Jianer Zhou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jianer Zhou has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
Qifu Bao
School of Materials Science and Engineering, Jingdezhen Ceramic University, Jingdezhen, People’s Republic of China
5 shared publicationsTiangui Zhao
School of Materials Science and Engineering, Jingdezhen Ceramic University, Jingdezhen, People’s Republic of China
5 shared publicationsLi Liu
School of Materials Science and Engineering, Jingdezhen Ceramic University, Jingdezhen, People’s Republic of China
4 shared publicationsWei Zhu
Department of Mathematics and Physics, Quzhou University, Quzhou, People’s Republic of China
4 shared publicationsXiaolong Li
School of Materials Science and Engineering, Jingdezhen Ceramic University, Jingdezhen, People’s Republic of China
4 shared publicationsDetai Shi
School of Materials Science and Engineering, Jingdezhen Ceramic University, Jingdezhen, People’s Republic of China
3 shared publications
Latest Publications
- Open Access
- 27 September 2024
- Published by Springer Nature in Scientific Reports
- Vol. 14 (1) , 1-12
Study on the mechanism of ROS-induced oxidative stress injury and the broad-spectrum antimicrobial performance of nickel ion-doped V6O13 powder
In this study, pure V6O13 and nickel ion-doped V6O13 powders were synthesized by a simple hydrothermal-calcination method, and their broad-spectrum antimicrobial properties and mechanisms were investigated. The crystal structure, morphology, and chemical state of the powders were thoroughly analyzed by XRD, SEM, TEM, XPS, and UV–Vis. Their antimicrobial properties and mechanisms were evaluated by the ring of inhibition, bio-SEM, live-dead cell staining, ROS detection, and protein leakage experiments. The results showed that nickel ion doping modulated the oxygen defects of V6O13, generating more reactive oxygen species and leading to more severe oxidative stress, resulting in a broad-spectrum and highly efficient antimicrobial effect. This study also revealed the antimicrobial mechanism based on oxygen defect -induced ROS production, which caused cellular oxidative stress damage, leading to leakage of intracellular substances and cell death. This study not only demonstrates the potential of V6O13 as an efficient antimicrobial agent but also provides a strong experimental basis and theoretical support for the engineering design and optimization of novel antimicrobial materials by modulating material defects through ion doping.
- 27 September 2024
- Published by Springer Nature in Scientific Reports
- Vol. 14 (1) , 1-12
Open AccessStudy on the mechanism of ROS-induced oxidative stress injury and the broad-spectrum antimicrobial performance of nickel ion-doped V6O13 powder
In this study, pure V6O13 and nickel ion-doped V6O13 powders were synthesized by a simple hydrothermal-calcination method, and their broad-spectrum antimicrobial properties and mechanisms were investigated. The crystal structure, morphology, and chemical state of the powders were thoroughly analyzed by XRD, SEM, TEM, XPS, and UV–Vis. Their antimicrobial properties and mechanisms were evaluated by the ring of inhibition, bio-SEM, live-dead cell staining, ROS detection, and protein leakage experiments. The results showed that nickel ion doping modulated the oxygen defects of V6O13, generating more reactive oxygen species and leading to more severe oxidative stress, resulting in a broad-spectrum and highly efficient antimicrobial effect. This study also revealed the antimicrobial mechanism based on oxygen defect -induced ROS production, which caused cellular oxidative stress damage, leading to leakage of intracellular substances and cell death. This study not only demonstrates the potential of V6O13 as an efficient antimicrobial agent but also provides a strong experimental basis and theoretical support for the engineering design and optimization of novel antimicrobial materials by modulating material defects through ion doping.
- 26 February 2024
- Published by World Scientific Pub Co Pte Ltd in Modern Physics Letters B
- Vol. 38 (25)
Mössbauer and magnetic studies of Fe-doped ZnO nanoparticles prepared by solution co-precipitation method
A series of Zn[ ]FexO ([ ], 0.015, 0.045, 0.075) nanoparticles were synthesized using the solution co-precipitation method, and their structural and property characteristics were investigated. X-ray diffraction (XRD) analysis revealed that all Zn[ ]FexO samples exhibited a hexagonal wurtzite crystal structure with the P63mc space group. The introduction of Fe doping led to a slight lattice distortion in the samples. The morphology of the nanoparticles, including polydispersion and agglomeration, as well as the presence of the second phase ZnFe2O4, was examined by scanning electron microscope (SEM) and transmission electron microscope (TEM). UV–Vis diffuse reflectance spectroscopy demonstrated that the band gap of Zn[ ]FexO lies between 3.152 and 3.163[ ]eV. With the increase in Fe ion doping, the band gap shows a slight decreasing trend. Mössbauer spectroscopy revealed that iron ions in the nanoparticles existed in a trivalent state and exhibited two different configurations: One involved iron replacing zinc without creating a vacancy, while the other involved iron substituting zinc with a vacancy. The ferromagnetic nature of the Fe-doped samples can be attributed to the exchange interaction between two Fe[ ] ions mediated by the F-center mechanism.
