Zhibo Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Zhibo Zhang has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Wenyong Ma
Shijiazhuang Tiedao Univ
3 shared publications - Qiang Li
School of Civil Engineering, Shijiazhuang Tiedao University, Shijiazhuang, China
2 shared publications Chundi Si
State Key Laboratory of Mechanical Behavior and System Safety of Traffic Engineering Structures, Shijiazhuang Tiedao University, Shijiazhuang, China
1 shared publicationFeiqiang Li
Shijiazhuang Tiedao Univ
1 shared publicationHao Tang
Key Laboratory of Wind Engineering and Bridge Engineering in Hunan Province, Hunan University, Changsha, China
1 shared publicationQiang Li
Shijiazhuang Tiedao Univ
1 shared publication
Latest Publications
- 1 December 2026
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 152 (12)
Nonuniform Snow Distribution Mechanism and Load Modeling for Photovoltaic Modules in Cold Regions
As photovoltaic (PV) systems expand into high-latitude regions, snow loads have become a critical factor affecting both structural safety and energy efficiency. Existing design codes, which are derived from traditional single-slope roof methods, do not fully account for snow retention caused by module frame obstruction or wind-induced nonuniform snow deposition, potentially leading to underestimated design loads. This study combines field observations and numerical simulations to investigate snow accumulation patterns on PV modules under both calm and windblown conditions. The results show that under calm conditions, the frame-induced snow retention remains significant even at a 50° tilt angle, with nondimensional snow depth reaching approximately 0.6, which is much higher than the value specified in the Chinese load code but consistent with that in the US code for warm roofs with obstructions. Under wind action, panels with low tilt angles experience relatively uniform erosion, whereas panels with medium and high tilt angles develop pronounced nonuniform accumulation characterized by thickening at the lower edge and thinning at the upper edge due to flow separation and vortex formation. For large-span module arrays, quasi-two-dimensional flow enhances this nonuniformity, aligning with observed localized structural failures in practice. Wind speed governs redistribution behavior, with moderate speeds producing the most severe nonuniform accumulation and strong winds removing snow entirely. Based on these results, recommended nonuniform snow distribution coefficients of 1.3 and 0.7 are proposed to support PV system design and inform future revisions of snow load standards in cold-region environments.
- 1 December 2026
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 152 (12)
Nonuniform Snow Distribution Mechanism and Load Modeling for Photovoltaic Modules in Cold Regions
As photovoltaic (PV) systems expand into high-latitude regions, snow loads have become a critical factor affecting both structural safety and energy efficiency. Existing design codes, which are derived from traditional single-slope roof methods, do not fully account for snow retention caused by module frame obstruction or wind-induced nonuniform snow deposition, potentially leading to underestimated design loads. This study combines field observations and numerical simulations to investigate snow accumulation patterns on PV modules under both calm and windblown conditions. The results show that under calm conditions, the frame-induced snow retention remains significant even at a 50° tilt angle, with nondimensional snow depth reaching approximately 0.6, which is much higher than the value specified in the Chinese load code but consistent with that in the US code for warm roofs with obstructions. Under wind action, panels with low tilt angles experience relatively uniform erosion, whereas panels with medium and high tilt angles develop pronounced nonuniform accumulation characterized by thickening at the lower edge and thinning at the upper edge due to flow separation and vortex formation. For large-span module arrays, quasi-two-dimensional flow enhances this nonuniformity, aligning with observed localized structural failures in practice. Wind speed governs redistribution behavior, with moderate speeds producing the most severe nonuniform accumulation and strong winds removing snow entirely. Based on these results, recommended nonuniform snow distribution coefficients of 1.3 and 0.7 are proposed to support PV system design and inform future revisions of snow load standards in cold-region environments.
- 24 December 2024
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2679 (4) , 939-951
Field Measurements and Predictions of Snow Distribution around Horizontal-Slat Snow Fences
The present study investigates snow growth and equilibrium drift for horizontal slatted snow fences with varying porosities in the field measurements in Xinjiang, China. A mathematical model is proposed to describe the profile of the equilibrium drift. Equations are derived to model the drift length and snow storage capacity for snow fences with different porosities. The results reveal that the snow accumulation around horizontal-slat snow fences can be categorized into five stages. The final snow shapes strongly depended on X/H (distance versus the height of the fence). The snow drift length and amount of snow accumulation on the leeward side can be described by functions of porosity, P. It is noteworthy that the snow storage capacity of the high-porosity fence significantly surpasses that of the low-porosity snow fences. For regions with moderate snowfall, the horizontal-slat snow fence with a porosity of 50% is recommended, whereas regions with heavy snowfall would benefit from a 60%-porosity fence.
- 24 December 2024
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2679 (4) , 939-951
Field Measurements and Predictions of Snow Distribution around Horizontal-Slat Snow Fences
The present study investigates snow growth and equilibrium drift for horizontal slatted snow fences with varying porosities in the field measurements in Xinjiang, China. A mathematical model is proposed to describe the profile of the equilibrium drift. Equations are derived to model the drift length and snow storage capacity for snow fences with different porosities. The results reveal that the snow accumulation around horizontal-slat snow fences can be categorized into five stages. The final snow shapes strongly depended on X/H (distance versus the height of the fence). The snow drift length and amount of snow accumulation on the leeward side can be described by functions of porosity, P. It is noteworthy that the snow storage capacity of the high-porosity fence significantly surpasses that of the low-porosity snow fences. For regions with moderate snowfall, the horizontal-slat snow fence with a porosity of 50% is recommended, whereas regions with heavy snowfall would benefit from a 60%-porosity fence.
