LSLi Sun

Li Sun

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Li Sun has a total of 38 co-authors. Here are the top co-authors by number of shared publications:

  • Ming Xu

    Shaanxi University Key Laboratory of Photonic Power Devices and Discharge Regulation, Xi’an University of Technology

    8 shared publications
  • Ruidong Lv

    Shaanxi University Key Laboratory of Photonic Power Devices and Discharge Regulation, Xi’an University of Technology

    5 shared publications
  • Wei Jiang

    Huazhong University of Science and Technology

    3 shared publications
  • Zeng-Yao Li

    Key Laboratory of Thermo-Fluid and Science and Engineering, Ministry of Education, School of Energy and Power Engineering, Xi'an Jiaotong University , Xi'an 710049

    3 shared publications
  • Hao Wu

    School of Electronics and Information Engineering, Hubei University of Science and Technology, Xianning 437100, People’s Republic of China

    2 shared publications
  • Kun Qu

    School of Optoelectronic Science and Intelligent Instrumentation and Shaanxi University Key Laboratory of Photonic Power Devices and Discharge Regulation, Xi’an University of Technology

    2 shared publications

Latest Publications

  • Carrier Transport Characteristics of Vanadium-Doped 4H-SiC PCSS Under Broad-Spectrum Composite Light Excitation

    by Hao Song, Ming Xu, Ruidong Lv, Yiwen Zhang, Li Sun, Miao Li, Jiuxin Wang, Yanan Wu, Yunxiang Tian

  • Effect of external circuit on the self-bias of capacitively coupled plasma driven by tailored voltage waveforms

    by Junbao Zhan, Yue Zhao, Zili Chen, Hao Wu, Ran An, Li Sun, Shali Yang, Wei Jiang

    In this work, the influences of the direct current blocking capacitor, stray capacitance, and stray resistance in the external circuit on the self-bias driven by tailored voltage waveform (TVW)-driven asymmetric capacitive discharges are investigated using a one-dimensional three-velocity particle-in-cell/Monte Carlo collision model coupled with an external circuit. Under a zero-initial-phase sinusoidal TVW drive with an amplitude ratio of 3:2:1, a dc self-bias voltage is generated and can be significantly modulated by the blocking capacitor, stray resistance, and stray capacitance. The approximate adjustment ranges of each external circuit parameter, as well as an optimized combination of circuit parameters under specific discharge conditions are presented. Based on bias control using a single external component, combined control of multiple external circuit parameters enables a wider tuning range of plasma density, ion flux, and ion energy at the boundary. In addition, the mechanisms responsible for the formation of positive and negative self-bias voltages at different pressures are discussed. These results may provide insight and a theoretical reference for the engineering design of bias control in electrical asymmetric capacitively coupled plasma systems.

  • Numerical simulation of Paschen's curve in Low pressure rf-driven capacitive discharge based on particle-in-cell/Monte Carlo algorithm

    by Liuxiu He, Zihao Ren, Jiahao Huang, Ran An, Hua Chen, Shali Yang, Li Sun, Wei Jiang, Hao Wu, Ya Zhang

    A computational method based on the particle-in-cell/Monte Carlo (PIC/MC) algorithm is developed to simulate the breakdown characteristics of low-pressure, radio-frequency (RF) driven capacitive discharges. The simulation framework incorporates key procedures such as initialization, breakdown determination, and a voltage–pressure scanning strategy, enabling efficient and accurate calculation of breakdown curves. To balance reliability and computational cost, a combined criterion based on electron avalanche growth and critical electron density is adopted for breakdown identification. Using this approach, breakdown curves under different electron surface emission conditions are investigated, revealing clear boundary effects. The results indicate that ion-induced secondary electron emission (SEE) primarily influences the high-voltage region of the curve, whereas electron-induced SEE and reflection coefficients significantly extend the breakdown region toward lower pressures and voltages. Furthermore, increases in driving frequency and gap distance both substantially expand the low-pressure breakdown region, with the drift-diffusion branch becoming more pronounced. At frequencies beyond a certain threshold, the low-pressure breakdown curve transitions from closed to open, accompanied by a voltage span exceeding 100V — a behavior associated with the transition from RF-driven plasma to multipactor discharge under sub-millitorr conditions. In the high-pressure, high-voltage regime, the breakdown behavior remains consistent with Paschen’s law, while the drift-diffusion branch exhibits clear scaling with gap distance.

