Mais Alzgool
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Mais Alzgool has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
Abdulelah AlWahhabi
University of Business and Technology
1 shared publicationAbdullah Adnan Khalaf
1 shared publication- Ahmad Alamleh
Energy Engineering Dep. Zarqa University Zarqaa, Jordan
1 shared publication Akram Hamdan
Palestine Technical University-kadoorie
1 shared publicationBaraa Raed
Palestine Technical University-kadoorie
1 shared publication- Ibrahim Mansour
Electrical Engineering Department, Zarqa University, Zarqa 13110, Jordan
1 shared publication
Latest Publications
- Open Access
- 16 June 2025
- Published by Wiley in Energy Science & Engineering
- Vol. 13 (8) , 3998-4010
Innovative Dual Rotor Wind Turbine Design Based on Humpback Whale Blades: Simulation Analysis
To enhance the performance of wind turbines, this study investigates the integration of two wind energy harvesting systems. An optimal wind turbine configuration has been identified by using dual rotor wind turbine (DRWT) technology with a novel blade design known as the humpback blade, which is inspired by the fins of humpback whales. This design features tubercles and ridges along the leading edge that extend over the last third of the blade's length. The innovative humpback blade design lowered the nominal angle of attack in comparison to conventional blades, which led to a significant boost in lift and a notable reduction in drag forces. This enhancement in the lift‐to‐drag ratio enabled more efficient rotation at lower wind speeds. Furthermore, single rotor turbines fitted with these blades showed improved energy extraction and decreased turbulence intensity behind the rotor, making them especially effective in DRWT setups. The results validated the benefits of the humpback blade design in dual rotor systems, where the new design enhanced the lift‐to‐drag ratio in both upwind and downwind positions, resulting in higher overall energy output than turbines with standard blades. As a result, different configurations of the DRWT have been tested and examined. The proposed configuration with a humpback rotor in the downwind position resulted in a increase in the lift‐to‐drag ratio. Similarly, employing a humpback rotor in the upwind position improved the lift‐to‐drag ratio by . These enhancements lead to greater energy extraction from DRWTs compared to those with standard blades under the same study conditions.
- 16 June 2025
- Published by Wiley in Energy Science & Engineering
- Vol. 13 (8) , 3998-4010
Open AccessInnovative Dual Rotor Wind Turbine Design Based on Humpback Whale Blades: Simulation Analysis
To enhance the performance of wind turbines, this study investigates the integration of two wind energy harvesting systems. An optimal wind turbine configuration has been identified by using dual rotor wind turbine (DRWT) technology with a novel blade design known as the humpback blade, which is inspired by the fins of humpback whales. This design features tubercles and ridges along the leading edge that extend over the last third of the blade's length. The innovative humpback blade design lowered the nominal angle of attack in comparison to conventional blades, which led to a significant boost in lift and a notable reduction in drag forces. This enhancement in the lift‐to‐drag ratio enabled more efficient rotation at lower wind speeds. Furthermore, single rotor turbines fitted with these blades showed improved energy extraction and decreased turbulence intensity behind the rotor, making them especially effective in DRWT setups. The results validated the benefits of the humpback blade design in dual rotor systems, where the new design enhanced the lift‐to‐drag ratio in both upwind and downwind positions, resulting in higher overall energy output than turbines with standard blades. As a result, different configurations of the DRWT have been tested and examined. The proposed configuration with a humpback rotor in the downwind position resulted in a increase in the lift‐to‐drag ratio. Similarly, employing a humpback rotor in the upwind position improved the lift‐to‐drag ratio by . These enhancements lead to greater energy extraction from DRWTs compared to those with standard blades under the same study conditions.
- Open Access
Reliability Enhancement of a Double-Switch Single-Ended Primary Inductance–Buck Regulator in a Wind-Driven Permanent Magnet Synchronous Generator Using a Double-Band Hysteresis Current Controller
The wind power exchange system (WECS) covered in this paper consists of a voltage source inverter (VSI), a DSSB regulator, and an uncontrolled rectifier. An AC grid or a heavy inductive or resistive load (RL) can be supplied by this system. The DSSB is a recently developed DC-DC regulator consisting of an improved single-ended primary inductance regulator (SEPIC) followed by a buck regulator. It has a peak efficiency of 95–98% and a voltage gain of (. where D is the regulator transistor’s on-to-off switching ratio. The proposed regulator improves the voltage stability and MPPT strategy (optimal or maximum power-point tracking). The combination of the DSSB and the proposed regulator improves the efficiency of the system and increases the power output of the wind turbine by reducing the harmonics of the system voltages and current. This method also reduces the influence of air density as well as wind speed variations on the MPPT strategy. Classical proportional–integral (PI) controllers are used in conjunction with a vector-controlled voltage source inverter, which adheres to the suggested DSSB regulator, to control the PMSM speed and d-q axis currents and to correct for current error. In addition to the vector-controlled voltage source inverter (which follows the recommended DSSB regulator), classical proportional–integral controllers are used to regulate the PMSM speed and d-q axis currents, and to correct current errors. In addition, a model Predictive Controller (PPC) is used with the pitch angle control (PAC) of WECS. This is done to show how well the proposed WECS (WECS with DSSB regulator) enhances voltage stability. A software-based simulation (MATLAB/Simulink) evaluates the results for ideal and unoptimized parameters of the WT and WECS under a variety of conditions. The results of the simulation show an increase in MPPT precision and output power performance.Open AccessReliability Enhancement of a Double-Switch Single-Ended Primary Inductance–Buck Regulator in a Wind-Driven Permanent Magnet Synchronous Generator Using a Double-Band Hysteresis Current Controller
