Huayue Ai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Huayue Ai has a total of 78 co-authors. Here are the top co-authors by number of shared publications:
- Yi Cui
Stanford University
9 shared publications - John Holoubek
Stanford University
5 shared publications - Louisa C. Greenburg
Department of Materials Science and Engineering, Stanford University, Stanford, California 94305, United States
3 shared publications - Wenbo Zhang
Stanford University
3 shared publications Xun Guan
Department of Materials Science and Engineering
3 shared publications- Yusheng Ye
Beijing Institute of Technology
3 shared publications
Latest Publications
- 23 October 2026
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 11 (11) , 7200-7206
Quantifying Sodium Metal SEI Dissolution and Relation to Corrosion Using Quartz Crystal Microbalance
Sodium-metal batteries present a more abundant alternative to lithium-based batteries, with high theoretical capacity and comparable reduction potential. Ether electrolytes perform well in sodium-metal batteries under continuous cycling and are presumed to have a stable solid-electrolyte interphase (SEI). However, the solubility of sodium SEI components is a cause for concern, and SEI evolution during calendar aging is not commonly studied for the ether sodium-metal system. In this work, SEI mass formation and dissolution are quantitatively measured for NaPF6 in diglyme. For varying potential hold levels, significant SEI dissolution is observed, from 55 to 76% of the originally formed SEI. Characterization shows that in addition to organic component dissolution, inorganic salts such as NaF and NaxPOyFz are unstable in SEI during open circuit rest. This instability results in continuous corrosion of sodium metal during calendar aging, highlighting an important understanding and concern of SEI stability in sodium-metal batteries.
- 23 October 2026
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 11 (11) , 7200-7206
Quantifying Sodium Metal SEI Dissolution and Relation to Corrosion Using Quartz Crystal Microbalance
Sodium-metal batteries present a more abundant alternative to lithium-based batteries, with high theoretical capacity and comparable reduction potential. Ether electrolytes perform well in sodium-metal batteries under continuous cycling and are presumed to have a stable solid-electrolyte interphase (SEI). However, the solubility of sodium SEI components is a cause for concern, and SEI evolution during calendar aging is not commonly studied for the ether sodium-metal system. In this work, SEI mass formation and dissolution are quantitatively measured for NaPF6 in diglyme. For varying potential hold levels, significant SEI dissolution is observed, from 55 to 76% of the originally formed SEI. Characterization shows that in addition to organic component dissolution, inorganic salts such as NaF and NaxPOyFz are unstable in SEI during open circuit rest. This instability results in continuous corrosion of sodium metal during calendar aging, highlighting an important understanding and concern of SEI stability in sodium-metal batteries.
- 17 July 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
One-Step Integration of Sulfonated Polymer Films with Separators for Shuttle Mitigation in Lithium–Sulfur Batteries
Interfacial polymerization (IP) offers a rapid and inexpensive method for fabricating thin polymer films. In this work, a one-step IP reaction between a triacyl chloride monomer and sulfonated diamine monomer is employed to add a dense, charge-selective sulfonated thin-film coating onto a commercial separator to improve selective transport in lithium-sulfur batteries. The coating effectively suppresses polysulfide shuttling, enhancing capacity retention, although at the expense of compromised rate performance due to hindered lithium conduction through the dense film. Fractional substitution of the trifunctionalized acyl chloride monomer for a difunctionalized analogue reduces the film cross-link density, which improves rate performance but decreases uniformity in film coverage. Uniform film coverage is achieved upon addition of a small fraction (0.25 wt %) of higher reactivity, nonsulfonated diamine in the IP reaction. This optimized thin film coating breaks the rate-capacity retention trade-off, enabling a capacity of 711.6 mAh g-1 after 200 cycles at 0.5C while still reaching over 800 mAh g-1 during rate testing at 2C.
- 17 July 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
One-Step Integration of Sulfonated Polymer Films with Separators for Shuttle Mitigation in Lithium–Sulfur Batteries
Interfacial polymerization (IP) offers a rapid and inexpensive method for fabricating thin polymer films. In this work, a one-step IP reaction between a triacyl chloride monomer and sulfonated diamine monomer is employed to add a dense, charge-selective sulfonated thin-film coating onto a commercial separator to improve selective transport in lithium-sulfur batteries. The coating effectively suppresses polysulfide shuttling, enhancing capacity retention, although at the expense of compromised rate performance due to hindered lithium conduction through the dense film. Fractional substitution of the trifunctionalized acyl chloride monomer for a difunctionalized analogue reduces the film cross-link density, which improves rate performance but decreases uniformity in film coverage. Uniform film coverage is achieved upon addition of a small fraction (0.25 wt %) of higher reactivity, nonsulfonated diamine in the IP reaction. This optimized thin film coating breaks the rate-capacity retention trade-off, enabling a capacity of 711.6 mAh g-1 after 200 cycles at 0.5C while still reaching over 800 mAh g-1 during rate testing at 2C.
