WWWenlei Wang

Wenlei Wang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Wenlei Wang has a total of 23 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Design and Analysis of Full-Metal Omnidirectional Filtenna With Improved Selectivity and Low Profile

    by Wenlei Wang, Chengjie Yang, Huayan Jin, Weiliang Yu, Ke Ming Chen, Leilei Liu, Guo Qing Luo

    Two typical equivalent circuit models for filtering antennas (filtennas) are investigated to facilitate the optimization of frequency selectivity. The circuit analysis guides the design of a full-metal omnidirectional filtenna with improved selectivity and a low profile for vehicular communications. This filtenna is primarily made of a cylindrical metal block with an inner air cavity and a circular side groove. The cavity top has four slots for independent cavity mode control, while the bottom of the groove includes another four slots to improve frequency selectivity. This custom-designed metal block centrally fed by a coaxial probe can generate two radiation nulls to synthesize the bandpass filtering characteristic, along with three resonant poles working in patch TM02, patch half-TM02, and cavity TM010 modes, respectively. The full-metal omnidirectional filtenna is fabricated, and experimental results show a–10-dB impedance bandwidth of 23.3%, a peak gain of 8.81 dBi, and excellent gain-suppression indexes of 0.13 and 0.21 for lower and upper frequency bands, respectively. In addition, a counterpart fabricated by the printed circuit board (PCB) technology is tested for comparison, which demonstrates that the low-cost full-metal design has a 3.85 dB gain improvement.

  • Copolarized In-Band Full-Duplex Radiator-Shared SIW Cavity-Backed Patch Antenna Based on Mode Superposition Method

    by Huayan Jin, Chunyang Yang, Wenlei Wang, Weiliang Yu, Guo Qing Luo

    In this communication, a co-polarized in-band full-duplex (IBFD) radiator-shared antenna based on the mode superposition method is proposed. The antenna features a single-layer design, consisting of a substrate integrated waveguide (SIW) cavity and a square metal patch, fed by a pair of symmetrically placed coaxial probes. When one port of the antenna is excited, the superposition of the TE110 mode generated by the SIW cavity and the TM01 mode generated by the patch creates an electric field null region around the unexcited port, achieving a measured peak port isolation of 48 dB without the need for additional decoupling structures. To further reduce the antenna size, a quasi-TEM SIW cavity with a lower resonant frequency than TE110 mode is employed. The miniaturized SIW cavity’s TE010 mode is used in combination with a modified patch’s TM01 mode to achieve high port isolation. Measurements demonstrate isolation greater than 22 dB across the entire operating band, with a peak isolation of 53 dB, while reducing the structure size from 0.70λ0 × 0.70λ0 × 0.03λ0 to 0.39λ0 × 0.39λ0 × 0.04λ0. The simple antenna structure requires no additional decoupling structures, making it highly suitable for applications in IBFD systems and related scenarios.


  • Low-RCS Ultrawideband Antenna Based on Band-Absorptive Frequency Selective Rasorber

    by Yufeng Yu, Weiliang Yu, Wenlei Wang, Leilei Liu, Guo Qing Luo

    A low-radar cross section (RCS) ultra-wideband antenna based on band-absorptive frequency selective rasorber (BA-FSR) is proposed for the first time in this paper. The BAFSR achieves a low-pass band (|S21|≥ –1dB) below 1.62GHz, and an absorption band between 7.2GHz and 13.6GHz. The antenna operates between 0.8 and 2.4GHz, exhibiting a gain enhancement (up to 3.6dB at 2GHz) from 1.54 to 2.25GHz after employing the BA-FSR, and achieving a 10dB RCS reduction between 7.76 and 14.2GHz. The result reveals that the transition band of BA-FSR doesn't simply deteriorate the radiation performance of the antenna, but may even improve it. This work demonstrates the significant potential of the BA-FSR for applications in lowfrequency wideband antenna systems, and has the big reference value for the integration of wideband antenna and radome.


