QZQibin Zhang

Qibin Zhang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Qibin Zhang has a total of 25 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Experimental Research on Two-Phase Pulse Detonation Characteristics under Elevated Initial Pressures and High-Frequency Conditions

    by Pengfei Ma, Zaijie Feng, Qibin Zhang, Keyu Duan, Wei Fan

    To investigate the operating characteristics of two-phase pulse detonation engines (PDEs) under elevated initial pressures and high-frequency conditions, experiments were conducted using gasoline as the fuel and 50% oxygen-enriched air as the oxidizer. Elevated initial pressures ranging from 0.10 to 0.31 MPa have been achieved by increasing the reactant supply pressures and installing convergent nozzles with varying contraction ratios at the tube exit. The results show that, as the supply pressure increases, the stable detonation ranges both the equivalence ratio and the oxidizer-to-fuel supply pressure ratio initially widen and then narrow. All stable detonation cycles occur at supply pressure ratios below unity. Increasing the initial pressure enables stable detonation under fuel-lean conditions, with the lowest equivalence ratios decreasing to 0.495 and 0.492 for contraction ratios of 1.23 and 1.0, respectively. The nozzle with a contraction ratio of 1.56 provides the widest equivalence ratio range, spanning from 0.811 to 2.530. Moreover, increasing the initial pressure has only a limited influence on the deflagration-to-detonation transition (DDT) distance in the present study. The detonation wave pressure increases almost linearly with rising initial pressure, reaching a detonation-to-initial pressure ratio of 29.85. Furthermore, the maximum stable detonation frequency depends on both the nozzle contraction ratio and the initial pressure. A stable frequency of 100 Hz is achieved under specific initial pressure and contraction ratio conditions, while excessively large contraction ratios or significant increases in initial pressure can reduce the stable operating frequency.

  • Experimental study on detonation characteristics of liquid fuel under near-lean limit conditions

    by Zaijie Feng, Kaiyuan Shao, Qibin Zhang, Yujia Yang, Rui Yang, Duan Chen, Wei Fan

    This study delves into the contradiction between lean combustion and detonation stability in liquid-fueled pulse detonation engines (PDE) by employing a stratified combustion organization method with secondary oxidizer injection. The experiments on the detonation combustion characteristics of liquid fuel near the lean limit used 92# gasoline, 40% oxygen-enriched air, and air as reactants. Experimental results indicate that injecting a secondary stream of oxidizer after the deflagration-to-detonation transition (DDT) segment allows for stable multi-cycle detonation under globally lean conditions, even with an equivalence ratio as low as φ = 0.89. Additionally, this approach reduces the DDT distance by 34% through enhanced turbulence and boosts thrust by approximately 28.6%. Conversely, injecting the secondary stream before the DDT segment fails to produce a fully developed detonation wave. Furthermore, increasing fuel pressure further reduces the global equivalence ratio of the PDE. When combined with secondary oxidizer injection, this optimizes the isolation effect for high-frequency detonation.

  • Study on the pressure relief law of multistage relief isolator

    by Xiaomin Ma, Wei Fan, Qibin Zhang, Yonghui Zhang

    The relationship between the pressure relief efficiency of a multistage pressure relief isolator and three geometric parameters—the relief groove size (w), the spacing between grooves (Δx), and the number of sections (n)—is investigated in this study. A mathematical model based on local pressure differences is proposed to describe the interaction between these four variables. By analyzing the relief law of the backpressure wave in the isolator, it is known that the local pressure difference is the key factor that dominates the relief degree, and the mathematical model can reflect this physical law. Using 45 simulation results for model fitting, the model's root mean square error is approximately 0.037. Correlation analysis reveals that, for a constant initial backpressure generated by detonation combustion, the structural parameters of the pressure relief isolator are all negatively correlated with backpressure. Among these, the correlation between backpressure and the number of sections is the most significant, with a Spearman coefficient of −0.641. Additionally, when the values of w and Δx are significant, further increases in these parameters have a limited impact on the relief effect. Therefore, the most effective design approach is to minimize w, Δx, and n while still achieving the desired pressure relief, preferring a multistage relief approach rather than maximizing any single parameter. Experimental results also suggest that environmental conditions can influence the model's coefficients, requiring recalibration for each specific condition. The fitted coefficients should, therefore, be applied only within the context of the corresponding environmental conditions.

