Dyaga Bharath
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Dyaga Bharath has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
Balaiah Shanigaram
Catalysis and Fine Chemicals Department CSIR‐Indian Institute of Chemical Technology Hyderabad Telangana India
2 shared publications- Narendra Reddy Chereddy
Crop Protection Chemicals Division, CSIR-Indian Institute of Chemical Technology, Hyderabad-500007, India
2 shared publications - Vaidya Jayathirtha Rao
CSIR–Indian Institute of Chemical Technology
2 shared publications Antoine Lemaire
Institute Charles Sadron, UPR022 CNRS – University of Strasbourg, 23 rue du loess, 67034 Strasbourg, France
1 shared publication- Bruno Schmaltz
Laboratoire de Physico-Chimie des Matériaux et des Electrolytes Pour l’Energie (PCM2E) EA6299, Université de Tours, 37200 Tours, France
1 shared publication - Ejjurothu Appalanaidu
Fluoro‐Agro Chemicals Division CSIR‐Indian Institute of Chemical Technology Hyderabad Telangana India
1 shared publication
Latest Publications
- 14 November 2023
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 11 (47) , 16554-16562
Impact of the dopant location in the semi-crystalline structure of alternated donor–acceptor copolymers on the polarity switching p → n mechanism
Strong p-type doping of alternated donor–acceptor copolymers induces p → n polarity switching upon progressive band filling, the change of polarity coinciding with the maximum of charge conductivity. This study uncovers the role of the dopant's location in the semi-crystalline structure of the conjugated polymer on the mechanism of polarity switching in highly aligned polymer films of two alternated donor–acceptor copolymers. Using a combination of transmission electron microscopy and polarized UV-vis-NIR spectroscopy, the polarity switching is only observed when the dopants are present in both the crystalline and the amorphous domains of the polymer. This is observed for dopants such as FeCl3. In strong contrast, the dopant magic blue is not able to induce polarity switching because the dopants are not intercalated into the crystals but only in the amorphous phase of the polymer semiconductors. The precise location of dopants in the semi-crystalline structure of a polymer semiconductor is therefore a handle to induce or not the polarity switch and to tune the thermoelectric and charge transport properties of doped polymer semiconductors.
- 14 November 2023
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 11 (47) , 16554-16562
Impact of the dopant location in the semi-crystalline structure of alternated donor–acceptor copolymers on the polarity switching p → n mechanism
Strong p-type doping of alternated donor–acceptor copolymers induces p → n polarity switching upon progressive band filling, the change of polarity coinciding with the maximum of charge conductivity. This study uncovers the role of the dopant's location in the semi-crystalline structure of the conjugated polymer on the mechanism of polarity switching in highly aligned polymer films of two alternated donor–acceptor copolymers. Using a combination of transmission electron microscopy and polarized UV-vis-NIR spectroscopy, the polarity switching is only observed when the dopants are present in both the crystalline and the amorphous domains of the polymer. This is observed for dopants such as FeCl3. In strong contrast, the dopant magic blue is not able to induce polarity switching because the dopants are not intercalated into the crystals but only in the amorphous phase of the polymer semiconductors. The precise location of dopants in the semi-crystalline structure of a polymer semiconductor is therefore a handle to induce or not the polarity switch and to tune the thermoelectric and charge transport properties of doped polymer semiconductors.
- Open Access
- 7 December 2020
- Published by Wiley in Nano Select
- Vol. 2 (3) , 549-560
Non‐fullerene all small molecule OBHJSCs with profound device characteristics
In this work, we have reported two donor materials ONAF and SNAF that complement the widely used non‐fullerene acceptor ITIC, with the aim to develop non‐fullerene all small molecule organic bulk heterojunction solar cells (NF‐ASM‐OBHJSCs). Two small molecule donors A‐D‐D'‐D‐A architecture, namely ONAF and SNAF are synthesized and explored their ability to act as donor material along with the ITIC acceptor. Benzodithiophene (BDT) is used as central donor unit (dialkoxy‐BDT for ONAF and Dialkylthiophene‐BDT for SNAF) along with novel naphthodithiophene (NDT) terminal donor to improve light harvesting and charge conducting ability of the donor materials. N‐Butylrhodanine is employed as terminal acceptor to enhance the intramolecular charge transfer (ICT) and to place energy level of the donor materials. Both the small molecule donor materials have good thermal stability, broad and intense absorption displayed in the UV‐vis region with energy levels suitable for ITIC acceptor. NF‐ASM‐OBHJSCs are fabricated by using all small molecules (ONAF & SNAF) as donors and ITIC as acceptor. OBHJSCs based on SNAF displayed superior photovoltaic properties with power conversion efficiency (PCE) as 9.94 % (Jsc = 15.93 mA cm‐2, Voc = 0.96 V and FF = 0.65) compared to ONAF based devices with PCE as 7.48 % (Jsc = 14.93 mA cm‐2, Voc = 0.82 V and FF = 0.61). The substantial high PCE of SANF is attributed to the broad absorption, relatively well‐matched HOMO‐LUMO energy levels between SNAF – ITIC acceptor, better film morphology for efficient charge transport and exciton dissociation at donor/acceptor (D‐A) junction. The observed PCE is one of the best reported for the NDT‐BDT‐based all small molecule non‐fullerene OBHJSCs. Moreover, simplicity in the device fabrication procedures and low energy loss associated are added advantages with the SNAF based devices. We predict that the HOMO‐LUMO levels (CV) of D/A falling in this category, as in Figure S7, with further close energy levels will have implications on the efficiency of OBHJSCs.
