Victor Hjort
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Victor Hjort has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Arnaud le Febvrier
Department of Physics, Chemistry and Biology (IFM), Linköping University, Linköping, Sweden
4 shared publications - Per Eklund
Linköping University
4 shared publications - Abhisek Mishra
National Institute of Science Education and Research (NISER)
1 shared publication - Aditya Singh
School of Physical Sciences Indian Institute of Technology Mandi Mandi Himachal Pradesh India
1 shared publication - Ajay Soni
Indian Institute of Technology Mandi
1 shared publication - Björn Alling
Linköping University
1 shared publication
Latest Publications
- Open Access
- 14 September 2025
- Published by Wiley in Advanced Materials Interfaces
- Vol. 12 (22)
Lattice Mismatch‐Driven In‐Plane Strain Engineering for Enhanced Upper Critical Fields in Mo 2 N Superconducting Thin Films
Transition metal nitrides are a fascinating class of hard coating material that provides an excellent platform for investigating superconductivity and fundamental electron‐phonon ( e‐ph ) interactions. In this work, the structural, morphological, and superconducting properties have been studied for Mo 2 N thin films deposited via direct current magnetron sputtering on c‐plane Al 2 O 3 and MgO substrates to elucidate the effect of internal strain on superconducting properties. High‐resolution X‐ray diffraction and time‐of‐flight elastic recoil detection analysis confirm the growth of single‐phase Mo 2 N thin films exhibiting epitaxial growth with twin‐domain structure. Low‐temperature electrical transport measurements reveal superconducting transitions at ≈5.2 and ≈5.6 K with corresponding upper critical fields of ≈5 and ≈7 T for the films deposited on Al 2 O 3 and MgO, respectively. These results indicate strong type‐II superconductivity, and the observed differences in superconducting properties are attributed to substrate‐induced strain, which leads to higher e‐ph coupling for the film on MgO substrate. These findings highlight the tunability of superconducting properties in Mo 2 N films through strategic substrate selection.
- 14 September 2025
- Published by Wiley in Advanced Materials Interfaces
- Vol. 12 (22)
Open AccessLattice Mismatch‐Driven In‐Plane Strain Engineering for Enhanced Upper Critical Fields in Mo 2 N Superconducting Thin Films
Transition metal nitrides are a fascinating class of hard coating material that provides an excellent platform for investigating superconductivity and fundamental electron‐phonon ( e‐ph ) interactions. In this work, the structural, morphological, and superconducting properties have been studied for Mo 2 N thin films deposited via direct current magnetron sputtering on c‐plane Al 2 O 3 and MgO substrates to elucidate the effect of internal strain on superconducting properties. High‐resolution X‐ray diffraction and time‐of‐flight elastic recoil detection analysis confirm the growth of single‐phase Mo 2 N thin films exhibiting epitaxial growth with twin‐domain structure. Low‐temperature electrical transport measurements reveal superconducting transitions at ≈5.2 and ≈5.6 K with corresponding upper critical fields of ≈5 and ≈7 T for the films deposited on Al 2 O 3 and MgO, respectively. These results indicate strong type‐II superconductivity, and the observed differences in superconducting properties are attributed to substrate‐induced strain, which leads to higher e‐ph coupling for the film on MgO substrate. These findings highlight the tunability of superconducting properties in Mo 2 N films through strategic substrate selection.
- Open Access
- 28 May 2025
- Published by Linkoping University Electronic Press
Thermoelectric properties of CrN alloy thin films
A thermoelectric material can be used to convert heat to electricity, and vice versa, all without moving parts. Thermoelectric devices can be used for a multitude of applications, such as thermoele ...
- 28 May 2025
- Published by Linkoping University Electronic Press
Open AccessThermoelectric properties of CrN alloy thin films
A thermoelectric material can be used to convert heat to electricity, and vice versa, all without moving parts. Thermoelectric devices can be used for a multitude of applications, such as thermoele ...
- Open Access
- 15 October 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (15)
Effects of W alloying on the electronic structure, phase stability, and thermoelectric power factor in epitaxial CrN thin films
CrN-based alloy thin films are of interest as thermoelectric materials for energy harvesting. Ab initio calculations show that dilute alloying of CrN with 3 at. % W substituting Cr induce flat electronic bands and push the Fermi level EF into the conduction band while retaining dispersive Cr 3d bands. These features are conducive for both high electrical conductivity σ and high Seebeck coefficient α and, hence, a high thermoelectric power factor α2σ. To investigate this possibility, epitaxial CrWxNz films were grown on c-sapphire by dc-magnetron sputtering. However, even films with the lowest W content (x = 0.03) in our study contained metallic h-Cr2N, which is not conducive for a high α. Nevertheless, the films exhibit a sizeable power factor of α2σ ∼ 4.7 × 10−4 W m−1 K−2 due to high σ ∼ 700 S cm−1, and a moderate α ∼ − 25 μV/K. Increasing h-Cr2N fractions in the 0.03 < x ≤ 0.19 range monotonically increases σ, but severely diminishes α leading to two orders of magnitude decrease in α2σ. This trend continues with x > 0.19 due to W precipitation. These findings indicate that dilute W additions below its solubility limit in CrN are important for realizing a high thermoelectric power factor in CrWxNz films.
