GLGuangfeng Liu

Guangfeng Liu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Guangfeng Liu has a total of 10 co-authors. Here are the top co-authors by number of shared publications:

  • Bo Cai

    PetroChina Research Institute of Petroleum Exploration and Development, Beijing 100083, China

    1 shared publication
  • Daoyong Yang

    Energy Systems Engineering, Faculty of Engineering and Applied Science, University of Regina, Regina, SK S4S 0A2, Canada

    1 shared publication
  • Honglin Lu

    State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation Southwest Petroleum University Chengdu China

    1 shared publication
  • Jun Tang

    School of Geosciences, Yangtze University, Wuhan 430100, China

    1 shared publication
  • Lianhe Wang

    State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation, Southwest Petroleum University, Chengdu, China

    1 shared publication
  • Shimin Liu

    Department of Energy and Mineral Engineering, G3 Center and Energy Institute, Pennsylvania State University, University Park, PA 16802, USA

    1 shared publication

Latest Publications

  • Open Access

    Effect of Stress-Sensitive Fracture Conductivity on Transient Pressure Behavior for a Multi-Well Pad With Multistage Fractures in a Naturally Fractured Tight Reservoir

    by Zhan Meng, Honglin Lu, Xiaohua Tan, Guangfeng Liu, Lianhe Wang, Daoyong Yang

    This paper presents a semianalytical solution for evaluating transient pressure behavior of a multi-well pad with multistage fractures in a naturally fractured tight reservoir by considering the stress-sensitive effect imposed by both natural and hydraulic fractures. More specifically, the model pertaining to matrix/natural fractures is considered as a dual-porosity continuum, while its analytical flow model can be obtained by use of a slab-source function in the Laplace domain. The hydraulic fracture model is solved by discretizing each fracture into small segments to describe the flow behavior, while stress sensitivity in both the natural fracture (NF) subsystem and hydraulic fracture (HF) subsystem has been taken into account. To validate the newly developed semianalytical model, its solution has been obtained and compared with those of a commercial numerical simulator. By generating the type curves, there may exhibit eight flow regimes: pure wellbore storage, skin effect transition flow, linear flow regime within HFs, early radial flow, biradial flow, transition flow, pseudo-steady diffusion, and the late-time pseudo-radial flow. Furthermore, late-time flow regimes are found to be significantly distorted by the multi-well pressure interference. The smaller the well-rate ratio is, the more distorted the pressure and pressure derivative curves will be. In addition, well spacing and fracture length are found to dominate the flow behavior when multi-well pressure interference occurs. As the well spacing is decreased, the fracture length is increased, and thus occurrence of multi-well pressure interference is initiated earlier. Permeability moduli of NFs and HFs impose no impact on the multi-well pressure interference; however, it can distort flow regimes, leading to a severe distortion of pressure and pressure derivative curves. Similarly, the effect of HF permeability modulus on the flow in a hydraulic fracture, the minimum fracture conductivity is another key factor affecting the “hump” on the pressure curve. As the crossflow coefficient is increased, flow exchange between matrix and NFs is increased. With an increase in the storage ratio, flow exchange lasts longer and the second “dip” on the pressure curve becomes deeper.


  • Open Access

    Recovery of Low Permeability Reservoirs Considering Well Shut-Ins and Surfactant Additivities

    by Shuai Li, Jun Tang, Yunhong Ding, Shimin Liu, Guangfeng Liu, Bo Cai

    To investigate the mechanism whereby well shut-ins and surfactant additivities can increase hydrocarbon output after hydraulic fracturing, in this paper, we simulated well shut-ins with one end open (OEO) rock samples and performed a serious of imbibition experiments with different surfactant additivities based on contact angle (CA) and interfacial tension (IFT) measurements. Scanning electron microscope (SEM) and nuclear magnetic resonance (NMR) methods were also been adopted in the detection before and after shut-ins. The results demonstrated that cationic surfactants result in better improving oil recovery (IOR) performance due to their high wettability alteration ability on vertical fracture faces, while different kinds of surfactants have a similar ability in lowering IFT. As for shut-ins duration, the NMR transverse relaxation time (T2) spectrum move towards the left side, indicating that aqueous phases migrate to smaller pores spaces and deeper distances. Aqueous migration during the shut-ins period can remove near-fracture trapped water, while surfactant additivities can accelerate and enhance this process, and these two points are the most direct reasons for the observed hydrocarbon output increases.