Alberto Marcuzzi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Alberto Marcuzzi has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
- Matteo Meneghini
University of Padova
6 shared publications - Carlo De Santi
University of Padova
4 shared publications - Enrico Zanoni
University of Padova
4 shared publications - Gaudenzio Meneghesso
University of Padova
4 shared publications - Davide Favero
Information Engineering, University of Padua, Via Gradenigo 6/b, Padova, Padova, 35121, ITALY
2 shared publications G. Meneghesso
University of Padua
2 shared publications
Latest Publications
- 1 August 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 73 (8) , 4804-4808
Modeling Leakage Current Variations Starting From Threshold Voltage Shift in SiC MOSFETs Submitted to Positive Gate Stress
- 1 August 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 73 (8) , 4804-4808
Modeling Leakage Current Variations Starting From Threshold Voltage Shift in SiC MOSFETs Submitted to Positive Gate Stress
- Open Access
- 1 December 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (21)
720 V quasi-vertical GaN-on-silicon p–n diodes with surge capability fabricated using selective area growth
This work demonstrates, for the first time, avalanche breakdown capability in quasi-vertical gallium nitride (GaN) on silicon (Si) substrates employing localized epitaxial growth. On industry-standard 200 mm wafers, we integrated an 8 μm thick GaN drift layer onto Si, enabling the fabrication of 720 V quasi-vertical p–n diodes. This method yields high-performance power devices in CMOS-compatible cleanrooms at a reduced cost. The GaN p–n junctions exhibit a specific on-resistance of 3.3 mΩ cm2, a current on/off ratio exceeding 1010, and a current density of 1.4 kA/cm2 at 10 V. Robust avalanche behavior was confirmed through temperature-dependent reverse bias measurements from 298 to 373 K, and over 3000 over-voltage surge ruggedness was demonstrated by unclamped inductive switching stress tests. These results underscore the advantages of localized epitaxy for achieving high-quality GaN layers on Si, paving the way for scalable integration of high-voltage GaN power devices with conventional Si technology.
- 1 December 2025
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 138 (21)
Open Access720 V quasi-vertical GaN-on-silicon p–n diodes with surge capability fabricated using selective area growth
This work demonstrates, for the first time, avalanche breakdown capability in quasi-vertical gallium nitride (GaN) on silicon (Si) substrates employing localized epitaxial growth. On industry-standard 200 mm wafers, we integrated an 8 μm thick GaN drift layer onto Si, enabling the fabrication of 720 V quasi-vertical p–n diodes. This method yields high-performance power devices in CMOS-compatible cleanrooms at a reduced cost. The GaN p–n junctions exhibit a specific on-resistance of 3.3 mΩ cm2, a current on/off ratio exceeding 1010, and a current density of 1.4 kA/cm2 at 10 V. Robust avalanche behavior was confirmed through temperature-dependent reverse bias measurements from 298 to 373 K, and over 3000 over-voltage surge ruggedness was demonstrated by unclamped inductive switching stress tests. These results underscore the advantages of localized epitaxy for achieving high-quality GaN layers on Si, paving the way for scalable integration of high-voltage GaN power devices with conventional Si technology.
- Top Cited PapersOpen Access
- 10 January 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 71 (3) , 1344-1355
Review and Outlook on GaN and SiC Power Devices: Industrial State-of-the-Art, Applications, and Perspectives
We present a comprehensive review and outlook of silicon carbide (SiC) and gallium nitride (GaN) transistors available on the market for current and next-generation power electronics. Material properties and structural differences among GaN and SiC devices are first discussed. Based on the analysis of different commercially available GaN and SiC power transistors, we describe the state-of-the-art of these technologies, highlighting the preferential power conversion topologies and the key characteristics of each technological platform. Current and future fields of application for GaN and SiC devices are also reviewed. The article also reports on the main reliability aspects related to both technologies. For GaN HEMTs, threshold voltage stability, dynamic ON-resistance, and breakdown limitation are described, whereas for SiC MOSFETs the analysis also focuses on gate oxide failure and short-circuit (SC) robustness. Finally, we give an overview on the perspective of such materials in different fields of interest. An indication of possible future improvements and developments for both technologies is drawn. The requirements for hybrid converters, along with a careful optimization of performance and the use of innovative optimization tools, are underlined.
