Fatma Tuba Kıraç Demirel
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Fatma Tuba Kıraç Demirel has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Adnan Fatih Dagdelen
Department of Food Engineering, Faculty of Engineering and Natural Science, Bursa Technical University, 16310 Bursa, Türkiye
2 shared publications Fatma Tuba
2 shared publications- Furkan Turker Saricaoglu
Department of Food Engineering, Faculty of Engineering and Natural Science, Bursa Technical University, 16310 Bursa, Türkiye
2 shared publications - Yasemin Sahan
Department of Food Engineering, Faculty of Agriculture Bursa Uludag University Bursa Türkiye
2 shared publications Adnan Fatih
1 shared publicationAdnan Fatih Dağdelen
1 shared publication
Latest Publications
- Open Access
- 5 June 2026
- Published by Springer Nature in Journal of Food Measurement and Characterization
- p. 1-18
Effect of fibroin-based edible coatings enriched with mulberry leaf extract on postharvest quality and bioactive properties of table grapes
Natural edible coatings offer a sustainable approach to extending fruit shelf life; however, their potential for antidiabetic bioactivities and impact on the glycemic response of fresh fruits remain largely unexplored. This study proposes a novel edible coating leveraging the biocompatibility and film-forming ability of fibroin, enriched with the bioactive potential of Morus alba leaf extract (MLE), to simultaneously enhance shelf life and impart antidiabetic functionality to table grapes. Following the optimization of MLE extraction via response surface methodology (maximum 1-deoxynojirimycin (DNJ) content: 6.8 mg/g DW), fibroin-based coatings (8%) containing 2–8% MLE were formulated and characterized for their antioxidant, in vitro antidiabetic, and antimicrobial activities before being applied to ‘Ata Sarısı’ and ‘Red Globe’ grape varieties. During 20 days of storage at 4 °C and 21 °C, the coatings effectively maintained postharvest quality by reducing weight loss and preserving fruit firmness compared to uncoated controls. Furthermore, MLE-enriched coatings significantly enhanced total phenolic content, antioxidant capacity, and in vitro α-amylase and α-glucosidase inhibition, while effectively reducing the in vitro glycemic index (GI) and microbial growth, particularly under cold storage. Among the formulations, the RG-8-4 treatment exhibited the most potent effects (TPC: 225.44 mg GAE/100 g; CUPRAC: 73.24 µmol TE/100 g; α-amylase inhibition: 42.37%; α-glucosidase inhibition: 53.65%; and GI: 46.25). These findings demonstrate that fibroin-based edible coatings enriched with MLE represent a promising functional solution for extending shelf life while developing fresh fruits with significant antidiabetic and antimicrobial potential.
- 5 June 2026
- Published by Springer Nature in Journal of Food Measurement and Characterization
- p. 1-18
Open AccessEffect of fibroin-based edible coatings enriched with mulberry leaf extract on postharvest quality and bioactive properties of table grapes
Natural edible coatings offer a sustainable approach to extending fruit shelf life; however, their potential for antidiabetic bioactivities and impact on the glycemic response of fresh fruits remain largely unexplored. This study proposes a novel edible coating leveraging the biocompatibility and film-forming ability of fibroin, enriched with the bioactive potential of Morus alba leaf extract (MLE), to simultaneously enhance shelf life and impart antidiabetic functionality to table grapes. Following the optimization of MLE extraction via response surface methodology (maximum 1-deoxynojirimycin (DNJ) content: 6.8 mg/g DW), fibroin-based coatings (8%) containing 2–8% MLE were formulated and characterized for their antioxidant, in vitro antidiabetic, and antimicrobial activities before being applied to ‘Ata Sarısı’ and ‘Red Globe’ grape varieties. During 20 days of storage at 4 °C and 21 °C, the coatings effectively maintained postharvest quality by reducing weight loss and preserving fruit firmness compared to uncoated controls. Furthermore, MLE-enriched coatings significantly enhanced total phenolic content, antioxidant capacity, and in vitro α-amylase and α-glucosidase inhibition, while effectively reducing the in vitro glycemic index (GI) and microbial growth, particularly under cold storage. Among the formulations, the RG-8-4 treatment exhibited the most potent effects (TPC: 225.44 mg GAE/100 g; CUPRAC: 73.24 µmol TE/100 g; α-amylase inhibition: 42.37%; α-glucosidase inhibition: 53.65%; and GI: 46.25). These findings demonstrate that fibroin-based edible coatings enriched with MLE represent a promising functional solution for extending shelf life while developing fresh fruits with significant antidiabetic and antimicrobial potential.
