Jie Song
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Jie Song has a total of 41 co-authors. Here are the top co-authors by number of shared publications:
Danxi Liang
China Electric Power Research Institute Beijing China
2 shared publicationsGuizhi Xu
China Electric Power Research Institute Beijing China
2 shared publicationsShaojie Ke
China Electric Power Research Institute Beijing China
2 shared publicationsYanmin Zu
China Electric Power Research Institute Beijing China
2 shared publicationsZheng Zong
China Electric Power Research Institute Beijing China
2 shared publications- Asad Mujeeb
Department of Electrical Engineering, Tsinghua University, Beijing, China
1 shared publication
Latest Publications
- 18 October 2026
- Published by Wiley in Fuel Cells
- Vol. 26 (5)
Online Net‐Power‐Optimal Air Supply Control With Per‐Interval Prescribed Performance for PEMFC Systems Under Uncertainty
Existing air supply control approaches for proton exchange membrane fuel cell (PEMFC) systems calibrate the optimal oxygen excess ratio (OER) offline and apply it as a reference trajectory for online tracking, which fails to compensate for net power degradation caused by stack aging, membrane humidity variation, or stack temperature fluctuation. Therefore, this paper proposes a novel air supply control method with prescribed performance and online net power optimization for the PEMFC system. First, a prescribed‐time observer is designed to provide accurate OER estimation within a guaranteed convergence time window. Second, an adaptive reference governor is developed to correct the nominal OER reference online, with the calibration‐referenced net power deviation serving as one of the correction‐enabling conditions, without requiring gradient computation or perturbation injection. Third, a per‐interval reset prescribed performance controller is constructed via a two‐step backstepping procedure, and the performance boundary can be re‐initialized at each load transient event to prevent controller singularity under repeated load steps. The hardware‐in‐the‐loop (HIL) experimental results demonstrate that the mean net power achieved by the proposed method increased by 4.67% compared to the traditional one under simulated stack‐aging conditions, no boundary violations throughout all HIL tests, and robust control performance under parameter perturbations.
- 18 October 2026
- Published by Wiley in Fuel Cells
- Vol. 26 (5)
Online Net‐Power‐Optimal Air Supply Control With Per‐Interval Prescribed Performance for PEMFC Systems Under Uncertainty
Existing air supply control approaches for proton exchange membrane fuel cell (PEMFC) systems calibrate the optimal oxygen excess ratio (OER) offline and apply it as a reference trajectory for online tracking, which fails to compensate for net power degradation caused by stack aging, membrane humidity variation, or stack temperature fluctuation. Therefore, this paper proposes a novel air supply control method with prescribed performance and online net power optimization for the PEMFC system. First, a prescribed‐time observer is designed to provide accurate OER estimation within a guaranteed convergence time window. Second, an adaptive reference governor is developed to correct the nominal OER reference online, with the calibration‐referenced net power deviation serving as one of the correction‐enabling conditions, without requiring gradient computation or perturbation injection. Third, a per‐interval reset prescribed performance controller is constructed via a two‐step backstepping procedure, and the performance boundary can be re‐initialized at each load transient event to prevent controller singularity under repeated load steps. The hardware‐in‐the‐loop (HIL) experimental results demonstrate that the mean net power achieved by the proposed method increased by 4.67% compared to the traditional one under simulated stack‐aging conditions, no boundary violations throughout all HIL tests, and robust control performance under parameter perturbations.
- Top Cited Papers
- 5 May 2026
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 238
Adaptive model predictive control for PEM electrolysis system with pre-regulated temperature and pressure approach
- 5 May 2026
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 238
Top Cited PapersAdaptive model predictive control for PEM electrolysis system with pre-regulated temperature and pressure approach
- 23 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Transportation Electrification
- Vol. 10 (3) , 7443-7455
Remaining-Useful-Lifetime Prediction of Proton Exchange Membrane Fuel Cell Considering Model Uncertainty Quantification on the Full-Time Scale
A prognostics and health management (PHM) system with prediction at its core optimizes the durability of the proton exchange membrane fuel cell (PEMFC). However, the aging behavior model has some uncertainty due to limited knowledge, affecting the predictive performance in remaining useful life (RUL) prediction. To address this issue, an RUL prediction method based on the Bayesian framework considering uncertainty quantification on the full-time scale is proposed. Firstly, the state of health (SOH) of the PEMFC is estimated, and the behavior of uncertainty is quantified. Afterwards, a long short-term memory (LSTM) neural network is employed to make a prediction for its behavior. Finally, the RUL of PEMFC is predicted based on historical SOH and the predicted behavior of uncertainty. Validation indicates that the proposed method can make a long-term prediction and provide RUL prediction with high accuracy. Under the dynamic operating condition, in terms of long-term prediction, compared to unscented Kalman filter, adaptive unscented Kalman filter, double-input-echo-state-network and bidirectional LSTM, the proposed method decreases the error by 88.12%, 41.99%, 13.82% and 3.21%, respectively. And under the dynamic operating condition, the proposed method shows good stability. Moreover, the robustness of this method has also been verified.
