Xusheng Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Xusheng Li has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Jian Hu
College of Shipbuilding Engineering, Harbin Engineering University, Harbin 150001, China
5 shared publications - Fugeng Li
College of Shipbuilding Engineering, Harbin Engineering University , Harbin 150001, China
2 shared publications Jianxin Ren
2 shared publicationsQingyuan Wan
2 shared publicationsXiaoshen Ning
2 shared publications- Xiaoshen Ning
College of Shipbuilding Engineering, Harbin Engineering University , Harbin 150001
2 shared publications
Latest Publications
- 7 May 2026
- Published by Elsevier in Ocean Engineering
- Vol. 358
Spatiotemporal characteristics of hydrofoil surface pressure fluctuations in an upstream rod wake
- 7 May 2026
- Published by Elsevier in Ocean Engineering
- Vol. 358
Spatiotemporal characteristics of hydrofoil surface pressure fluctuations in an upstream rod wake
- 18 February 2026
- Published by Elsevier in Ocean Engineering
- Vol. 353
Numerical investigation of submarine surface scattering and scaling effects under point forces excitation
- 18 February 2026
- Published by Elsevier in Ocean Engineering
- Vol. 353
Numerical investigation of submarine surface scattering and scaling effects under point forces excitation
- 1 December 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (12)
Numerical research of unsteady forces induced by turbulence inflow for propeller
In this work, the unsteady force response of non-cavitation propeller is analyzed. Numerical simulation is carried out using large-eddy simulation on the hydrodynamic performance of a ten-blade propeller. Different grid-propeller models are established, and the influence of turbulent flow conditions and skew angle on propeller unsteady force is studied. Results show that both turbulence intensity and turbulence length scale affect unsteady propeller force, which is mainly reflected in the broadband part of unsteady propeller force. In addition, the load distribution on the blade surface changes with the increase in the skew angle, which also changes the unsteady force performance of the propeller.
- 1 December 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (12)
Numerical research of unsteady forces induced by turbulence inflow for propeller
In this work, the unsteady force response of non-cavitation propeller is analyzed. Numerical simulation is carried out using large-eddy simulation on the hydrodynamic performance of a ten-blade propeller. Different grid-propeller models are established, and the influence of turbulent flow conditions and skew angle on propeller unsteady force is studied. Results show that both turbulence intensity and turbulence length scale affect unsteady propeller force, which is mainly reflected in the broadband part of unsteady propeller force. In addition, the load distribution on the blade surface changes with the increase in the skew angle, which also changes the unsteady force performance of the propeller.
- 1 November 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (11)
Effect of cavitation on vortex-induced vibration of hydrofoil
The numerical investigation focuses on the vortex shedding behavior of hydrofoils under the simultaneous occurrence of cavitation and lock-in. To assess the influence of cavitation on vortex-induced vibration in a two-dimensional hydrofoil with a blunt trailing edge, simulations are conducted at 0° and 4° angles of attack. The accuracy of the numerical simulation method is validated through a comparison with experimental cavitation data on the hydrofoil. The results indicate that as the cavitation number decreases, the frequency of the vortex shedding increases, and the vibration amplitude decreases. As cavitation occurs, the vortex shape transitions from circular to elongated ellipsoidal, with an accompanying increase in both strength and volume. At an angle of attack of 0°, the frequency range of the lock-in-state of the hydrofoil is reduced. At an angle of attack of 4°, both sheet cavitation and vortex cavitation manifest during the whole stage of vortex shedding in lock-in and the unstable stage of vortex shedding in non-lock-in.
- 1 November 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (11)
Effect of cavitation on vortex-induced vibration of hydrofoil
The numerical investigation focuses on the vortex shedding behavior of hydrofoils under the simultaneous occurrence of cavitation and lock-in. To assess the influence of cavitation on vortex-induced vibration in a two-dimensional hydrofoil with a blunt trailing edge, simulations are conducted at 0° and 4° angles of attack. The accuracy of the numerical simulation method is validated through a comparison with experimental cavitation data on the hydrofoil. The results indicate that as the cavitation number decreases, the frequency of the vortex shedding increases, and the vibration amplitude decreases. As cavitation occurs, the vortex shape transitions from circular to elongated ellipsoidal, with an accompanying increase in both strength and volume. At an angle of attack of 0°, the frequency range of the lock-in-state of the hydrofoil is reduced. At an angle of attack of 4°, both sheet cavitation and vortex cavitation manifest during the whole stage of vortex shedding in lock-in and the unstable stage of vortex shedding in non-lock-in.
- Open Access
- 1 November 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (11)
Hydrodynamic response of a pitching elastic hydrofoil in the wake of a circular body
A hydrofoil with a classic cylinder–hydrofoil structure is adopted for study in this paper. The hydrofoil is invented by National Advisory Committee for Aeronautics (NACA) and so-called NACA0012.The hydrofoil is placed in an unsteady turbulent environment by positioning a cylinder in front of the hydrofoil. The simulation includes a solid stress model to calculate the hydrofoil's elastic deformation. Large-eddy simulation is used to simulate the effects of different materials on the hydrodynamic performance and noise characteristics. Researching the hydrodynamic performance and acoustic radiation characteristics of the pitching hydrofoil in a turbulent flow provides a reference basis for its design and manufacture. It was found that different material properties have limited effects on the hydrodynamic performance of pitching hydrofoils, and the generated lift is similar for each case. An analysis of stress changes shows that the stress increases with increasing elastic modulus and as the fixed rod is approached. In contrast, the displacement decreases as the elastic modulus increases. The displacement increases with the distance from the fixed rod. In addition, the noise component results show that thickness noise dominates, and an elastic material hydrofoil has better noise performance.
- 1 November 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (11)
Open AccessHydrodynamic response of a pitching elastic hydrofoil in the wake of a circular body
A hydrofoil with a classic cylinder–hydrofoil structure is adopted for study in this paper. The hydrofoil is invented by National Advisory Committee for Aeronautics (NACA) and so-called NACA0012.The hydrofoil is placed in an unsteady turbulent environment by positioning a cylinder in front of the hydrofoil. The simulation includes a solid stress model to calculate the hydrofoil's elastic deformation. Large-eddy simulation is used to simulate the effects of different materials on the hydrodynamic performance and noise characteristics. Researching the hydrodynamic performance and acoustic radiation characteristics of the pitching hydrofoil in a turbulent flow provides a reference basis for its design and manufacture. It was found that different material properties have limited effects on the hydrodynamic performance of pitching hydrofoils, and the generated lift is similar for each case. An analysis of stress changes shows that the stress increases with increasing elastic modulus and as the fixed rod is approached. In contrast, the displacement decreases as the elastic modulus increases. The displacement increases with the distance from the fixed rod. In addition, the noise component results show that thickness noise dominates, and an elastic material hydrofoil has better noise performance.
- 1 June 2012
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 37 (12) , 9669-9676
Integrated characteristics and performance of zero emission coal system
- 1 June 2012
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 37 (12) , 9669-9676
Integrated characteristics and performance of zero emission coal system