- 15 October 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (15)
Open AccessEffects of W alloying on the electronic structure, phase stability, and thermoelectric power factor in epitaxial CrN thin films
CrN-based alloy thin films are of interest as thermoelectric materials for energy harvesting. Ab initio calculations show that dilute alloying of CrN with 3 at. % W substituting Cr induce flat electronic bands and push the Fermi level EF into the conduction band while retaining dispersive Cr 3d bands. These features are conducive for both high electrical conductivity σ and high Seebeck coefficient α and, hence, a high thermoelectric power factor α2σ. To investigate this possibility, epitaxial CrWxNz films were grown on c-sapphire by dc-magnetron sputtering. However, even films with the lowest W content (x = 0.03) in our study contained metallic h-Cr2N, which is not conducive for a high α. Nevertheless, the films exhibit a sizeable power factor of α2σ ∼ 4.7 × 10−4 W m−1 K−2 due to high σ ∼ 700 S cm−1, and a moderate α ∼ − 25 μV/K. Increasing h-Cr2N fractions in the 0.03 < x ≤ 0.19 range monotonically increases σ, but severely diminishes α leading to two orders of magnitude decrease in α2σ. This trend continues with x > 0.19 due to W precipitation. These findings indicate that dilute W additions below its solubility limit in CrN are important for realizing a high thermoelectric power factor in CrWxNz films.
- Open Access
- 30 July 2024
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 7 (15) , 6785-6792
Influence of Ammonia Annealing on Cr–N Thin Films and Their Thermoelectric Properties
- 30 July 2024
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 7 (15) , 6785-6792
Open AccessInfluence of Ammonia Annealing on Cr–N Thin Films and Their Thermoelectric Properties
- Open Access
- 15 November 2023
- Published by American Physical Society (APS) in Physical Review B
- Vol. 108 (20) , 205134
Thermoelectric properties and electronic structure of thin films studied by synchrotron and lab-based x-ray spectroscopyChromium-based nitrides are used in hard, resilient coatings and show promise for thermoelectric applications due to their combination of structural, thermal, and electronic properties. Here, we investigate the electronic structures and chemical bonding correlated to the thermoelectric properties of epitaxially grown chromium-based multicomponent nitride thin films. The small amount of N vacancies causes Cr and N states to appear at the Fermi level and reduces the band gap in . Incorporating holes by alloying of V in N-deficient CrN results in an enhanced thermoelectric power factor with marginal change in the charge transfer of Cr to N compared with . Further alloying of Mo, isoelectronic to Cr, increases the density of states at the Fermi level due to hybridization of the (Cr, V) and Mo -N states in . This hybridization and N off-stoichiometry result in more metal-like electrical resistivity and reduction in Seebeck coefficient. The N deficiency in also depicts a critical role in reduction of the charge transfer from metal to N site compared with and . In this paper, we envisage ways for enhancing thermoelectric properties through electronic band engineering by alloying and competing effects of N vacancies.- 15 November 2023
- Published by American Physical Society (APS) in Physical Review B
- Vol. 108 (20) , 205134
Open AccessThermoelectric properties and electronic structure of thin films studied by synchrotron and lab-based x-ray spectroscopyChromium-based nitrides are used in hard, resilient coatings and show promise for thermoelectric applications due to their combination of structural, thermal, and electronic properties. Here, we investigate the electronic structures and chemical bonding correlated to the thermoelectric properties of epitaxially grown chromium-based multicomponent nitride thin films. The small amount of N vacancies causes Cr and N states to appear at the Fermi level and reduces the band gap in . Incorporating holes by alloying of V in N-deficient CrN results in an enhanced thermoelectric power factor with marginal change in the charge transfer of Cr to N compared with . Further alloying of Mo, isoelectronic to Cr, increases the density of states at the Fermi level due to hybridization of the (Cr, V) and Mo -N states in . This hybridization and N off-stoichiometry result in more metal-like electrical resistivity and reduction in Seebeck coefficient. The N deficiency in also depicts a critical role in reduction of the charge transfer from metal to N site compared with and . In this paper, we envisage ways for enhancing thermoelectric properties through electronic band engineering by alloying and competing effects of N vacancies.