- 10 January 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 71 (3) , 1344-1355
Top Cited PapersOpen AccessReview and Outlook on GaN and SiC Power Devices: Industrial State-of-the-Art, Applications, and Perspectives
We present a comprehensive review and outlook of silicon carbide (SiC) and gallium nitride (GaN) transistors available on the market for current and next-generation power electronics. Material properties and structural differences among GaN and SiC devices are first discussed. Based on the analysis of different commercially available GaN and SiC power transistors, we describe the state-of-the-art of these technologies, highlighting the preferential power conversion topologies and the key characteristics of each technological platform. Current and future fields of application for GaN and SiC devices are also reviewed. The article also reports on the main reliability aspects related to both technologies. For GaN HEMTs, threshold voltage stability, dynamic ON-resistance, and breakdown limitation are described, whereas for SiC MOSFETs the analysis also focuses on gate oxide failure and short-circuit (SC) robustness. Finally, we give an overview on the perspective of such materials in different fields of interest. An indication of possible future improvements and developments for both technologies is drawn. The requirements for hybrid converters, along with a careful optimization of performance and the use of innovative optimization tools, are underlined.
- Open Access
- 27 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 71 (3) , 1561-1566
Correlating Interface and Border Traps With Distinctive Features of C–V Curves in Vertical Al2O3/GaN MOS Capacitors
In this article, we present an analysis of the correlation between interface traps (ITs) and border traps (BTs) on distinctive features of C – V curves in vertical Al $_{\text{2}}$ O $_{\text{3}}$ /gallium-nitride (GaN) MOS capacitors. First, pulsed C – V curves were characterized during the application of quiescent gate bias stresses of different magnitudes and signs. This characterization revealed four main distinctive features: 1) rightward rigid shift; 2) leftward rigid shift; 3) decrease of the $\Delta$ C – $\Delta$ V slope; and 4) formation of a hump in a gate bias range before the accumulation of electrons at the oxide/semiconductor interface. By means of a combined experimental/simulation analysis, these features were univocally attributed to specific ITs or BTs in the overall trap distribution. The simulation-aided analysis enhances the physical understanding of the C – V curves features and increases the dependability of the adopted IT measurement technique, allowing for a more rapid process optimization and device technology development.
- 27 November 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 71 (3) , 1561-1566
Open AccessCorrelating Interface and Border Traps With Distinctive Features of C–V Curves in Vertical Al2O3/GaN MOS Capacitors
In this article, we present an analysis of the correlation between interface traps (ITs) and border traps (BTs) on distinctive features of C – V curves in vertical Al $_{\text{2}}$ O $_{\text{3}}$ /gallium-nitride (GaN) MOS capacitors. First, pulsed C – V curves were characterized during the application of quiescent gate bias stresses of different magnitudes and signs. This characterization revealed four main distinctive features: 1) rightward rigid shift; 2) leftward rigid shift; 3) decrease of the $\Delta$ C – $\Delta$ V slope; and 4) formation of a hump in a gate bias range before the accumulation of electrons at the oxide/semiconductor interface. By means of a combined experimental/simulation analysis, these features were univocally attributed to specific ITs or BTs in the overall trap distribution. The simulation-aided analysis enhances the physical understanding of the C – V curves features and increases the dependability of the adopted IT measurement technique, allowing for a more rapid process optimization and device technology development.
- 17 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
GaN-on-Si Power HEMTs for Automotive: Current Status and Perspectives
In this paper we present a comprehensive review and outlook of gallium nitride power devices for next-generation power electronics, with focus on the emerging automotive field. The analysis of different markets available GaN-on-Si HEMTs will draw the present state of this technology for power applications and automotive, highlighting the different available topologies and their key characteristics, together with a comparison with Si and SiC. Furthermore, we will investigate the present and future of GaN devices in the different building blocks composing an automotive system (power train inverter, on board charger, off board charger, DC/DC converters, ADAS, infotainment). In the end, we will highlight the present reliability issues and limits of GaN-on-Si power devices (threshold voltage instabilities, dynamic on-resistance, breakdown limitation).
- 17 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
GaN-on-Si Power HEMTs for Automotive: Current Status and Perspectives
In this paper we present a comprehensive review and outlook of gallium nitride power devices for next-generation power electronics, with focus on the emerging automotive field. The analysis of different markets available GaN-on-Si HEMTs will draw the present state of this technology for power applications and automotive, highlighting the different available topologies and their key characteristics, together with a comparison with Si and SiC. Furthermore, we will investigate the present and future of GaN devices in the different building blocks composing an automotive system (power train inverter, on board charger, off board charger, DC/DC converters, ADAS, infotainment). In the end, we will highlight the present reliability issues and limits of GaN-on-Si power devices (threshold voltage instabilities, dynamic on-resistance, breakdown limitation).