Jack C. Brennan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jack C. Brennan has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
- João Barbosa
James Watt School of Engineering, University of Glasgow, Advanced Research Centre 1 , Glasgow, G11 6EW Scotland
2 shared publications - Martin Weides
James Watt School of Engineering, University of Glasgow 1 , Glasgow G12 8QQ
2 shared publications - Alessandro Casaburi
James Watt School of Engineering, University of Glasgow 1 , Glasgow G12 8QQ
1 shared publication - Alex F. Kirichenko
HYPRES, Elmsford, NY, USA
1 shared publication Calum Rose
James Watt School of Engineering Advanced Research Centre University of Glasgow G11 6EW Glasgow Scotland United Kingdom
1 shared publication- Calum S. Rose
James Watt School of Engineering, University of Glasgow, Advanced Research Centre 1 , Glasgow, G11 6EW Scotland
1 shared publication
Latest Publications
- Open Access
- 1 December 2025
- Published by AIP Publishing in APL Quantum
- Vol. 2 (4)
Classical interfaces for controlling cryogenic quantum computing technologies
Quantum processors have the potential to revolutionize computing on a scale unseen since the development of semiconductor technology in the middle of the twentieth century. However, while there is now huge activity and investment in the field, there are a number of challenges that must be overcome before the technology can be fully realized. Of primary concern is the development of the classical technology required to interface with quantum systems, as we push toward a new era of high-performance, large-scale quantum computing. In this review, we briefly discuss some of the main challenges facing the development of universally useful quantum computers and the different architectures being investigated. We are primarily concerned with cryogenic quantum systems. These systems are among the most mature quantum computing architectures to date and are garnering a lot of both industrial and academic attention. We present and analyze the leading methods of interfacing with quantum processors, both now and for the next generation of larger, multi-qubit systems. Recent advancements in control cryoelectronics, both semiconducting and superconducting, are covered, while a view toward newer methods such as optical and wireless qubit interfaces is also presented.
- 1 December 2025
- Published by AIP Publishing in APL Quantum
- Vol. 2 (4)
Open AccessClassical interfaces for controlling cryogenic quantum computing technologies
Quantum processors have the potential to revolutionize computing on a scale unseen since the development of semiconductor technology in the middle of the twentieth century. However, while there is now huge activity and investment in the field, there are a number of challenges that must be overcome before the technology can be fully realized. Of primary concern is the development of the classical technology required to interface with quantum systems, as we push toward a new era of high-performance, large-scale quantum computing. In this review, we briefly discuss some of the main challenges facing the development of universally useful quantum computers and the different architectures being investigated. We are primarily concerned with cryogenic quantum systems. These systems are among the most mature quantum computing architectures to date and are garnering a lot of both industrial and academic attention. We present and analyze the leading methods of interfacing with quantum processors, both now and for the next generation of larger, multi-qubit systems. Recent advancements in control cryoelectronics, both semiconducting and superconducting, are covered, while a view toward newer methods such as optical and wireless qubit interfaces is also presented.
- Open Access
Classical Interfaces for Controlling Cryogenic Quantum Computing Technologies
Quantum processors have the potential to revolutionise computing on a scale unseen since the development of semiconductor technology in the middle of the 20th century. However, while there is now huge activity and investment in the field, there are a number of challenges that must be overcome before the technology can be fully realised. Of primary concern is the development of the classical technology required to interface with quantum systems, as we push towards a new era of high-performance, large-scale quantum computing. In this review, we briefly discuss some of the main challenges facing the development of universally useful quantum computers and the different architectures being investigated. We are primarily concerned with cryogenic quantum systems. These systems are among the most mature quantum computing architectures to date, and are garnering a lot of both industrial and academic attention. We present and analyse the leading methods of interfacing with quantum processors, both now and for the next generation of larger, multi-qubit systems. Recent advancements in control cryoelectronics, both semiconducting and superconducting, are covered, while a view towards newer methods such as optical and wireless qubit interfaces are also presented.
