode interface circuits for micro-generators. This paper introduces a self-powered and self-starting solution for small-scale electromagnetic energy harvesters. The self-start solution uses a passive voltage multiplier and an energy buffer-release circuit to kickstart the circuit during cold start-up. Introducing an energy buffer-release mechanism in the start-up process reduces the required voltage amplitude for cold-start. The energy buffer-release circuit features low power dissipation and adjustable thresholds. The operation principle of the proposed energy buffer-release circuit is elaborated. The voltage thresholds are theoretically derived and experimentally validated. In experiments, the proposed start-up circuit is applied to the synchronized current inversion and energy extraction (SCIEE) circuit, which enhances the harvested power of a low-voltage electromagnetic energy harvester. Experiments show that it can start at a relatively small input voltage amplitude, as small as 1.35 V. The total power consumption of the start-up and control circuits accounts for 8.8 % of the harvested power at 14 V load voltage. The energy buffer-release circuit only dissipates around 46 μW.
- 5 August 2025
- Published by IOP Publishing in Smart Materials and Structures
- Vol. 34 (8)
Open AccessSelf-powered solution of synchronous current inversion and energy extraction (SCIEE) for electromagnetic energy harvesting enhancement
Self-powered and self-start issues are essential for the standalone applications of switched-mode interface circuits for micro-generators. This paper introduces a self-powered and self-starting solution for small-scale electromagnetic energy harvesters. The self-start solution uses a passive voltage multiplier and an energy buffer-release circuit to kickstart the circuit during cold start-up. Introducing an energy buffer-release mechanism in the start-up process reduces the required voltage amplitude for cold-start. The energy buffer-release circuit features low power dissipation and adjustable thresholds. The operation principle of the proposed energy buffer-release circuit is elaborated. The voltage thresholds are theoretically derived and experimentally validated. In experiments, the proposed start-up circuit is applied to the synchronized current inversion and energy extraction (SCIEE) circuit, which enhances the harvested power of a low-voltage electromagnetic energy harvester. Experiments show that it can start at a relatively small input voltage amplitude, as small as 1.35 V. The total power consumption of the start-up and control circuits accounts for 8.8 % of the harvested power at 14 V load voltage. The energy buffer-release circuit only dissipates around 46 μW.
- 24 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 71 (12) , 5471-5481
A Synchronous Current Inversion and Energy Extraction Circuit for Electromagnetic Energy Harvesting Enhancement
Synchronous switch (SS) technique has been extensively studied in piezoelectric energy harvesting (PEH). The SS circuits can significantly enhance the output power under the same vibration excitation. Some SS solutions have also been developed for an inductive electromagnetic (EM) source by referring to its capacitive PEH counterpart and taking a reciprocal design. This paper proposes a synchronized current inversion and energy extraction (SCIEE) circuit for EM energy harvesting (EMEH). SCIEE utilizes two switched capacitive branches to carry out the synchronized current inversion at the electromotive voltage negative-to-positive zero-crossing instants and energy extraction at the voltage positive-to-negative zero-crossing instants. By inverting the transducer current, SCIEE increases the torque/force inside the transducer to extract more energy from the relative movement between magnets and coils. Theoretical analysis shows that the proposed circuit is suitable for use with an EM transducer, whose quality factor is relatively large. Experiments compared the output power of three harvesting schemes: SCIEE, synchronized switch energy extraction (SSEE), and conventional pulse-width modulation (PWM)-based harvesting scheme. When using the same prototyped EM harvester under the same mechanical excitation, SCIEE can harvest 38% more power, compared with the cutting-edge SSEE circuit for EMEH; and 900% more power, compared with the PWM-based harvesting scheme.
- 24 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 71 (12) , 5471-5481
A Synchronous Current Inversion and Energy Extraction Circuit for Electromagnetic Energy Harvesting Enhancement
Synchronous switch (SS) technique has been extensively studied in piezoelectric energy harvesting (PEH). The SS circuits can significantly enhance the output power under the same vibration excitation. Some SS solutions have also been developed for an inductive electromagnetic (EM) source by referring to its capacitive PEH counterpart and taking a reciprocal design. This paper proposes a synchronized current inversion and energy extraction (SCIEE) circuit for EM energy harvesting (EMEH). SCIEE utilizes two switched capacitive branches to carry out the synchronized current inversion at the electromotive voltage negative-to-positive zero-crossing instants and energy extraction at the voltage positive-to-negative zero-crossing instants. By inverting the transducer current, SCIEE increases the torque/force inside the transducer to extract more energy from the relative movement between magnets and coils. Theoretical analysis shows that the proposed circuit is suitable for use with an EM transducer, whose quality factor is relatively large. Experiments compared the output power of three harvesting schemes: SCIEE, synchronized switch energy extraction (SSEE), and conventional pulse-width modulation (PWM)-based harvesting scheme. When using the same prototyped EM harvester under the same mechanical excitation, SCIEE can harvest 38% more power, compared with the cutting-edge SSEE circuit for EMEH; and 900% more power, compared with the PWM-based harvesting scheme.
