Yasser S. Shama

Electrostatic actuation is widely employed in microelectromechanical systems (MEMS) due to its distinct advantages. However, it requires high voltage, typically provided by a power supply and a high voltage amplifier, which is limited in gain, especially at high frequencies. Various methods have been proposed to amplify the voltage signal fed into the system by coupling it in series to an LC tank circuit. In this work, we analyze and compare three methods, resonance matching, multi-frequency excitation, and amplitude modulation. We also compare their performance to that of a voltage amplifier. We demonstrate that resonant circuits significantly enhance performance, offering a more effective solution for high-frequency MEMS actuation.

This paper presents a novel technique for low-power generation of frequency combs (FC) over a wide frequency range. It leverages modal interactions between electrical and mechanical resonators in electrostatic NEMS operating in air to provide a simple architecture for FC generators. A biased voltage signal drives the electrical resonator at resonance which is set to match an integer submultiple of twice the mechanical resonator’s resonance. Experimental results demonstrate that the NEMS displacement exhibit more than 150 equidistant peaks in the case of a 2:1 modal interaction and more than 60 equidistant peaks in the case of a 1:1 modal interaction. In both cases, the Free Spectral Range (FSR) was equal to the mechanical resonance frequency. Comparison between the FCs generated by the 2:1 and 1:1 modal interactions demonstrate the superiority of the former in terms of bandwidth and stability. The superior phase coherence of the FC generated via the 2:1 modal interaction was demonstrated via time-domain analysis. Our technique has the flexibility to generate multiple frequency combs and to fine-tune their FSR depending on the number of mechanical modes accessible to and the order of the activated modal interaction. It can be integrated into portable devices and is well aligned with modern miniaturization technology.

This paper presents a novel technique for low-power generation of frequency combs (FC) over a wide frequency range. It leverages modal interactions between electrical and mechanical resonators in electrostatic NEMS operating in air to provide a simple architecture for FC generators. A biased voltage signal drives the electrical resonator at resonance which is set to match an integer submutiple of twice the mechanical resonator's resonance. Experimental results demonstrate that the NEMS displacement exhibits more than 150 equidistant peaks in the case of a 2:1 modal interaction and more than 60 equidistant peaks in the case of a 1:1 modal interaction. In both cases, the Free Spectral Range (FSR) was equal to the mechanical resonance frequency. Comparison between the FCs generated by the 2-1 and 1-1 modal interactions demonstrate the superiority of the former in terms of bandwidth and stability. The superior phase coherence of the FC generated via the 2-1 modal interaction was demonstrated via time-domain analysis. Our technique has the flexibility to generate multiple frequency combs and to fine-tune their FSR depending on the number of mechanical modes accessible to and the order of the activated modal interaction. It can be integrated into portable devices and is well aligned with modern miniaturization technology.

This paper investigates the fundamental sensing mechanism of electrostatic MEMS gas sensors. It compares among the responsivities of a set of MEMS isopropanol sensors before and after functionalization, and in the presence and absence of electrostatic fields when operated in static and dynamic detection modes. In the static mode, we found that the sensors do not exhibit a measurable change in displacement due to added mass. On the other hand, bare sensors showed a clear change in displacement in response to isopropanol vapor. In the dynamic mode, functionalized sensors showed a measurable frequency shift due to the added mass of isopropanol vapor. In the presence of strong electrostatic fields, the measured frequency shift was found to be threefold larger than that in their absence in response to the same concentration of isopropanol vapor. The enhanced responsivity of dynamic detection allows the sensors to measure the vapor mass captured by the functional material, which is not the case for static detection. The detection of isopropanol by bare sensors in static mode shows that change in the medium permittivity is the primary sensing mechanism. The enhanced responsivity of dynamic mode sensors when operated in strong electrostatic fields shows that their sensing mechanism is a combination of a weaker added mass effect and a stronger permittivity effect. These findings show that electrostatic MEMS gas sensors are independent of the direction of the gravitational field and are, thus, robust to changes in alignment. It is erroneous to refer to them as ‘gravimetric’ sensors.

This paper investigates the fundamental sensing mechanism of electrostatic MEMS gas sensors. It compares among the responsivities of a set of MEMS isopropanol sensors before and after functionalization, and in the presence and absence of electrostatic fields when operated in static and dynamic detection modes. In the static mode, we found that the sensors do not exhibit a measurable change in displacement due to added mass. On the other hand, bare sensors showed a clear change in displacement in response to isopropanol vapor. In the dynamic mode, functionalized sensors showed a measurable frequency shift due to the added mass of isopropanol vapor. In the presence of strong electrostatic fields, the measured frequency shift was found to be threefold larger than that in their absence in response to the same concentration of isopropanol vapor. The enhanced responsivity of dynamic detection allows the sensors to measure the vapor mass captured by the functional material, which is not the case for static detection. The detection of isopropanol by bare sensors in static mode shows that change in the medium permittivity is the primary sensing mechanism. The enhanced responsivity of dynamic mode sensors when operated in strong electrostatic fields shows that their sensing mechanism is a combination of a weaker added mass effect and a stronger permittivity effect. These findings show that electrostatic MEMS gas sensors are independent of the direction of the gravitational field and are, thus, robust to changes in alignment. It is erroneous to refer to them as 'gravimetric' sensors.