Open AccessClassical Interfaces for Controlling Cryogenic Quantum Computing Technologies
Quantum processors have the potential to revolutionise computing on a scale unseen since the development of semiconductor technology in the middle of the 20th century. However, while there is now huge activity and investment in the field, there are a number of challenges that must be overcome before the technology can be fully realised. Of primary concern is the development of the classical technology required to interface with quantum systems, as we push towards a new era of high-performance, large-scale quantum computing. In this review, we briefly discuss some of the main challenges facing the development of universally useful quantum computers and the different architectures being investigated. We are primarily concerned with cryogenic quantum systems. These systems are among the most mature quantum computing architectures to date, and are garnering a lot of both industrial and academic attention. We present and analyse the leading methods of interfacing with quantum processors, both now and for the next generation of larger, multi-qubit systems. Recent advancements in control cryoelectronics, both semiconducting and superconducting, are covered, while a view towards newer methods such as optical and wireless qubit interfaces are also presented.
- Open Access
- 20 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Quantum Engineering
- Vol. 6, 1-11
RSFQ All-Digital Programmable Multitone Generator for Quantum Applications
One of the most important and topical challenges of quantum circuits is their scalability. Rapid single flux quantum (RSFQ) technology is at the forefront of replacing current standard CMOS-based control architectures for a number of applications, including quantum computing and quantum sensor arrays. By condensing the control and readout to single-flux-quantum-based on-chip devices that are directly connected to the quantum systems, it is possible to minimize the total system overhead, improving scalability and integration. In this article, we present a novel RSFQ device that generates multitone digital signals, based on complex pulse train sequences using a circular shift register (CSR) and a comb filter stage. We show that the frequency spectrum of the pulse trains is dependent on a preloaded pattern on the CSR, as well as on the delay line of the comb filter stage. By carefully selecting both the pattern and delay, the desired tones can be isolated and amplified as required. Finally, we propose architectures where this device can be implemented to control and read out arrays of quantum devices, such as qubits and single-photon detectors.
- 20 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Quantum Engineering
- Vol. 6, 1-11
Open AccessRSFQ All-Digital Programmable Multitone Generator for Quantum Applications
One of the most important and topical challenges of quantum circuits is their scalability. Rapid single flux quantum (RSFQ) technology is at the forefront of replacing current standard CMOS-based control architectures for a number of applications, including quantum computing and quantum sensor arrays. By condensing the control and readout to single-flux-quantum-based on-chip devices that are directly connected to the quantum systems, it is possible to minimize the total system overhead, improving scalability and integration. In this article, we present a novel RSFQ device that generates multitone digital signals, based on complex pulse train sequences using a circular shift register (CSR) and a comb filter stage. We show that the frequency spectrum of the pulse trains is dependent on a preloaded pattern on the CSR, as well as on the delay line of the comb filter stage. By carefully selecting both the pattern and delay, the desired tones can be isolated and amplified as required. Finally, we propose architectures where this device can be implemented to control and read out arrays of quantum devices, such as qubits and single-photon detectors.
- Open Access
- 8 August 2024
- Published by Wiley in Journal of Microscopy
- Vol. 297 (1) , 35-42
Analysis of the Ag M4,5 EELS edge to study silver nanoparticle corrosion
Electron energy loss spectra collected from fresh and corroded silver nanoparticles are compared with those from a number of reference materials, focusing on the M4,5 edge. Chemical shifts and changes in the energy loss near edge structure (ELNES) are described and found to be sufficient to distinguish metallic silver from chemically oxidised silver. The measurements, in conjunction with electron energy loss spectrum imaging, are used to assess the mechanisms for atmospheric corrosion of silver nanoparticles. We unambiguously assign the corrosion product under atmospheric conditions to be silver sulphide, but show the reaction process to be distinctly inhomogeneous, producing a variety of types of corroded particles.LAY DESCRIPTION: >Here, we use analytical electron microscopy to track the corrosion of silver nanoparticles and present chemical maps of the corrosion products. We show clear spectroscopic differences between metallic and corroded silver using the M4,5 electron energy loss spectral feature, which is not commonly studied. Our study shows that corrosion is due to interactions with sulphur in the atmosphere; and the corrosion is not uniform, but appears to develop from specific points on the surface of the nanoparticles.
