Muthanna Jabbar Ahmed
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Muthanna Jabbar Ahmed has a total of 42 co-authors. Here are the top co-authors by number of shared publications:
- Ioannis Anastopoulos
Department of Agriculture, University of Ioannina, UoI Kostakii Campus, 47100 Arta, Greece
6 shared publications - Abdul Amir Hassan Kadhum
Department of Chemical & Process Engineering, Universiti Kebangsaan Malaysia (UKM), Bangi, Selangor 43000, Malaysia
5 shared publications - Samar Kareem Theydan
University of Baghdad
5 shared publications - Abdul Halim Abdul Karim Mohammed
Chemical Engineering Department-College of Engineering-University of Baghdad-Iraq
4 shared publications - Bassim Hamid Hameed
Department of Chemical Engineering, College of Engineering, Qatar University, Doha, Qatar
2 shared publications - Mohammed Danish
Department of Chemistry, Faculty of Science Islamic University of Madinah Madinah Saudi Arabia
2 shared publications
Latest Publications
- Open Access
- 28 October 2026
- Published by MDPI AG in Pollutants
- Vol. 6 (4) , 65
Advances in the Adsorptive Removal of Alizarin Red S from Wastewater: Adsorbents, Mechanisms, Influencing Factors, and Environmental Perspectives
Alizarin Red S (ARS) is a persistent anthraquinone dye whose discharge into aquatic environments represents an important concern due to its chemical stability, intense coloration, and potential ecological impact. Adsorption has emerged as one of the most practical approaches for its removal from aqueous media because of its operational simplicity, adaptability, and compatibility with low-cost and regenerable materials. This review critically examines recent progress in the adsorption of Alizarin Red S using a broad spectrum of adsorbents, including biomass-derived materials, activated carbons, carbon nanotubes, graphene-based systems, polymeric sorbents, metal oxides, metal–organic frameworks, hydrogels, magnetic composites, and hybrid nanostructures. Particular attention is given to the relationship between adsorbent composition, surface chemistry, porosity, functional groups, and adsorption performance. The effects of pH, adsorbent dosage, initial dye concentration, contact time, temperature, and coexisting ions are discussed as key factors controlling dye uptake, equilibrium behavior, and removal efficiency. The reviewed studies indicate that ARS adsorption is commonly governed by electrostatic attraction; hydrogen bonding; π–π interactions; surface complexation; pore diffusion; and, in some systems, dye–metal complex formation. Langmuir and Freundlich isotherms, together with pseudo-second-order kinetics, are the most frequently reported models. Despite significant laboratory-scale advances, challenges remain regarding adsorbent regeneration, selectivity in complex matrices, long-term stability, cost-effective synthesis, and scale-up. Future research should prioritize real wastewater validation, multicomponent systems, circular adsorbent design, computational modeling, machine learning-assisted optimization, and life cycle assessment to support the transition of ARS adsorption technologies toward practical wastewater treatment applications.
- 28 October 2026
- Published by MDPI AG in Pollutants
- Vol. 6 (4) , 65
Open AccessAdvances in the Adsorptive Removal of Alizarin Red S from Wastewater: Adsorbents, Mechanisms, Influencing Factors, and Environmental Perspectives
Alizarin Red S (ARS) is a persistent anthraquinone dye whose discharge into aquatic environments represents an important concern due to its chemical stability, intense coloration, and potential ecological impact. Adsorption has emerged as one of the most practical approaches for its removal from aqueous media because of its operational simplicity, adaptability, and compatibility with low-cost and regenerable materials. This review critically examines recent progress in the adsorption of Alizarin Red S using a broad spectrum of adsorbents, including biomass-derived materials, activated carbons, carbon nanotubes, graphene-based systems, polymeric sorbents, metal oxides, metal–organic frameworks, hydrogels, magnetic composites, and hybrid nanostructures. Particular attention is given to the relationship between adsorbent composition, surface chemistry, porosity, functional groups, and adsorption performance. The effects of pH, adsorbent dosage, initial dye concentration, contact time, temperature, and coexisting ions are discussed as key factors controlling dye uptake, equilibrium behavior, and removal efficiency. The reviewed studies indicate that ARS adsorption is commonly governed by electrostatic attraction; hydrogen bonding; π–π interactions; surface complexation; pore diffusion; and, in some systems, dye–metal complex formation. Langmuir and Freundlich isotherms, together with pseudo-second-order kinetics, are the most frequently reported models. Despite significant laboratory-scale advances, challenges remain regarding adsorbent regeneration, selectivity in complex matrices, long-term stability, cost-effective synthesis, and scale-up. Future research should prioritize real wastewater validation, multicomponent systems, circular adsorbent design, computational modeling, machine learning-assisted optimization, and life cycle assessment to support the transition of ARS adsorption technologies toward practical wastewater treatment applications.
