SZShiyuan Zhou

Shiyuan Zhou

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Shiyuan Zhou has a total of 70 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Nitrogen atom number regulated charge transfer in conjugated organic polymers for efficient hydrogen peroxide synthesis

    by Xun Chen, Xiaobo Luo, Wenwen Chen, Deli Kong, Danfeng Wang, Guangfeng Liu, Shiyuan Zhou, Peng Wang, Qiuxuan Zhou, Peiyang Gu

  • Hydroxyl Positional Isomerism in Anthraquinone Porous Polymers Enhances Sacrificial-Agent-Free H2O2 Photosynthesis from Water and Air

    by Danfeng Wang, Sheng Yang, Heman Xu, Shiyuan Zhou, Peng Wang, Lixuan Kan, Lingyun Xu, Guangfeng Liu, Peiyang Gu

    Photocatalytic H2O2 synthesis from water and air without sacrificial agents is limited by the poor use of photogenerated holes, and hydroxyl functionalization of photocatalysts has so far been tuned mainly through the number of hydroxyl groups. This study examines whether the position of hydroxyl groups on an anthraquinone unit, at a fixed hydroxyl count, can improve photocatalytic H2O2 production from water and air without sacrificial agents. Three hypercrosslinked porous polymers (AQ, 1,4-AQ and 1,8-AQ) were prepared in one Friedel–Crafts step from anthraquinone, 1,4-dihydroxyanthraquinone, and 1,8-dihydroxyanthraquinone under identical conditions. Every hydroxyl group is hydrogen-bonded to a peri carbonyl, so each carbonyl of 1,4-AQ carries one hydrogen bond, whereas 1,8-AQ carries two on one carbonyl and none on the other. Compared to 1,8-AQ and AQ, 1,4-AQ showed a longer average excited-state lifetime (1890.6 vs 146.4, 267.3 ps), which we relate to its larger estimated fraction of H2O2 formed by water oxidation (20.8% vs 15.0%). Separately, its surface was more wettable (contact angle 61.2° vs 128.4°). In pure water under air, 1,4-AQ produced H2O2 at 5.70 mmol g–1 h–1, vs 4.46 (1,8-AQ) and 3.17 mmol g–1 h–1 (AQ), and retained 90.5% activity over five cycles. Immobilized in a recirculating flow photoreactor, 1,4-AQ accumulated 44.30 mM H2O2 in 18 h without catalyst separation. This work identifies the position of hydroxyl groups relative to a redox-active carbonyl as a design variable that can be set by selecting a commercial isomer.

  • Unveiling the Trade-Off between H2O2 Photosynthetic Efficiency and Stability for Sustained H2O2 Accumulation

    by Xiaobo Luo, Lixuan Kan, Wenwen Chen, Lei Zhu, Danfeng Wang, Guangfeng Liu, Peiyang Gu, Guping Zhang, Xiaoqiong Hao, Shiyuan Zhou

    Sustained hydrogen peroxide (H2O2) accumulation remains a critical bottleneck for conjugated organic polymers (COPs). Spirobifluorene-based COPs, namely NBT, BT, and 2FBT, were synthesized using benzothiadiazole derivatives as the crosslinkers to determine H2O2 adsorption and desorption properties. NBT exhibited a superior H2O2 production rate of 6.40 mmol g–1 h–1, an apparent quantum yield of 11.1%, and a solar-to-chemical conversion efficiency of 1.19%. However, its long-term H2O2 accumulation declined relative to both BT and 2FBT, owing to excessively strong H2O2 adsorption arising from hydrogen bonding. Whereas BT exhibited enhanced H2O2 accumulation owing to its favorable production rate, rapid desorption, and minimal decomposition, thereby achieving H2O2 concentrations of 4.0 mmol L–1 in a stirred biphasic system and 19.2 mmol L–1 in a continuous-flow system employing a benzyl alcohol/water biphasic medium. This work proposes a fundamental trade-off between H2O2 photosynthetic efficiency and stability: an efficient H2O2 production rate should be synergistically coupled with weak adsorption and rapid desorption, even though the production rate is not maximal.

