SVSandra De Vries

Sandra De Vries

*This is an algorithmically generated author record based on publicly available information.

Sandra De Vries has a total of 26 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Exploring the urban effect on humidity using crowdsourced data

    by Emil Severiens, Arjan Droste, Sandra De Vries, Marjolein Van Esch, Remko Uijlenhoet

    Improving our understanding of the behaviour of near-surface atmospheric properties will help us prepare for changing climatic conditions. Especially in cities, where human health risk is concentrated, and where surfaces present a radical departure from natural conditions. Research shows that air temperature is relatively high in cities as a consequence of the urban heat island effect, increasing the risk of heat stress. Humidity too affects human thermal perception and is altered by the urban environment. The urban effect on near-surface atmospheric humidity, however, is not nearly as well studied as the urban effect on air temperature.Studies of the urban effect on humidity primarily compare measurements in proximate but contrasting urban and rural locations, aiming to establish the existence and behaviour of an urban moisture excess/deficit (also known as the urban moisture island effect). This has yet to be done with crowdsourced data. Unlike traditional stationary data collection methods, crowdsourced data is both temporally and spatially dense. Using quality controlled data from privately operated weather stations may therefore allow for a better representation of the heterogeneous urban environment than previously possible for studies of the urban effect on humidity.From a network of personal weather stations managed by the DelftMeet citizen science project, we used 35 stations in an area of 17.5 km2 in Delft, the Netherlands. Each weather station measured inter alia air temperature, relative humidity, and air pressure approximately every 5 minutes. These measurements were aggregated to 15 minute averages and used to calculate vapour pressure values for assessing the urban moisture excess/deficit. The measurement campaign ran for a period of 24 months from 01/10/2023 to 30/09/2025. Excluding missing values this left approximately 2,379,282 vapour pressure values with which to conduct comparisons with rural reference data. Although the analysis is yet to be finalised, initial results show a slight moisture deficit in Delft compared to its surroundings. This deficit does seem to persist throughout the day and throughout the year, however. Such a stable but weak moisture deficit would certainly be uncommon.

  • Open Access

    Develop A Citizen Science Toolbox for Change in the Danube Basin Ecosystem 

    by Sandra Vries, Felix Gajdusek

    Imagine that you run a museum along the Danube. You know that the Danube and its ecosystem play an important role in the area and for the people that live there. You would like to involve these people in an active way in the ecosystem recovery of the Danube and its basin, aiming to increase and change their awareness and knowledge. But how?At this point the EU Horizon project DANUBE4all (https://www.danube4allproject.eu/) may step in, dedicated to developing a strategic Danube Basin Restoration Action Plan in close collaboration with stakeholders, by fostering Citizen Science as an element in community co-design. It will be able to trigger the change by integrating action on environmental concerns with social and economic wellbeing; embracing a science-to-people approach that actively integrates public interests and empowers all Danube basin inhabitants and communities to monitor the change in the ecosystem around the Danube.For this, we are working on a Citizen Science Toolbox, a changemaker that can be used by communities, CSOs, museums, nature parks, and many other organizations in the Danube basin. We will share the set-up of this toolbox, which will consist of a decision tree of options of (existing) citizen science monitoring tools, programs, apps, and methods useful to contribute to ecosystem restoration. The decision tree will guide these museums and other community groups to choose what level of involvement they want and how they make use of the tools and methods. Next to that, there will be a sensor multi-tool connection kit for water quality monitoring added, where we assist people in how to make use of existing low-cost sensors, what quality they have, and what fitness for use. We focus in this Toolbox not only on the technical knowledge that these museums and their participants need, but also on how to relate to the actual need within the basin, and to connect them to researchers, research questions, and make it so that their collected citizen science data becomes valuable for the ecosystem restoration in the Danube Delta. To connect them to sustainable monitoring and research in the basin like for example the Join Danube Survey that is already organized along the Danube and where scientists collaborate to monitor the river status.

