Tongwei Ju
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Tongwei Ju has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Guli Jiapaer
State Key Laboratory of Desert and Oasis Ecology, Xinjiang Institute of Ecology and Geography, Chinese Academy of Sciences, Urumqi 830011, China
3 shared publications - Hongwu Liang
State Key Laboratory of Desert and Oasis Ecology, Xinjiang Institute of Ecology and Geography, Chinese Academy of Sciences, Urumqi 830011, China
3 shared publications - Bojian Chen
State Key Laboratory of Desert and Oasis Ecology, Xinjiang Institute of Ecology and Geography, Chinese Academy of Sciences, Urumqi 830011, China
2 shared publications - Kaixiong Lin
State Key Laboratory of Desert and Oasis Ecology, Xinjiang Institute of Ecology and Geography, Chinese Academy of Sciences, Urumqi 830011, China
2 shared publications - Liancheng Zhang
State Key Laboratory of Desert and Oasis Ecology, Xinjiang Institute of Ecology and Geography, Chinese Academy of Sciences, Urumqi 830011, China
2 shared publications - Tao Yu
State Key Laboratory of Ecological Safety and Sustainable Development in Arid Lands, Xinjiang Institute of Ecology and Geography, Chinese Academy of Sciences, Urumqi 830011, China
2 shared publications
Latest Publications
- Open Access
- 6 November 2026
- Published by MDPI AG in Remote Sensing
- Vol. 18 (21) , 3826
Estimating Dryland Vegetation Biomass from Multi-Modal UAV Data: Disentangling the Contributions and Scale Responses of Spectral, Structural, and Textural Features
Low vegetation cover and patchy distribution in arid regions make vegetation spectral signals susceptible to interference from bare-soil backgrounds, while differences in canopy structure among herbaceous vegetation, shrubs, and trees further increase the difficulty of accurate aboveground biomass (AGB) estimation. This study investigated heterogeneous vegetation in the middle and lower plains of the Yarkand River Basin, China, using field-measured AGB, UAV multispectral imagery, and LiDAR point clouds. Spectral (S), canopy height (H), and texture (T) features were derived, and four combinations (S, S + H, S + T, and S + H + T) were evaluated with SVR, GPR, XGBoost, and RF under repeated nested five-fold cross-validation. The results showed that the optimal texture window size varied among models, with the 7 × 7 pixel window providing a reasonable balance between prediction accuracy and stability. Adding canopy height to spectral-only models increased R2 by 0.282–0.455 and reduced RMSE by 28.2–41.9%, exceeding the incremental contribution of texture. S + H + T achieved the best overall performance (R2 = 0.643–0.806; RMSE = 1.189–1.629 kg·m−2). XGBoost yielded the highest mean accuracy, whereas RF was more stable. SHAP analysis attributed 63.6%, 30.2%, and 6.2% of the overall contribution to canopy height, spectral, and texture features, respectively. Overall, multisource feature integration improved AGB estimation, with canopy height providing the main incremental information; however, accurately retrieving canopy height for low-stature vegetation in arid regions remains a key challenge for further improving estimation reliability.
- 6 November 2026
- Published by MDPI AG in Remote Sensing
- Vol. 18 (21) , 3826
Open AccessEstimating Dryland Vegetation Biomass from Multi-Modal UAV Data: Disentangling the Contributions and Scale Responses of Spectral, Structural, and Textural Features
Low vegetation cover and patchy distribution in arid regions make vegetation spectral signals susceptible to interference from bare-soil backgrounds, while differences in canopy structure among herbaceous vegetation, shrubs, and trees further increase the difficulty of accurate aboveground biomass (AGB) estimation. This study investigated heterogeneous vegetation in the middle and lower plains of the Yarkand River Basin, China, using field-measured AGB, UAV multispectral imagery, and LiDAR point clouds. Spectral (S), canopy height (H), and texture (T) features were derived, and four combinations (S, S + H, S + T, and S + H + T) were evaluated with SVR, GPR, XGBoost, and RF under repeated nested five-fold cross-validation. The results showed that the optimal texture window size varied among models, with the 7 × 7 pixel window providing a reasonable balance between prediction accuracy and stability. Adding canopy height to spectral-only models increased R2 by 0.282–0.455 and reduced RMSE by 28.2–41.9%, exceeding the incremental contribution of texture. S + H + T achieved the best overall performance (R2 = 0.643–0.806; RMSE = 1.189–1.629 kg·m−2). XGBoost yielded the highest mean accuracy, whereas RF was more stable. SHAP analysis attributed 63.6%, 30.2%, and 6.2% of the overall contribution to canopy height, spectral, and texture features, respectively. Overall, multisource feature integration improved AGB estimation, with canopy height providing the main incremental information; however, accurately retrieving canopy height for low-stature vegetation in arid regions remains a key challenge for further improving estimation reliability.
