Zhiqiang Zhu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Zhiqiang Zhu has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Ding He
Aerospace Information Research Institute, Chinese Academy of Sciences, Beijing, China
3 shared publications - Cheng Tan
Aerospace Information Research Institute, Chinese Academy of Sciences, Beijing 100190, China
2 shared publications - Jie Chen
Institute of Remote Sensing, Naval Submarine Academy, Qingdao 266000, China
2 shared publications - Kaiyuan Du
Aerospace Information Research Institute, Chinese Academy of Sciences, Beijing 100190, China
2 shared publications - Pu Cheng
Navy Submarine Academy, Qingdao 266000, China
2 shared publications - Zhentao Yu
Naval Submarine Academy, Qingdao 266000, China
2 shared publications
Latest Publications
- Open Access
- 28 February 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (3) , 332
Modified Broadband Ruthroff-Type Transmission Line Transformer Balun for Isolation-Enhanced Passive Mixer Design
Generalized broadband operation facilitates multifunction or multiband highly integrated applications, such as modern transceiver systems, where ultra-wideband bidirectional passive mixers are favored to avoid a complex up/down-conversion scheme. In this paper, a modified Ruthroff-type transmission line transformer (TLT) balun is presented to enhance the isolation of the mixer from the local oscillator (LO) to the radio frequency (RF). Compared to the conventional methods, the proposed Ruthroff-type architecture adopts a combination of shunt capacitors and parallel coupled lines to improve the return loss at the LO port, thus effectively avoiding the area consumption for the diode-to-balun impedance transformation while simultaneously providing a suitable point for IF extraction. In addition, a parallel compensation technique consisting of an inductor and resistor is applied to the RF balun to significantly improve the amplitude/phase balance performance over a wide bandwidth. Benefiting from the aforementioned operations, an isolation-enhanced 8–30 GHz passive double-balanced mixer is designed as a proof-of-principle demonstration via 0.15-micrometer GaAs p-HEMT technology. It exhibits ultra-broadband performance with 7 dB average conversion loss and 50 dB LO-to-RF isolation under 15 dBm LO power. The monolithic microwave integrated circuit area is 0.96 × 1.68 mm2 including all pads.
- 28 February 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (3) , 332
Open AccessModified Broadband Ruthroff-Type Transmission Line Transformer Balun for Isolation-Enhanced Passive Mixer Design
Generalized broadband operation facilitates multifunction or multiband highly integrated applications, such as modern transceiver systems, where ultra-wideband bidirectional passive mixers are favored to avoid a complex up/down-conversion scheme. In this paper, a modified Ruthroff-type transmission line transformer (TLT) balun is presented to enhance the isolation of the mixer from the local oscillator (LO) to the radio frequency (RF). Compared to the conventional methods, the proposed Ruthroff-type architecture adopts a combination of shunt capacitors and parallel coupled lines to improve the return loss at the LO port, thus effectively avoiding the area consumption for the diode-to-balun impedance transformation while simultaneously providing a suitable point for IF extraction. In addition, a parallel compensation technique consisting of an inductor and resistor is applied to the RF balun to significantly improve the amplitude/phase balance performance over a wide bandwidth. Benefiting from the aforementioned operations, an isolation-enhanced 8–30 GHz passive double-balanced mixer is designed as a proof-of-principle demonstration via 0.15-micrometer GaAs p-HEMT technology. It exhibits ultra-broadband performance with 7 dB average conversion loss and 50 dB LO-to-RF isolation under 15 dBm LO power. The monolithic microwave integrated circuit area is 0.96 × 1.68 mm2 including all pads.
- Open Access
- 30 December 2023
- Published by MDPI AG in Micromachines
- Vol. 15 (1) , 84
A 10–20 GHz 6-Bit High-Accuracy Digital Step Attenuator with Low Insertion Loss in 0.15 µm GaAs p-HEMT Technology
In a beamforming circuit for a modern broadband phased-array system, high accuracy and compactness have received sufficient attention as they are directly related to side lobe level and fabrication cost, respectively. In order to meet the low phase error required, this paper proposed an ultra-broadband 6-bit digital step switched-type attenuator (STA) with capacitive/inductive compensation networks. Compared to the conventional methods, the proposed technique employs an improved simplified T-structure with capacitive compensation networks, which simultaneously achieves low insertion loss and high-accuracy amplitude/phase control. In addition, on-chip level shifting circuit is integrated to avoid complex control schemes. The strategy of prioritizing return loss is adopted to alleviate the performance degradation caused by impedance mismatch after cascade. As a proof-of-principle demonstration, a wideband 6-bit STA with core area of only 0.5 mm × 1.8 mm was designed via 0.15-micrometer GaAs pHEMT technology. It exhibits ultra-broadband operation with a 31.5 dB amplitude tuning range and a 0.5 dB tuning step. The insertion loss of the reference state is 4–5.3 dB. The return loss is better than 15 dB for all the 64 states. The RMS amplitude and phase errors are less than 0.2 dB and 2° over the 10 to 20 GHz.
