Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Pengzheng Guo has a total of 8 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Full Life Cycle Evaluation of Stability Pile in High Slope with Multi-Layer Weak Interlayers

    by Guie Shi, Jiaming Zhang, Mingzhi Lu, Fei Liu, Pengzheng Guo, Chenxi Wang

    High slopes with multi-layer weak interlayers are a type of special slope that tends to fail due to the unfavorable mechanical properties of interlayers. In this study, the influence of the position, length, diameter, and ratio of on-center spacing to the pile diameter on the stability of such slopes is investigated using the three-dimensional strength reduction elastoplastic finite element method. Based on a high slope with multi-layer weak interlayers, two models were created, and three states (an initial state, a state with a safety factor of 1.35, and a limit equilibrium state) were considered. The pile can improve slope stability when the it is located at the lower to lower-middle part of a high slope. The resistance effect no longer has a strengthening property if it exceeds a critical pile length (28 m and 30 m in the two models); 30 m was found to be the optimal pile length for the high slope. As the diameter increased, the safety factor increased from 1.38 (1.37) to 1.41 (1.40) in Model 1 (or in Model 2), while the maximum compressive stress, the maximum shear stress of the pile, and the maximum displacement of the pile head decreased in the two models from 20.84 (81.24) MPa to 16.15 (18.8) MPa, 11.19 (42.02) MPa to 7.77 (10.43) MPa, and 714.1 (4585.00) mm to 396.3 (1272.00) mm, respectively. The pile diameter should be >1.4 m in such cases. When stress and displacement increased, the arching effect and the pile group effect weakened, and the safety factor decreased as the ratio of on-center spacing to diameter increased. The ratio should be <3 to ensure slope ability.

  • Open Access

    Experimental Study on Shear Creep and Long-Term Strength of Clay-Type Muddy Interlayer

    by Pengzheng Guo, Jiaming Zhang, Fei Liu, Wenlian Liu, Zhiqiang Wang, Jipu Chen

    In order to have a better understanding of the shear creep characteristics of muddy interlayer in unstable landslides, we took the more “inferior” clay muddy interlayer as the research object, and shear creep experiments under different normal stress levels were carried out by means of hierarchical loading. This paper focuses on the variation law of creep curve and its long-term strength in the clay-type muddy interlayer under different normal stresses. The results showed that the creep characteristics of clay-type muddy interlayer were obvious: at the same normal stress level, instantaneous deformation, initial creep and stable creep appeared at lower shear stress level; at the level of rupture shear stress, there were two cases: the creep curve included three stages of typical initial creep, stable creep and accelerated creep failure, or directly entered the accelerated creep stage until the specimen’s failure. The average shear and stable creep rate of the muddy interlayer specimen increased exponentially with the increase in shear stress. The empirical formula u = u0 + A [1 − e(−Bt)] + Ctn of shear strength could better reflect the creep deformation law of muddy interlayer, and the correlation coefficient R2 varies from 0.90 to 0.99. Based on the definition of long-term ultimate strength, the long-term strength of clay-type muddy interlayer was determined.