- 26 February 2024
- Published by World Scientific Pub Co Pte Ltd in Modern Physics Letters B
- Vol. 38 (25)
Mössbauer and magnetic studies of Fe-doped ZnO nanoparticles prepared by solution co-precipitation method
A series of Zn[ ]FexO ([ ], 0.015, 0.045, 0.075) nanoparticles were synthesized using the solution co-precipitation method, and their structural and property characteristics were investigated. X-ray diffraction (XRD) analysis revealed that all Zn[ ]FexO samples exhibited a hexagonal wurtzite crystal structure with the P63mc space group. The introduction of Fe doping led to a slight lattice distortion in the samples. The morphology of the nanoparticles, including polydispersion and agglomeration, as well as the presence of the second phase ZnFe2O4, was examined by scanning electron microscope (SEM) and transmission electron microscope (TEM). UV–Vis diffuse reflectance spectroscopy demonstrated that the band gap of Zn[ ]FexO lies between 3.152 and 3.163[ ]eV. With the increase in Fe ion doping, the band gap shows a slight decreasing trend. Mössbauer spectroscopy revealed that iron ions in the nanoparticles existed in a trivalent state and exhibited two different configurations: One involved iron replacing zinc without creating a vacancy, while the other involved iron substituting zinc with a vacancy. The ferromagnetic nature of the Fe-doped samples can be attributed to the exchange interaction between two Fe[ ] ions mediated by the F-center mechanism.
- 19 December 2023
- Published by Wiley in Physica Status Solidi (b)
Exploring the Magnetism and Magnetocaloric Effect of W‐Doped VO2 Based on J1–J2 Ising Model
W‐doped VO2 exhibits a significant reduction in the metal–insulator transition temperature. In this study, the authors aim to investigate the magnetic influences of different proportions of W doping in VO2 with a rutile structure, using the J1–J2 model. The J1 and J2 values are calculated as 1.21 and −0.024 eV, respectively, using the generalized gradient approximation (GGA)+U method. Additionally, the J1–J2 model without W doping (x = 0) is simulated using the Ising model, and the obtained phase transition temperature of approximately 361 K closely matches the temperature calculated by Zheng et al. based on the spin dimer model. Furthermore, employing this model, the magnetization curves and magnetic entropy change (ΔS) are simulated for different W doping levels (x = 0–0.2). Through comprehensive analysis, it is found that the system exhibits the most promising research potential at a doping level of x = 0.12. These findings deepen the understanding of the mechanisms underlying the magnetic effects of W‐doped VO2 and provide a theoretical model guidance for future development of vanadium oxide materials.
- 19 December 2023
- Published by Wiley in Physica Status Solidi (b)
Exploring the Magnetism and Magnetocaloric Effect of W‐Doped VO2 Based on J1–J2 Ising Model
W‐doped VO2 exhibits a significant reduction in the metal–insulator transition temperature. In this study, the authors aim to investigate the magnetic influences of different proportions of W doping in VO2 with a rutile structure, using the J1–J2 model. The J1 and J2 values are calculated as 1.21 and −0.024 eV, respectively, using the generalized gradient approximation (GGA)+U method. Additionally, the J1–J2 model without W doping (x = 0) is simulated using the Ising model, and the obtained phase transition temperature of approximately 361 K closely matches the temperature calculated by Zheng et al. based on the spin dimer model. Furthermore, employing this model, the magnetization curves and magnetic entropy change (ΔS) are simulated for different W doping levels (x = 0–0.2). Through comprehensive analysis, it is found that the system exhibits the most promising research potential at a doping level of x = 0.12. These findings deepen the understanding of the mechanisms underlying the magnetic effects of W‐doped VO2 and provide a theoretical model guidance for future development of vanadium oxide materials.
