JCJiahao Chen

Jiahao Chen

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Jiahao Chen has a total of 48 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Demonstration of 500 °C RF performance in AlGaN/GaN MISHEMTs with Pt/Au gates

    by Ruixin Bai, Biddut K Sarker, Leonard A Duncan, Swarnav Mukhopadhyay, Jiahao Chen, Chenglong Li, Shubhra S Pasayat, Andrew J Green, Ahmad E Islam, Chirag Gupta

    In this letter, we demonstrate radio frequency (RF) performance of AlGaN/GaN MISHEMTs with Pt/Au gate up to 500 °C, which is the first report of RF operation at 500 °C using a refractory gate metal. The device achieves 1.08 A mm −1 , f t of 42.9 GHz, and f max of 82.4 GHz at room temperature, and retains 0.6 A mm −1 , f t of 21 GHz, and f max of 33.5 GHz at 500 °C. The gate bias for peak f t remains nearly unchanged with temperature, indicating stable RF threshold behavior. These results demonstrate robust high-temperature operation enabled by Pt gate and highlight their potential for extreme-environment RF applications.

  • Passivation-Free Ga-Polar AlGaN/GaN Recessed-Gate HEMTs on Sapphire With 2.8W/mm P OUT and 26.8% PAE at 94 GHz

    by Ruixin Bai, Swarnav Mukhopadhyay, Michael Elliott, Ryan Gilbert, Jiahao Chen, Rafael A. Choudhury, Kyudong Kim, Yu-Chun Wang, Ahmad E. Islam, Andrew J. Green, et al.

    In this work, we demonstrate a passivation-free Ga-polar recessed-gate AlGaN/GaN HEMT on a sapphire substrate for W-band operation, featuring a 5.5-nm Al0.35Ga0.65N barrier under the gate and a 31nm Al0.35Ga0.65N barrier in the gate access regions. The device achieves a drain current density of 1.7A/mm, a peak transconductance of 750mS/mm, and low gate leakage with a high on/off ratio of $10^{7}$ . Small-signal characterization reveals a current-gain cutoff frequency of 127GHz and a maximum oscillation frequency of 203GHz. Continuous-wave (CW) load-pull measurements at 94GHz demonstrate an output power density of 2.8W/mm with 26.8% power-added efficiency (PAE), both of which are approximately twice the values previously reported for Ga-polar GaN HEMTs fabricated on sapphire substrates and are comparable to state-of-the-art Ga-polar GaN HEMTs on SiC substrates. Considering the low cost of sapphire, the simplicity of the epitaxial design, and the reduced fabrication complexity relative to N-polar devices, this work highlights the potential of recessed-gate Ga-polar AlGaN/GaN HEMTs on sapphire as a promising candidate for next-generation millimeter-wave power applications.


  • K-Band (20 GHz) Large-Signal Performance in Al 0.65 Ga 0.35 N Channel HEMTs With 2.3-W/mm Output Power and 22.8% Associated PAE

    by Ruixin Bai, Swarnav Mukhopadhyay, Caleb Desmier, Khush Gohel, Surjava Sanyal, Jiahao Chen, Dashiel Matlock, Edward Gebara, Nicholas C. Miller, Shubhra S. Pasayat, et al.

    In this work, we demonstrate the power performance of high composition Al ${}_{{0}.{65}}$ Ga ${}_{{0}.{35}}$ N channel high-electron-mobility transistors (HEMTs) operating at 20 GHz (with pulsed passive load-pull), achieving a power-added efficiency (PAE) of 22.86% and output power density (P ${}_{\text {OUT}}\text {)}$ of 2.3 W/mm. These results surpass previously reported ultra-wide bandgap (UWBG) transistors at 20 GHz by nearly 10 times in terms of both POUT and PAE and still represent the highest PAE among even lower-frequency (>8 GHz) UWBG devices. The outstanding performance is attributed to an Al ${}_{{0}.{65}}$ Ga ${}_{{0}.{35}}$ N channel that enables a high breakdown field, and effective dispersion control achieved via a conformal TiN Schottky T-gate deposited by atomic layer deposition (ALD). This work sets a new benchmark for UWBG RF transistors and highlights the potential of AlxGa ${}_{{1}-\text {x}}$ N (x>0.6) channel HEMTs for high-power RF amplifiers.


