Takeshi Aihara
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Takeshi Aihara has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Keigo Kamata
Materials and Structures Laboratory, Institute of Integrated Research Institute of Science Tokyo Yokohama Japan
7 shared publications Wataru Aoki
Materials and Structures Laboratory Institute of Integrated Research Institute of Science Tokyo Yokohama Japan
3 shared publications- Keiju Wachi
Materials and Structures Laboratory, Institute of Integrated Research Institute of Science Tokyo Yokohama Japan
2 shared publications - Yu Kumagai
Institute for Materials Research Tohoku University Sendai Japan
2 shared publications Hideyoshi Kawai
Materials and Structures Laboratory Institute of Integrated Research Institute of Science Tokyo Yokohama Japan
1 shared publicationKeiju Wachi
Laboratory for Materials and Structures, Institute of Innovative Research, Tokyo Institute of Technology, Nagatsuta-cho 4259-R3-6, Midori-ku, Yokohama, Kanagawa 226-8501, Japan
1 shared publication
Latest Publications
- Open Access
- 27 September 2026
- Published by Wiley in ChemElectroChem
- Vol. 13 (19)
Structural Transformation of Fe 3 O 3 PO 4 Nanoparticles During ON/OFF Operation for Oxygen Evolution Reaction
The development of effective catalysts for alkaline water electrolysis is strongly demanded for green hydrogen production. In the present study, we synthesized various crystalline metal oxide and phosphate nanoparticles and evaluated their catalytic performance for the oxygen evolution reaction by linear sweep voltammetry measurements. Among approximately 50 types of nanoparticles and benchmark catalysts (e.g., IrO 2 and RuO 2 ), Fe 3 O 3 PO 4 exhibited the lowest potential (1.57 ± 0.02 V vs. RHE) at a current density of 0.5 A cm −2 . Furthermore, ON/OFF durability tests simulating system startup and shutdown revealed that this material exhibits high durability and a degradation rate of only 15 μV cycle −1 during 4000 cycles. Spectroscopic analyses, including inductively coupled plasma−atomic emission, Raman, X‐ray absorption, and X‐ray photoelectron spectroscopy likely suggested that Fe 3 O 3 PO 4 is electrochemically activated to form a γ ‐FeOOH‐type species accompanied by leaching of phosphorus species from the structure during the reaction. In addition, PO 4 3− species on the catalyst surface may affect both OER activity and the durability of the resultant γ ‐FeOOH electrocatalyst under reverse current conditions.
- 27 September 2026
- Published by Wiley in ChemElectroChem
- Vol. 13 (19)
Open AccessStructural Transformation of Fe 3 O 3 PO 4 Nanoparticles During ON/OFF Operation for Oxygen Evolution Reaction
The development of effective catalysts for alkaline water electrolysis is strongly demanded for green hydrogen production. In the present study, we synthesized various crystalline metal oxide and phosphate nanoparticles and evaluated their catalytic performance for the oxygen evolution reaction by linear sweep voltammetry measurements. Among approximately 50 types of nanoparticles and benchmark catalysts (e.g., IrO 2 and RuO 2 ), Fe 3 O 3 PO 4 exhibited the lowest potential (1.57 ± 0.02 V vs. RHE) at a current density of 0.5 A cm −2 . Furthermore, ON/OFF durability tests simulating system startup and shutdown revealed that this material exhibits high durability and a degradation rate of only 15 μV cycle −1 during 4000 cycles. Spectroscopic analyses, including inductively coupled plasma−atomic emission, Raman, X‐ray absorption, and X‐ray photoelectron spectroscopy likely suggested that Fe 3 O 3 PO 4 is electrochemically activated to form a γ ‐FeOOH‐type species accompanied by leaching of phosphorus species from the structure during the reaction. In addition, PO 4 3− species on the catalyst surface may affect both OER activity and the durability of the resultant γ ‐FeOOH electrocatalyst under reverse current conditions.
- Open Access
- 19 March 2026
- Published by Wiley in ChemCatChem
- Vol. 18 (6) , e01851
Effective Glycerol Carbonate Synthesis From Glycerol and Dimethyl Carbonate Over Rb‐Doped SrTiO 3 Nanoparticles
The development of effective solid catalysts for adding high value to biomass‐derived compounds is crucial for the realization of a sustainable society. We investigated the transesterification of glycerol with dimethyl carbonate using alkali‐metal‐doped SrTiO 3 nanoparticles. Among the tested catalysts, Rb‐doped SrTiO 3 exhibited the highest catalytic performance under mild conditions (353 K), to give glycerol carbonate in 91% yield after 1 h. This catalyst could be reused without a substantial loss of catalytic performance and was applicable to a larger‐scale reaction of glycerol with dimethyl carbonate, in which 1.10 g of the analytically pure product was isolated. In the presence of Rb‐doped SrTiO 3 catalyst, various combinations of diols and alkyl carbonates gave the desired cyclic carbonates in high‐to‐excellent yields. Temperature‐programmed desorption and infrared spectroscopy measurements using various probe molecules, along with poisoning tests, revealed that the strong basic sites generated by Rb doping promoted the activation of both diols and alkyl carbonates, which led to the high activity of the catalyst.