  • Open Access

    The Delft Measures Recipe: how to implement a similar citizen science project in other cities

    by Sandra Vries, Arjan Droste

    The Dutch citizen science project Delft Measures (https://bit.ly/DelftMeasures) focuses on the collaboration between citizens, local institutions, and NGOs to map the weather and changing climate in the city of Delft. It has been running for 4 years, during which citizens of Delft measure long-term changes in rainfall patterns, temperature, and now also soil moisture in their private gardens. Currently, there are over 45 of the Alecto WS5500 citizen-science weather stations spread across neighborhoods in Delft, capturing rainfall variability in different urban microclimates. But in the past years, more than 100 different inhabitants have already been engaged and have helped to collect data.The data is used by a diverse number of organizations like the National Meteorological Institute, the Delft University of Technology and the Delft Municipality, to answer different scientific, engineering, or policy questions. We collaborate with multiple NGOs in project execution. Considering the diverse interests of all stakeholders, the project addresses a variety of goals from education to improving climate adaptation to implementing open science practices.All in all, the project grew into a successful co-creation between many different partners. Delft Measures has been growing and changing and it managed to reach a consistent base of enthusiastic citizens that support the goals of the project, engaging them in making changes in the city for climate change adaptation. For Delft, as a city below sea level, this means a better drainage network to deal with the larger showers of summer rain, while retaining water during longer periods of drought. By setting up secure collaborations with the municipality and university, the data citizens collect is used as direct input for the (future) efficiency of the municipality’s city-wide sewer and drainage network. For the university, this is valuable for education and research into how city infrastructure influences local weather patterns and the variability of rainfall, to understand better where high-intensity rainfall events will have the highest effect. Currently, such high spatial resolution on rainfall in cities is scarce. Additionally, the project functions as a case study for the university’s Open Science program, aiming to evaluate the implementation of open science practices in local citizen science projects, while NGOs invested in climate change adaptation in the city roll up their sleeves to help citizens make the practical changes needed for our new climate.We are currently in the process of writing down the ‘recipe’ of Delft Measures, to help other cities implement similar projects and not to have to reinvent the wheel. We would like to share this recipe during this session, where we will answer questions such as how we manage to collect useful information and increase community involvement and awareness, what kind of participatory approaches we implemented to facilitate community involvement, how we tackle legitimate concerns about potential data biases, inaccuracies and how we ensure the long-term sustainability of the project.

  • Open Access

    Assessing the quality of citizen-science rainfall data based on station setup

    by Arjan Droste, Marchien Boonstra, Marie-Claire Ten Veldhuis, Marit Bogert, Marc Schleiss, Sandra De Vries

    The Delft Measures Rain Citizen-Science programme has been running for several years in the city of Delft, the Netherlands. Within this programme, interested citizens can apply to receive a low-cost Alecto WS5500 weather station, to measure local meteorological parameters in their own garden. Currently there are over 45 of these citizen-science weather stations spread across neighbourhoods in Delft, capturing rainfall variability in different urban microclimates. However, the scientific quality of these specific stations has never been tested, and from previous work we know that rigorous quality assurance is necessary in order to get meaningful (precipitation) data. Thus we have installed 8 Alecto stations in The Green Village outdoors urban climate field lab at the TU Delft. Stations have been explicitly installed in ways that a citizen might do: slightly tilted, next to a wall (simulating the limited open garden space of a Dutch urban residence), on top of a shed as well as free-standing. These different measurement setups, combined with a row of stations installed in the same way right next to one another, allow us to investigate the bias caused by less-than-ideal station installation, as well as systematic errors related to the tipping bucket mechanism and sensor drifts. Initial results show a general overestimation of the Alecto compared to reference stations and radar observations, and a discernible negative bias caused by sheltering effects of plants and, to a lesser extent by walls.

  • Open Access

    Evaluating Participant Outcomes in the Weather Monitoring Citizen Science Project “Delft Meet Regen”

    by Jordy Janssen, Marit Bogert, Margaret Gold, Sandra De Vries

    Understanding the outcomes and impacts achieved in citizen science (CS) initiatives is essential for evaluating and enhancing participatory research practices. There is increasing attention paid in the literature to the broad range of benefits experienced by participants in CS initiatives. While existing frameworks provide structured guidance for the evaluation of participant outcomes, they might overlook nuanced participant experiences. This study explores outcomes reported by participants from the Delft Meet Regen (Delft Measures Rain, DMR) project, a CS initiative focused on environmental monitoring. Using semi-structured qualitative interviews to inductively collect participant outcomes, we applied a combination of the Individual Learning Outcomes (ILO) and Impact Domain (ID) frameworks to reflect on these outcomes with participants. Participants reported meaningful experiences such as a sense of contribution, increased awareness of rainfall patterns, and strengthened feelings of pre-existing environmental stewardship. These outcomes did not neatly align with predefined categories of the ILO and ID frameworks, and this illustrates the complexity of evaluating participant outcomes. Our findings highlight the value of integrating inductive qualitative methods within structured evaluations. By sharing these findings, we aim to support the continued development of comprehensive evaluation tools that fully capture the complex experiences of citizen scientists.