- Open Access
- 2 November 2023
- Published by MDPI AG in Inorganics
- Vol. 11 (11) , 429
Antibacterial Activity of Oxygen Vacancy-Mediated ROS Production of V6O13 Powder against Candida albicans
The emergence of drug resistance due to the overuse of antibiotics has made the prevention and treatment of invasive fungal infections caused by Candida albicans (C. albicans) a great challenge. Oxygen vacancy-rich inorganic materials show great promise in the antimicrobial field due to their unique physicochemical properties. Defect engineering can significantly optimize the electronic structure of inorganic materials to further enhance their antimicrobial activity. We designed oxygen vacancy defect-rich V6O13 powders using the hydrothermal-calcination method and investigated their anti-C. albicans activity. The results showed that the stronger antibacterial activity is attributed to the fact that the optimized V6O13 powder oxygen vacancy defects induced a reduction reaction of dissolved oxygen in the environment, which produced ROS with strong oxidative properties, causing damage to the wall membrane of C. albicans and leakage of intracellular material. The minimum inhibitory concentration (99% or more inhibition) of V6O13 powders is 4 mg/mL. This work not only provides a facile method for constructing oxygen-rich vacancies in V6O13 powders, but also provides new insights into the potential of inorganic materials optimized by defect engineering for efficient antimicrobial activity.
- 2 November 2023
- Published by MDPI AG in Inorganics
- Vol. 11 (11) , 429
Open AccessAntibacterial Activity of Oxygen Vacancy-Mediated ROS Production of V6O13 Powder against Candida albicans
The emergence of drug resistance due to the overuse of antibiotics has made the prevention and treatment of invasive fungal infections caused by Candida albicans (C. albicans) a great challenge. Oxygen vacancy-rich inorganic materials show great promise in the antimicrobial field due to their unique physicochemical properties. Defect engineering can significantly optimize the electronic structure of inorganic materials to further enhance their antimicrobial activity. We designed oxygen vacancy defect-rich V6O13 powders using the hydrothermal-calcination method and investigated their anti-C. albicans activity. The results showed that the stronger antibacterial activity is attributed to the fact that the optimized V6O13 powder oxygen vacancy defects induced a reduction reaction of dissolved oxygen in the environment, which produced ROS with strong oxidative properties, causing damage to the wall membrane of C. albicans and leakage of intracellular material. The minimum inhibitory concentration (99% or more inhibition) of V6O13 powders is 4 mg/mL. This work not only provides a facile method for constructing oxygen-rich vacancies in V6O13 powders, but also provides new insights into the potential of inorganic materials optimized by defect engineering for efficient antimicrobial activity.
- Open Access
- 1 January 2017
- Published by Ceramic Society of Japan in Journal of the Ceramic Society of Japan
- Vol. 125 (9) , 690-694
Preparation of porcelain building tiles using “K2O–Na2O” feldspar flux as a modifier agent of low-temperature firing
In this paper, to save energy and reduce consumption in building ceramic process, the low temperature porcelain building tiles were prepared by fast firing process using two kinds of “K2O–Na2O” feldspar with different amounts of alkaline and alkaline earth oxides fluxing agents, Si/Al ratio and melting point. The sintering properties of the samples were evaluated by linear shrinkage, water absorption and bulk density. The crystalline phase and microstructure of the samples were characterized by X-ray diffraction and scanning electron microscope. The results showed that the optimum linear shrinkage of 7.55%, water absorption of 0.03% and bending strength of 78.3–85.8 MPa can be achieved for the sample fired at 1170–1190°C, which is attributed to the effect of the combined “K2O–Na2O” feldspar flux system.
- 1 January 2017
- Published by Ceramic Society of Japan in Journal of the Ceramic Society of Japan
- Vol. 125 (9) , 690-694
Open AccessPreparation of porcelain building tiles using “K2O–Na2O” feldspar flux as a modifier agent of low-temperature firing
In this paper, to save energy and reduce consumption in building ceramic process, the low temperature porcelain building tiles were prepared by fast firing process using two kinds of “K2O–Na2O” feldspar with different amounts of alkaline and alkaline earth oxides fluxing agents, Si/Al ratio and melting point. The sintering properties of the samples were evaluated by linear shrinkage, water absorption and bulk density. The crystalline phase and microstructure of the samples were characterized by X-ray diffraction and scanning electron microscope. The results showed that the optimum linear shrinkage of 7.55%, water absorption of 0.03% and bending strength of 78.3–85.8 MPa can be achieved for the sample fired at 1170–1190°C, which is attributed to the effect of the combined “K2O–Na2O” feldspar flux system.