- Open Access
- 21 May 2026
- Published by Springer Nature in Food Biophysics
- Vol. 21 (2) , 67
Enhancement of Starch-Based Biodegradable Films Through Single and Multiple Crosslinking Agents for Potential Packaging Applications
In this study, the suitability of starch as a biodegradable packaging material was enhanced through single and multiple applications of three cross-linking agents (CLA) (citric acid, boric acid, glutaraldehyde). 12 film formulations containing 2–8% CLA were prepared using the casting method. The films were characterized for molecular structure, optical properties, thickness, mechanical properties, water vapor permeability (WVP), and crystallinity. The mechanical and barrier properties, which are critical for packaging performance, were evaluated using the multi-criteria decision-making method (TOPSIS), and 4 formulations with the most favorable properties were selected. The selected films were subjected to further analyses, including surface topography, microstructural properties, water contact angle (WCA) and puncture resistance. While the incorporation of CLA did not significantly influence the optical properties of the films, it resulted in a reduction in WVP and an increase in crystallinity. Films containing boric acid exhibited enhanced tensile strength. According to TOPSIS, the application of CLA generally decreased the WCA, indicating modified surface wettability, whereas puncture resistance properties were strongly dependent on both the type of CLA and the cross-linking strategy employed. The use of multiple CLA led to significant improvements in puncture strength and elongation, while single citric acid application reduced these parameters. Cross-linking reduced the granular surface structure observed in the control film, yielding a more homogeneous surface with increased roughness. Overall, the findings demonstrate that a multiple cross-linking strategy effectively enhances the mechanical, barrier, and surface properties of starch-based packaging films, highlighting its strong potential for biodegradable packaging applications.
- 21 May 2026
- Published by Springer Nature in Food Biophysics
- Vol. 21 (2) , 67
Open AccessEnhancement of Starch-Based Biodegradable Films Through Single and Multiple Crosslinking Agents for Potential Packaging Applications
In this study, the suitability of starch as a biodegradable packaging material was enhanced through single and multiple applications of three cross-linking agents (CLA) (citric acid, boric acid, glutaraldehyde). 12 film formulations containing 2–8% CLA were prepared using the casting method. The films were characterized for molecular structure, optical properties, thickness, mechanical properties, water vapor permeability (WVP), and crystallinity. The mechanical and barrier properties, which are critical for packaging performance, were evaluated using the multi-criteria decision-making method (TOPSIS), and 4 formulations with the most favorable properties were selected. The selected films were subjected to further analyses, including surface topography, microstructural properties, water contact angle (WCA) and puncture resistance. While the incorporation of CLA did not significantly influence the optical properties of the films, it resulted in a reduction in WVP and an increase in crystallinity. Films containing boric acid exhibited enhanced tensile strength. According to TOPSIS, the application of CLA generally decreased the WCA, indicating modified surface wettability, whereas puncture resistance properties were strongly dependent on both the type of CLA and the cross-linking strategy employed. The use of multiple CLA led to significant improvements in puncture strength and elongation, while single citric acid application reduced these parameters. Cross-linking reduced the granular surface structure observed in the control film, yielding a more homogeneous surface with increased roughness. Overall, the findings demonstrate that a multiple cross-linking strategy effectively enhances the mechanical, barrier, and surface properties of starch-based packaging films, highlighting its strong potential for biodegradable packaging applications.
- Open Access
Concentration-Dependent Reinforcement and Structural Modulation of Silk Fibroin Films Induced by Mulberry Leaf Extract for Sustainable Bio-Based Materials
Fibroin-based films represent a promising platform for sustainable and bio-derived materials. Existing literature has mainly focused on isolated molecules, plasticizers, or chemical cross-linkers, and the function of complex, multi-component natural extracts as structure-modulating agents in fibroin films remains poorly understood. In this study, edible films containing mulberry leaf extract (MLE; 2–8 wt%) and fibroin (8 wt%) were prepared by solution casting, and their structures were investigated using spectroscopic, morphological, thermal, mechanical, and barrier property analyses. The results reveal that MLE induces concentration-dependent changes in film performance through multicomponent, non-covalent interactions with the fibroin. An approximately 187% increase in tensile strength was achieved at high MLE concentration, confirming effective physical reinforcement. The water vapor transmission rate decreased markedly from 0.888 to 0.170 g·h−1·m−2, indicating an enhanced moisture barrier, whereas oxygen permeability increased at higher extract loadings, suggesting localized chain rearrangements. High optical transparency in the visible region was maintained (79.95–83.77%), while UV response was selectively altered with extract concentration. Overall, the 8MLE formulation exhibited the most balanced performance. This study demonstrates that plant-derived extracts can serve as effective natural modifiers for tailoring fibroin film properties without inducing crystallization, offering a sustainable strategy for designing bio-based and edible protein film systems.
