Ryota Maeda
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ryota Maeda has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
- Kohei Ueno
Institute of Industrial Science, The University of Tokyo , 4-6-1 Komaba, Meguro, Tokyo 153 8505
4 shared publications Hiroshi Fujioka
Institute of Industrial Science, The University of Tokyo
2 shared publications- Hiroshi Fujioka
Institute of Industrial Science University of Tokyo 4‐6‐1 Komaba, Meguro Tokyo 153 8505 Japan
2 shared publications Takao Kozaka
Institute of Industrial Science, The University of Tokyo
2 shared publications- Takao Kozaka
Institute of Industrial Science, The University of Tokyo , 4-6-1 Komaba, Meguro, Tokyo 153-8505
1 shared publication
Latest Publications
- Open Access
- 1 June 2026
- Published by Springer Nature in Research Square
Al-rich AlGaN multichannel transistors with degenerate semiconductor electrodes
Ultrawide-bandgap (UWBG) Al-rich AlGaN multichannel high-electron-mobility transistors (HEMTs) are promising components for high-power, high-frequency electronics, but their device-level potential is limited by difficulties in forming low-resistance ohmic contacts to 2D electron gases (2DEGs) buried in Al-rich AlGaN superlattices. Here, we demonstrate undoped AlN/Al0.6Ga0.4N/AlN multichannel trigate HEMTs where vertically stacked polarization-induced 2DEG channels are accessed from etched sidewalls by epitaxially regrown highly degenerate n++-GaN (d-GaN) semiconductor electrodes formed via pulsed sputter deposition. The regrown d-GaN acts as an intermediate semiconductor electrode that mitigates the metal–channel injection mismatch while providing 3D access to the buried channels. The devices achieve annealing-free contact resistance of below 1 Ω·mm, breakdown voltages exceeding 3 kV with average breakdown fields reaching 3.8 MV/cm, and power figures of merit approaching 3.2 GW/cm2. These results demonstrate that the regrown highly degenerate semiconductor electrodes are a practical route to low-loss access in UWBG multichannel transistor platforms.
- 1 June 2026
- Published by Springer Nature in Research Square
Open AccessAl-rich AlGaN multichannel transistors with degenerate semiconductor electrodes
Ultrawide-bandgap (UWBG) Al-rich AlGaN multichannel high-electron-mobility transistors (HEMTs) are promising components for high-power, high-frequency electronics, but their device-level potential is limited by difficulties in forming low-resistance ohmic contacts to 2D electron gases (2DEGs) buried in Al-rich AlGaN superlattices. Here, we demonstrate undoped AlN/Al0.6Ga0.4N/AlN multichannel trigate HEMTs where vertically stacked polarization-induced 2DEG channels are accessed from etched sidewalls by epitaxially regrown highly degenerate n++-GaN (d-GaN) semiconductor electrodes formed via pulsed sputter deposition. The regrown d-GaN acts as an intermediate semiconductor electrode that mitigates the metal–channel injection mismatch while providing 3D access to the buried channels. The devices achieve annealing-free contact resistance of below 1 Ω·mm, breakdown voltages exceeding 3 kV with average breakdown fields reaching 3.8 MV/cm, and power figures of merit approaching 3.2 GW/cm2. These results demonstrate that the regrown highly degenerate semiconductor electrodes are a practical route to low-loss access in UWBG multichannel transistor platforms.
- Open Access
- 1 April 2025
- Published by AIP Publishing in APL Materials
- Vol. 13 (4)
Degenerate GaN source–drain AlN/AlxGa1−xN/AlN high electron mobility transistors with a high breakdown electric field reaching 6.0 MV/cm
This study presents a comprehensive analysis of the structural and electrical properties of degenerate GaN source–drain AlN/AlxGa1−xN/AlN high electron mobility transistors (HEMTs) fabricated using low-temperature pulsed sputtering epitaxial growth. The investigation encompassed a range of Al compositions (0.3 ≤ x ≤ 0.7). Partially relaxed AlN/Al0.3Ga0.7N/AlN HEMTs exhibited a high drain current (ID = 580 mA/mm) and low contact resistance (RC = 0.30 Ω mm). Fully strained AlN/Al0.5Ga0.5N/AlN HEMTs achieved a balance between low on-resistance and high breakdown voltage, resulting in the highest lateral figure of merit of 319 MW/cm2 in this study. For x = 0.6, a peak breakdown electric field of 6.0 MV/cm was observed in a device with a short gate–drain distance. These results show the great potential of the low-temperature sputtering epitaxial growth process of AlN/AlxGa1−xN/AlN double heterostructure HEMTs with the degenerate regrowth GaN source–drain for the next-generation ultrahigh BV power electronics.