  • Open Access

    Temperature dependent high frequency performance of a 62% AlGaN channel HEMT

    by Jiahao Chen, Abdullah Al Mamun Mazumder, Parthasarathy Seshadri, Dheekshinn Nandakumar, Ruixin Bai, Rafael Andrew Choudhury, Asif Khan, Chirag Gupta

    This article reports on the temperature dependent performance of a HEMT with an Al0.62Ga0.38N channel layer and an Al0.84Ga0.16N barrier layer grown by metal–organic chemical vapor deposition. The device in this report was measured at room temperature and elevated temperatures of 100–150 °C. The sheet resistance increased from 3.5 kΩ/sq (25 °C) to 5.4 kΩ/sq (150 °C), while the contact resistance remained nominally similar. For a device with 160 nm gate length and 2 μm source-to-drain length, excellent electrical characteristics have been achieved when the device was operated at 150 °C with a fT of 17 GHz and a fmax of 25.6 GHz. The reported device also exhibited outstanding gate leakage control, where 60% Al composition AlGaN channel HEMT, which suggests the great potential of AlGaN channel devices for high frequency, high power, high temperature applications.


  • Demonstration of High Output Power (3.75 W/mm) With 31.8% PAE in Ga-Polar AlGaN/GaN HEMTs on Sapphire at 94 GHz

    by Ruixin Bai, Swarnav Mukhopadhyay, Michael Elliott, Ryan Gilbert, Surjava Sanyal, Darryl Shima, Jiahao Chen, Rafael A. Choudhury, Kyudong Kim, Yu-Chun Wang, et al.

  • Open Access

    Improved dispersion control and gate stability in scaled RF GaN HEMTs using ALD TiN gate

    by Ruixin Bai, Parthasarathy Seshadri, Jiahao Chen, Swarnav Mukhopadhyay, Chenglong Li, Shubhra S. Pasayat, Chirag Gupta

    In this work, atomic layer deposition (ALD) TiN is investigated as the Schottky T-gate electrode for scaled Ga-polar AlGaN/GaN high-electron-mobility transistors (HEMTs), and its performance is compared with Ni/Au-gate devices fabricated under identical process conditions to elucidate the benefits of TiN gates for electrical, thermal, and reliability performance in RF applications. The TiN-gate devices achieve an on-state drain current density of 1.25 A/mm and a peak transconductance of 0.28 S/mm at Vgs = −4 V. Pulsed IV measurements at Vgsq = −6 V and Vdsq = 20 V show only 4.3% current collapse, markedly lower than the 22.6% observed for Ni/Au-gate devices, indicating superior large-signal stability. A breakdown voltage of ∼50 V (∼1 MV/cm) is achieved under pinch-off, with post-measurement recovery confirming a soft-breakdown mechanism without permanent degradation. With a 120 nm gate length, an ft/fmax of 66/87 GHz is achieved at room temperature and 37/60 GHz at 150 °C. Small-signal analysis reveals that high-temperature degradation is dominated by phonon-limited carrier transport, while TiN gate capacitances remain stable. Under prolonged stress (Vds = 18 V, Vgs = −4 V, 1800 s), TiN devices show only ∼1.8% drain current variation, significantly lower than Ni/Au-gate counterparts. Statistical analysis of ten devices confirms reproducibility with an average variation of 2.5% (σ = 1.4%). These results demonstrate the promise of ALD TiN Schottky gates for reliable scaled RF GaN HEMTs.


  • Thermal Degradation Characteristics of GaN RF HEMT With Ni/Au T-Gate (L G ~ 150 nm)

    by Parthasarathy Seshadri, Ruixin Bai, Swarnav Mukhopadhyay, Jiahao Chen, Shubhra Pasayat, Chirag Gupta

    This letter investigates the high-temperature small signal performance, dispersion, and intrinsic electron velocity in short-channel GaN HEMT, featuring a Schottky Ni/Au gate with a 150-nm gate length. Small-signal two-port S-parameter measurements revealed a peak $f_{t}$ of 56 GHz at $25~^{\circ }$ C, decreasing by 27% at $150~^{\circ }$ C due to thermal effects. This degradation was accompanied by a significant increase in dispersion, rising from 8% to 29% across the same temperature range, driven by trap-assisted processes and thermal degradation. Furthermore, intrinsic electron velocity declined from $1.14\times 10^{7}$ cm/s to $5.9\times 10^{6}$ cm/s, which is attributed to phonon scattering, further limiting device performance at elevated temperatures. These findings provide critical insights into designing and optimizing GaN HEMTs with Schottky gates for reliable high-frequency performance in extreme thermal environments.