The wind power exchange system (WECS) covered in this paper consists of a voltage source inverter (VSI), a DSSB regulator, and an uncontrolled rectifier. An AC grid or a heavy inductive or resistive load (RL) can be supplied by this system. The DSSB is a recently developed DC-DC regulator consisting of an improved single-ended primary inductance regulator (SEPIC) followed by a buck regulator. It has a peak efficiency of 95–98% and a voltage gain of (. where D is the regulator transistor’s on-to-off switching ratio. The proposed regulator improves the voltage stability and MPPT strategy (optimal or maximum power-point tracking). The combination of the DSSB and the proposed regulator improves the efficiency of the system and increases the power output of the wind turbine by reducing the harmonics of the system voltages and current. This method also reduces the influence of air density as well as wind speed variations on the MPPT strategy. Classical proportional–integral (PI) controllers are used in conjunction with a vector-controlled voltage source inverter, which adheres to the suggested DSSB regulator, to control the PMSM speed and d-q axis currents and to correct for current error. In addition to the vector-controlled voltage source inverter (which follows the recommended DSSB regulator), classical proportional–integral controllers are used to regulate the PMSM speed and d-q axis currents, and to correct current errors. In addition, a model Predictive Controller (PPC) is used with the pitch angle control (PAC) of WECS. This is done to show how well the proposed WECS (WECS with DSSB regulator) enhances voltage stability. A software-based simulation (MATLAB/Simulink) evaluates the results for ideal and unoptimized parameters of the WT and WECS under a variety of conditions. The results of the simulation show an increase in MPPT precision and output power performance. - Open Access
- 14 September 2024
- Published by Learning Gate in Edelweiss Applied Science and Technology
- Vol. 8 (6) , 3754-3769
Wind flow characteristics through shrouded wind turbine using ANSYS
Wind energy is a mature and quick-growing source of energy in many nations. New wind energy technologies must be introduced to increase effectiveness and reduce the cost of wind turbine installation. Wind energy conversion experts believe that shrouded wind turbines are a promising technology that could raise output and efficiency levels. A low-pressure zone is created behind the turbine because of the shroud’s unique structure. As a result, the turbine draws in greater mass flow to produce more power. With the aid of this innovative technology, wind turbines could be used in populated areas where lower wind speeds could be captured. In this study, a comparative analysis has been applied to different designs of shrouded wind turbines to analyze the wind speed, pressure, output power and power coefficient. ANSYS software has been conducted in this paper where the results obtained that the output power could be increased up to 3-4 times compared to the bare wind turbine, also a high-power coefficient could be reached up to 83.1%.
- 14 September 2024
- Published by Learning Gate in Edelweiss Applied Science and Technology
- Vol. 8 (6) , 3754-3769
Open AccessWind flow characteristics through shrouded wind turbine using ANSYS
Wind energy is a mature and quick-growing source of energy in many nations. New wind energy technologies must be introduced to increase effectiveness and reduce the cost of wind turbine installation. Wind energy conversion experts believe that shrouded wind turbines are a promising technology that could raise output and efficiency levels. A low-pressure zone is created behind the turbine because of the shroud’s unique structure. As a result, the turbine draws in greater mass flow to produce more power. With the aid of this innovative technology, wind turbines could be used in populated areas where lower wind speeds could be captured. In this study, a comparative analysis has been applied to different designs of shrouded wind turbines to analyze the wind speed, pressure, output power and power coefficient. ANSYS software has been conducted in this paper where the results obtained that the output power could be increased up to 3-4 times compared to the bare wind turbine, also a high-power coefficient could be reached up to 83.1%.
- Open Access
- 30 June 2024
- Published by Acadlore Publishing Services Limited in International Journal of Energy Production and Management
- Vol. 9 (2) , 73-81
Performance Enhancement by Cooling the PV Panels Using Phase Change Material (RT35): ANSYS Simulation and Experimental Investigation
- 30 June 2024
- Published by Acadlore Publishing Services Limited in International Journal of Energy Production and Management
- Vol. 9 (2) , 73-81
Open AccessPerformance Enhancement by Cooling the PV Panels Using Phase Change Material (RT35): ANSYS Simulation and Experimental Investigation
- 26 January 2024
- Published by Springer Nature
- p. 635-646
Advanced Un Interruptible Power Supply
- Open Access
- 29 December 2023
- Published by Acadlore Publishing Services Limited in International Journal of Energy Production and Management
- Vol. 8 (4) , 219-227
Design and Simulation of a Renewable Energy-Based Smart Grid for Ma'an City, Jordan: A Feasibility Study
- 29 December 2023
- Published by Acadlore Publishing Services Limited in International Journal of Energy Production and Management
- Vol. 8 (4) , 219-227
Open AccessDesign and Simulation of a Renewable Energy-Based Smart Grid for Ma'an City, Jordan: A Feasibility Study