- Open Access
- 30 June 2026
- Published by Iraqi Journal of Chemical and Petroleum Engineering in Iraqi Journal of Chemical and Petroleum Engineering
- Vol. 27 (2) , 77-88
Fixed bed adsorption of nitrate and phosphate nutrients using char prepared by co-pyrolysis of waste tires and date stones
Conversion of waste tires and date stones into char through co-pyrolysis is an effective way to safely remove and recycle these materials. This study tested char as a low-cost adsorbent for removing nitrate and phosphate in fixed-bed systems, offering a way to reuse waste tires and date stones. The effects of inlet pollutant concentration (50, 150, and 300 mg/L), flow rate (5, 10, and 15 ml/min), and bed height (5, 10, and 15 cm) on the adsorption system’s breakthrough were measured. Characteristics of char were analyzed via the Fourier transform of infrared (FTIR), Brunauer-Emmett-Teller (BET), and zeta potential. The fixed-bed analysis demonstrated superior correlation of breakthrough data with both the Yoon-Nelson and Thomas models. Under varying circumstances, the findings agreed with the Yoon-Nelson and Thomas models, as measured by the correlation coefficient R2 values (0.8147-0.9913) for phosphate, (0.9187-0.9913) for nitrate, and (0.8146-0.9907) for phosphate, (0.9189-0.9801) for nitrate, respectively. The results demonstrate the potential of the prepared char as an efficient and sustainable adsorbent for nutrient removal in continuous treatment systems, providing a promising approach for wastewater treatment and waste valorization.
- 30 June 2026
- Published by Iraqi Journal of Chemical and Petroleum Engineering in Iraqi Journal of Chemical and Petroleum Engineering
- Vol. 27 (2) , 77-88
Open AccessFixed bed adsorption of nitrate and phosphate nutrients using char prepared by co-pyrolysis of waste tires and date stones
Conversion of waste tires and date stones into char through co-pyrolysis is an effective way to safely remove and recycle these materials. This study tested char as a low-cost adsorbent for removing nitrate and phosphate in fixed-bed systems, offering a way to reuse waste tires and date stones. The effects of inlet pollutant concentration (50, 150, and 300 mg/L), flow rate (5, 10, and 15 ml/min), and bed height (5, 10, and 15 cm) on the adsorption system’s breakthrough were measured. Characteristics of char were analyzed via the Fourier transform of infrared (FTIR), Brunauer-Emmett-Teller (BET), and zeta potential. The fixed-bed analysis demonstrated superior correlation of breakthrough data with both the Yoon-Nelson and Thomas models. Under varying circumstances, the findings agreed with the Yoon-Nelson and Thomas models, as measured by the correlation coefficient R2 values (0.8147-0.9913) for phosphate, (0.9187-0.9913) for nitrate, and (0.8146-0.9907) for phosphate, (0.9189-0.9801) for nitrate, respectively. The results demonstrate the potential of the prepared char as an efficient and sustainable adsorbent for nutrient removal in continuous treatment systems, providing a promising approach for wastewater treatment and waste valorization.
