HGHui Gao

Hui Gao

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Hui Gao has a total of 36 co-authors. Here are the top co-authors by number of shared publications:

  • Hao Wang

    Key Laboratory of Concrete and Prestressed, Concrete Structures of Ministry of Education, Southeast University, Nanjing 211189, P. R. China

    9 shared publications
  • Zhihao Wang

    School of Civil Engineering and communication, North China University of Water Resources and Electric Power, Zhengzhou 450045, China

    5 shared publications
  • Jianxiao Mao

    Key Laboratory of C&PC Structures of the Ministry of Education, Southeast University, Nanjing 211189, P. R. China

    3 shared publications
  • Tianyi Lang

    Key Laboratory of Concrete and Prestressed Concrete Structures of Ministry of Education, Southeast University, Nanjing 210096, China

    3 shared publications
  • Fangfang Yue

    International Joint Research Lab for Eco-building Materials and Engineering of Henan Province, North China University of Water Resources and Electric Power, Zhengzhou 450045, China

    2 shared publications
  • Zhipeng Cheng

    2 State Key Laboratory of Bridge Safety and Resilience, Beijing University of Technology, Beijing, China

    2 shared publications

Latest Publications

  • Experimental study on vortex-induced vibrations of double-hanger cable: Upstream wake flow induces downstream vibrations

    by Tianyi Lang, Hao Wang, Hui Gao, Zidong Xu

    This study is inspired by an experimental observation for vortex-induced vibrations (VIVs) of a double-hanger cable system, in which a smaller vibration of the downwind hanger cable is re-excited over a narrow range of wind speeds beyond the “lock-in” range. This phenomenon is known as the wake vortex-induced vibrations (WVIVs), where the upstream wake flow induces downstream vibrations. To further investigate the characteristics and reasons for WVIVs, a refined wind tunnel test of double-hanger cable was conducted to consider the influence of aerodynamic interaction. The double-hanger cable was modeled by the tandem-arranged spring-mounted cylinders vibrating in two dimensions. The vibration responses of hanger cables were obtained under various wind speeds to reproduce the lock-in phenomenon. In addition, the vibration trajectory, phase relationship, damping ratio, inter-cable correlation, and the wind pressure on the surface of cables were analyzed. Finally, the Stockbridge dampers were designed to suppress the vibrations. The results show that under the aerodynamic interaction of the cables, the onset wind speed of VIVs in the double cables increases, and the downstream cable WVIVs closely follow the VIVs. During the WVIV phase, the downstream cable behavior is characterized by increased negative aerodynamic damping and an inverse displacement correlation between the cables. The phase relationships between the cables are time-varying due to the aerodynamic interaction. The first proper orthogonal decomposition mode of wind pressure dominates the cross-wind of motions and is crucial in vibrations. Stockbridge dampers can effectively reduce the amplitude of VIVs and eliminate WVIVs in cables.


  • Open Access

    Finite Element Modeling and Calibration of a Three-Span Continuous Suspension Bridge Based on Loop Adjustment and Temperature Correction

    by Hai Zong, Xun Su, Jianxiao Mao, Hao Wang, Hui Gao

    Precise finite element modeling is critically important for the construction and maintenance of long-span suspension bridges. During the process of modeling, shape-finding and model calibration directly impact the accuracy and reliability. Scholars have provided numerous alternative proposals for the shape-finding of main cables in suspension bridges from both theoretical and finite element analysis perspectives. However, it is difficult to apply these solutions to suspension bridges with special components. Seeking a viable solution for such suspension bridges holds practical significance. The Nanjing Qixiashan Yangtze River Bridge is the first three-span suspension bridge in China. To maintain the configuration of the main cable, the suspension bridge is equipped with specialized suspenders near the anchors, referred to as displacement-limiting suspenders. It is the first suspension bridge in China to use displacement-limiting suspenders and their anchorage system. Taking the suspension bridge as a research background, this paper introduces a refined finite element modeling approach considering the effect of geometric nonlinearity. Firstly, based on the loop adjustment and temperature correction, the shape-finding and force assessment of the main cables are carried out. On this basis, a nonlinear finite element model of the bridge was established and calibrated, taking into account factors such as pylon settlement and cable saddle precession. Finally, the static and dynamic characteristics of the suspension bridge were thoroughly investigated. This study aims to provide a reference for the design, construction and operation of the three-span continuous suspension bridge.


