HTHidekazu Tsuchida

Hidekazu Tsuchida

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Hidekazu Tsuchida has a total of 82 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Characterization and modeling of forward current conduction in 4H-SiC PiN diodes based on device simulation analysis

    by Satoshi Asada, Koichi Murata, Tsubasa Shiono, Naoto Ishibashi, Yuichiro Mabuchi, Hidekazu Tsuchida

    The decay curves in time-resolved photoluminescence (TRPL) characteristics of n-type 4H-SiC epilayers were simulated by a technology computer aided design (TCAD) and compared with experimental results. In the simulation of TRPL decay curves, the direct recombination rate in the epilayer after illuminating samples with a pulse laser was regarded as the PL intensity. The simulated time-dependent PL intensities were fitted to the experimental results by adjusting the parameter AP, which characterizes Shockley–Read–Hall carrier recombination ratio. By employing the value of AP determined from the analysis on TRPL decay curves, a successful reproduction of experimental current–voltage characteristics of SiC PiN diodes fabricated on the epilayers was achieved by TCAD simulation at various temperatures ranging from 300 to 523 K.

  • Photoionization Current Spectroscopy of Individual Silicon Vacancies in Silicon Carbide

    by Kazuki Okajima, Tetsuri Nishikawa, Hiroshi Abe, Koichi Murata, Takeshi Ohshima, Hidekazu Tsuchida, Naoya Morioka, Norikazu Mizuochi

    Defect charge-state dynamics are central to both spin−photon interfaces and photoelectrical spin readout. Despite the significance of silicon vacancies (V1/V2) in silicon carbide (4H-SiC) for both applications, their ionization behavior has remained unclear because conventional optical charge-state analysis is prevented by undetectable optical blinking. Here, we employ photocurrent spectroscopy of individual defects to measure the wavelength-dependent ionization cross sections. We reveal similar ionization cross sections for V1 and V2, increasing toward shorter wavelengths, while carbon vacancies dominate the more steeply increasing background photocurrent. These results indicate that, under resonant excitation at the respective ZPLs, V2 is less susceptible to photoionization, and its surrounding background defects are less ionized than V1. We also identify wavelength regimes that optimize defect-origin photocurrent for photoelectrical spin readout relative to background contributions, which differ between single-defect and ensemble measurements. Our results establish photocurrent spectroscopy as a powerful complement to optical methods, advancing defect-based quantum device development.


  • Open Access

    The critical excitation intensity for expansion of single Shockley stacking fault in 4H-silicon carbide: Experimental study

    by Koji Maeda, Koichi Murata, Satoshi Asada, Hidekazu Tsuchida

    Mechanical stressing experiments devised to evaluate the formation energy of a single Shockley stacking fault (1SSF) γ1SSF have been conducted with the use of photoluminescence imaging of partial dislocations bounding 1SSFs in various 4H-SiC epilayers. Elaborate care was taken to avoid the blocking effect of point obstacles on the glide motion of partial dislocations that enables expansion and contraction of the 1SSFs. Analysis of the experimental results appears to show apparently different values of γ1SSF between n-type and p-type samples. Conversely, the critical ultraviolet light intensity that demarcates 1SSF expansion and contraction showed a similar temperature dependence for n-type and p-type samples.

  • Open Access

    The critical excitation intensity for expansion of single Shockley stacking fault in 4H-silicon carbide: Theoretical study

    by Koji Maeda, Satoshi Asada, Koichi Murata, Hidekazu Tsuchida

    Modeling the single Shockley stacking fault (1SSF) in 4H-silicon carbide as a classical well built in the bottom of the conduction band, technical computer-aided design simulations were conducted rigorously incorporating carrier recombination at the 1SSF. The experimentally observed temperature dependences of the critical photoexcitation intensity for 1SSF expansion can be reproduced only if the radiative recombination coefficient in the 1SSF at room temperature is enhanced by a factor of about 103 times larger than the value in the matrix. The primary cause of energy reduction Δγ due to the presence of the 1SSF is such enhanced carrier recombination in the 1SSF. However, the main contribution to Δγ arises from the reduction in electronic energy in the perfect matrix surrounding the 1SSF over the range of minority carrier diffusion length. This provides another reason why 1SSF expansion is suppressed by the reduction in carrier lifetime. The cause of the apparent discrepancy of experimentally evaluated γ1SSF, the formation energy of the 1SSF in thermo-equilibrium, between n- and p-type samples obtained in mechanical stressing experiments can be attributed to the nonlinear dependence of Δγ on the electron–hole generation rate in the low-injection regime and the inherent difference in the degree of the nonlinearity between n- and p-type samples. The value of γ1SSF is considered to be closer to 7.9 ± 1.3 mJ/m2, which is experimentally deduced in p-type samples.

  • Open Access

    Vanadium photoluminescence in 3C-SiC

    by Danial Shafizadeh, Valdas Jokubavicius, Koichi Murata, Hidekazu Tsuchida, Péter Udvarhelyi, Guodong Bian, Oliver Lang, Merve Karaman, Diego Haya Enriquez, Moritz Brehm, et al.

    Early investigations on vanadium in the cubic 3C-SiC polytype concluded that the luminescence of the center is not possible because the excited state is degenerate with the conduction band. However, later work refuted this notion, demonstrating a doublet in photoluminescence (PL) at ∼ 1493 – 1495 nm , apparently associated with vanadium (V). In this work, we undertake a detailed experimental and theoretical study of the V center in 3C-SiC. We show that the vanadium PL can be seen as a recombination of an exciton bound to V, in contrast to the other two common hexagonal polytypes (4H- and 6H-SiC), where the PL is due to an interatomic transition of the 3 d electron within the V center, according to a well-established model. We also show that the splitting observed in the PL lines is likely not inherent to the center and is due to stress present in the samples. Ideally, in a strain-free 3C-SiC material, the vanadium PL will comprise a single line, which makes the V center in this polytype attractive for applications as a qubit at moderate temperatures. This contrasts with the hexagonal polytypes where the splitting of the zero-phonon line is inherent to the center due to the crystal structure, which has a negative effect on the spin coherence at liquid helium temperature, and millikelvin temperatures are needed to improve the spin coherence.