  • Open Access

    The Effects of Pilot Structure on the Lean Ignition Characteristics of the Internally Staged Combustor

    by Zhengyan Guo, Yan Lu, Jingtao Yuan, Pimin Chen, Qibin Zhang, Wei Fan

    In order to explore the influence of pilot structure on the lean ignition characteristics in a certain type of internally staged combustor, the current study was conducted on the effects of the auxiliary fuel nozzle diameter, the rotating direction of the pilot swirler, and the swirl number on the lean ignition fuel–gas ratio limit, combining numerical simulation and experimental validation. The optimization potential of the mixing structure of this type of internally staged combustor was further explored. It indicated that the lean ignition fuel–gas ratio limit was significantly influenced by the diameter of the auxiliary fuel nozzles the swirl number of the pilot swirler and the combination of the same rotating direction for both pilot swirlers, while the mass flow rate of air was constant. Increasing the diameter of the auxiliary fuel path nozzles (0.4~0.6 mm) and having excessively higher or lower swirl numbers of the pilot module primary swirlers are not conducive to broadening the lean ignition boundary. Compared with the two-stage pilot swirler with the same rotation combination, the fuel–gas ignition performance of the two-stage pilot swirler with the opposite rotation combination is better. Under the typical working conditions (the air mass flow rate is 46.7 g/s and the ignition energy is 4 J), for a pilot swirler with a rotating direction opposite to the main swirler, the diameter of the auxiliary fuel nozzles is 0.2 mm, the swirl number of first-stage of pilot swirler is 1.4, and the lean ignition fuel–air ratio was reduced to 0.0121, which is 32.78% lower than the baseline scheme, which further broadens the lean ignition boundary of the centrally staged combustion chamber.

  • Breakup characteristics of droplets induced by detonation waves under different diameters and Mach numbers

    by Rui Yang, Qibin Zhang, Qiang Xiao, Qingyun Chen, Yuguang Jiang, Wei Fan

    The growing interest of liquid-fueled detonation engines for the next-generation propulsion applications necessitates extensive understanding of the breakup physics of droplets induced by detonation waves. However, current knowledge of this topic still remains very limited. The breakup dynamics of water droplets induced by detonation waves under varying diameters and Mach numbers were experimentally investigated in the present study. High-speed schlieren imaging was used to capture the detailed breakup process of the droplets. Based on the experimentally observed flow instabilities, the detonation-induced droplet breakup can be classified into two stages dominated by the Kelvin–Helmholtz instability (KHI) and Rayleigh–Taylor instability (RTI), respectively. During the KHI-dominated phase, droplets of different Mach numbers and diameters exhibit nearly identical linear growth in non-dimensional cross-stream diameter with non-dimensional time. For the first time, significant differences in droplet acceleration between detonation waves and shock waves have been reported. The dimensionless droplet acceleration induced by shock waves is 11–17 times greater than that induced by detonation waves. Finally, theoretical analysis and experimental results show that decreasing droplet diameter and increasing Mach number can accelerate the instability development and shorten the absolute breakup time.


  • Experimental investigation on the spray structure of supercritical aviation kerosene in a swirling flow field

    by Pengyu Shi, Yuguang Jiang, Xudong Long, Jintao Jiang, Qibin Zhang, Wei Fan

    In advanced aeroengines with higher inlet temperature, the cooling capacity of kerosene should be fully used, which turns kerosene into supercritical. The spray features of supercritical kerosene make the mixing process of supercritical kerosene with air different from that of subcritical kerosene. In this work, the spray of supercritical kerosene in a swirling flow field is investigated experimentally. The spray characteristics of supercritical kerosene are obtained using the schlieren technique. The instability of the jet morphology is analyzed using proper orthogonal decomposition (POD) method. The results prove that the combustor head structure significantly affects the overall spray morphology. A “packet structure” caused by density stratification is observed in the spray, which suppresses the circumferential diffusion of the jet. The “packet structure” is highly correlated with the airflow speed. The structural parameters of the supercritical kerosene jet are not sensitive to the changes in kerosene injection pressure, which, however, has a positive correlation with injection temperature. The main cause of the instability of the jet morphology in supercritical kerosene jets is the formation and shedding of vortices on the jet surface, which can be intensified by condensation. Density stratification suppresses shear layer instability, stabilizing the “packet structure” during the injection.


