Isao Sakaguchi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Isao Sakaguchi has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
- Naoki Ohashi
National Institute for Materials Science (NIMS), 1-1 Namiki, Tsukuba, Ibaraki 305-0044, Japan
7 shared publications Hajime Haneda
National Institute for Materials Science (NIMS) , 1-1 Namiki, Tsukuba, Ibaraki 305-0044, Japan
5 shared publications- Shunichi Hishita
National Institute for Materials Science, Tsukuba 305-0044, Japan
3 shared publications - Yutaka Adachi
National Institute for Materials Science (NIMS), Tsukuba, Ibaraki 305-0044, Japan
3 shared publications - Kian Ping Loh
Department of Chemistry, National University of Singapore, Singapore, Singapore
2 shared publications - Mikka Nishitani-Gamo
Research Institute of Industrial Technology, Toyo University, Saitama, Japan
2 shared publications
Latest Publications
- Open Access
- 20 June 2024
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 7 (13) , 5321-5325
Surface Treatment of Garnet-Type Solid Electrolyte for Suppressing Dendritic Growth
- 20 June 2024
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 7 (13) , 5321-5325
Open AccessSurface Treatment of Garnet-Type Solid Electrolyte for Suppressing Dendritic Growth
- Open Access
- 1 January 2024
- Published by Geochemical Society of Japan in GEOCHEMICAL JOURNAL
- Vol. 58 (1) , 1-8
Hydrogen diffusion in apatite parallel to the c-axis under vapor flow
Apatite is ubiquitous in various planetary bodies in the Solar System. Because its structure contains a hydroxy group, researchers have performed extensive investigations to determine the hydrogen isotopic composition of apatite to reveal the origins and evolution of water in planetary bodies. The hydrogen isotopic composition in apatite can change owing to diffusion. Although there have been several diffusion studies related to hydrogen in apatite, they vary in experimental conditions, such as the diffusion source and pressure, making it difficult to estimate the change in hydrogen isotopic composition. Herein, we report hydrogen diffusion experiments under a 2H2O/O2 vapor flow at 550 °C–700 °C using apatite slices with better surface conditions by adapting new polishing methods. 2H concentration depth profiles were obtained via secondary ion mass spectrometry, and the diffusion coefficients were obtained by fitting the profiles using Fick’s second law. The temperature dependence of the diffusion coefficients at 550 °C–700 °C is represented as the following expression: This indicates a reduction in the influence of fast diffusion paths, reported by Higashi et al. (2017). These diffusion coefficients would be the hydrogen self-diffusion coefficients in apatite by lattice diffusion and should be employed instead. In addition, the activation energy of diffusion was consistent with oxygen diffusion under wet conditions, thus suggesting that hydrogen diffuses via a mechanism similar to that of oxygen in apatite.
- 1 January 2024
- Published by Geochemical Society of Japan in GEOCHEMICAL JOURNAL
- Vol. 58 (1) , 1-8
Open AccessHydrogen diffusion in apatite parallel to the c-axis under vapor flow
Apatite is ubiquitous in various planetary bodies in the Solar System. Because its structure contains a hydroxy group, researchers have performed extensive investigations to determine the hydrogen isotopic composition of apatite to reveal the origins and evolution of water in planetary bodies. The hydrogen isotopic composition in apatite can change owing to diffusion. Although there have been several diffusion studies related to hydrogen in apatite, they vary in experimental conditions, such as the diffusion source and pressure, making it difficult to estimate the change in hydrogen isotopic composition. Herein, we report hydrogen diffusion experiments under a 2H2O/O2 vapor flow at 550 °C–700 °C using apatite slices with better surface conditions by adapting new polishing methods. 2H concentration depth profiles were obtained via secondary ion mass spectrometry, and the diffusion coefficients were obtained by fitting the profiles using Fick’s second law. The temperature dependence of the diffusion coefficients at 550 °C–700 °C is represented as the following expression: This indicates a reduction in the influence of fast diffusion paths, reported by Higashi et al. (2017). These diffusion coefficients would be the hydrogen self-diffusion coefficients in apatite by lattice diffusion and should be employed instead. In addition, the activation energy of diffusion was consistent with oxygen diffusion under wet conditions, thus suggesting that hydrogen diffuses via a mechanism similar to that of oxygen in apatite.
