Wencan Ma
Research Subjects
Wencan Ma has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
Haomin Wu
Key Laboratory of High-Performance Polymer Material and Technology of MOE, Department of Polymer Science and Engineering, School of Chemistry and Chemical Engineering, Nanjing University, Nanjing 210023, P. R. China
3 shared publications- Qiuhong Zhang
School of Chemistry and Chemical Engineering Nanjing University Nanjing China
3 shared publications Guigan Fang
2 shared publicationsTeng Long
2 shared publicationsXudong Jia
State Key Laboratory of Coordination Chemistry Nanjing University Nanjing P. R. China
2 shared publicationsYifeng Cai
Key Laboratory of High-Performance Polymer Material and Technology of MOE, Department of Polymer Science and Engineering, School of Chemistry and Chemical Engineering, Nanjing University, Nanjing 210023, P. R. China
2 shared publications
Latest Publications
- 19 May 2026
- Published by Wiley in Macromolecular Rapid Communications
- p. e70308
Rapid Self‐Healing Polyurethane Elastomer Based on Ionic Aggregation for Triboelectric Nanogenerator
Self‐healing materials are urgently needed in the electronics due to their ability to significantly extend product lifespan and reduce maintenance costs. However, achieving a balance between self‐healing efficiency and mechanical properties remains a challenge. To overcome the challenge, a rapid self‐healing polyurethane (IL‐PU) is proposed on the basis of introducing dynamic ionic exchange method. To realize the method, hydroxyl‐functionalized carboxylic acid and hydroxyl‐functionalized imidazolium salts are introduced into the linear polyurethane system as chain extenders, resulting in imidazolium and carboxyl groups hanging from the main chain and work as stickers. In IL‐PU regime of polyurethane matrix, the nano aggregates formed between imidazolium and carboxylate groups serve as physical crosslinking sites. These dynamic interactions allow the continuous rearrangement of the network at room temperature. It is shown that an increase in the content and length of imidazolium alkyl chain could also promote the self‐healing ability. Based on self‐healing elastomer (IL‐PU), a triboelectric nanogenerator (IL‐PU‐TENG) was fabricated, with an open circuit voltage (Voc) of 200 V, and a power density of 3.07 W·m−2, demonstrating outstanding electron‐donating ability. Moreover, even after cutting, the output performance of IL‐PU‐TENG could rapidly recover within 2 h at 40°C.
- 19 May 2026
- Published by Wiley in Macromolecular Rapid Communications
- p. e70308
Rapid Self‐Healing Polyurethane Elastomer Based on Ionic Aggregation for Triboelectric Nanogenerator
Self‐healing materials are urgently needed in the electronics due to their ability to significantly extend product lifespan and reduce maintenance costs. However, achieving a balance between self‐healing efficiency and mechanical properties remains a challenge. To overcome the challenge, a rapid self‐healing polyurethane (IL‐PU) is proposed on the basis of introducing dynamic ionic exchange method. To realize the method, hydroxyl‐functionalized carboxylic acid and hydroxyl‐functionalized imidazolium salts are introduced into the linear polyurethane system as chain extenders, resulting in imidazolium and carboxyl groups hanging from the main chain and work as stickers. In IL‐PU regime of polyurethane matrix, the nano aggregates formed between imidazolium and carboxylate groups serve as physical crosslinking sites. These dynamic interactions allow the continuous rearrangement of the network at room temperature. It is shown that an increase in the content and length of imidazolium alkyl chain could also promote the self‐healing ability. Based on self‐healing elastomer (IL‐PU), a triboelectric nanogenerator (IL‐PU‐TENG) was fabricated, with an open circuit voltage (Voc) of 200 V, and a power density of 3.07 W·m−2, demonstrating outstanding electron‐donating ability. Moreover, even after cutting, the output performance of IL‐PU‐TENG could rapidly recover within 2 h at 40°C.
- 18 September 2024
- Published by Royal Society of Chemistry (RSC) in Polymer Chemistry
- Vol. 15 (44) , 4529-4541
Single-ion quasi-solid-state electrolytes based on sulfonimide-functionalized covalent organic framework
The COF based SIQSSEs with a high ionic conductivity of 4.3 × 10 −4 S cm −1 , a high LTN of 0.90. A high initial capacity (150.3 mA h g −1 ), high retention (99% after 100 cycles), good cycling stability and rate performance in Li/LFP battery test.
- 18 September 2024
- Published by Royal Society of Chemistry (RSC) in Polymer Chemistry
- Vol. 15 (44) , 4529-4541
Single-ion quasi-solid-state electrolytes based on sulfonimide-functionalized covalent organic framework
The COF based SIQSSEs with a high ionic conductivity of 4.3 × 10 −4 S cm −1 , a high LTN of 0.90. A high initial capacity (150.3 mA h g −1 ), high retention (99% after 100 cycles), good cycling stability and rate performance in Li/LFP battery test.
- 21 December 2023
- Published by Elsevier in Chemical Engineering Journal
- Vol. 480
High performance polydimethylsiloxane elastomer for triboelectric nanogenerators in extreme environment
- 21 December 2023
- Published by Elsevier in Chemical Engineering Journal
- Vol. 480
High performance polydimethylsiloxane elastomer for triboelectric nanogenerators in extreme environment
Bamboo Inspired Silicon Anodes with Ultrahigh Initial Coulombic Efficiency and High Capacity for the Li‐Ion Batteries
Silicon is regarded as the most promising candidate due to its ultrahigh theoretical energy density (4200 mAh g−1). However, the large volume expansion of silicon nanoparticles would result in the destruction of electrodes and a shortened cycle lifetime. Here, inspired by the natural structure of bamboo, the silicon anode with vascular bundle‐like structure is proposed to improve the electrochemical performance for the first time. The dense channel wall in the silicon anode can accommodate the volume change of silicon nanoparticles and the transport of ions and electrons is also enhanced. The obtained silicon anodes display excellent mechanical properties (50% compression resilience and the average peel force of 4.34 N) and good wettability. What more, the silicon anodes exhibit high initial coulombic efficiency (94.5%), excellent cycle stability (2100 mAh g−1 after 300 cycles) which stands out among the silicon anodes. Specially, the silicon anode with impressive areal capacity of 36.36 mAh cm−2 and initial coulombic efficiency of 84% is also achieved. This work offers a novel and efficient strategy for the preparation of the flexible electrodes with outstanding performance.
Bamboo Inspired Silicon Anodes with Ultrahigh Initial Coulombic Efficiency and High Capacity for the Li‐Ion Batteries
Silicon is regarded as the most promising candidate due to its ultrahigh theoretical energy density (4200 mAh g−1). However, the large volume expansion of silicon nanoparticles would result in the destruction of electrodes and a shortened cycle lifetime. Here, inspired by the natural structure of bamboo, the silicon anode with vascular bundle‐like structure is proposed to improve the electrochemical performance for the first time. The dense channel wall in the silicon anode can accommodate the volume change of silicon nanoparticles and the transport of ions and electrons is also enhanced. The obtained silicon anodes display excellent mechanical properties (50% compression resilience and the average peel force of 4.34 N) and good wettability. What more, the silicon anodes exhibit high initial coulombic efficiency (94.5%), excellent cycle stability (2100 mAh g−1 after 300 cycles) which stands out among the silicon anodes. Specially, the silicon anode with impressive areal capacity of 36.36 mAh cm−2 and initial coulombic efficiency of 84% is also achieved. This work offers a novel and efficient strategy for the preparation of the flexible electrodes with outstanding performance.