  • Comprehensive multi-physics modeling of thermally sustained microdischarges at atmospheric pressure: A coupled PIC/MCC–DSMC approach

    by Pengze Xiao, Xiandi Li, Li Sun, Bocong Zheng, Wei Jiang, Hongyu Wang, Ya Zhang

    Optimization of microfluidic plasma devices hinges on accurate characterization of microscale plasma–fluid–thermal coupling, a process that cannot be reliably captured by traditional single-timescale models. Here, we develop a novel self-consistent model that couples particle-in-cell/Monte Carlo collision, direct simulation Monte Carlo, and thermal conduction modules, each operating on its own tailored timescale. This model enables 1 s steady-state simulations of atmospheric-pressure direct current argon microdischarges in a 100-μm gap with a hot tungsten cathode. Quantitative results reveal that inter-electrode gas thermal conduction (1.6×106 W m−2) plays a dominant role in governing the system energy balance, thermal state of the neutral gas, and overall discharge dynamics. A 30 K drop in cathode temperature (from 2400 to 2370 K) leads to a 14% decrease in discharge current and a 68% increase in plasma dynamic resistance. We demonstrate that time-resolved gas–electrode thermal interactions govern transient plasma dynamics and device thermal management, while also showing that conventional models with fixed temperature assumptions introduce non-negligible errors in predicting key plasma parameters. This coupled model provides a robust numerical framework for the design and optimization of thermally sustained microdischarge devices.

  • Extrinsic Dual-Beam Triggering for Enhanced Photoconductivity in GaAs PCSS

    by Chun Liu, Ming Xu, Shengtao Chen, Ruidong Lv, Li Sun, Kun Qu, Mi Pang

    The limited utilization efficiency of extrinsic triggering remains a major constraint on the performance of GaAs photoconductive semiconductor switches (PCSS). In this work, the transient output characteristics of a single opposed-contact GaAs PCSS under extrinsic dual-beam synchronous triggering are investigated, assuming uniform optical energy splitting. Measurements within the 2-3.5 kV bias range indicate that dual-beam triggering effectively enhances the output pulse amplitude compared with single-beam triggering. Specifically, at a bias voltage of 3 kV, the amplitude reaches approximately 2.73-fold that of the single-beam case. Simulated spatial distributions of photogeneration rate and current density further reveal the underlying mechanism of enhanced photoconductivity with dual-beam triggering. These results offer valuable insights into optimizing the triggering strategy to enhance the efficiency and performance of GaAs PCSS under extrinsic triggering.


  • Uniform Current Density and Thermal Distribution in Vanadium-Doped 4H-SiC PCSS Based on Dual-Beam Synchronous Excitation

    by Shengtao Chen, Ming Xu, Ruidong Lv, Li Sun, Rujun Liu, Mi Pang, Zhuo Dai

    The mitigation of current crowding and the improvement of thermal distribution uniformity are of great significance for the high-power applications of silicon carbide photoconductive semiconductor switches (SiC PCSSs). The transient output characteristics of a vanadium-doped 4H-SiC PCSS with a vertical electrode structure were investigated by changing the optical path of the 532 nm pulse laser beam. Furthermore, a multiphysics-coupled model was established to simulate the distribution of current density and heat generation within the PCSS during conduction. The results indicate that dual-pulse laser beam (dual-beam) synchronous excitation significantly reduces the peak current density and temperature at the electrode-semiconductor-insulator triple point, promotes a more uniform distribution of these parameters within the substrate, and does so without compromising the transient output characteristics of the PCSS.

