Lukáš Snopek
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Lukáš Snopek has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Dominik Javorský
Institute of Machine and Industrial Design, Faculty of Mechanical Engineering, Brno University of Technology, 61669 Brno, Czech Republic
1 shared publication - Jan Foltýn
Faculty of Mechanical Engineering, Brno University of Technology, Brno, Czech Republic
1 shared publication - Martin Čupr
Institute of Machine and Industrial Design, Faculty of Mechanical Engineering, Brno University of Technology, 61669 Brno, Czech Republic
1 shared publication - Michal Michalec
Faculty of Mechanical Engineering, Brno University of Technology, Brno, Czech Republic
1 shared publication - Petr Svoboda
Faculty of Mechanical Engineering, Brno University of Technology, Technická 2896/2, 616 69 Brno, Czech Republic
1 shared publication - Tomáš Dryml
Institute of Machine and Industrial Design, Faculty of Mechanical Engineering, Brno University of Technology, 61669 Brno, Czech Republic
1 shared publication
Latest Publications
- Open Access
Assembly Error Tolerance Estimation for Large-Scale Hydrostatic Bearing Segmented Sliders under Static and Low-Speed Conditions
Hydrostatic bearings come with certain advantages over rolling bearings in moving large-scale structures. However, assembly errors are a serious matter on large scales. This study focuses on finding assembly error tolerances for the most common types in segmented errors of hydrostatic bearing sliders: tilt and offset. The experimental part was performed in the laboratory on a full diagnostic hydrostatic bearing testing rig. An investigation of the type of error on bearing performance was first conducted under static conditions. We identified the limiting error-to-film thickness ratio (e/h) for static offset error as 2.5 and the tilt angle as θ = 0.46° for the investigated case. Subsequently, two types of offset error were investigated under slow-speed conditions at 38 mm/s. The limiting error for the offset error considering the relative bi-directional movement of the slider and the pad was determined as e/h < 1. The results further indicate that the error tolerance would further decrease with increasing speed. The experimental results of error tolerances can be used to determine the required film thickness or vice versa.
Open AccessAssembly Error Tolerance Estimation for Large-Scale Hydrostatic Bearing Segmented Sliders under Static and Low-Speed Conditions
Hydrostatic bearings come with certain advantages over rolling bearings in moving large-scale structures. However, assembly errors are a serious matter on large scales. This study focuses on finding assembly error tolerances for the most common types in segmented errors of hydrostatic bearing sliders: tilt and offset. The experimental part was performed in the laboratory on a full diagnostic hydrostatic bearing testing rig. An investigation of the type of error on bearing performance was first conducted under static conditions. We identified the limiting error-to-film thickness ratio (e/h) for static offset error as 2.5 and the tilt angle as θ = 0.46° for the investigated case. Subsequently, two types of offset error were investigated under slow-speed conditions at 38 mm/s. The limiting error for the offset error considering the relative bi-directional movement of the slider and the pad was determined as e/h < 1. The results further indicate that the error tolerance would further decrease with increasing speed. The experimental results of error tolerances can be used to determine the required film thickness or vice versa.