- 30 December 2023
- Published by MDPI AG in Micromachines
- Vol. 15 (1) , 84
Open AccessA 10–20 GHz 6-Bit High-Accuracy Digital Step Attenuator with Low Insertion Loss in 0.15 µm GaAs p-HEMT Technology
In a beamforming circuit for a modern broadband phased-array system, high accuracy and compactness have received sufficient attention as they are directly related to side lobe level and fabrication cost, respectively. In order to meet the low phase error required, this paper proposed an ultra-broadband 6-bit digital step switched-type attenuator (STA) with capacitive/inductive compensation networks. Compared to the conventional methods, the proposed technique employs an improved simplified T-structure with capacitive compensation networks, which simultaneously achieves low insertion loss and high-accuracy amplitude/phase control. In addition, on-chip level shifting circuit is integrated to avoid complex control schemes. The strategy of prioritizing return loss is adopted to alleviate the performance degradation caused by impedance mismatch after cascade. As a proof-of-principle demonstration, a wideband 6-bit STA with core area of only 0.5 mm × 1.8 mm was designed via 0.15-micrometer GaAs pHEMT technology. It exhibits ultra-broadband operation with a 31.5 dB amplitude tuning range and a 0.5 dB tuning step. The insertion loss of the reference state is 4–5.3 dB. The return loss is better than 15 dB for all the 64 states. The RMS amplitude and phase errors are less than 0.2 dB and 2° over the 10 to 20 GHz.
- Open Access
- 29 August 2023
- Published by MDPI AG in Micromachines
- Vol. 14 (9) , 1692
Compact Bandwidth-Enhanced 180-Degree Phase Shifter Using Edge-Coupled Multi-Microstrip and Artificial Transmission Line
Compactness has obtained sufficient importance in wideband phase shifter design considerations, as it is directly related to fabrication cost. In this paper, a novel structure was presented to create compact broadband 180-degree phase shifter, which has the advantages of enhanced bandwidth and significantly reduced chip area. The proposed configuration consists of edge-coupled multi-microstrip lines (ECMML) and an artificial transmission line (ATL) with dual-shorted inductors, both of which have the periodic shunt load of capacitors. The ECMML can provide a high coupling coefficient, leading to an increase in the bandwidth, while the introduced capacitors can greatly reduce the line length (35.8% of the conventional method). To verify the relevant mechanisms, a wideband switched network with compact dimensions of 0.67 × 0.46 mm2 was designed via 0.15-micrometer GaAs pHEMT technology. Combined with the measured switch transistor, it was shown that the proposed phase shifter exhibits an insertion loss of less than 2 dB, a return loss of greater than 12 dB, a maximum phase error of less than 0.6° and a channel amplitude difference of less than 0.1 dB in the range of 10 to 20 GHz.
- 29 August 2023
- Published by MDPI AG in Micromachines
- Vol. 14 (9) , 1692
Open AccessCompact Bandwidth-Enhanced 180-Degree Phase Shifter Using Edge-Coupled Multi-Microstrip and Artificial Transmission Line
Compactness has obtained sufficient importance in wideband phase shifter design considerations, as it is directly related to fabrication cost. In this paper, a novel structure was presented to create compact broadband 180-degree phase shifter, which has the advantages of enhanced bandwidth and significantly reduced chip area. The proposed configuration consists of edge-coupled multi-microstrip lines (ECMML) and an artificial transmission line (ATL) with dual-shorted inductors, both of which have the periodic shunt load of capacitors. The ECMML can provide a high coupling coefficient, leading to an increase in the bandwidth, while the introduced capacitors can greatly reduce the line length (35.8% of the conventional method). To verify the relevant mechanisms, a wideband switched network with compact dimensions of 0.67 × 0.46 mm2 was designed via 0.15-micrometer GaAs pHEMT technology. Combined with the measured switch transistor, it was shown that the proposed phase shifter exhibits an insertion loss of less than 2 dB, a return loss of greater than 12 dB, a maximum phase error of less than 0.6° and a channel amplitude difference of less than 0.1 dB in the range of 10 to 20 GHz.