  • Recent Advances in Covalent Triazine Frameworks for Solar‐Driven Photocatalysis: Intrinsic Advantages, Modification Strategies, and Photocatalytic Applications

    by Xueqing Li, Xiaobo Luo, Huizhen Liang, Rong Tan, Feng Zhou, Qijian Zhang, Guping Zhang, Shiyuan Zhou, Peiyang Gu

    Photocatalysis, a highly attractive technology, can harness abundant and clean solar energy to produce chemical fuels and degrade hazardous pollutants into harmless molecules, offering a promising pathway to tackle both energy crises and environmental pollution. Owing to their distinctive π‐conjugated structure, nitrogen‐rich triazine motifs, high specific surface area, and good chemical and thermal stability, covalent triazine frameworks (CTFs) have emerged as an important class of porous organic semiconductors with widespread photocatalytic applications. This review summarizes recent advances in utilizing CTFs and CTF‐based materials for solar‐driven photocatalysis. First, the essential advantages of CTFs for photocatalysis are concisely outlined. Subsequently, the latest research progress on the different modifications of CTFs are discussed, such as crystallinity enhancement, morphology and structural design, heterojunction engineering, construction of donor–acceptor systems, and single‐atom catalyst loading. Besides, various significant applications of CTF‐based photocatalysts are detailedly illustrated through specific examples, involving photocatalytic carbon dioxide reduction, water splitting, hydrogen peroxide production, organic transformations, and pollutant removal. Based on the state‐of‐the‐art advances in this topic, the current challenges and future perspectives for CTFs are pointed out, aiming to guide the rational design of CTF‐based photocatalysts for efficient solar energy conversion and environmental remediation.

  • Linking isomerism matters: tuning conjugated microporous polymers’ topology for enhanced photocatalytic H 2 O 2 evolution

    by Yina Gu, Deli Kong, Xiaobo Luo, Wenwen Chen, Danfeng Wang, Xiaoqiong Hao, Guangfeng Liu, Shiyuan Zhou, Peiyang Gu

    By engineering the isomeric linkage sites, the topological configurations, porosities, and charge transfer properties of conjugated microporous polymers were regulated.

  • Manipulating Spin‐Orbit Coupling in Conjugated Microporous Polymers Through Torsion Engineering to Generate Efficient Triplet Excitons for High‐Performance Photocatalysis

    by Danfeng Wang, Heman Xu, Yihan Tang, Lixuan Kan, Jingwen Dong, Shiyuan Zhou, Qianfeng Gu, Yuzhe Zhang, Guangfeng Liu, Qichun Zhang, et al.

    Maximizing photon utilization in organic photocatalysis requires harnessing both singlet and triplet excitons, however, the strategies to populate the spin‐forbidden triplet state in metal‐free polymers are rare. To address this issue, we report a new strategy, namely employing a spin‐orbit charge transfer intersystem crossing (SOCT‐ISC), to unlock the triplet manifold in conjugated microporous polymers (CMPs). Using a postsynthetic [2 + 2] cycloaddition‐retroelectrocyclization (CA‐RE) reaction, we precisely control the cyano number in the polymer backbone. This chemical modification induces a critical orthogonal molecular torsion, which maximizes spin‐orbit coupling (SOC) and minimizes the singlet‐triplet energy gap (Δ E ST ). Femtosecond transient absorption spectroscopy confirms the efficient triplet generation by torsion engineering. Consequently, the optimized photocatalyst achieves a hydrogen peroxide (H 2 O 2 ) production rate of 5.01 mmol g −1 h −1 in pure water and a rate of 101.26 mmol g −1 h −1 in a benzyl alcohol‐coupled system, with a solar‐to‐chemical conversion (SCC) efficiency of 0.62%, and an outdoor production reaches 5 mmol L −1 daily. This work leverages torsion engineering to harness triplet excitons, demonstrating the successful overcoming of thermodynamic barriers in artificial photosynthesis.