- Open Access
- 6 November 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (19)
Full polarization reversal at room temperature in unsubstituted AlN
Room temperature ferroelectricity in unsubstituted AlN films is studied to examine the role of cation substitution into wurtzite materials. AlN and (Al0.7Sc0.3)N films deposited on (111) 0.5 wt. % Nb-doped SrTiO3 have a (0001)-orientation with different in-plane lattice alignments with respect to those of the substrate, depending on the composition and the deposition temperature. The AlN films deposited at 450 °C showed complete ferroelectric switching above 140 °C but local polarization switching at room temperature because a dielectric breakdown occurred before complete switching, while full polarization reversal was observed at all measurement temperatures for (Al0.7Sc0.3)N. Low-temperature deposition, such as at 250 °C, significantly enhanced the dielectric breakdown field and also increased leakage current. As a result, sufficient polarization switching at room temperature was observed in the AlN film deposited at 250 °C. Positive-up/negative-down pulse measurements showed remanent polarization of 150 μC/cm2 and a coercive field of 8.3 MV/cm, in agreement with the theoretical value and temperature dependence observed for the AlN film deposited at 450 °C. The observed coercive field value lies on the line composed of the previously reported data in Sc concentration dependence. This tendency implies that the reduction in the coercive field is primarily attributable to the alteration of crystal lattice anisotropy caused by Sc.
- 6 November 2023
- Published by AIP Publishing in Applied Physics Letters
- Vol. 123 (19)
Open AccessFull polarization reversal at room temperature in unsubstituted AlN
Room temperature ferroelectricity in unsubstituted AlN films is studied to examine the role of cation substitution into wurtzite materials. AlN and (Al0.7Sc0.3)N films deposited on (111) 0.5 wt. % Nb-doped SrTiO3 have a (0001)-orientation with different in-plane lattice alignments with respect to those of the substrate, depending on the composition and the deposition temperature. The AlN films deposited at 450 °C showed complete ferroelectric switching above 140 °C but local polarization switching at room temperature because a dielectric breakdown occurred before complete switching, while full polarization reversal was observed at all measurement temperatures for (Al0.7Sc0.3)N. Low-temperature deposition, such as at 250 °C, significantly enhanced the dielectric breakdown field and also increased leakage current. As a result, sufficient polarization switching at room temperature was observed in the AlN film deposited at 250 °C. Positive-up/negative-down pulse measurements showed remanent polarization of 150 μC/cm2 and a coercive field of 8.3 MV/cm, in agreement with the theoretical value and temperature dependence observed for the AlN film deposited at 450 °C. The observed coercive field value lies on the line composed of the previously reported data in Sc concentration dependence. This tendency implies that the reduction in the coercive field is primarily attributable to the alteration of crystal lattice anisotropy caused by Sc.
- Open Access
- 1 January 2013
- Published by Ceramic Society of Japan in Journal of the Ceramic Society of Japan
- Vol. 121 (1420) , 1004-1007
Ion implantation and diffusion of zinc in dense SnO2 ceramics
- 1 January 2013
- Published by Ceramic Society of Japan in Journal of the Ceramic Society of Japan
- Vol. 121 (1420) , 1004-1007
Open AccessIon implantation and diffusion of zinc in dense SnO2 ceramics
- 1 July 2011
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 485, 215-218
Planarization of Zinc Oxide Surface and Evaluation of Processing Damage
The processes for polishing a ZnO surface were investigated with the aim of establishing a process for obtaining an atomically flat surface with high crystalline quality. The defects in a layer undergoing mechanical polishing were monitored through photoluminescence measurements, and the purity of the polished surface was characterized by SIMS. An atomicallyfishing process.
