Alexey Dovnarovich
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Alexey Dovnarovich has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Igor Avetissov
Department of Chemistry and Technology of Crystals, D. Mendeleyev University of Chemical Technology of Russia, Moscow, Russia, Russia
2 shared publications - Vladimir Kostikov
D. Mendeleyev University of Chemical Technology of Russia, Moscow, Russia, Russia
2 shared publications - Artem Anatolevich Atlaskin
SMART Polymeric Materials and Technologies Laboratory, Mendeleev University of Chemical Technology of Russia, 125047 Moscow, Russia
1 shared publication - Dmitry Bocharnikov1 shared publication
- Elena Mozhevitina
Department of Chemistry and Technology of Crystals, Mendeleev University of Chemical Technology, 125047 Moscow, Russia
1 shared publication - Kate Trishina
D. Mendeleyev University of Chemical Technology of Russia, Moscow, Russia, Russia
1 shared publication
Latest Publications
- Open Access
- 12 November 2026
- Published by MDPI AG in Preprints.org
Numerical Simulation of p-Terphenyl Crystal Growth by Bridg-Man Technique Assisted by Axial Low-Frequency Oscillations of the Melt
The influence of forced convection induced by axial low-frequency oscillations of an inert body on the melt hydrodynamics and crystallization front morphology during the vertical Bridgman growth of p-terphenyl single crystals was investigated by numerical simulations. An efficient numerical technique using a P-controller-based momentum source term was developed, which allowed the transient integration time step to be increased to ∆t = 0.1 s and ensured high computational stability without the need for direct modeling of high-frequency disk oscillations. It was established that for moderate forced convection intensities, the maximum melt flow velocity correlates linearly with the maximum disk velocity vmax ≈ 2Aω. The analysis of energetic characteristics demonstrated a cubic scaling of the time-averaged viscous dissipation power Qµ proportional to A3ω3. Efficient stabilization of the crystallization front was successfully demonstrated by vibrations of the triangular cross-section disk.
- 12 November 2026
- Published by MDPI AG in Preprints.org
Open AccessNumerical Simulation of p-Terphenyl Crystal Growth by Bridg-Man Technique Assisted by Axial Low-Frequency Oscillations of the Melt
The influence of forced convection induced by axial low-frequency oscillations of an inert body on the melt hydrodynamics and crystallization front morphology during the vertical Bridgman growth of p-terphenyl single crystals was investigated by numerical simulations. An efficient numerical technique using a P-controller-based momentum source term was developed, which allowed the transient integration time step to be increased to ∆t = 0.1 s and ensured high computational stability without the need for direct modeling of high-frequency disk oscillations. It was established that for moderate forced convection intensities, the maximum melt flow velocity correlates linearly with the maximum disk velocity vmax ≈ 2Aω. The analysis of energetic characteristics demonstrated a cubic scaling of the time-averaged viscous dissipation power Qµ proportional to A3ω3. Efficient stabilization of the crystallization front was successfully demonstrated by vibrations of the triangular cross-section disk.
- Open Access
- 13 December 2023
- Published by MDPI AG in Preprints.org
Numerical Simulation of CdTe Crystal Growth by VGF Technique Assisted by Axial Low-Frequency Oscillations of the Melt
The problem of intensification of melt crystal growth process has been analyzed using CdTe as an actual material. Numerical simulation of 100 mm diameter CdTe crystal growth by VGF technique has been carried out. The heat-mass transfer was controlled by introducing of low-frequency oscillating baffle into the melt, so called axial vibrational control (AVC) technique. The baffle configuration has been optimized to destroy solid «tails», which were formed near the crucible walls at high cooling rates due to the low thermoconductivity and the corresponding latent heat. Analysis of CdTe homogeneity range showed that during fast crystal cooling Te micro precipitations were formed resulting from decay of oversaturated Cd-riched nonstoichiometric solid solution at Bridgman crystal growth technique. A VGF grown CdTe crystal after full crystallization stays inside the phase field of the high temperature wurtzite polymorph. This makes it possible to go through the polymorph transition without Te micro-precipitating using the advantages of VGF specific feature of very slow cooling.
- 13 December 2023
- Published by MDPI AG in Preprints.org
Open AccessNumerical Simulation of CdTe Crystal Growth by VGF Technique Assisted by Axial Low-Frequency Oscillations of the Melt
The problem of intensification of melt crystal growth process has been analyzed using CdTe as an actual material. Numerical simulation of 100 mm diameter CdTe crystal growth by VGF technique has been carried out. The heat-mass transfer was controlled by introducing of low-frequency oscillating baffle into the melt, so called axial vibrational control (AVC) technique. The baffle configuration has been optimized to destroy solid «tails», which were formed near the crucible walls at high cooling rates due to the low thermoconductivity and the corresponding latent heat. Analysis of CdTe homogeneity range showed that during fast crystal cooling Te micro precipitations were formed resulting from decay of oversaturated Cd-riched nonstoichiometric solid solution at Bridgman crystal growth technique. A VGF grown CdTe crystal after full crystallization stays inside the phase field of the high temperature wurtzite polymorph. This makes it possible to go through the polymorph transition without Te micro-precipitating using the advantages of VGF specific feature of very slow cooling.