TYTomokazu Yamamoto

Tomokazu Yamamoto

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Tomokazu Yamamoto has a total of 55 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    In-situ Gas Atmosphere Transmission Electron Microscopy Observation of Hydrogen De/Absorption in Metal Hydrides

    by Xin Fu Tan, Youichirou Kawami, Yuma Hamano, Tomokazu Yamamoto, Kazuhiro Nogita, Kazuhiro Yasuda

    Hydrogen does not produce any greenhouse gas upon combustion and green hydrogen is a desirable renewable energy carrier. However, because of its low density, hydrogen is hard to store, and novel methods are required for improved hydrogen storage and transportation. With high gravimetric and volumetric hydrogen capacities, metal hydrides are promising materials for safe hydrogen storage and transportation [ 1]. Many studies have been dedicated to metal hydrides to understand the hydrogen absorption/desorption mechanisms in order to improve performance. In-situ transmission electron microscopy (TEM) observation can contribute to the understanding of the mechanisms of phase transformation during hydrogen absorption and desorption at submicron levels. In-situ hydrogen desorption can be readily performed under the high vacuum environment in TEM. An example of in-situ study of hydrogen desorption of Mg-based hydrides ( Fig. 1) under high voltage TEM (HV-TEM) conducted at Kyushu University’s Ultramicroscopy Research Center will be presented [ 2, 3]. The study shows that thin and bulk MgH 2 particles desorb hydrogen through different mechanisms, namely the ‘shrinking core’ model and the ‘nucleation and growth’ model, respectively. On the other hand, due to the high vacuum environment in TEM, in-situ hydrogen absorption experiments which require the observed material to be in a hydrogen atmosphere, are difficult and limited [ 4, 5]. In this presentation, the possibility to perform in-situ absorption experiments using a state-of-the-art gas cell (Protochips) sample holder will be discussed. Using this setup, TEM observation under gas atmosphere up to 101.3 kPa at elevated temperature up to 1000°C can be performed. Fig. 2a shows a pristine TiH 2 single crystal particle with a surface oxide layer in the Protochips cell. Fig. 1. In-situ desorption of (a) a thin (a few tens of nm) MgH 2, and (b) a bulk (∼2μm) MgH 2, under HV-TEM. (Open access under Creative Commons Attribution 4.0 International License [ 4]) Fig. 2. TEM images of a TiH 2 particle (a) as-received, (b) after in-situ hydrogen desorption at 500°C, (c) after hydrogen absorption at 500°C under a 101.3kPa hydrogen atmosphere.


  • Open Access

    Realization of Ideal Ba Promoter State by Simultaneous Incorporation with Co into Carbon‐protective Framework for Ammonia Synthesis Catalyst

    by K. Kanishka H. De Silva, Katsutoshi Sato, Takahiro Naito, Takaaki Toriyama, Tomokazu Yamamoto, Ryotaro Aso, Yasukazu Murakami, Pradeep R. Varadwaj, Ryoji Asahi, Koji Inazu, et al.

    Developing non‐noble metal catalysts with excellent NH3 synthesis activity under mild conditions is a long‐term goal. The best catalysts reported to date often require laborious fabrication methods and controlled environments to fabricate the catalysts or high temperatures and long times to activate the catalysts. This work introduces a facile one‐pot method to fabricate carbon (C)‐based, barium (Ba)‐promoted cobalt (Co) catalysts via the citric acid sol–gel method with metal nitrates as precursors and water as the solvent. This approach ensures the homogeneous incorporation of metal ions into the carbon framework. The resulting (Ba/Co)0.3/C catalyst demonstrates an outstanding NH3 synthesis activity of 34 mmol gcat−1 h−1 (350 °C, 1.0 MPa) with excellent stability. In‐depth characterizations reveal that Ba exists as barium oxide (BaO), uniformly distributed on the carbon framework and around the Co nanoparticles. It is uncovered that retarding barium carbonate (BaCO3) formation in the fresh catalyst significantly reduces the reduction temperature and time (485 °C/4 h), which is a fundamental advantage of this method. Density functional theory and molecular dynamics simulations indeed support the experimental observations. It is anticipated that this simple and economical strategy will resolve the issues in a broad field of heterogeneous catalyst research.


  • Open Access

    Barium-doped iron nanoparticles supported on MgO as an efficient catalyst for ammonia synthesis under mild reaction conditions

    by Kohei Era, Katsutoshi Sato, Shin-Ichiro Miyahara, Takahiro Naito, Kanishka De Silva, Saeid Akrami, Hiroshi Yamada, Takaaki Toriyama, Takehiro Tamaoka, Tomokazu Yamamoto, et al.

    A Ba-doped Fe/MgO catalyst pre-reduced at 700 °C, much higher than that of conventional Fe catalysts, forms an Fe0-core and BaO-shell structure. This enhances ammonia synthesis activity due to electron donation from BaO to N2via Fe0.