- 8 August 2024
- Published by Wiley in Journal of Microscopy
- Vol. 297 (1) , 35-42
Open AccessAnalysis of the Ag M4,5 EELS edge to study silver nanoparticle corrosion
Electron energy loss spectra collected from fresh and corroded silver nanoparticles are compared with those from a number of reference materials, focusing on the M4,5 edge. Chemical shifts and changes in the energy loss near edge structure (ELNES) are described and found to be sufficient to distinguish metallic silver from chemically oxidised silver. The measurements, in conjunction with electron energy loss spectrum imaging, are used to assess the mechanisms for atmospheric corrosion of silver nanoparticles. We unambiguously assign the corrosion product under atmospheric conditions to be silver sulphide, but show the reaction process to be distinctly inhomogeneous, producing a variety of types of corroded particles.LAY DESCRIPTION: >Here, we use analytical electron microscopy to track the corrosion of silver nanoparticles and present chemical maps of the corrosion products. We show clear spectroscopic differences between metallic and corroded silver using the M4,5 electron energy loss spectral feature, which is not commonly studied. Our study shows that corrosion is due to interactions with sulphur in the atmosphere; and the corrosion is not uniform, but appears to develop from specific points on the surface of the nanoparticles.
- Open Access
- 20 November 2023
- Published by IOP Publishing in Materials for Quantum Technology
- Vol. 3 (4) , 045401
High-uniformity atomic layer deposition of superconducting niobium nitride thin films for quantum photonic integration
Atomic layer deposition (ALD) has been identified as a promising growth method for high-uniformity superconducting thin films for superconducting quantum photonic applications, offering superior uniformity, thickness control and conformality to techniques such as reactive sputtering. The potential scalability of ALD makes this method especially appealing for fabrication of superconducting nanowires and resonators across large areas. We report on the growth of highly uniform superconducting NbN thin films via plasma-enhanced atomic layer deposition (PEALD) with radio frequency substrate biasing, on a 200 mm (8 inch) Si wafer, specifically for superconducting nanowire single-photon detector applications. Niobium nitride films were grown using (tert-butylimido)-tris(diethylamido)-niobium(V) precursor and an H2/Ar plasma. The superconducting properties of a variable thickness series of films (5.9–29.8 nm) show critical temperature (T c) of 13.5 K approaching bulk thickness (28.8 nm) with low suppression down to the ultrathin regime (5.9 nm), with T c = 10.2 K. T c across the 200 mm wafer with 8 nm thick NbN, measured in 15 mm intervals, exhibits minimal variation ( 10 MA cm−2 at 2.6 K. PEALD could therefore be a pivotal technique in enabling large-scale fabrication of integrated quantum photonic devices across a variety of applications.
- 20 November 2023
- Published by IOP Publishing in Materials for Quantum Technology
- Vol. 3 (4) , 045401
Open AccessHigh-uniformity atomic layer deposition of superconducting niobium nitride thin films for quantum photonic integration
Atomic layer deposition (ALD) has been identified as a promising growth method for high-uniformity superconducting thin films for superconducting quantum photonic applications, offering superior uniformity, thickness control and conformality to techniques such as reactive sputtering. The potential scalability of ALD makes this method especially appealing for fabrication of superconducting nanowires and resonators across large areas. We report on the growth of highly uniform superconducting NbN thin films via plasma-enhanced atomic layer deposition (PEALD) with radio frequency substrate biasing, on a 200 mm (8 inch) Si wafer, specifically for superconducting nanowire single-photon detector applications. Niobium nitride films were grown using (tert-butylimido)-tris(diethylamido)-niobium(V) precursor and an H2/Ar plasma. The superconducting properties of a variable thickness series of films (5.9–29.8 nm) show critical temperature (T c) of 13.5 K approaching bulk thickness (28.8 nm) with low suppression down to the ultrathin regime (5.9 nm), with T c = 10.2 K. T c across the 200 mm wafer with 8 nm thick NbN, measured in 15 mm intervals, exhibits minimal variation ( 10 MA cm−2 at 2.6 K. PEALD could therefore be a pivotal technique in enabling large-scale fabrication of integrated quantum photonic devices across a variety of applications.