- 1 April 2025
- Published by AIP Publishing in APL Materials
- Vol. 13 (4)
Open AccessDegenerate GaN source–drain AlN/AlxGa1−xN/AlN high electron mobility transistors with a high breakdown electric field reaching 6.0 MV/cm
This study presents a comprehensive analysis of the structural and electrical properties of degenerate GaN source–drain AlN/AlxGa1−xN/AlN high electron mobility transistors (HEMTs) fabricated using low-temperature pulsed sputtering epitaxial growth. The investigation encompassed a range of Al compositions (0.3 ≤ x ≤ 0.7). Partially relaxed AlN/Al0.3Ga0.7N/AlN HEMTs exhibited a high drain current (ID = 580 mA/mm) and low contact resistance (RC = 0.30 Ω mm). Fully strained AlN/Al0.5Ga0.5N/AlN HEMTs achieved a balance between low on-resistance and high breakdown voltage, resulting in the highest lateral figure of merit of 319 MW/cm2 in this study. For x = 0.6, a peak breakdown electric field of 6.0 MV/cm was observed in a device with a short gate–drain distance. These results show the great potential of the low-temperature sputtering epitaxial growth process of AlN/AlxGa1−xN/AlN double heterostructure HEMTs with the degenerate regrowth GaN source–drain for the next-generation ultrahigh BV power electronics.
- 1 June 2024
- Published by Wiley in Physica Status Solidi (RRL) – Rapid Research Letters
- Vol. 18 (11)
Pulsed Sputtering Epitaxy of Coherent AlN/Al0.5Ga0.5N/AlN Multichannel Structures
In this article, the advantages of AlN low‐temperature interface protective layer (LT‐IPL) prepared by sputtering epitaxy for the fabrication of AlN/Al0.5Ga0.5N/AlN multichannel device structures are discussed. In this study, it is found that the use of LT‐IPL enhances the AlN/AlGaN interface surface morphology and reduces AlN/Al0.5Ga0.5N/AlN multichannel structure misfit dislocations. This approach results in a coherent four‐channel AlN/AlGaN/AlN structure with considerably improved crystallinity. Moreover, consistent with predictions from 1D simulations, reductions in sheet resistance are inversely proportional to the number of channels. These advancements are pivotal for the development of sophisticated AlN/AlGaN/AlN multichannel structures, which are tailored for applications that require low resistance and high voltage.
- 1 June 2024
- Published by Wiley in Physica Status Solidi (RRL) – Rapid Research Letters
- Vol. 18 (11)
Pulsed Sputtering Epitaxy of Coherent AlN/Al0.5Ga0.5N/AlN Multichannel Structures
In this article, the advantages of AlN low‐temperature interface protective layer (LT‐IPL) prepared by sputtering epitaxy for the fabrication of AlN/Al0.5Ga0.5N/AlN multichannel device structures are discussed. In this study, it is found that the use of LT‐IPL enhances the AlN/AlGaN interface surface morphology and reduces AlN/Al0.5Ga0.5N/AlN multichannel structure misfit dislocations. This approach results in a coherent four‐channel AlN/AlGaN/AlN structure with considerably improved crystallinity. Moreover, consistent with predictions from 1D simulations, reductions in sheet resistance are inversely proportional to the number of channels. These advancements are pivotal for the development of sophisticated AlN/AlGaN/AlN multichannel structures, which are tailored for applications that require low resistance and high voltage.
- Open Access
- 1 January 2024
- Published by IOP Publishing in Applied Physics Express
- Vol. 17 (1) , 011006
Pulsed sputtering selective epitaxial formation of highly degenerate n-type GaN ohmic contacts for GaN HEMT applications
This study describes the selective formation process of highly degenerate n-type GaN (d-GaN) ohmic contacts for the source and drain regions of GaN high electron mobility transistors (HEMTs) using pulsed sputtering deposition (PSD). The selective formation process using SiO2 masks and PSD epitaxial growth enabled the uniform formation of d-GaN in micron-meter size. The optimally formed d-GaN exhibited a minimum resistivity as low as 0.16 mΩ·cm, an electron concentration of 3.6 × 1020 cm−3, and a mobility of 108 cm2 V−1 s−1. Transmission-line-method measurements demonstrated that the contact resistance of GaN HEMTs with d-GaN regrowth contacts was remarkably low at 0.28 Ω·mm, leading to the reasonable DC output characteristics with an on-resistance of 2.8 Ω·mm and a maximum current density of 850 mA mm−1. These findings suggest that PSD epitaxial regrowth of d-GaN is a promising approach for the high-throughput formation of low-resistivity ohmic contacts on large-area GaN HEMT wafers.
- 1 January 2024
- Published by IOP Publishing in Applied Physics Express
- Vol. 17 (1) , 011006
Open AccessPulsed sputtering selective epitaxial formation of highly degenerate n-type GaN ohmic contacts for GaN HEMT applications
This study describes the selective formation process of highly degenerate n-type GaN (d-GaN) ohmic contacts for the source and drain regions of GaN high electron mobility transistors (HEMTs) using pulsed sputtering deposition (PSD). The selective formation process using SiO2 masks and PSD epitaxial growth enabled the uniform formation of d-GaN in micron-meter size. The optimally formed d-GaN exhibited a minimum resistivity as low as 0.16 mΩ·cm, an electron concentration of 3.6 × 1020 cm−3, and a mobility of 108 cm2 V−1 s−1. Transmission-line-method measurements demonstrated that the contact resistance of GaN HEMTs with d-GaN regrowth contacts was remarkably low at 0.28 Ω·mm, leading to the reasonable DC output characteristics with an on-resistance of 2.8 Ω·mm and a maximum current density of 850 mA mm−1. These findings suggest that PSD epitaxial regrowth of d-GaN is a promising approach for the high-throughput formation of low-resistivity ohmic contacts on large-area GaN HEMT wafers.