  • Dual-Polarization Wideband Bandpass Absorptive Frequency Selective Structure With High Angular Stability

    by Yuchang Chen, Weiliang Yu, Yi Du, Wenlei Wang, Leilei Liu, Guo Qing Luo

    This paper proposes a dual-polarized bandpass absorptive frequency selective structure (AFSS) with high angular stability, achieved through the integration of dielectric matching layers (DMLs) and a metamaterial absorber (MMA). The proposed MMA is embedded within the spacer layer to stabilize the electrical length while enhancing absorption performance. An angle-stable absorber is developed using dielectric matching technology, incorporating both MMA and DML. Furthermore, this absorber is engineered into a bandpass AFSS with stable absorption bands. An additional DML positioned beneath the AFSS further improves angular stability of passband. Both simulations and experimental results demonstrate the design's angular stability up to 60° across operational band.


  • Fully Shielded Half-Mode SIW Cavity-Based Compact Filtenna for 5G n257 Operations

    by Wenlei Wang, Huayan Jin, Weiliang Yu, Leilei Liu, Guo Qing Luo

    A compact filtenna is presented in this letter based on the study on a fully shielded half-mode substrate-integrated waveguide (FSD-HMSIW) cavity. The proposed FSD-HMSIW cavity uses a shielded combined boundary instead of the open magnetic boundary, enabling radiation while preventing energy leakage into the substrate region. Resultantly, two FSD-HMSIW cavities can be closely placed to reduce the size and produce two in-band resonance poles, as well as an additional radiation null due to the electric-dominated cross coupling. By further adding a shorted concave loop, a magnetic-dominated cross coupling path can be introduced to produce a resonance pole and an extra radiation null at the lower band. The active simulation of a 1 × 8 beam scanning array verifies that the proposed compact filtenna can provide a stable bandpass filtering response over a wide beam-scanning angle of ±45°. For verification, a prototype of the proposed filtenna with a compact size of 0.32λ0 × 0.32λ0 was fabricated and tested, showing a wide bandwidth covering the 5G n257 band (26.5–29.5 GHz), a high peak gain of 6.8 dBi, excellent frequency selectivity, and good radiation patterns.


  • A Compact Dual-Band Radiator-Shared Antenna With Enhanced Isolation and Flexible Frequency Ratio Regulation

    by Wenlei Wang, Huayan Jin, Weiliang Yu, Leilei Liu, Guo Qing Luo

    In this communication, a radiator-shared duplex antenna (RSDA) with enhanced isolation, flexible frequency ratio (FR) regulation, and compact size is proposed for applications in multiband/standard communication systems. The radiator-shared design is based on a shaping scheme by utilizing a parasitic resonator to make the lower band (LB) and higher band (HB) antennas have the same radiation structure. Customized feeding methods are employed to individually excite the high-order substrate integrated waveguide (SIW) cavity mode and the fractional-order patch mode, enabling dual-band operation and allowing a flexible FR regulation from 1.3 to 1.7. The proposed RSDA eliminates the need for decoupling structures or additional duplexing/filtering circuits. Isolation enhancement of over 24 dB is accomplished by exploiting the layered feeding architecture, shielded sidewalls, and a high-pass SIW feedline to suppress the feedline coupling, surface wave interference, and out-of-band signal propagation, respectively. For verification, a prototype of the proposed RSDA was measured, demonstrating dual-wideband operation that encompasses the targeted 5G/Sub 6G n78 band (3.3–3.6 GHz) and n79 band (4.8–5 GHz). The prototype achieved a peak gain of 5.3 dBi at 3.45 GHz and 7.4 dBi at 4.95 GHz, while exhibiting a high isolation level exceeding 53 dB and good radiation patterns.