Open AccessConcentration-Dependent Reinforcement and Structural Modulation of Silk Fibroin Films Induced by Mulberry Leaf Extract for Sustainable Bio-Based Materials
Fibroin-based films represent a promising platform for sustainable and bio-derived materials. Existing literature has mainly focused on isolated molecules, plasticizers, or chemical cross-linkers, and the function of complex, multi-component natural extracts as structure-modulating agents in fibroin films remains poorly understood. In this study, edible films containing mulberry leaf extract (MLE; 2–8 wt%) and fibroin (8 wt%) were prepared by solution casting, and their structures were investigated using spectroscopic, morphological, thermal, mechanical, and barrier property analyses. The results reveal that MLE induces concentration-dependent changes in film performance through multicomponent, non-covalent interactions with the fibroin. An approximately 187% increase in tensile strength was achieved at high MLE concentration, confirming effective physical reinforcement. The water vapor transmission rate decreased markedly from 0.888 to 0.170 g·h−1·m−2, indicating an enhanced moisture barrier, whereas oxygen permeability increased at higher extract loadings, suggesting localized chain rearrangements. High optical transparency in the visible region was maintained (79.95–83.77%), while UV response was selectively altered with extract concentration. Overall, the 8MLE formulation exhibited the most balanced performance. This study demonstrates that plant-derived extracts can serve as effective natural modifiers for tailoring fibroin film properties without inducing crystallization, offering a sustainable strategy for designing bio-based and edible protein film systems.
- Open Access
- 14 August 2024
- Published by Association of Food Technology, Turkey in Gıda
- Vol. 49 (4) , 624-640
PREVENTING OF MIGRATION IN FOOD CONTACT POLYVINYL CHLORIDE-BASED STRETCH FILMS WITH POLYLACTIC ACID LAYER
In this study, the effectiveness of biodegradable polylactic acid (PLA) coatings for the prevention of residues migrating through polyvinyl chloride (PVC) films was investigated. PLA films prepared in chloroform at concentrations of 5, 10, 15 and 20 wt% were heat sealed to PVC film surfaces in a hot press (130 °C, 5 min, 5 tons). Physical, mechanical, FTIR and migration analyses were performed on these two-layer films. With PLA coating, the thickness of the films increased, mechanical properties decreased and some changes in color values occurred. It was determined by FTIR that there was no structural change on both surfaces of the films as a result of hot pressing. From the overall migration analysis, no migration was observed in the tests with aqueous food simulants, while migration was detected in fatty food simulants. In the specific migration analysis by GC-MS, di-2-ethylhexyl phthalate (DEHP) migration decreased by 50% with PLA coating. It is concluded that PLA coating of PVC stretch films may be a promising application to reduce migration.
- 14 August 2024
- Published by Association of Food Technology, Turkey in Gıda
- Vol. 49 (4) , 624-640
Open AccessPREVENTING OF MIGRATION IN FOOD CONTACT POLYVINYL CHLORIDE-BASED STRETCH FILMS WITH POLYLACTIC ACID LAYER
In this study, the effectiveness of biodegradable polylactic acid (PLA) coatings for the prevention of residues migrating through polyvinyl chloride (PVC) films was investigated. PLA films prepared in chloroform at concentrations of 5, 10, 15 and 20 wt% were heat sealed to PVC film surfaces in a hot press (130 °C, 5 min, 5 tons). Physical, mechanical, FTIR and migration analyses were performed on these two-layer films. With PLA coating, the thickness of the films increased, mechanical properties decreased and some changes in color values occurred. It was determined by FTIR that there was no structural change on both surfaces of the films as a result of hot pressing. From the overall migration analysis, no migration was observed in the tests with aqueous food simulants, while migration was detected in fatty food simulants. In the specific migration analysis by GC-MS, di-2-ethylhexyl phthalate (DEHP) migration decreased by 50% with PLA coating. It is concluded that PLA coating of PVC stretch films may be a promising application to reduce migration.
- 27 December 2023
- Published by Elsevier in Food Hydrocolloids
- Vol. 150
Gelatin extraction from chicken skin by conventional and Ohmic heating methods and comparison with commercial halal gelatins
- 27 December 2023
- Published by Elsevier in Food Hydrocolloids
- Vol. 150
Gelatin extraction from chicken skin by conventional and Ohmic heating methods and comparison with commercial halal gelatins
- Open Access
- 24 December 2023
- Published by Elsevier in Food Chemistry Advances
- Vol. 4
Isolation and characterization of a new potential source of bioactive peptides: White mulberry (Morus alba) fruits and its leaves
- 24 December 2023
- Published by Elsevier in Food Chemistry Advances
- Vol. 4
Open AccessIsolation and characterization of a new potential source of bioactive peptides: White mulberry (Morus alba) fruits and its leaves