  • Photon Absorption Effects on the Transient Carrier Dynamics in High-Purity 4H-SiC PCSS

    by Shengtao Chen, Ming Xu, Ruidong Lv, Li Sun, Liang Zhou, Fengjuan Wang, Wei Wang

    Photon absorption is a key factor for the transient output characteristics of silicon carbide photoconductive semiconductor switch (SiC PCSS), which is determined by the effective photo flux in the substrate. A high-purity 4H-SiC PCSS with a 1 mm gap is excited by a 532 nm laser pulse from different laser incidence planes. The results show that the output amplitude of the PCSS under the side trigger at 70 kV/cm is about 3.1 kV, which is 1.82 and 1.26 times higher than that of the front and back, respectively. Furthermore, 3D simulation indicates that the number of photo-generated carriers under the side trigger is one order of magnitude higher than that of the front and back. The efficient utilization and rapid enhancement of the electric fields make it exhibit better spatio-temporal characteristics during carrier transport processes.


  • A Coulomb collision model based on collision cross section and its effects on kinetic characteristics of atmospheric thermal microplasmas

    by Li Sun, Ming Xu, Zeng-Yao Li

    Coulomb collisions are important transport processes of charged particles and should not be neglected in atmospheric thermal microplasmas due to the high density of charged particles. However, there have been a few attempts at Coulomb collisions in atmospheric thermal microplasmas, and it is still unclear how to couple Coulomb collisions between different charged particles with collisions between charged particles and neutral atoms. This work proposes a Coulomb collision model based on the collision cross section, which is more computationally efficient than the typical Nanbu model and TA (Takizuka and Abebinary) model by reproducing the anisotropic electron–electron collision process. Then, the effects of Coulomb collision on the kinetic parameters and electron dynamics of atmospheric thermal microplasmas are investigated by coupling the implicit particle in cell and Monte Carlo collision (PIC MCC) method. It is found that the existence of electron–electron and electron–ion collisions reduces the particle number density in the bulk-plasma region. The electron–electron collisions are stronger than the electron–ion collisions and the ion–ion collisions can be ignored. The Coulomb collisions increase the dispersion of electron energy in the high-energy region.


  • Numerical Simulation of Kinetic Characteristics of Thermal Emission-Driven Argon Microarc Discharge at Atmospheric Pressure

    by Li Sun, Ming Xu, Xian-Pin Sun, Zeng-Yao Li

    Recent studies have shown that the thermal emission from the cathode plays a crucial role in the basic research on microarc discharge. In this work, a 1-D implicit particle-in-cell coupled with the Monte Carlo collision (PIC-MCC) method is adopted to simulate thermal emission-driven microarc discharge at atmospheric pressure. Two thermal emission models—thermionic emission (TE) model and thermofield emission (TFE) model—are applied to contrast and analyze the particle transport phenomena of thermal microplasma. Considering that the local electric field near the cathode affects the current densities and ionization can create sufficient space charge to modify the electric field, different current densities at the cathode and their contribution to the total current densities are evaluated under various conditions, including cathode temperatures ( T $_{\text{C}}$ $=$ 2500 $\sim$ 3500 K), applied voltages ( U $=$ 1 $\sim$ 30 V), and gap sizes ( d $=$ 10 $\sim$ 100 $\mu$ m). The electric field, maximum number density, and spatially averaged temperature of charged particles are also examined to study the interaction between thermal emission and discharge physics. Furthermore, the effects of secondary electron emission are analyzed to accurately predict electron emission in the microarc discharge. The results indicate the difference between thermal microplasma generated by TE and TFE becomes more pronounced as the gap size decreases, the cathode temperature increases, and the applied voltage increases due to the enhanced field emission (FE). In addition, gas breakdown occurs at a relatively lower voltage of 17 V for the two emission models because of the ion-enhancement effect. There exists a maximum at d $=$ 30 $\mu$ m in current density at the cathode due to the difference between collision mean free path of electron and gap sizes. Besides, the secondary electron emission becomes more pronounced at higher cathode temperatures and larger secondary electron emission coefficients.