Jianyu Ye
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jianyu Ye has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Guang Hua
State Key Laboratory of Millimeter Waves, School of Information Science and Engineering, Southeast University, Nanjing, China
4 shared publications - Jianbo Wang
State Key Laboratory of Millimeter Waves, School of Information Science and Engineering Southeast University Nanjing China
4 shared publications - Jianqing Sun
State Key Laboratory of Millimeter Waves, School of Information Science and Engineering, Southeast University, Nanjing, China
3 shared publications - Xiaoliang Wu
State Key Laboratory of Millimeter Waves, School of Information Science and Engineering, Southeast University, Nanjing, China
3 shared publications Guang Hua
State Key Laboratory of Millimeter Waves, School of Information Science and Engineering Southeast University Nanjing China
1 shared publication- Ke Zhang
State Key Laboratory of Millimeter Waves, School of Information Science and Engineering, Southeast University, Nanjing, China
1 shared publication
Latest Publications
- Open Access
- 10 July 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 13, 126574-126581
A Novel Design of Non-Uniform Limited Scan Array Based on Tri-Polarized Metamaterial Element
Limited scan arrays have attracted a lot of attentions in recent years, due to its many merits, such as fewer array elements, lower weight and easy heat dissipation of transmit and receive(T/R) channels. In the conventional literature, the subarray is usually chosen as the radiation element, however the subarray need an additional passive feeding network, which will cause an additional insertion loss and cost. Also, as far as we know, the grating lobes caused by large array element spacing haven’t been perfectly eliminated in the published literature. In this paper, we firstly design a tri-polarized metamaterial element with the “flat-top” pattern, and then design a non-uniform linear limited scan array with large spacing based on the proposed metamaterial element. Measurement results demonstrate that the metamaterial element exhibits nearly identical voltage standing wave ratio and radiation patterns under excitation for all three polarizations, indicating promising application prospects in polarization-diversity radar. Furthermore, simulation results indicate that this element also exhibits a certain level of grating lobe suppression effect in large-element-spacing, non-uniform linear arrays within the limited-scan domain.
- 10 July 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 13, 126574-126581
Open AccessA Novel Design of Non-Uniform Limited Scan Array Based on Tri-Polarized Metamaterial Element
Limited scan arrays have attracted a lot of attentions in recent years, due to its many merits, such as fewer array elements, lower weight and easy heat dissipation of transmit and receive(T/R) channels. In the conventional literature, the subarray is usually chosen as the radiation element, however the subarray need an additional passive feeding network, which will cause an additional insertion loss and cost. Also, as far as we know, the grating lobes caused by large array element spacing haven’t been perfectly eliminated in the published literature. In this paper, we firstly design a tri-polarized metamaterial element with the “flat-top” pattern, and then design a non-uniform linear limited scan array with large spacing based on the proposed metamaterial element. Measurement results demonstrate that the metamaterial element exhibits nearly identical voltage standing wave ratio and radiation patterns under excitation for all three polarizations, indicating promising application prospects in polarization-diversity radar. Furthermore, simulation results indicate that this element also exhibits a certain level of grating lobe suppression effect in large-element-spacing, non-uniform linear arrays within the limited-scan domain.
- 13 June 2025
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 67 (6)
Broadband and Compact Tunable Reflection‐Type Phase Shifter Based on Microstrip Slotline Coupler
This paper presents a broadband and compact tunable reflection‐type phase shifter based on microstrip slotline coupler. The phase shifter consists of a microstrip slotline 3 dB coupler, along with two identical reflected loads made of variable capacitors and high‐impedance transmission lines shorter than a quarter wavelength. This structure increases the bandwidth of reflection‐type phase shifter and reduces the maximum insertion loss and the fluctuation of insertion loss. The measured return loss of the phase shifter shows a 47.2% bandwidth better than 10 dB, with center frequency insertion loss of 1.0∼2.7 dB and a maximum phase shift of . The phase shifter occupies an area of at 3.6 GHz.
- 13 June 2025
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 67 (6)
Broadband and Compact Tunable Reflection‐Type Phase Shifter Based on Microstrip Slotline Coupler
This paper presents a broadband and compact tunable reflection‐type phase shifter based on microstrip slotline coupler. The phase shifter consists of a microstrip slotline 3 dB coupler, along with two identical reflected loads made of variable capacitors and high‐impedance transmission lines shorter than a quarter wavelength. This structure increases the bandwidth of reflection‐type phase shifter and reduces the maximum insertion loss and the fluctuation of insertion loss. The measured return loss of the phase shifter shows a 47.2% bandwidth better than 10 dB, with center frequency insertion loss of 1.0∼2.7 dB and a maximum phase shift of . The phase shifter occupies an area of at 3.6 GHz.
- 6 May 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 35 (8) , 1158-1161
Highly Balanced Hybrid Ring Based on Microstrip Slotline Tight Coupling
This letter presents a compact, highly balanced broadband hybrid ring. The device replaces the $3\lambda /4$ segment of the traditional hybrid ring with a $\lambda /4~3$ -dB microstrip slotline coupled line to reduce the size. This hybrid ring only requires simple manufacturing techniques and a single-layer substrate with a size of $0.32\times 0.34\lambda _{g}$ . The measured relative bandwidth with a return loss better than 10 dB is 80.6%, and the amplitude imbalance measured in 2.5–4.8 GHz is less than 0.1 dB. The simulation and experimental results are consistent.