- 23 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Transportation Electrification
- Vol. 10 (3) , 7443-7455
Remaining-Useful-Lifetime Prediction of Proton Exchange Membrane Fuel Cell Considering Model Uncertainty Quantification on the Full-Time Scale
A prognostics and health management (PHM) system with prediction at its core optimizes the durability of the proton exchange membrane fuel cell (PEMFC). However, the aging behavior model has some uncertainty due to limited knowledge, affecting the predictive performance in remaining useful life (RUL) prediction. To address this issue, an RUL prediction method based on the Bayesian framework considering uncertainty quantification on the full-time scale is proposed. Firstly, the state of health (SOH) of the PEMFC is estimated, and the behavior of uncertainty is quantified. Afterwards, a long short-term memory (LSTM) neural network is employed to make a prediction for its behavior. Finally, the RUL of PEMFC is predicted based on historical SOH and the predicted behavior of uncertainty. Validation indicates that the proposed method can make a long-term prediction and provide RUL prediction with high accuracy. Under the dynamic operating condition, in terms of long-term prediction, compared to unscented Kalman filter, adaptive unscented Kalman filter, double-input-echo-state-network and bidirectional LSTM, the proposed method decreases the error by 88.12%, 41.99%, 13.82% and 3.21%, respectively. And under the dynamic operating condition, the proposed method shows good stability. Moreover, the robustness of this method has also been verified.
- 13 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Network Science and Engineering
- Vol. 11 (6) , 5526-5537
Exploring Carbon Equilibrium in Integrated Electricity–Hydrogen System
Global carbon emissions from electricity and hydrogen production have grown rapidly in recent years. Some existing literature has proposed the method of reducing carbon emissions by power-to-hydrogen (P2H) technology. However, due to the fossil-based energy structure of electricity system, excessive electricity to hydrogen may lead to an increase in carbon emissions. To reduce carbon emissions effectively, a low carbon-driven optimal capacity configuration method for P2Hs is proposed in this paper to explore carbon equilibrium in integrated electricity-hydrogen system. A joint economic dispatch model for integrated electricity-hydrogen system is formulated. The electricity system model is a security-constrained economic dispatch model with P2H constraints. The hydrogen system model is a hydrogen supply chain model with pipeline pack constraints and Weymouth equation, whose sources are fossil fuel reforming and electrolytic hydrogen. We propose a second-order cone programming (SOCP)-based solution to transform the hydrogen system model into a mixed integer second order cone programming (MISCOP), which can be readily solved by commercial solvers. To preserve the internal information of each system, a decentralized algorithm based on optimality condition decomposition (OCD) is developed. Case study based on modified IEEE 30-bus and Belgium 20-node integrated energy system demonstrates the effectiveness of the proposed strategy.
- 13 June 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Network Science and Engineering
- Vol. 11 (6) , 5526-5537
Exploring Carbon Equilibrium in Integrated Electricity–Hydrogen System
Global carbon emissions from electricity and hydrogen production have grown rapidly in recent years. Some existing literature has proposed the method of reducing carbon emissions by power-to-hydrogen (P2H) technology. However, due to the fossil-based energy structure of electricity system, excessive electricity to hydrogen may lead to an increase in carbon emissions. To reduce carbon emissions effectively, a low carbon-driven optimal capacity configuration method for P2Hs is proposed in this paper to explore carbon equilibrium in integrated electricity-hydrogen system. A joint economic dispatch model for integrated electricity-hydrogen system is formulated. The electricity system model is a security-constrained economic dispatch model with P2H constraints. The hydrogen system model is a hydrogen supply chain model with pipeline pack constraints and Weymouth equation, whose sources are fossil fuel reforming and electrolytic hydrogen. We propose a second-order cone programming (SOCP)-based solution to transform the hydrogen system model into a mixed integer second order cone programming (MISCOP), which can be readily solved by commercial solvers. To preserve the internal information of each system, a decentralized algorithm based on optimality condition decomposition (OCD) is developed. Case study based on modified IEEE 30-bus and Belgium 20-node integrated energy system demonstrates the effectiveness of the proposed strategy.
- 29 November 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 3221-3225
An economic evaluation model for user-side energy storage considering uncertainties of demand response
The key commercialization of user-side energy storage is to quantify the economic benefits of energy storage considering all kinds of battery application scenarios. To solve this problem, the economic evaluation model for user-side energy storage considering uncertainties of demand response is proposed. Firstly, the principle of user side energy storage configuration is put forward based on diversified requirements of different users. Then, the economic evaluation model of user-side energy storage is established respecting multiple battery application scenarios, while Latin hypercube sampling is conducted to address the uncertain impact of demand response revenue. Moreover, the specific economic measure of user-side energy storage is developed. Lastly, a case is presented to demonstrate the effectiveness of this model.
- 29 November 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 3221-3225
An economic evaluation model for user-side energy storage considering uncertainties of demand response
The key commercialization of user-side energy storage is to quantify the economic benefits of energy storage considering all kinds of battery application scenarios. To solve this problem, the economic evaluation model for user-side energy storage considering uncertainties of demand response is proposed. Firstly, the principle of user side energy storage configuration is put forward based on diversified requirements of different users. Then, the economic evaluation model of user-side energy storage is established respecting multiple battery application scenarios, while Latin hypercube sampling is conducted to address the uncertain impact of demand response revenue. Moreover, the specific economic measure of user-side energy storage is developed. Lastly, a case is presented to demonstrate the effectiveness of this model.
- 1 June 2012
- Published by IOP Publishing in Chinese Physics B
- Vol. 21 (6) , 066106
Growth characteristics of amorphous-layer-free nanocrystalline silicon films fabricated by very high frequency PECVD at 250°C
- 1 June 2012
- Published by IOP Publishing in Chinese Physics B
- Vol. 21 (6) , 066106
Growth characteristics of amorphous-layer-free nanocrystalline silicon films fabricated by very high frequency PECVD at 250°C
- 17 September 2009
- Published by Springer Nature in Applied Physics A
- Vol. 98 (2) , 455-460
Electronic properties of LiMn2−x Ti x O4
- 17 September 2009
- Published by Springer Nature in Applied Physics A
- Vol. 98 (2) , 455-460
Electronic properties of LiMn2−x Ti x O4