- 19 March 2026
- Published by Wiley in ChemCatChem
- Vol. 18 (6) , e01851
Open AccessEffective Glycerol Carbonate Synthesis From Glycerol and Dimethyl Carbonate Over Rb‐Doped SrTiO 3 Nanoparticles
The development of effective solid catalysts for adding high value to biomass‐derived compounds is crucial for the realization of a sustainable society. We investigated the transesterification of glycerol with dimethyl carbonate using alkali‐metal‐doped SrTiO 3 nanoparticles. Among the tested catalysts, Rb‐doped SrTiO 3 exhibited the highest catalytic performance under mild conditions (353 K), to give glycerol carbonate in 91% yield after 1 h. This catalyst could be reused without a substantial loss of catalytic performance and was applicable to a larger‐scale reaction of glycerol with dimethyl carbonate, in which 1.10 g of the analytically pure product was isolated. In the presence of Rb‐doped SrTiO 3 catalyst, various combinations of diols and alkyl carbonates gave the desired cyclic carbonates in high‐to‐excellent yields. Temperature‐programmed desorption and infrared spectroscopy measurements using various probe molecules, along with poisoning tests, revealed that the strong basic sites generated by Rb doping promoted the activation of both diols and alkyl carbonates, which led to the high activity of the catalyst.
- Open Access
- 22 April 2025
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 8 (17) , 8728-8739
Ion-Exchanged OMS-1 Nanoparticles for Efficient Aerobic Oxidation Catalysis of Sulfides and Other Organics under Mild Conditions
- 22 April 2025
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 8 (17) , 8728-8739
Open AccessIon-Exchanged OMS-1 Nanoparticles for Efficient Aerobic Oxidation Catalysis of Sulfides and Other Organics under Mild Conditions
- Open Access
- 3 April 2025
- Published by Wiley in Advanced Functional Materials
- Vol. 35 (29)
Oxygen Defect Engineering of Hexagonal Perovskite Oxides to Boost Catalytic Performance for Aerobic Oxidation of Sulfides to Sulfones
Oxygen defect engineering in metal oxides is a promising approach to designing efficient active sites for catalytic oxidation involving surface lattice oxygen. In the present study, a combined approach focusing on the structure of oxygen sites (face‐shared vs corner‐shared) and B ‐site substitution in an AB O 3 hexagonal perovskite oxide is investigated. Ru‐substituted SrMnO 3 nanoparticles (SrMn 1− x Ru x O 3 ) efficiently catalyzes the aerobic oxidation of thioanisole to sulfone with high selectivity (>99%) even at 30 °C, which is much lower than the temperatures required for the same reaction catalyzed using previously reported Mn‐ and Ru‐based oxide catalysts (80–150 °C). Only a small amount of Ru incorporation ( x = 0.01) substantially enhances its catalytic performance. The present catalyst can be reused five times and applied to the aerobic oxidation of various sulfides to afford the corresponding sulfones. Mechanistic studies reveal a bifunctional property of SrMn 1− x Ru x O 3 , where surface lattice oxygen is involved in sulfide oxidation, and the strong adsorption of sulfoxides onto the surfaces contributes to the rapid successive oxidation of sulfoxide. Catalyst reducibility estimations and density functional theory calculations indicate that the intrinsic role of Ru is likely to enhance the oxygen transferability of face‐shared Mn 4+ –O–Mn 4+ species.
- 3 April 2025
- Published by Wiley in Advanced Functional Materials
- Vol. 35 (29)
Open AccessOxygen Defect Engineering of Hexagonal Perovskite Oxides to Boost Catalytic Performance for Aerobic Oxidation of Sulfides to Sulfones
Oxygen defect engineering in metal oxides is a promising approach to designing efficient active sites for catalytic oxidation involving surface lattice oxygen. In the present study, a combined approach focusing on the structure of oxygen sites (face‐shared vs corner‐shared) and B ‐site substitution in an AB O 3 hexagonal perovskite oxide is investigated. Ru‐substituted SrMnO 3 nanoparticles (SrMn 1− x Ru x O 3 ) efficiently catalyzes the aerobic oxidation of thioanisole to sulfone with high selectivity (>99%) even at 30 °C, which is much lower than the temperatures required for the same reaction catalyzed using previously reported Mn‐ and Ru‐based oxide catalysts (80–150 °C). Only a small amount of Ru incorporation ( x = 0.01) substantially enhances its catalytic performance. The present catalyst can be reused five times and applied to the aerobic oxidation of various sulfides to afford the corresponding sulfones. Mechanistic studies reveal a bifunctional property of SrMn 1− x Ru x O 3 , where surface lattice oxygen is involved in sulfide oxidation, and the strong adsorption of sulfoxides onto the surfaces contributes to the rapid successive oxidation of sulfoxide. Catalyst reducibility estimations and density functional theory calculations indicate that the intrinsic role of Ru is likely to enhance the oxygen transferability of face‐shared Mn 4+ –O–Mn 4+ species.
- Open Access
- 8 October 2024
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 60 (81) , 11483-11499
Synthesis and catalytic application of nanostructured metal oxides and phosphates
This work summarizes catalyst design methodologies based on crystalline complex oxide nanostructures through the synthesis, catalytic application, and structure–activity relationship.
- 8 October 2024
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 60 (81) , 11483-11499
Open AccessSynthesis and catalytic application of nanostructured metal oxides and phosphates
This work summarizes catalyst design methodologies based on crystalline complex oxide nanostructures through the synthesis, catalytic application, and structure–activity relationship.
- 10 November 2023
- Published by Elsevier in Catalysis Today
- Vol. 428
Acid and base catalysis of SrTiO3 nanoparticles for C–C bond-forming reactions
- 10 November 2023
- Published by Elsevier in Catalysis Today
- Vol. 428
Acid and base catalysis of SrTiO3 nanoparticles for C–C bond-forming reactions