- 6 May 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 35 (8) , 1158-1161
Highly Balanced Hybrid Ring Based on Microstrip Slotline Tight Coupling
This letter presents a compact, highly balanced broadband hybrid ring. The device replaces the $3\lambda /4$ segment of the traditional hybrid ring with a $\lambda /4~3$ -dB microstrip slotline coupled line to reduce the size. This hybrid ring only requires simple manufacturing techniques and a single-layer substrate with a size of $0.32\times 0.34\lambda _{g}$ . The measured relative bandwidth with a return loss better than 10 dB is 80.6%, and the amplitude imbalance measured in 2.5–4.8 GHz is less than 0.1 dB. The simulation and experimental results are consistent.
- 9 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 23 (10) , 3108-3112
A Novel Two-Way Pattern Synthesis Method With the Uniform and Thinned Arrays
In this letter, a novel two-way product pattern synthesis method utilizing a uniform transmit array and a thinned receive array is proposed. Specifically, the thinned receive array is an extended coprime array (ECA). Based on the ECA's characteristics, the ECA's array factor is decomposed into the product of the slow-varying array factor and the fast-varying array factor. Subsequently, the positions of nulls and the first sidelobe of the ECA are derived, respectively. It reveals that the fast-varying array factor plays a dominant role in the positions of nulls and the first sidelobe. The ECA architecture is optimized for element number and element spacing using the combinatorial traversal algorithm (CTA). It enables the alignment of nulls and the first sidelobe between the uniform array and the ECA. Compared to the traditional uniform transmit-receive method with the same number of elements, a two-way product pattern with a lower peak sidelobe level (SLL), a larger aperture, a narrower beamwidth, and a higher resolution can be achieved by the proposed method. The efficiency of the proposed method has been validated by typical simulation results.
- 9 July 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Antennas and Wireless Propagation Letters
- Vol. 23 (10) , 3108-3112
A Novel Two-Way Pattern Synthesis Method With the Uniform and Thinned Arrays
In this letter, a novel two-way product pattern synthesis method utilizing a uniform transmit array and a thinned receive array is proposed. Specifically, the thinned receive array is an extended coprime array (ECA). Based on the ECA's characteristics, the ECA's array factor is decomposed into the product of the slow-varying array factor and the fast-varying array factor. Subsequently, the positions of nulls and the first sidelobe of the ECA are derived, respectively. It reveals that the fast-varying array factor plays a dominant role in the positions of nulls and the first sidelobe. The ECA architecture is optimized for element number and element spacing using the combinatorial traversal algorithm (CTA). It enables the alignment of nulls and the first sidelobe between the uniform array and the ECA. Compared to the traditional uniform transmit-receive method with the same number of elements, a two-way product pattern with a lower peak sidelobe level (SLL), a larger aperture, a narrower beamwidth, and a higher resolution can be achieved by the proposed method. The efficiency of the proposed method has been validated by typical simulation results.
- 29 August 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 59 (6) , 9807-9820
RCS Statistical Modeling of Stealth Targets Based on Fractional-Order Legendre Polynomials
In contrast to conventional targets, the electromagnetic simulation results of stealth targets usually exhibit the low radar cross section (RCS) scattering properties. Furthermore, electromagnetic simulation results of a typical stealth aircraft model show that the RCS statistical characteristics of stealth targets are skewed toward the low RCS side and typically exhibit the sharp fluctuation and oscillatory decaying characteristics exemplified by a typical stealth aircraft model. In this research, a fractional-order Legendre polynomial series-based (FLP) RCS distribution model is proposed to more precisely fit the RCS statistical properties of stealth targets. Compared with the conventional Legendre polynomial-series-based (LP) RCS distribution model, the biased side of the FLP RCS distribution model can be adjusted to adapt to the RCS statistical characteristics of stealth targets by varying the fractional order $\alpha$ . Based on this characteristic, the FLP RCS distribution model is adaptable to a variety of scenarios. Especially, the shifted Legendre polynomial-series-based (SLP) RCS distribution model with lower complexity is derived from the FLP RCS distribution model by setting $\alpha =1$ . In addition, the fundamental statistics of the FLP and SLP RCS distribution models, including the cumulative distribution function (CDF), moment generating function (MGF), and higher-order moments, are derived. Simulation results indicate that the FLP RCS distribution model can obtain better fitting results than the conventional RCS distribution models. SLP RCS distribution model fitting results for low RCS scattering areas of stealth targets are comparable to FLP RCS distribution model results.
- 29 August 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 59 (6) , 9807-9820
RCS Statistical Modeling of Stealth Targets Based on Fractional-Order Legendre Polynomials
In contrast to conventional targets, the electromagnetic simulation results of stealth targets usually exhibit the low radar cross section (RCS) scattering properties. Furthermore, electromagnetic simulation results of a typical stealth aircraft model show that the RCS statistical characteristics of stealth targets are skewed toward the low RCS side and typically exhibit the sharp fluctuation and oscillatory decaying characteristics exemplified by a typical stealth aircraft model. In this research, a fractional-order Legendre polynomial series-based (FLP) RCS distribution model is proposed to more precisely fit the RCS statistical properties of stealth targets. Compared with the conventional Legendre polynomial-series-based (LP) RCS distribution model, the biased side of the FLP RCS distribution model can be adjusted to adapt to the RCS statistical characteristics of stealth targets by varying the fractional order $\alpha$ . Based on this characteristic, the FLP RCS distribution model is adaptable to a variety of scenarios. Especially, the shifted Legendre polynomial-series-based (SLP) RCS distribution model with lower complexity is derived from the FLP RCS distribution model by setting $\alpha =1$ . In addition, the fundamental statistics of the FLP and SLP RCS distribution models, including the cumulative distribution function (CDF), moment generating function (MGF), and higher-order moments, are derived. Simulation results indicate that the FLP RCS distribution model can obtain better fitting results than the conventional RCS distribution models. SLP RCS distribution model fitting results for low RCS scattering areas of stealth targets are comparable to FLP RCS distribution model results.