Isis Chetzyl Ballardo Rodriguez

Isis Chetzyl Ballardo Rodriguez

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Isis Chetzyl Ballardo Rodriguez has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Influence of Zinc Doping on the Morphological, Structural, and Optical Characteristics of Copper Oxide Thin Films Prepared Through Ultrasound Spray Pyrolysis

    by Isis Chetzyl Ballardo Rodríguez, Brahim El Filali, Aarón Israel Díaz Cano, Rebeca Jiménez Rodríguez, Juan Antonio Jaramillo Gómez

    The study of wide-bandgap nanomaterials has gained considerable attention in recent years, especially in the case of semiconductor oxides that exhibit full or partial optical transparency in fundamental research and technological applications. These include optoelectronic devices, gas sensors and photovoltaic cells, among others. The activation or adjustment of optical and structural properties, especially the bandgap and the parameters of unit cell lattice, can be achieved by varying the dopant concentration during the synthesis of semiconductor thin films in these applications. In this context, copper oxide has emerged as a valuable material, owing to its thoroughly analyzed structural behavior and its broad potential across multiple technological fields. The present work focuses on the synthesis of zinc-doped copper oxide (ZnxCu1−xO) thin films on silicon and quartz substrates through ultrasonic spray pyrolysis. The effects of varying the zinc doping concentration (0.0, 5.0, 10.0 and 20.0 at. %) on the morphological, structural, and optical characteristics of the ZnxCu1−xO films were analyzed. Scanning electron microscopy (SEM) analysis indicated a gradual increase in nanoparticle size, rising from 221 nm for CuO to approximately 322 nm for the Zn0.2Cu0.8O samples as the zinc content increased. Structural characterization via X-ray diffraction (XRD) confirmed a monoclinic crystal arrangement belonging to the C2h6 (c2/c) space group. As the percentage of zinc increased, the XRD peaks shifted to lower angles, consequently increasing the volume and crystal lattice parameters of the ZnxCu1−xO structure; this finding was additionally supported by a redshift observed in the Raman analysis. The transmittance spectra of the films showed low transmittance between 40 and 44%. The optical bandgap of the ZnxCu1−xO thin films was estimated from the transmittance data by applying the Tauc plot method. A decrease in the band gap was observed at higher doping concentrations. It can be confirmed that no secondary phases are observed at a doping level of 20.0 at. % of zinc, indicating good solubility of zinc in CuO. The analysis and discussion of these findings are included throughout this work to elucidate the controversies noted in the literature.

  • Open Access

    The Effect of Doping with Aluminum on the Optical, Structural, and Morphological Properties of Thin Films of SnO2 Semiconductors

    by Isis Chetzyl Ballardo Rodriguez, U. Garduño Terán, A. I. Díaz Cano, B. El Filali, M. Badaoui

    There is considerable interest in broadband nanomaterials, particularly transparent semiconductor oxides, within both fundamental research and technological applications. Historically, it has been considered that the variation in dopant concentration during the synthesis of semiconductor materials is a crucial factor in activating and/or modulating the optical and structural properties, particularly the bandgap and the parameters of the unit cell, of semiconductor oxides. Recently, tin oxide has emerged as a key material due to its excellent structural properties, optical transparency, and various promising applications in optoelectronics. This study utilized the ultrasonic spray pyrolysis technique to synthesize aluminum-doped tin oxide (ATO) thin films on quartz and polished single-crystal silicon substrates. The impact of varying aluminum doping levels (0, 2, 5, and 10 at. %) on morphology and structural and optical properties was examined. The ATO thin films were characterized using scanning electron microscopy (SEM), X-ray diffraction (XRD), and transmittance spectroscopy. SEM images demonstrated a slight reduction in the size of ATO nanoparticles as the aluminum doping concentration increased. XRD analysis revealed a tetragonal crystalline structure with the space group P42/mnm, and a shift in the XRD peaks to higher angles was noted with increasing aluminum content, indicating a decrease in the crystalline lattice parameters of ATO. The transmittance of the ATO films varied between 75% and 85%. By employing the transmittance spectra and the established Tauc formula the optical bandgap values of ATO films were calculated, showing an increase in the bandgap with higher doping levels. These findings were thoroughly analyzed and discussed; additionally, an effort was made to clarify the contradictory analyses present in the literature and to identify a doping range that avoids the onset of a secondary phase.


  • Optical and structural properties of Sn doped ZnO thin films synthesized by spray pyrolysis

    by I. Ch. Ballardo Rodriguez, B. El Filali, T. Torchynska, J. Douda, I. C. Romero Ibarra