  • Atomic‐Scale 3D Structure of a Supported Pd Nanoparticle Revealed by Electron Tomography with Convolution Neural Network‐Based Image Inpainting

    by Hiroki Iwai, Fumiya Nishino, Tomokazu Yamamoto, Masaki Kudo, Masayuki Tsushida, Hiroshi Yoshida, Masato Machida, Junya Ohyama

    Electron tomography based on scanning transmission electron microscopy (STEM) is used to analyze 3D structures of metal nanoparticles on the atomic scale. However, in the case of supported metal nanoparticle catalysts, the supporting material may interfere with the 3D reconstruction of metal nanoparticles. In this study, a deep learning‐based image inpainting method is applied to high‐angle annular dark field (HAADF)–STEM images of a supported metal nanoparticle to predict and remove the background image of the support. The inpainting method can separate an 11 nm Pd nanoparticle from the θ‐Al2O3 support in HAADF–STEM images of the θ‐Al2O3‐supported Pd catalyst. 3D reconstruction of the extracted images of the Pd nanoparticle reveals that the Pd nanoparticle adopts a deformed structure of the cuboctahedron model particle, resulting in high index surfaces, which account for the high catalytic activity for methane combustion. Using the xyz coordinate of each Pd atom, the local Pd–Pd bond distance and its variance in a real supported Pd nanoparticle are visualized, showing large strain and disorder at the Pd–Al2O3 interface. The results demonstrate that 3D atomic‐scale analysis enables atomic structure‐based understanding and design of supported metal catalysts.


  • Open Access

    Catalytic Behavior of K‐doped Fe/MgO Catalysts for Ammonia Synthesis Under Mild Reaction Conditions

    by Kohei Era, Katsutoshi Sato, Shin‐Ichiro Miyahara, Takahiro Naito, Kanishka De Silva, Saeid Akrami, Hiroshi Yamada, Takaaki Toriyama, Tomokazu Yamamoto, Yasukazu Murakami, et al.

    An important part of realizing a carbon‐neutral society using ammonia will be the development of an inexpensive yet efficient catalyst for ammonia synthesis under mild reaction conditions (via an impregnation method, as a highly active catalyst for ammonia synthesis under mild reaction conditions (350 °C, 1.0 MPa). At the mentioned conditions, the activity of Fe/K(3)/MgO (17.5 mmol h−1 gcat−1) was greater than that of a commercial fused iron catalyst (8.6 mmol h−1 gcat−1) currently used in the Haber‐Bosch process. K doping was found to increase the ratio of Fe0 on the surface and turnover frequency of Fe in our Fe/K(3)/MgO catalyst. In addition, increasing the pressure to 3.0 MPa at the same temperature led to a significant improvement of the ammonia synthesis rate to 29.6 mmol h−1 gcat−1, which was higher than that of two more expensive, benchmark Ru‐based catalysts, which are also potential alternative catalysts. A kinetics analysis revealed that the addition of K enhanced the ammonia synthesis activity at ≥300 °C by changing the main adsorbed species from NH to N which can accelerate dissociative adsorption of nitrogen as the rate limiting step in ammonia synthesis.


  • Open Access

    In-situ observation of damage structure in Cu-Cr-Zr and Cu-Cr alloy during 1.25 MeV electron irradiation

    by M. Hatakeyama, T. Yamamoto, K. Yasuda, S. Matsumura, K. Yasunaga, K. Sato


  • Open Access

    Catalysts for Gas Purification: Highly Stable and Active Solid‐Solution‐Alloy Three‐Way Catalyst by Utilizing Configurational‐Entropy Effect (Adv. Mater. 16/2021)

    by Kohei Kusada, Dongshuang Wu, Yusuke Nanba, Michihisa Koyama, Tomokazu Yamamoto, Xuan Quy Tran, Takaaki Toriyama, Syo Matsumura, Ayano Ito, Katsutoshi Sato, et al.


  • Open Access

    Reply to ‘Comments on “Evidence of the hydrogen release mechanism in bulk MgH2”’

    by Kazuhiro Nogita, Xuan Q. Tran, Tomokazu Yamamoto, Eishi Tanaka, Stuart D. McDonald, Christopher M. Gourlay, Kazuhiro Yasuda, Syo Matsumura

    In a comment on our Article “Evidence of the hydrogen release mechanism in bulk MgH2”, Surrey et al. assert that the MgH2 sample we studied was not MgH2 at any time but rather MgO; and that the transformation we observed was the formation of Kirkendall voids due to the outward diffusion of Mg. We address these issues in this reply.

  • Open Access

    Detection of picometer-order atomic displacements in drift-compensated HAADF-STEM images of gold nanorods

    by Kohei Aso, Koji Shigematsu, Tomokazu Yamamoto, Syo Matsumura

    Cs-corrected atomic resolution scanning transmission electron microscopy under a drift-compensated operation enabled us to acquire high-angle annular dark-field (HAADF) images of entire gold nanorods without distortion induced by specimen drift. The precision in locating the atomic columns was evaluated to be ±5 pm in the images thus obtained, which is comparable to the image pixel size. A high-precision HAADF image of a single-crystalline gold nanorod revealed that the tip portions at both ends tended to undergo outward displacements along the rod axis and inward contraction along the perpendicular direction. A single nanosecond pulse shot of laser light with a wavelength of 1064 nm and an average intensity of 7.3 kJ/m 2 pulse deformed the nanorods into spherical shapes. Simultaneously, the particle interior was completely changed into a multiple twin structure. Substantial displacements of atomic columns on the order of several tens of picometers were confirmed to be localized in the corners of domains at multiple twin junctions. Both the magnitude and direction of displacements were linearly relaxed with increasing distance from a multiple junction.