  • Experimental investigation of the self-excited oscillation characteristics of a supercritical aviation kerosene jet in a swirling flow field

    by Pengyu Shi, Yuguang Jiang, Zhisheng Wang, Yang Liao, Qibin Zhang, Wei Fan

    As the pressure ratio and the turbine inlet temperature keep increasing in high performance aero-engines, the kerosene injected into the combustion chamber becomes supercritical. Thus, the traditional self-excited oscillations of the kerosene jets in the fuel–gas mixing are much more pronounced because of the drastic changes in the kerosene thermal properties, which may exacerbate the combustion instability and threaten engine efficiency and safety. In this work, an experimental study was carried out on the self-excited oscillation phenomena of supercritical kerosene injected into a swirling flow field. The injection of supercritical kerosene under different operating conditions was studied using the Schlieren technique and the proper orthogonal decomposition method. The results present that the mixing dominated oscillations of the kerosene jet are induced by the fuel–gas interaction. While the condensation dominated oscillations are due to the phase change of supercritical kerosene in the subcritical environment and the swirling flow field. The spatial distribution of the self-excited oscillations is found to be highly related to the velocity magnitude, instead of the variations in the injection temperature and pressure. The self-excited oscillations are easier to be induced in a low velocity flow field and the oscillation region moves closer to the upstream. Thermal properties also show distinct influences on the injection. At the near-critical region, the suppression effects of high injection pressure on the high-frequency (>100 Hz) self-excited oscillations are much more distinct.

  • Open Access

    LANGUAGE SITUATION IN THE CHAOSHAN COMMUNITY: A PILOT STUDY

    by Zhang Qibin

    Чаошань, расположенный на восточном побережье провинции Гуандун на юге Китая, представляет собой регион с культурными и языковыми особенностями. Данное исследование посвящено изучению языковой ситуации в городе Шаньтоу региона Чаошань. В нем рассматриваются такие ключевые социолингвистические вопросы, как языковая политика, отношение к языку, самоидентификация и взаимопонятность между разновидностями чаошаньского диалекта. Предыдущие исследования в основном были посвящены языковому сдвигу и сохранению языка, но данное исследование в большей степени изучает социолингвистические особенности внутри субсообществ и проблемы взаимопонятности [Lin, 1994, 2005, 2017; F. Chen, 2017; H. Chen., 2020; Huang, Fang, 2021]. Результаты, полученные от 142 участников, свидетельствуют о значительных различиях в языковой практике, отношении к языку и самоидентификации носителей в трех субсообществах. Районы Хаоцзян, Чаоян и Чаонань, составляющие южное субсообщество и его диалект, отличаются от двух других – центрального и северного, в первую очередь, языковой практикой, языковыми отношениями и самоидентификацией носителей. Исследование также дает представление о сложности языковой ситуации в регионе и дает оценку взаимопонятности между тремя разновидностями диалекта Чаошань.

  • Open Access

    Characteristics of multi-cycle two-phase pulse detonation waves traveling near the lean combustion limit

    by Rui Yang, Qibin Zhang, Zaijie Feng, Yujia Yang, Minghao Zhao, Wei Fan

    The need for high combustion efficiency in two-phase pulse detonation engines necessitates the implementation of a lean combustion concept. However, there have been no research initiatives attempting to conduct two-phase pulse detonation in a lean combustion environment due to the highly sensitive nature of the deflagration-to-detonation transition toward the reactivity of the reactant composition. The present study explores methods to realize lean combustion organization in two-phase pulse detonation through the incorporation of secondary air injection. Valveless pulse detonation operation based on gasoline was carried out, while the frequency varies from 20 to 100 Hz. The initiation and propagation characteristics of the pulse detonation wave are influenced first by the equivalence ratio of the detonation initiation section and then by the equivalence ratio of the detonation propagation section. Furthermore, secondary air injection enabled a reduction in the minimum global equivalence ratio for the stable operation of multi-cycle two-phase pulse detonation waves to 0.38, while maintaining an 80% detonation rate.