  • Open Access

    A High-Gain Series-Parallel Millimeter-Wave SIW Cavity-Backed Patch Array

    by Wenlei Wang, Huayan Jin, Lekai Zhou, Kuo-Sheng Chin, Guo Qing Luo

    This paper presents a wideband and high-gain 4 × 4 substrate integrated waveguide (SIW) cavity-backed patch array with a simplified feeding network for operation in the millimeter-wave (mmW) band. Furthermore, to improve gain and suppress the sidelobe level, a stepped waveguide horn is vertically integrated with each SIW cavity-backed patch. The proposed 4 × 4 array comprises eight series of 2 × 1 subarrays and a simplified 4-way power distribution network. In addition, two types of series-parallel 4 × 1 subarrays are examined to achieve a low sidelobe level. For verification, the proposed 4 × 4 antenna array was fabricated and measured, with the results showing good agreement with the simulations. The fabricated array prototype realized a -10 dB impedance bandwidth of 14.7% in the 24–27.8 GHz frequency band, with a peak gain of 22.05 dBi. Overall, based on its advantages—wide band, high gain, low cost, and compact feeding network—the proposed array can be considered a potential candidate for use in mmW wireless applications.


  • Low-Profile Independent Dual-Linear-Polarization Reflectarray Filtenna

    by Weiliang Yu, Shijun Tong, Wenlei Wang, Xiwang Dai, Leilei Liu, Guo Qing Luo

    This paper proposes a low-profile dual-linear polarization reflectarray filtenna with a unit cell featuring a dual-polarization magneto-electric (ME) dipole based on split-ring resonators (SRRs). The ME dipole has two independent feeding sections, each connected to a separate open-ended microstrip line, enabling independent control of dual-polarization reflection phases. The ME dipole and SRRs generate low and high frequency radiation nulls, respectively. The filtenna achieves 3dB gain bandwidths of 19.3% for x-polarization and 18.5% for y-polarization, with maximum gains of 21.77dBi (35.1% efficiency) for x-polarization and 21.93dBi (36.4% efficiency) for y-polarization. The selectivity characteristics for x- and y-polarizations are 0.5 and 0.52, respectively. With a relative thickness of only 0.072λ, this filtenna is suitable for long-distance communication systems requiring high-capacity data transmission and integration.


  • Polarization-Independent Switchable Frequency Selective Rasorber Based on Parallel DC Bias Network

    by Junbo Chen, Weiliang Yu, Wenlei Wang, Qingquan Tan, Leilei Liu, Guo Qing Luo

    This paper proposes a polarization-independent switchable (PIS) frequency selective rasorber (FSR) based on a parallel DC bias network. The design includes three layers: a non-switchable lossy layer, a PIS lossy layer, and a PIS frequency selective surface (FSS). Both the PIS FSS structure and the PIS lossy layer can control the state of each diode through a specific DC bias voltage, thus achieving polarization-independent switchable performance. Equivalent circuit models (ECMs) are developed to explain the operation. A prototype is fabricated, assembled, and tested to confirm the operational principle of the proposed PIS FSR. The measured results show an ultra-wide stealth band (|S11|≤–10dB) with a 139.2% fractional bandwidth (FBW) and a switchable transmission band for both TE and TM polarizations.


  • A Compact Harmonic-Suppressed Filtenna Based on Miniaturized High-Order Half-Mode SIW Cavity

    by Wenlei Wang, Huayan Jin, Weiliang Yu, Leilei Liu, Kuo-Sheng Chin, Guo Qing Luo

    A compact harmonic-suppressed filtenna (filtering antenna) for multi-antenna system applications is presented in this paper. It only consists of a miniaturized substrate integrated waveguide (SIW) half-TE 120 -mode cavity, a radiating patch, a row of metallic central vias, and a feeding probe. By using the shielded combined boundaries of electric via walls and U-shaped slots, the SIW half-TE 120 -mode cavity can reduce the size by 76.3%. As the reduction of size and the addition of central vias, the proposed cavity exhibits good harmonic suppression. The central vias can also be employed to push the radiation null produced by the SIW cavity half-TE 110 variant mode to the lower passband edge. Due to the cross coupling between radiators, a new radiation null can be introduced to synthesis the bandpass filtering response. Because there are neither external filtering circuits nor special parasitic filtering resonators, the structure of the proposed filtenna can be kept simple. A prototype centered at 5 GHz was fabricated and measured for demonstration, indicating an impedance bandwidth of 14.4%, a peak gain of 7 dBi, and a wide stopband up to 10 GHz.