  • Testing, Modelling, and Performance Evaluation of a Rotary Eddy-Current Damper with Inherent Nonlinear Damping Characteristics for Structural Vibration Control

    by Zhipeng Cheng, Zhihao Wang, Kaiming Bi, Kaiqiang Cui, Hui Gao

    This paper investigates the inherent nonlinear damping characteristics of a rotary eddy-current damper (RECD) and evaluates its vibration control performance on a single-degree-of-freedom (SDOF) system subjected to harmonic and seismic excitations. First, a RECD prototype was manufactured to experimentally identify its intrinsic nonlinear eddy-current damping characteristics. A magic formula model is then proposed to characterize the relationship between the eddy-current damping force and the velocity of the RECD, and its applicability in depicting the nonlinear damping characteristics of the RECD is evaluated by comparing with the electromagnetic finite-element (FE) model and the commonly used Wouterse’s model. Moreover, by comparing the experimental and analytical frequency–domain responses of an SDOF structure equipped with a RECD, the applicability of the magic formula model in evaluating the structural vibration control performance of the RECD is further verified. Finally, the control performance of the RECD for an SDOF structure subjected to earthquake ground motions is numerically evaluated and compared. Results show that the eddy-current damping force of the RECD presents obvious nonlinear characteristics with increasing velocity, and the proposed magic formula model can adequately depict the nonlinear eddy-current damping characteristics of the RECD. Moreover, the RECD exhibits superior structural control performance under harmonic and seismic excitations.


  • Multi-Mode Vibration Control of Super-Long Stay Cables with Negative Stiffness and Stockbridge Dampers

    by Zhihao Wang, Yang Liu, Hui Gao, Zhipeng Cheng, Hao Wang, Yanwei Xu

    Installing mechanical dampers near the cable anchorage is a commonly used measure for suppressing rain-wind-induced vibrations (RWIVs) of stay cables. However, the high-mode vortex-induced vibrations (VIVs) are still observed on super-long stay cables installed with dampers. To this end, the study presents the combination of a negative stiffness damper (NSD) and Stockbridge dampers (SDs) to simultaneously suppress cable RWIVs and VIVs. In the proposed cable–NSD–SDs system, the NSD is installed near the cable anchorage to suppress cable RWIVs, and the SDs are installed at a higher location to suppress cable VIVs. First, the generalized characteristic equation of the cable–NSD–SDs system is derived for computing the coupled damping effect. Subsequently, a novel design method of an NSD and two SDs for mitigating cable multi-mode vibrations is proposed, and its effectiveness is numerically verified on an ultra-long stay cable of the Sutong Bridge. Finally, the control performance of an NSD and two SDs for the cable under white noise and harmonic excitations is emphatically evaluated and compared. Results indicate that the NSD–SDs system is quite effective for mitigating high-mode vibrations of super-long stay cables. Compared with the cable–NSD system, the cable acceleration response of the cable–NSD–SDs system is reduced by over 35%.


  • Open Access

    Dynamic Behaviors of a Two‐Cable Network With Two Negative Stiffness Dampers and a Cross‐Tie

