Krzysztof Dyś
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Krzysztof Dyś has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Daniel Grzegorz Soliński
Regional Specialist Hospital in Wroclaw, Research and Development Center, 51-124 Wroclaw, Poland
1 shared publication - Maciej Wiewióra
Department of General Surgery, Vascular Surgery, Angiology and Phlebology, Faculty of Medical Sciences in Katowice, Medical University of Silesia, 40-635 Katowice, Poland
1 shared publication - Marcin Celer
Regional Specialist Hospital in Wroclaw, Research and Development Center, Wroclaw, Poland
1 shared publication - Wojciech Witkiewicz
Research and Development Centre, Voivodeship Specialist Hospital in Wrocław, 51-124 Wrocław, Poland
1 shared publication
Latest Publications
- Open Access
- 10 November 2023
- Published by Wolters Kluwer Health in Medicine
- Vol. 102 (45) , e35844
3D printing in the endovascular treatment of visceral artery aneurysms
Visceral artery aneurysms (VAAs) are vascular pathologies that are difficult to treat. The variable geometry of the vessels and the location of aneurysms render difficult their evaluation in radiological imaging studies. Less invasive endovascular procedures are increasingly used in common practice. Our aim was to test the feasibility of using 3D printing technology in the preparation of preoperative spatial models of visceral artery aneurysms and their impact on interventional treatment. In our observational study, we examined a group of patients with true aneurysms of the visceral arteries who were followed and who underwent endovascular procedures with the use of 3D prints for better imaging of vascular lesions. We analyzed the fused filament fabrication method of 3D printing and printable materials in the preparation of spatial vascular models. We confirmed that more accurate visualization and analysis of vascular anatomy could assist operators in attempting minimally invasive treatment with good results. Extending imaging studies using 3D printing models that allow for the assessment of the position, morphology and geometry of the aneurysm sac, particularly of vessel branches, could encourage surgeons to perform endovascular procedures.
- 10 November 2023
- Published by Wolters Kluwer Health in Medicine
- Vol. 102 (45) , e35844
Open Access3D printing in the endovascular treatment of visceral artery aneurysms
Visceral artery aneurysms (VAAs) are vascular pathologies that are difficult to treat. The variable geometry of the vessels and the location of aneurysms render difficult their evaluation in radiological imaging studies. Less invasive endovascular procedures are increasingly used in common practice. Our aim was to test the feasibility of using 3D printing technology in the preparation of preoperative spatial models of visceral artery aneurysms and their impact on interventional treatment. In our observational study, we examined a group of patients with true aneurysms of the visceral arteries who were followed and who underwent endovascular procedures with the use of 3D prints for better imaging of vascular lesions. We analyzed the fused filament fabrication method of 3D printing and printable materials in the preparation of spatial vascular models. We confirmed that more accurate visualization and analysis of vascular anatomy could assist operators in attempting minimally invasive treatment with good results. Extending imaging studies using 3D printing models that allow for the assessment of the position, morphology and geometry of the aneurysm sac, particularly of vessel branches, could encourage surgeons to perform endovascular procedures.