  • Top Cited Papers

    64% AlGaN Channel HFET With High Johnson’s Figure of Merit (>6 THz·V)

    by Jiahao Chen, Parthasarathy Seshadri, Kenneth Stephenson, Abdullah Mamun, Ruixin Bai, Zehuan Wang, Asif Khan, Chirag Gupta

    In this letter, we report a heterostructure field effect transistor (HFET) with Al0.87Ga0.13N barrier and Al0.64Ga0.36N channel grown by metalorganic chemical vapor deposition (MOCVD). TLM measurements of the structure showed a sheet resistance of $\sim ~2000~\Omega $ /sq and linear ohmic contact resistance of $4.54~\Omega \cdot $ mm. A HFET with a gate length of $\sim ~200$ nm, source-drain spacing of $4~\mu $ m showed a peak transconductance of ~40 mS/mm and a high peak drain current of ~0.6 A/mm. A current gain cutoff frequency (f $_{\text {T}}\text {)}$ of 15.7 GHz and a power gain cutoff frequency of 20.4 GHz was observed. The breakdown voltage of this device is 390 V, yielding a high Johnson’s figure of merit (JFOM) of 6.1 THz $\cdot $ V. This JFOM value is one of the highest reported JFOM values for AlxGa $_{\text {1-{x}}}$ N channel HFET (x >0.4) and also for other ultra-wide bandgap (UWBG) transistors.


  • High-Frequency (f T > 30 GHz) High Breakdown (>300 V) Al0.62Ga0.38N Channel HEMT

    by Jiahao Chen, Parthasarathy Seshadri, Abdullah Al Mamun Mazumder, Ruixin Bai, Rohan Rao, Asif Khan, Chirag Gupta

    The integration of touchscreen technology in military aviation is a significant step towards modernizing cockpit interfaces, enhancing pilot efficiency, and reducing cognitive workload. This study verifies the suitability of the designed layout for evaluating reaction time and touch accuracy in static and dynamic environments. While effective, traditional HandsOn Throttle-And-Stick (HOTAS) controls have limitations in accommodating the increasing complexity of modern avionics. Touchscreens offer flexibility, ergonomic advantages, and a dynamic interface adaptable to missionspecific requirements. The experimental setup involves a Gyroscope simulator that replicates angular accelerations experienced in flight. Ten participants (8 males and 2 females) performed touch-based tasks using a Lenovo tablet, both in static and dynamic conditions. Reaction time and accuracy were measured using a custombuilt Android application. Results showed that angular motion significantly affected both reaction time and touch accuracy, decreasing in precision from 98% (static) to 91.5% (dynamic). Statistical analyses confirmed the significance of these differences. While touchscreens provide benefits such as reduced cockpit clutter and improved customization, challenges remain, including lack of tactile feedback. Future research should explore haptic feedback, eye-tracking, and gesture-based controls to enhance touchscreen usability in high-stress aviation environments. This study demonstrates the viability of touch interfaces in military aviation and provides a framework for evaluating future technological advancements.


  • 376 nm High-Power UV-A Laser Diodes With GaN Waveguide

    by Qinchen Lin, Cheng Liu, Guangying Wang, Surjava Sanyal, Matthew Dwyer, Matthew Seitz, Jiahao Chen, Yuting Li, Tom Earles, Nelson Tansu, et al.

    Early studies suggest that absorption coefficient of GaN exceeds 100 cm−1 at wavelengths below 380 nm, indicating GaN might not be suitable as a waveguide (WG) material for laser diodes (LDs) in this range. However, in those studies, material defects (rather than GaN band edge absorption) could contribute significantly to the measured absorption loss. In this work, III-Nitride LDs emitting at 376 nm using unintentionally doped GaN WG was demonstrated for high-power operation. Devices with a cavity length of $750 \; \mu $ m and a ridge width of $10 \; \mu $ m exhibited a threshold current of 625 mA and a slope efficiency of 1.13 W/A under pulsed conditions. The highest output power of 3.4 W was obtained at an injection current of 3.5 A. These promising results suggest that GaN band edge absorption may not be as significant at 376 nm or even shorter wavelengths, allowing more flexibility in epitaxial design.