- 27 January 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 148 (5) , 5048-5056
NiSO 4 -Driven In Situ Alloy Formation To Unlock Highly Reversible Iron Electrochemistry in Aqueous Batteries
- 27 January 2026
- Published by American Chemical Society (ACS) in Journal of the American Chemical Society
- Vol. 148 (5) , 5048-5056
NiSO 4 -Driven In Situ Alloy Formation To Unlock Highly Reversible Iron Electrochemistry in Aqueous Batteries
- 23 December 2025
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 11 (1) , 726-732
Double-Layer Design Enables Independent Kinetic Modulation in CO 2 Electrolysis
- 23 December 2025
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 11 (1) , 726-732
Double-Layer Design Enables Independent Kinetic Modulation in CO 2 Electrolysis
- Open Access
- 17 October 2025
- Published by American Chemical Society (ACS) in ChemRxiv
One-Step Integration of Sulfonated Polymer Films with Separators for Shuttle Mitigation in Lithium-Sulfur Batteries
Interfacial polymerization (IP) offers a rapid and inexpensive method to fabricate thin polymer films. In this work, a one-step, scalable IP reaction between a tri-acyl chloride monomer and sulfonated diamine monomer is employed to add a dense, charge-selective sulfonated thin-film coating onto a commercial separator to improve selective transport in lithium-sulfur batteries. The coating effectively suppresses polysulfide shuttling, enhancing capacity retention, though at the expense of compromised rate performance due to hindered lithium conduction through the dense film. Fractional substitution of the tri- functionalized acyl chloride monomer for a di-functionalized analog reduces the film crosslink density, which improves rate performance but decreases uniformity in film coverage. Uniform film coverage is achieved upon addition of a small fraction (0.25 wt%) of higher reactivity, non-sulfonated diamine in the IP reaction. This optimized thin film coating breaks the rate-capacity retention tradeoff, enabling a capacity of 885.5 mAh g-1 after 100 cycles at 0.2 C while still reaching over 800 mAh g-1 during rate testing at 2 C.
- 17 October 2025
- Published by American Chemical Society (ACS) in ChemRxiv
Open AccessOne-Step Integration of Sulfonated Polymer Films with Separators for Shuttle Mitigation in Lithium-Sulfur Batteries
Interfacial polymerization (IP) offers a rapid and inexpensive method to fabricate thin polymer films. In this work, a one-step, scalable IP reaction between a tri-acyl chloride monomer and sulfonated diamine monomer is employed to add a dense, charge-selective sulfonated thin-film coating onto a commercial separator to improve selective transport in lithium-sulfur batteries. The coating effectively suppresses polysulfide shuttling, enhancing capacity retention, though at the expense of compromised rate performance due to hindered lithium conduction through the dense film. Fractional substitution of the tri- functionalized acyl chloride monomer for a di-functionalized analog reduces the film crosslink density, which improves rate performance but decreases uniformity in film coverage. Uniform film coverage is achieved upon addition of a small fraction (0.25 wt%) of higher reactivity, non-sulfonated diamine in the IP reaction. This optimized thin film coating breaks the rate-capacity retention tradeoff, enabling a capacity of 885.5 mAh g-1 after 100 cycles at 0.2 C while still reaching over 800 mAh g-1 during rate testing at 2 C.
- 18 August 2025
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 18 (18) , 8608-8617
A solvation-driven reevaluation of organic electrolytes for zinc batteries
Organic electrolytes based on mass-produced components mitigate calendar-life deficiencies in Zn batteries while minimizing levelized cost.
- 18 August 2025
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 18 (18) , 8608-8617
A solvation-driven reevaluation of organic electrolytes for zinc batteries
Organic electrolytes based on mass-produced components mitigate calendar-life deficiencies in Zn batteries while minimizing levelized cost.
- 5 August 2025
- Published by American Chemical Society (ACS) in ACS Energy Letters
- p. 4203-4211
Homogeneous 3D Porous Conductive Electrodes for High-Energy Battery Fast Charging
- 5 August 2025
- Published by American Chemical Society (ACS) in ACS Energy Letters
- p. 4203-4211
Homogeneous 3D Porous Conductive Electrodes for High-Energy Battery Fast Charging
- Top Cited Papers
- 3 February 2025
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 10 (2) , 1022-1029
Crowding Agent Stabilizes Aqueous Electrolyte for Reversible Iron Metal Anode
- 3 February 2025
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 10 (2) , 1022-1029
Top Cited PapersCrowding Agent Stabilizes Aqueous Electrolyte for Reversible Iron Metal Anode
- 18 October 2024
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 386 (6719) , 322-327
Capacity recovery by transient voltage pulse in silicon-anode batteries
In the quest for high-capacity battery electrodes, addressing capacity loss attributed to isolated active materials remains a challenge. We developed an approach to substantially recover the isolated active materials in silicon electrodes and used a voltage pulse to reconnect the isolated lithium-silicon (Li x Si) particles back to the conductive network. Using a 5-second pulse, we achieved >30% of capacity recovery in both Li-Si and Si–lithium iron phosphate (Si-LFP) batteries. The recovered capacity sustains and replicates through multiple pulses, providing a constant capacity advantage. We validated the recovery mechanism as the movement of the neutral isolated Li x Si particles under a localized nonuniform electric field, a phenomenon known as dielectrophoresis.
- 18 October 2024
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 386 (6719) , 322-327
Capacity recovery by transient voltage pulse in silicon-anode batteries
In the quest for high-capacity battery electrodes, addressing capacity loss attributed to isolated active materials remains a challenge. We developed an approach to substantially recover the isolated active materials in silicon electrodes and used a voltage pulse to reconnect the isolated lithium-silicon (Li x Si) particles back to the conductive network. Using a 5-second pulse, we achieved >30% of capacity recovery in both Li-Si and Si–lithium iron phosphate (Si-LFP) batteries. The recovered capacity sustains and replicates through multiple pulses, providing a constant capacity advantage. We validated the recovery mechanism as the movement of the neutral isolated Li x Si particles under a localized nonuniform electric field, a phenomenon known as dielectrophoresis.
- 28 February 2024
- Published by Springer Nature in Nature Energy
- Vol. 9 (6) , 643-653
Quadruple the rate capability of high-energy batteries through a porous current collector design
- 28 February 2024
- Published by Springer Nature in Nature Energy
- Vol. 9 (6) , 643-653
Quadruple the rate capability of high-energy batteries through a porous current collector design