    by Mengyu Li, Yanwei Xu, Hui Gao, Zhipeng Cheng, Zhihao Wang

    Due to their structural characteristics, stay cables are inherently susceptible to vibrations. Addressing this issue, the research explores the dynamics of a two‐cable network system, emphasizing the impact of composite vibration control methods. A system consisting of two horizontal cables is presented, each fitted with negative stiffness dampers (NSDs) at their anchored ends and interconnected by a cross‐tie. A complex eigenvalue equation, formulated based on displacement boundary conditions and the continuity of displacement and force, is validated through numerical simulations. The multimode damping effects of the dual NSDs and cross‐tie on the two‐cable network are explored through parameter analysis and optimization. The results demonstrate that reducing the stiffness of the cross‐tie improves the fundamental modal damping ratio, whereas increasing its stiffness or positioning it close to the cable’s midpoint enhances the vibration frequency. The incorporation of NSDs into the hybrid system significantly increases the maximum damping ratio while lowering the optimal damping coefficient. This study presents a method for calculating the range of negative stiffness values, providing insights into the selection of installation positions and stiffness for the cross‐tie, thereby facilitating the design of highly effective multimode vibration control solutions for stay cables.


  • Open Access

    Vortex‐Induced Vibration of Long Suspenders of a Long‐Span Suspension Bridge and Its Effect on Local Deck Acceleration Based on Field Monitoring

    by Xun Su, Jianxiao Mao, Hao Wang, Hui Gao, Xiaoming Guo, Hai Zong

    As the main structural component, the possibility of wind‐induced vibration, especially vortex‐induced vibrations (VIVs), is greatly increased due to the shape and structural characteristics of the long suspenders. To investigate the full‐scale wind‐induced vibration of the long suspenders of a long‐span suspension bridge with a main span of 1418 m, the long‐term vibration‐based monitoring system was established. Based on the recorded structural health monitoring (SHM) data, the corresponding wind conditions and the vibration characteristics of long suspenders with different diameters and tensions are investigated. Furthermore, modal parameters including frequencies and damping ratios of long suspenders are identified and tracked during the VIV period. The relationship between the shedding frequency of long suspenders and the corresponding wind speed is studied. Results show that the VIVs with frequencies ranging from 8 Hz to 20 Hz were observed continuously across a wide range of wind speeds in both sets of long suspenders. Due to the relatively low modal damping, significant vortex characteristics and lock‐in phenomena can be expected on the long suspenders. A new frequency‐adjustable Stockbridge damper is employed to suppress multimodal VIVs in the long suspenders. The effectiveness of Stockbridge damper is verified through field application and comparative analysis. Finally, the effect of long suspender VIVs on local deck vibration is discussed, and it is clarified that the bridge deck vibration is mainly caused by multimodal VIVs of the long suspenders, rather than by external loads such as vehicles and wind. The study endeavors to provide a case to progress the identification, assessment, and control of long suspender VIVs in similar long‐span bridges.


  • Vortex-Induced Vibration Performance and Mechanism Analysis of a Suspension Bridge Affected by Water-Filled Barriers

    by Tianyi Lang, Hao Wang, Zhenqing Liu, Zidong Xu, Hui Gao

    The existence of water-filled barriers alters the cross-sectional shape of the main girder, which may lead to vortex-induced vibrations (VIVs) in suspension bridges. However, the mechanism and occurrence conditions of VIVs in the main girder that is affected by water-filled barriers are still unclear. To this end, this study investigates the effect of water-filled barriers on the VIV performance of suspension bridges. The evolution of the vortex structure during one VIV cycle and the corresponding pressure variations, including the average and fluctuating values on the surface, were analyzed. Additionally, the spatiotemporal distribution of the surface pressure was studied using proper orthogonal decomposition (POD). The results show that VIV occurs in the main girder when the height of the water-filled barriers exceeds a threshold value of 0.317. Moreover, a significant negative pressure vortex occurred when the barriers were installed. The vortex underwent the following distinct phases in one VIV cycle: generation, separation, reattachment, and shedding. However, the negative pressure vortex behind the barrier did not vary substantially when the water-filled barriers were installed without VIV. Additionally, the average pressure on the surface of the main girder remained constant regardless of the occurrence of VIVs. In the presence of VIVs, the pressure fluctuations became much more pronounced and were mainly concentrated on the top surface and leading edge of the main girder. Additionally, the dominant modes of the pressure variations correlated with the evolution of the vortices and pressure distribution.