Zhangang Zhang

Aiming at the significant needs of flexible DC converter valve applications in high-altitude areas, we investigate the effect of atmospheric neutrons on the failure rate of key core power devices in three kinds of converter valves, namely IGBTs, thyristors, and diodes. The safe working voltage boundary of the devices is obtained, and the failure rate caused by atmospheric neutrons in the real working environment of the power devices is calculated according to the results of the ground-accelerated irradiation test of atmospheric neutrons and the atmospheric neutron environment under the actual working conditions. The test results show that the failure rate of IGBTs, thyristors, and diodes caused by atmospheric neutrons is greatly affected by the blocking voltage, and the larger the blocking voltage is, the higher the failure rate of the device is. The research results can provide a basis for the design of the operating voltage of key core power devices of flexible DC converter valves and guide the evaluation of the failure rate and engineering design of the electronic system of DC ultra-high-voltage power transmission and transformation converter stations in the high-altitude environment of the Qinghai-Tibet Plateau.

This paper investigates the temperature-dependent effects of gamma-ray irradiation on β-Ga₂O₃ vertical Schottky barrier diodes (SBDs) under a 100 V reverse bias condition at a total dose of 1 Mrad(Si). As the irradiation dose increased, the radiation damage became more severe. The total ionizing dose (TID) degradation behavior and mechanisms were evaluated through DC, capacitance–voltage (C-V), and low-frequency noise (LFN) measurements by varying irradiation, and the test results indicated that TID effects introduced interface defects and altered the carrier concentration within the material. The impact of TID effects was more pronounced at lower temperatures compared to higher temperatures. Additionally, the annealing effect in the high-temperature experimental conditions ameliorated the growth of interface trap defects caused by irradiation. These results suggest that compared to low-temperature testing, the device exhibits higher TID tolerance after high-temperature exposure, providing valuable insights for in-depth radiation reliability studies on subsequent related devices.

In this article, the effects of high-energy proton irradiation on top-gate graphene field-effect transistors (GFETs) were investigated by using 20 MeV protons. The basic electrical parameters of the top-gate GFETs were measured before and after proton irradiation with a fluence of 1 × 10¹¹ p/cm² and 5 × 10¹¹ p/cm², respectively. Decreased saturation current, increased Dirac sheet resistance, and negative drift in the Dirac voltage in response to proton irradiation were observed. According to the transfer characteristic curves, it was found that the carrier mobility was reduced after proton irradiation. The analysis suggests that proton irradiation generates a large net positive charge in the gate oxide layer, which induces a negative drift in the Dirac voltage. Introducing defects and increased impurities at the gate oxide/graphene interface after proton irradiation resulted in enhanced Coulomb scattering and reduced mobility of the carriers, which in turn affects the Dirac sheet resistance and saturation current. After annealing at room temperature, the electrical characteristics of the devices were partially restored. The results of the technical computer-aided design (TCAD) simulation indicate that the reduction in carrier mobility is the main reason for the degradation of the electrical performance of the device. Monte Carlo simulations were conducted to determine the ionization and nonionization energy losses induced by proton incidence in top-gate GFET devices. The simulation data show that the ionization energy loss is the primary cause of the degradation of the electrical performance.