- 1 July 2011
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 485, 215-218
Planarization of Zinc Oxide Surface and Evaluation of Processing Damage
The processes for polishing a ZnO surface were investigated with the aim of establishing a process for obtaining an atomically flat surface with high crystalline quality. The defects in a layer undergoing mechanical polishing were monitored through photoluminescence measurements, and the purity of the polished surface was characterized by SIMS. An atomicallyfishing process.
- 9 June 2008
- Published by AIP Publishing in Applied Physics Letters
- Vol. 92 (23) , 232108
Hard x-ray photoemission spectroscopy in wurtzite-type zinc magnesium oxide solid-solution films grown by pulsed-laser deposition
The electronic structure of Zn1−xMgxO alloy thin films was determined by hard x-ray photoemission spectroscopy (HX-PES) and optical transmittance measurements. HX-PES measurements revealed that the binding energies of valence band, Zn 2p, and O 1s levels increased with increasing MgO fraction. The energy shift correlated with a widening of the band gap and change in ionicity of chemical bonds by alloying. The Fermi level in the alloy compounds was found to be close to the bottom of conduction band regardless of the MgO fraction.
- 9 June 2008
- Published by AIP Publishing in Applied Physics Letters
- Vol. 92 (23) , 232108
Hard x-ray photoemission spectroscopy in wurtzite-type zinc magnesium oxide solid-solution films grown by pulsed-laser deposition
The electronic structure of Zn1−xMgxO alloy thin films was determined by hard x-ray photoemission spectroscopy (HX-PES) and optical transmittance measurements. HX-PES measurements revealed that the binding energies of valence band, Zn 2p, and O 1s levels increased with increasing MgO fraction. The energy shift correlated with a widening of the band gap and change in ionicity of chemical bonds by alloying. The Fermi level in the alloy compounds was found to be close to the bottom of conduction band regardless of the MgO fraction.
- 1 July 2007
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 46 (7R) , 4099
Diffusion Model of Gallium in Single-Crystal ZnO Proposed from Analysis of Concentration-Dependent Profiles Based on the Fermi-Level Effect
- 1 July 2007
- Published by IOP Publishing in Japanese Journal of Applied Physics
- Vol. 46 (7R) , 4099
Diffusion Model of Gallium in Single-Crystal ZnO Proposed from Analysis of Concentration-Dependent Profiles Based on the Fermi-Level Effect
- 1 May 2000
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 181-182, 101-104
Microstructure of Zinc Oxide Grown by rf Magnetron Sputtering: Aspect of Oxygen Vacancy
- 1 May 2000
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 181-182, 101-104
Microstructure of Zinc Oxide Grown by rf Magnetron Sputtering: Aspect of Oxygen Vacancy
- 15 April 1999
- Published by American Physical Society (APS) in Physical Review B
- Vol. 59 (15) , 10347-10350
Surface structure ofstudied by a quantitative LEED analysisThe structure of the hydrogen terminated, reconstructed diamond (100) surface has been investigated by low-energy electron-diffraction (LEED) intensity versus energy measurements in combination with tensor LEED calculations. It has been found that the surface corresponds to the formation of symmetric dimers on the top C layer, with a dimer length of 1.60 Å. The top layer shows slight inward relaxation; the interlayer spacing between the first and second C layers reduces to 0.81 Å, which corresponds to an ∼7% contraction compared to the bulk value. The structural details of the first four carbon layers have been determined and are compared to those given by theoretical calculations.- 15 April 1999
- Published by American Physical Society (APS) in Physical Review B
- Vol. 59 (15) , 10347-10350
Surface structure ofstudied by a quantitative LEED analysisThe structure of the hydrogen terminated, reconstructed diamond (100) surface has been investigated by low-energy electron-diffraction (LEED) intensity versus energy measurements in combination with tensor LEED calculations. It has been found that the surface corresponds to the formation of symmetric dimers on the top C layer, with a dimer length of 1.60 Å. The top layer shows slight inward relaxation; the interlayer spacing between the first and second C layers reduces to 0.81 Å, which corresponds to an ∼7% contraction compared to the bulk value. The structural details of the first four carbon layers have been determined and are compared to those given by theoretical calculations.