Sajida Mushtaq
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Sajida Mushtaq has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
A. Naeem
Department of Mathematics, SBK Women's University 1 , Quetta 87300, Balochistan, Pakistan
1 shared publicationAyesha Hafeez
Government College Women University
1 shared publication- Moazama Batool
Department of Zoology Government College Women University Sialkot Pakistan
1 shared publication - Naheed Bano
Government College Women University
1 shared publication - Nazia Ehsan
University of Agriculture, Pakistan
1 shared publication - Noreen Azhar
Sardar Bahadur Khan Women’s University, Quetta
1 shared publication
Latest Publications
- Open Access
- 1 December 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (12)
Numerical investigation of flow past a triangular cylinder at various Reynolds numbers
Numerical simulation of flow around a triangular cylinder placed both in left and right position at Reynolds number Re = 80–200 is presented in this study. The single relaxation time lattice Boltzmann method is used. The results are obtained in terms of vorticity contour visualization, drag and lift coefficients, and force statistics. Regular vortex shedding is observed for both cases, but the vortices generated for a triangular cylinder placed in the right position move toward the top downstream position as the range of Reynolds number increases due to effect of pressure (effect of thrust). The drag coefficient is constant, and lift coefficient is containing negative values from Re = 80–150 for that case, but negative Cdmean values are not observed for a triangular cylinder placed in the left position. In that case, it is due to the reason that the effect of thrust diminishes. The maximum value of Cdmean is obtained at Re = 200, that is, 1.5006 for the left triangular cylinder, but the value of the mean drag coefficient for the right triangular cylinder is zero throughout the cases for Re = 80–200. No fluid forces are produced for right triangular case. The Strouhal number (St) values increased by increasing the Reynolds number, i.e., Re = 80–200, for the right triangular cylinder, and it has a mixed trend for the left triangular cylinder. In literature, a lot of work has been found on rectangular and square cylinders, but triangular cylinder has not been studied much.
- 1 December 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (12)
Open AccessNumerical investigation of flow past a triangular cylinder at various Reynolds numbers
Numerical simulation of flow around a triangular cylinder placed both in left and right position at Reynolds number Re = 80–200 is presented in this study. The single relaxation time lattice Boltzmann method is used. The results are obtained in terms of vorticity contour visualization, drag and lift coefficients, and force statistics. Regular vortex shedding is observed for both cases, but the vortices generated for a triangular cylinder placed in the right position move toward the top downstream position as the range of Reynolds number increases due to effect of pressure (effect of thrust). The drag coefficient is constant, and lift coefficient is containing negative values from Re = 80–150 for that case, but negative Cdmean values are not observed for a triangular cylinder placed in the left position. In that case, it is due to the reason that the effect of thrust diminishes. The maximum value of Cdmean is obtained at Re = 200, that is, 1.5006 for the left triangular cylinder, but the value of the mean drag coefficient for the right triangular cylinder is zero throughout the cases for Re = 80–200. No fluid forces are produced for right triangular case. The Strouhal number (St) values increased by increasing the Reynolds number, i.e., Re = 80–200, for the right triangular cylinder, and it has a mixed trend for the left triangular cylinder. In literature, a lot of work has been found on rectangular and square cylinders, but triangular cylinder has not been studied much.
- 1 January 2022
- Published by Researcher Connect Innovation and Impact Private Limited and MRI in Journal of Entomological Research
- Vol. 46 (1) , 24-27
Approximation of agricultural loss caused by pernicious larvae of Helicoverpa armigera (Noctuidae; Lepidoptera) by analysis of feeding potential on selected plants
For approximation of damage caused by pernicious larvae of Helicoverpa armigera, nutritional indices, host plant preference, amount of plant consumed, and developmental stages of the larvae were studied. For this purpose larvae were reared in laboratory at optimum conditions. Larvae were provided with fresh and pre-weighed leaves and shoots of Brassica, cauliflower, cabbage and turnip. After 24 h food was replaced with fresh food and consumed food was weighed. By repeating the same process until pupal formation per day food consumption and total food consumption was calculated. Other developmental parameters such as pupal weight, pupal duration and adult longevity was also observed. One way ANOVA was applied to check significance of results. Maximum consumption was on cauliflower (18.04 ± 0.68 g) while turnip was least preferred diet with 6.47 ± 0.19 g total consumption. Pupal weight was also highest on cauliflower 0.48 ± 0.04 g and lowest on turnip 0.39b ± 0.03 g. Significant relation (p < 0.001) was found between total consumption of host plants. Larval duration, pupal weight and pupal duration were related to each other.
- 1 January 2022
- Published by Researcher Connect Innovation and Impact Private Limited and MRI in Journal of Entomological Research
- Vol. 46 (1) , 24-27
Approximation of agricultural loss caused by pernicious larvae of Helicoverpa armigera (Noctuidae; Lepidoptera) by analysis of feeding potential on selected plants
For approximation of damage caused by pernicious larvae of Helicoverpa armigera, nutritional indices, host plant preference, amount of plant consumed, and developmental stages of the larvae were studied. For this purpose larvae were reared in laboratory at optimum conditions. Larvae were provided with fresh and pre-weighed leaves and shoots of Brassica, cauliflower, cabbage and turnip. After 24 h food was replaced with fresh food and consumed food was weighed. By repeating the same process until pupal formation per day food consumption and total food consumption was calculated. Other developmental parameters such as pupal weight, pupal duration and adult longevity was also observed. One way ANOVA was applied to check significance of results. Maximum consumption was on cauliflower (18.04 ± 0.68 g) while turnip was least preferred diet with 6.47 ± 0.19 g total consumption. Pupal weight was also highest on cauliflower 0.48 ± 0.04 g and lowest on turnip 0.39b ± 0.03 g. Significant relation (p < 0.001) was found between total consumption of host plants. Larval duration, pupal weight and pupal duration were related to each other.