- 10 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1004-1009
A Synchronized Multiple Bias-Flip Interface Circuit for Piezoelectric Energy Harvesting Using Optimized Switched-Capacitor Arrays
This paper introduces a new implementation of the synchronized multiple bias-flip (SMBF) interface circuit for piezoelectric energy harvesting systems. The proposed circuit uses an optimized and easy-to-drive capacitor array for multiple voltage bias-flip actions. The switched-capacitor array consists of five capacitors. It is able to carry out 27 continuous voltage bias-flip actions by re-organizing the multiple capacitors and properly reusing them in different phases. The proposed circuit topology extracts more power than the previously proposed harvesting circuit, which again validates the optimal SMBF theorem. It also explores the potential and reveals the limitations of piezoelectric energy harvesting improvement by using multiple bias-flip actions.
- 10 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1004-1009
A Synchronized Multiple Bias-Flip Interface Circuit for Piezoelectric Energy Harvesting Using Optimized Switched-Capacitor Arrays
This paper introduces a new implementation of the synchronized multiple bias-flip (SMBF) interface circuit for piezoelectric energy harvesting systems. The proposed circuit uses an optimized and easy-to-drive capacitor array for multiple voltage bias-flip actions. The switched-capacitor array consists of five capacitors. It is able to carry out 27 continuous voltage bias-flip actions by re-organizing the multiple capacitors and properly reusing them in different phases. The proposed circuit topology extracts more power than the previously proposed harvesting circuit, which again validates the optimal SMBF theorem. It also explores the potential and reveals the limitations of piezoelectric energy harvesting improvement by using multiple bias-flip actions.
- 31 October 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 71 (2) , 962-973
Circuit Solutions Toward Broadband Piezoelectric Energy Harvesting: An Impedance Analysis
The literature on piezoelectric energy harvesting (PEH) systems underscores the role of circuit advancements in enhancing energy harvesting capability in resonance. Recent studies using phase-variable (PV) synchronized switch technologies have also shown potential in broadband PEH, thereby improving off-resonance energy harvesting. However, the electrically induced dynamics by existing interface circuits lack a comprehensive definition and demonstration, hampering the performance comparisons across different circuits. Regarding these gaps, this paper presents an impedance-based analysis and comparison of electromechanical joint dynamics in PEH systems employing various interface circuits. The focus is on their contributions to enhancing harvesting bandwidth. By introducing resonance tunability into the conventional ideal PEH model, this paper proposes a more generic impedance model. It reveals that the achievable dynamic ranges of practical interface circuits are subsets of the ideal arbitrarily tunable scenario. A detailed quantitative study on the attainable ranges of the PV synchronized switch circuit solutions is provided after the introduction of the ideal target. Simulation and experimental data from different interface circuits align well with theoretical findings. The paper concludes that resonance tunability hinges on the extent of the achievable reactive (imaginary) part of the equivalent impedance. Electromechanical coupling conditions and dielectric loss may further impact resonance tunability. The general ideal model and quantitative impedance analysis provided in this paper help guide the future design effort toward high-capability and broadband PEH systems.
- 31 October 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 71 (2) , 962-973
Circuit Solutions Toward Broadband Piezoelectric Energy Harvesting: An Impedance Analysis
The literature on piezoelectric energy harvesting (PEH) systems underscores the role of circuit advancements in enhancing energy harvesting capability in resonance. Recent studies using phase-variable (PV) synchronized switch technologies have also shown potential in broadband PEH, thereby improving off-resonance energy harvesting. However, the electrically induced dynamics by existing interface circuits lack a comprehensive definition and demonstration, hampering the performance comparisons across different circuits. Regarding these gaps, this paper presents an impedance-based analysis and comparison of electromechanical joint dynamics in PEH systems employing various interface circuits. The focus is on their contributions to enhancing harvesting bandwidth. By introducing resonance tunability into the conventional ideal PEH model, this paper proposes a more generic impedance model. It reveals that the achievable dynamic ranges of practical interface circuits are subsets of the ideal arbitrarily tunable scenario. A detailed quantitative study on the attainable ranges of the PV synchronized switch circuit solutions is provided after the introduction of the ideal target. Simulation and experimental data from different interface circuits align well with theoretical findings. The paper concludes that resonance tunability hinges on the extent of the achievable reactive (imaginary) part of the equivalent impedance. Electromechanical coupling conditions and dielectric loss may further impact resonance tunability. The general ideal model and quantitative impedance analysis provided in this paper help guide the future design effort toward high-capability and broadband PEH systems.