- 22 January 2026
- Published by Elsevier in Journal of Analytical and Applied Pyrolysis
- Vol. 195
Recent progress on carbonaceous materials and their composites as adsorbents for phenolic pollutants: A review
- 22 January 2026
- Published by Elsevier in Journal of Analytical and Applied Pyrolysis
- Vol. 195
Recent progress on carbonaceous materials and their composites as adsorbents for phenolic pollutants: A review
- Open Access
- 29 October 2025
- Published by Center of Biomass and Renewable Energy Scientia Academy in International Journal of Renewable Energy Development
- Vol. 15 (1) , 1-15
Batch and fixed-bed adsorption of phosphate and nitrate on char derived by the co-pyrolysis of waste tires and corn cobs
The existence of both phosphorus (P) and nitrogen (N) in water can severely affect the aquatic environment by causing eutrophication phenomena. Co-pyrolysis has emerged as a viable thermal technology for converting various solid waste blends into extremely effective char. In this research, the co-pyrolysis of waste tires (WT) and corn cobs (CC) into char and its application as an adsorbent against nitrate and phosphate were investigated. The influence of various variables, including WT/CC blend composition, pyrolysis time, and pyrolysis temperature, on the performance and yield of char was also considered using batch and fixed-bed column tests. The characteristics of the obtained char were evaluated through Brunauer-Emmett-Teller analysis, Fourier transform infrared, and Field emission scanning electron microscopy with energy-dispersive X-ray analysis. Enhanced functioning and adsorption of pollutants were seen in the resulting material when the blend mixture was 25% WT + 75% CC. From the Sips isotherm, which exhibited high R2 values (0.9957, 0.9953) as compared to the Langmuir and the Freundlich isotherms, the maximum adsorption capacities of nitrate and phosphate were 59.19 and 77.23 mg/g, respectively. Two models, one for pseudo-second order and one for pseudo-first order, were used to examine the kinetic data, showing a strong adherence to the former model for the studied pollutants. Also, two popular fixed-bed adsorption models, the Yoon-Nelson and Thomas models, were utilized to match the adsorption data. Under varying circumstances, the findings agreed with the Yoon-Nelson and Thomas models, as measured by the correlation coefficient R2 values (0.8853-0.9946) for phosphate, (0.9463-0.9913) for nitrate, and (0.9658-0.9965) for phosphate, (0.8848-0.9966) for nitrate, respectively.
- 29 October 2025
- Published by Center of Biomass and Renewable Energy Scientia Academy in International Journal of Renewable Energy Development
- Vol. 15 (1) , 1-15
Open AccessBatch and fixed-bed adsorption of phosphate and nitrate on char derived by the co-pyrolysis of waste tires and corn cobs
The existence of both phosphorus (P) and nitrogen (N) in water can severely affect the aquatic environment by causing eutrophication phenomena. Co-pyrolysis has emerged as a viable thermal technology for converting various solid waste blends into extremely effective char. In this research, the co-pyrolysis of waste tires (WT) and corn cobs (CC) into char and its application as an adsorbent against nitrate and phosphate were investigated. The influence of various variables, including WT/CC blend composition, pyrolysis time, and pyrolysis temperature, on the performance and yield of char was also considered using batch and fixed-bed column tests. The characteristics of the obtained char were evaluated through Brunauer-Emmett-Teller analysis, Fourier transform infrared, and Field emission scanning electron microscopy with energy-dispersive X-ray analysis. Enhanced functioning and adsorption of pollutants were seen in the resulting material when the blend mixture was 25% WT + 75% CC. From the Sips isotherm, which exhibited high R2 values (0.9957, 0.9953) as compared to the Langmuir and the Freundlich isotherms, the maximum adsorption capacities of nitrate and phosphate were 59.19 and 77.23 mg/g, respectively. Two models, one for pseudo-second order and one for pseudo-first order, were used to examine the kinetic data, showing a strong adherence to the former model for the studied pollutants. Also, two popular fixed-bed adsorption models, the Yoon-Nelson and Thomas models, were utilized to match the adsorption data. Under varying circumstances, the findings agreed with the Yoon-Nelson and Thomas models, as measured by the correlation coefficient R2 values (0.8853-0.9946) for phosphate, (0.9463-0.9913) for nitrate, and (0.9658-0.9965) for phosphate, (0.8848-0.9966) for nitrate, respectively.
- 29 May 2024
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 406
A comprehensive review of barley crop-based materials as adsorbents for the removal of aquatic pollutants
- 29 May 2024
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 406
A comprehensive review of barley crop-based materials as adsorbents for the removal of aquatic pollutants
- 20 February 2024
- Published by Elsevier in Environmental Research
- Vol. 250
Insight into the wheat residues-derived adsorbents for the remediation of organic and inorganic aquatic contaminants: A review
- 20 February 2024
- Published by Elsevier in Environmental Research
- Vol. 250
Insight into the wheat residues-derived adsorbents for the remediation of organic and inorganic aquatic contaminants: A review
- 16 January 2024
- Published by Elsevier in Environmental Research
- Vol. 247, 118203
Recent progress on tobacco wastes–derived adsorbents for the remediation of aquatic pollutants: A review
- 16 January 2024
- Published by Elsevier in Environmental Research
- Vol. 247, 118203
Recent progress on tobacco wastes–derived adsorbents for the remediation of aquatic pollutants: A review
- 6 December 2023
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 394
A comprehensive review on adsorption of Reactive Red 120 dye using various adsorbents
- 6 December 2023
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 394
A comprehensive review on adsorption of Reactive Red 120 dye using various adsorbents