  • Open Access

    Coherent photoelectrical readout of single spins in silicon carbide at room temperature

    by Tetsuri Nishikawa, Naoya Morioka, Hiroshi Abe, Koichi Murata, Kazuki Okajima, Takeshi Ohshima, Hidekazu Tsuchida, Norikazu Mizuochi

    Establishing a robust and integratable quantum system capable of sensitive qubit readout at ambient conditions is a key challenge for developing prevalent quantum technologies, including quantum networks and quantum sensing. Paramagnetic colour centres in wide bandgap semiconductors provide optical single-spin detection, yet realising efficient electrical readout technology in scalable material will unchain developing integrated ambient quantum electronics. Here, we demonstrate photoelectrical detection of single spins in silicon carbide, a material amenable to large-scale processing and electronic integration. With efficient photocarrier collection, we achieve a 1.7–2 times better signal-to-noise ratio for single spins of silicon vacancies with electrical detection than with optical detection suffering from saturating fluorescence and internal reflection. Based on our photoionisation dynamics study, further improvement would be expected with enhanced ionisation. We also observe single-defect-like features in the photocurrent image where photoluminescence is absent in the spectrum range of silicon vacancies. The efficient electrical readout in the mature material platform holds promise for developing integrated quantum devices.


  • Open Access

    Impacts of single Shockley-type stacking faults on current conduction in 4H-SiC PiN diodes

    by Satoshi Asada, Koichi Murata, Hidekazu Tsuchida

    The impacts of single Shockley-type stacking faults (1SSFs) on the electrical characteristics of 4H-SiC PiN diodes were examined by fabricating the PiN diodes containing the 1SSF monolayer in the active area with a covering ratio of unity and evaluating the forward current–voltage (I–V) characteristics at various temperatures from 296 to 523 K. The measured I–V characteristics were compared with the previous results for Schottky barrier diodes (SBDs) containing the 1SSF monolayer. Based on the comparison, we clarified the similarity and differences between the impacts of the 1SSFs on the unipolar and bipolar conductions. The forward current conduction of the PiN diodes is limited by the 1SSF similar to that of the SBDs, while the forward current in the PiN diodes exceeds that in the SBDs at elevated temperatures. The difference was attributed to the contribution of hole and recombination currents, the insights into which were obtained by analyzing several experimental results, including dependences of the forward current on the temperature and thickness of the blocking-voltage layer. A simulation analysis was also conducted by adopting the model proposed in the previous study.


  • Open Access

    Formation of basal plane dislocations by stress near epilayer/substrate interface of large-diameter SiC wafers with thick epitaxial layers

    by Fumihiro Fujie, Tsubasa Shiono, Koichi Murata, Naoto Ishibashi, Yuichiro Mabuchi, Hidekazu Tsuchida

    For large-diameter (150 mm) SiC epitaxial wafers with thick n− epilayers, stress analysis based on the finite element method and defect characterization near the epi/sub interface by synchrotron x-ray topography were performed. Observations on epitaxial wafers with epilayer thicknesses of 10, 20, 50, and 100 μm revealed that basal plane dislocation (BPD) half-loops were formed near triangular defects or from the edge of the wafer at an epilayer thickness of 50 μm and above. Two types of BPD half-loops with different edge components were observed: one with an extra half-plane above the core and present on the substrate side, and the other with a Burgers vector of opposite sign and present in the epilayer and at the epi/sub interface, forming an interfacial dislocation. The signs of these BPDs are consistent with those predicted from the calculation results, which mitigate compressive and tensile stresses in the epilayer and the substrate, respectively. It is considered that a thicker epilayer increases tensile stress in the substrate, which induces the formation of the BPD with an extra half-plane above the core on the substrate side. The distribution of the BPD half-loop width was also analyzed and compared with the calculated shear stress distribution caused by the radial temperature gradient. Calculations considering the local stress near the triangular defect revealed that the tensile stress near the epi/sub interface locally increases, exceeding the critical stress to form BPD, with an extra half-plane above the core for wafers with an epilayer thickness above 50 μm.


  • Open Access

    Experimental determination of intrinsic carrier density in 4H-SiC based on electron diffusion current in an npn bipolar junction transistor

    by Satoshi Asada, Koichi Murata, Hajime Tanaka, Hidekazu Tsuchida

    The intrinsic carrier density of 4H-SiC at temperatures ranging from 294 to 595 K was derived by analyzing a collector current in an npn-type SiC bipolar junction transistor, the structure of which was designed based on a device simulation. The obtained intrinsic carrier density was in good agreement with the value calculated from the bandgap and effective densities of states taking multiple and non-parabolic SiC bands into account. The coincidence of the intrinsic carrier density obtained by these two different approaches indicates the usefulness of the proposed method and the validity of the evaluated value of intrinsic carrier density. The temperature dependence of the bandgap was also estimated from the deduced intrinsic carrier density and compared with an empirical formula. The derived bandgap agreed well with the empirical formula showing bandgap shrinkage at high temperatures. The errors in evaluating the intrinsic carrier density and the bandgap caused by the estimation of the hole density and electron mobility in the base layer are also discussed for the proposed method.