- Open Access
- 7 December 2023
- Published by Springer Nature in Scientific Reports
- Vol. 13 (1) , 1-18
Study on wind load characteristics of stadium under tornado
The stadium is a wind-sensitive structure, and the tornado has a greater damage to the stadium. The Ward tornado generating device was used to simulate the wind load characteristics of the stadium during tornado action in order to investigate the wind load characteristics of the stadium. The results of this paper are compared with the experimental results to verify the accuracy of the simulation method. The wind load characteristics of the stadium and its most vulnerable location during a tornado are ascertained by examining the wind pressure coefficient and wind speed distribution law of the stadium’s upper and lower surfaces with different swirl ratio. The influence of uniform wind and wind profile on the wind load of the stadium is explored by comparing and analyzing the wind pressure coefficient of the stadium surface with and without wind profile at the entrance of the wind field. The impact of varying ground roughness on the stadium is compared in order to ascertain how it affects the wind speed, stadium wind pressure, and vortex core radius. The vorticity of the stadium in the tornado wind field with different swirl ratios was compared and analyzed, and the influence of the stadium on the vorticity development of the wind field was explored. This study reveals the effects of swirl ratio, ground roughness and wind profile on the wind pressure, wind speed and vorticity of the stadium under tornadoes, and determines the most vulnerable location and the most unfavorable factors. The above research is helpful to provide reference for disaster prevention and mitigation of stadium structure design.
- 7 December 2023
- Published by Springer Nature in Scientific Reports
- Vol. 13 (1) , 1-18
Open AccessStudy on wind load characteristics of stadium under tornado
The stadium is a wind-sensitive structure, and the tornado has a greater damage to the stadium. The Ward tornado generating device was used to simulate the wind load characteristics of the stadium during tornado action in order to investigate the wind load characteristics of the stadium. The results of this paper are compared with the experimental results to verify the accuracy of the simulation method. The wind load characteristics of the stadium and its most vulnerable location during a tornado are ascertained by examining the wind pressure coefficient and wind speed distribution law of the stadium’s upper and lower surfaces with different swirl ratio. The influence of uniform wind and wind profile on the wind load of the stadium is explored by comparing and analyzing the wind pressure coefficient of the stadium surface with and without wind profile at the entrance of the wind field. The impact of varying ground roughness on the stadium is compared in order to ascertain how it affects the wind speed, stadium wind pressure, and vortex core radius. The vorticity of the stadium in the tornado wind field with different swirl ratios was compared and analyzed, and the influence of the stadium on the vorticity development of the wind field was explored. This study reveals the effects of swirl ratio, ground roughness and wind profile on the wind pressure, wind speed and vorticity of the stadium under tornadoes, and determines the most vulnerable location and the most unfavorable factors. The above research is helpful to provide reference for disaster prevention and mitigation of stadium structure design.
- Open Access
- 7 November 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (22) , 12109
Snow Load Shape Coefficients and Snow Prevention Method for Stepped Flat Roofs
Excessive snow load and nonuniform snow deposition are the main factors leading to building collapses. The snow load shape coefficient represents the dimensionless snow load, and its value is related to the unbalanced distribution of snow. The snow load shape coefficients for stepped flat roofs vary greatly in the codes of different regions, which always leads to underestimation of snow loads. We need a widely used standard for snow load shape coefficients. Therefore, through a combination of field measurements and numerical simulations, this study probes the snow accumulation processes and snow load shape coefficients on stepped flat roofs and proposes an equation to calculate snow load shape coefficients and the optimal slope of snow protection for lower roofs. It is found that the maximum snow load shape coefficient emerges at the roof junction with a value of 3.44. The nonuniform length of the snow accumulation is equal to two times the level difference. Based on these, the equation of the snow load shape coefficients is summarized, which is combined with the discrepancies between different codes and the regularity of snow distributions. In this study, the dynamic grid technology under the Eulerian framework is used to successfully predict snow accumulation on stepped flat roofs, and it is noted that snow erosion and deposition are closely related to the location and size of vortexes. Finally, we consider that the ideal slope for the lower roof to prevent snow should be 11°.
- 7 November 2023
- Published by MDPI AG in Applied Sciences
- Vol. 13 (22) , 12109
Open AccessSnow Load Shape Coefficients and Snow Prevention Method for Stepped Flat Roofs
Excessive snow load and nonuniform snow deposition are the main factors leading to building collapses. The snow load shape coefficient represents the dimensionless snow load, and its value is related to the unbalanced distribution of snow. The snow load shape coefficients for stepped flat roofs vary greatly in the codes of different regions, which always leads to underestimation of snow loads. We need a widely used standard for snow load shape coefficients. Therefore, through a combination of field measurements and numerical simulations, this study probes the snow accumulation processes and snow load shape coefficients on stepped flat roofs and proposes an equation to calculate snow load shape coefficients and the optimal slope of snow protection for lower roofs. It is found that the maximum snow load shape coefficient emerges at the roof junction with a value of 3.44. The nonuniform length of the snow accumulation is equal to two times the level difference. Based on these, the equation of the snow load shape coefficients is summarized, which is combined with the discrepancies between different codes and the regularity of snow distributions. In this study, the dynamic grid technology under the Eulerian framework is used to successfully predict snow accumulation on stepped flat roofs, and it is noted that snow erosion and deposition are closely related to the location and size of vortexes. Finally, we consider that the ideal slope for the lower roof to prevent snow should be 11°.