  • Manipulating Spin‐Orbit Coupling in Conjugated Microporous Polymers Through Torsion Engineering to Generate Efficient Triplet Excitons for High‐Performance Photocatalysis

    by Danfeng Wang, Heman Xu, Yihan Tang, Lixuan Kan, Jingwen Dong, Shiyuan Zhou, Qianfeng Gu, Yuzhe Zhang, Guangfeng Liu, Qichun Zhang, et al.

    Maximizing photon utilization in organic photocatalysis requires harnessing both singlet and triplet excitons, however, the strategies to populate the spin‐forbidden triplet state in metal‐free polymers are rare. To address this issue, we report a new strategy, namely employing a spin‐orbit charge transfer intersystem crossing (SOCT‐ISC), to unlock the triplet manifold in conjugated microporous polymers (CMPs). Using a postsynthetic [2 + 2] cycloaddition‐retroelectrocyclization (CA‐RE) reaction, we precisely control the cyano number in the polymer backbone. This chemical modification induces a critical orthogonal molecular torsion, which maximizes spin‐orbit coupling (SOC) and minimizes the singlet‐triplet energy gap (Δ E ST ). Femtosecond transient absorption spectroscopy confirms the efficient triplet generation by torsion engineering. Consequently, the optimized photocatalyst achieves a hydrogen peroxide (H 2 O 2 ) production rate of 5.01 mmol g −1 h −1 in pure water and a rate of 101.26 mmol g −1 h −1 in a benzyl alcohol‐coupled system, with a solar‐to‐chemical conversion (SCC) efficiency of 0.62%, and an outdoor production reaches 5 mmol L −1 daily. This work leverages torsion engineering to harness triplet excitons, demonstrating the successful overcoming of thermodynamic barriers in artificial photosynthesis.


  • Hydroxymethyl functionalization enhancing hydrophilicity and polarity in conjugated organic polymers for efficient H 2 O 2 production

    by Yina Gu, Xiaobo Luo, Xiaoqiong Hao, Danfeng Wang, Guangfeng Liu, Peng Wang, Shiyuan Zhou, Peiyang Gu

    Hydroxymethyl groups were functionalized to simultaneously enhance hydrophilicity and microenvironment polarity of conjugated organic polymers.

  • Sulfonated perylene bisimide-based conjugated organic polymer for simultaneous bisphenol A degradation and hydrogen peroxide production

    by Yuzhe Zhang, Aomei Li, Zhenhao Fan, Danfeng Wang, Shiyuan Zhou, Guangfeng Liu, Peiyang Gu, Zhongyu Li

    Conjugated organic polymers (COPs) constructed from carbazole and perylene bisimide exhibit excellent performance in the simultaneous degradation of bisphenol A (BPA) and photocatalytic synthesis of hydrogen peroxide (H 2 O 2 ).

  • Bifunctional Aggregation‐Induced Emission Probes Based on Tetraphenylethylene for Detecting Pyrophosphoric Acid and Perfluorooctane Sulfonate

    by Liang Zhang, Wenxiu Guo, Feng Zhang, Qiuxuan Zhou, Shiyuan Zhou, Peiyang Gu

    The integration of different functions within a single fluorescent molecule provides a highly promising platform for expanding the application of fluorescent materials. Herein, two tetraphenylethylene‐based fluorescence probes, denoted as TBn and T 2 N, were synthesized to detect pyrophosphoric acid (PPi) and perfluorooctane sulfonate (PFOS) in solutions. The two probes both exhibit characteristic aggregation‐induced emission properties and large Stokes shifts (about 200 nm) in solutions. Leveraging electrostatic interactions and hydrophobic bonds, T 2 N demonstrates a remarkable response, with detection limits of 48 nM for PPi and 51 nM for PFOS. Notably, T 2 N can effectively detect PPi and PFOS in the pH range of 3–13 and in tap water.