  • Open Access

    Implementing Citizen Science within Open Science: Identifying Extra-Academic Skills, Collaborations, Rewards and Recognitions in the Context of a University

    by J.M. Bogert, Sandra De Vries, Sabine Kunst, Nicoleta Nastase, Winke Kloosterman, Karen Knols, Marc Schleiss, Femke Werkman

    What should a university do to support citizen science initiatives within an open science context, and to assist and facilitate researchers in performing effective citizen science? Delft University of Technology (TU Delft) has developed an open science program that includes, among other projects, citizen science. However, performing citizen science is not a straightforward task. For the people designing and managing citizen science projects, it demands appropriate knowledge, understanding, and experience of the field, as well as knowledge of the practical implementation of citizen science and open science. This requires a deeper understanding of which extra-academic skills, collaborations, rewards, and recognitions are needed for a citizen science project. Therefore, we used a local, hydrological citizen science project, “Delft Measures Rain,” as a case-study, implementing citizen science methods and the TU Delft Open Science principles. By means of this case-study, we identify key tools and facilitation needs to assist researchers within TU Delft to perform effective citizen science and open science. This paper shows how the various stakeholders (i.e., researchers, citizens, civil servants, and NGO’s) can benefit from performing participatory research implementing citizen science and open science principles. We list 10 key elements, encompassing tools, facilitation, and infrastructures that universities can provide for their researchers to stimulate and support the implementation and execution of successful, legally sound, and open citizen science. This case study shows that with appropriate and extra-academic knowledge, tools, collaborations, rewards, and recognitions, citizen science can deliver what it promises and be of great value to universities and open science in general.

  • Open Access

    Time-resolved and multifactorial profiling in single cells resolves the order of heterochromatin formation events during X-chromosome inactivation

    by Samy Kefalopoulou, Pim M. J. Rullens, Kim L. de Luca, Sandra S. de Vries, Tessy Korthout, Alexander van Oudenaarden, Peter Zeller, Jop Kind

    The regulation of gene expression is governed at multiple levels of chromatin organization. However, how coordination is achieved remains relatively unexplored. Here we present Dam&ChIC, a method that enables time-resolved and multifactorial chromatin profiling at high resolution in single cells. Analysis of genome-lamina interactions in haploid cells reveals highly dynamic spatial repositioning of small domains during interphase and partial inheritance over mitosis. Dam&ChIC applied to study random X-inactivation uncovers that spreading of H3K27me3 on the inactive X chromosome (Xi) overlaps with remarkable genome-lamina detachment. We find that genome-lamina detachment precedes H3K27me3 accumulation on the Xi and occurs upon mitotic exit. Domains that retain genome-lamina interactions are marked by high pre-existing H3K9me3 levels. These findings imply an important role for genome-lamina interactions in regulating H3K27me3 accumulation on the Xi. We anticipate that Dam&ChIC will be instrumental in unraveling the interconnectivity and order of chromatin events underlying cell-state changes in single cells.


  • Implementing Citizen Science within Open Science: Identifying Extra-Academic Skills, Collaborations, Rewards and Recognitions in the Context of a University

    by M. Bogert, Sandra De Vries, Sabine Kunst, Nicoleta Nastase, Winke Kloosterman, Karen Knols, Marc Schleiss, Femke Werkman

    What should a university do to support citizen science initiatives within an open science context, and to assist and facilitate researchers in performing effective citizen science? Delft University of Technology (TU Delft) has developed an open science program that includes, among other projects, citizen science. However, performing citizen science is not a straightforward task. For the people designing and managing citizen science projects, it demands appropriate knowledge, understanding, and experience of the field, as well as knowledge of the practical implementation of citizen science and open science. This requires a deeper understanding of which extra-academic skills, collaborations, rewards, and recognitions are needed for a citizen science project. Therefore, we used a local, hydrological citizen science project, “Delft Measures Rain,” as a case-study, implementing citizen science methods and the TU Delft Open Science principles. By means of this case-study, we identify key tools and facilitation needs to assist researchers within TU Delft to perform effective citizen science and open science. This paper shows how the various stakeholders (i.e., researchers, citizens, civil servants, and NGO’s) can benefit from performing participatory research implementing citizen science and open science principles. We list 10 key elements, encompassing tools, facilitation, and infrastructures that universities can provide for their researchers to stimulate and support the implementation and execution of successful, legally sound, and open citizen science. This case study shows that with appropriate and extra-academic knowledge, tools, collaborations, rewards, and recognitions, citizen science can deliver what it promises and be of great value to universities and open science in general.