- 7 December 2020
- Published by Wiley in Nano Select
- Vol. 2 (3) , 549-560
Open AccessNon‐fullerene all small molecule OBHJSCs with profound device characteristics
In this work, we have reported two donor materials ONAF and SNAF that complement the widely used non‐fullerene acceptor ITIC, with the aim to develop non‐fullerene all small molecule organic bulk heterojunction solar cells (NF‐ASM‐OBHJSCs). Two small molecule donors A‐D‐D'‐D‐A architecture, namely ONAF and SNAF are synthesized and explored their ability to act as donor material along with the ITIC acceptor. Benzodithiophene (BDT) is used as central donor unit (dialkoxy‐BDT for ONAF and Dialkylthiophene‐BDT for SNAF) along with novel naphthodithiophene (NDT) terminal donor to improve light harvesting and charge conducting ability of the donor materials. N‐Butylrhodanine is employed as terminal acceptor to enhance the intramolecular charge transfer (ICT) and to place energy level of the donor materials. Both the small molecule donor materials have good thermal stability, broad and intense absorption displayed in the UV‐vis region with energy levels suitable for ITIC acceptor. NF‐ASM‐OBHJSCs are fabricated by using all small molecules (ONAF & SNAF) as donors and ITIC as acceptor. OBHJSCs based on SNAF displayed superior photovoltaic properties with power conversion efficiency (PCE) as 9.94 % (Jsc = 15.93 mA cm‐2, Voc = 0.96 V and FF = 0.65) compared to ONAF based devices with PCE as 7.48 % (Jsc = 14.93 mA cm‐2, Voc = 0.82 V and FF = 0.61). The substantial high PCE of SANF is attributed to the broad absorption, relatively well‐matched HOMO‐LUMO energy levels between SNAF – ITIC acceptor, better film morphology for efficient charge transport and exciton dissociation at donor/acceptor (D‐A) junction. The observed PCE is one of the best reported for the NDT‐BDT‐based all small molecule non‐fullerene OBHJSCs. Moreover, simplicity in the device fabrication procedures and low energy loss associated are added advantages with the SNAF based devices. We predict that the HOMO‐LUMO levels (CV) of D/A falling in this category, as in Figure S7, with further close energy levels will have implications on the efficiency of OBHJSCs.
- 14 October 2015
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 5 (115) , 94859-94865
A detailed study on the thermal, photo-physical and electrochemical properties and OFET applications of D–π–A–π–D structured unsymmetrical diketopyrrolopyrrole materials
A series of seven unsymmetrical diketopyrrolopyrrole (DPP) derivatives with donor–pi–acceptor–pi–donor (D–π–A–π–D) architecture have been designed, synthesized and well characterised. The effect of the electron donating capacity and extent of electronic conjugation of the end-capping units on the thermal, photo-physical and electrochemical properties of the synthesized materials was thoroughly investigated using various experimental techniques and theoretical calculations. Organic field-effect transistors (OFETs) were fabricated using these materials to obtain their hole/electron transporting characteristics. All these materials showed moderate to good hole transporting ability, and the OFET fabricated using the DPP-derivative with benzofuran and pyrene end groups exhibited a hole mobility of 6.7 × 10−4 cm2 V−1 s−1 with VT of −9 V. The observed photo-physical, electrochemical, thermal, and charge carrier properties of the synthesized DPP-derivatives indicated their applicability in various areas like organic photovoltaics, disposable electronics and biomedical devices.
- 14 October 2015
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 5 (115) , 94859-94865
A detailed study on the thermal, photo-physical and electrochemical properties and OFET applications of D–π–A–π–D structured unsymmetrical diketopyrrolopyrrole materials
A series of seven unsymmetrical diketopyrrolopyrrole (DPP) derivatives with donor–pi–acceptor–pi–donor (D–π–A–π–D) architecture have been designed, synthesized and well characterised. The effect of the electron donating capacity and extent of electronic conjugation of the end-capping units on the thermal, photo-physical and electrochemical properties of the synthesized materials was thoroughly investigated using various experimental techniques and theoretical calculations. Organic field-effect transistors (OFETs) were fabricated using these materials to obtain their hole/electron transporting characteristics. All these materials showed moderate to good hole transporting ability, and the OFET fabricated using the DPP-derivative with benzofuran and pyrene end groups exhibited a hole mobility of 6.7 × 10−4 cm2 V−1 s−1 with VT of −9 V. The observed photo-physical, electrochemical, thermal, and charge carrier properties of the synthesized DPP-derivatives indicated their applicability in various areas like organic photovoltaics, disposable electronics and biomedical devices.