- Open Access
- 30 September 2024
- Published by MDPI AG in Remote Sensing
- Vol. 16 (19) , 3653
Identification of Potential Landslides in the Gaizi Valley Section of the Karakorum Highway Coupled with TS-InSAR and Landslide Susceptibility Analysis
Landslides have become a common global concern because of their widespread nature and destructive power. The Gaizi Valley section of the Karakorum Highway is located in an alpine mountainous area with a high degree of geological structure development, steep terrain, and severe regional soil erosion, and landslide disasters occur frequently along this section, which severely affects the smooth flow of traffic through the China-Pakistan Economic Corridor (CPEC). In this study, 118 views of Sentinel-1 ascending- and descending-orbit data of this highway section are collected, and two time-series interferometric synthetic aperture radar (TS-InSAR) methods, distributed scatter InSAR (DS-InSAR) and small baseline subset InSAR (SBAS-InSAR), are used to jointly determine the surface deformation in this section and identify unstable slopes from 2021 to 2023. Combining these data with data on sites of historical landslide hazards in this section from 1970 to 2020, we constructed 13 disaster-inducing factors affecting the occurrence of landslides as evaluation indices of susceptibility, carried out an evaluation of regional landslide susceptibility, and identified high-susceptibility unstable slopes (i.e., potential landslides). The results show that DS-InSAR and SBAS-InSAR have good agreement in terms of deformation distribution and deformation magnitude and that compared with single-orbit data, double-track SAR data can better identify unstable slopes in steep mountainous areas, providing a spatial advantage. The landslide susceptibility results show that the area under the curve (AUC) value of the artificial neural network (ANN) model (0.987) is larger than that of the logistic regression (LR) model (0.883) and that the ANN model has a higher classification accuracy than the LR model. A total of 116 unstable slopes were identified in the study, 14 of which were determined to be potential landslides after the landslide susceptibility results were combined with optical images and field surveys. These 14 potential landslides were mapped in detail, and the effects of regional natural disturbances (e.g., snowmelt) and anthropogenic disturbances (e.g., mining projects) on the identification of potential landslides using only SAR data were assessed. The results of this research can be directly applied to landslide hazard mitigation and prevention in the Gaizi Valley section of the Karakorum Highway. In addition, our proposed method can also be used to map potential landslides in other areas with the same complex topography and harsh environment.
- 30 September 2024
- Published by MDPI AG in Remote Sensing
- Vol. 16 (19) , 3653
Open AccessIdentification of Potential Landslides in the Gaizi Valley Section of the Karakorum Highway Coupled with TS-InSAR and Landslide Susceptibility Analysis
Landslides have become a common global concern because of their widespread nature and destructive power. The Gaizi Valley section of the Karakorum Highway is located in an alpine mountainous area with a high degree of geological structure development, steep terrain, and severe regional soil erosion, and landslide disasters occur frequently along this section, which severely affects the smooth flow of traffic through the China-Pakistan Economic Corridor (CPEC). In this study, 118 views of Sentinel-1 ascending- and descending-orbit data of this highway section are collected, and two time-series interferometric synthetic aperture radar (TS-InSAR) methods, distributed scatter InSAR (DS-InSAR) and small baseline subset InSAR (SBAS-InSAR), are used to jointly determine the surface deformation in this section and identify unstable slopes from 2021 to 2023. Combining these data with data on sites of historical landslide hazards in this section from 1970 to 2020, we constructed 13 disaster-inducing factors affecting the occurrence of landslides as evaluation indices of susceptibility, carried out an evaluation of regional landslide susceptibility, and identified high-susceptibility unstable slopes (i.e., potential landslides). The results show that DS-InSAR and SBAS-InSAR have good agreement in terms of deformation distribution and deformation magnitude and that compared with single-orbit data, double-track SAR data can better identify unstable slopes in steep mountainous areas, providing a spatial advantage. The landslide susceptibility results show that the area under the curve (AUC) value of the artificial neural network (ANN) model (0.987) is larger than that of the logistic regression (LR) model (0.883) and that the ANN model has a higher classification accuracy than the LR model. A total of 116 unstable slopes were identified in the study, 14 of which were determined to be potential landslides after the landslide susceptibility results were combined with optical images and field surveys. These 14 potential landslides were mapped in detail, and the effects of regional natural disturbances (e.g., snowmelt) and anthropogenic disturbances (e.g., mining projects) on the identification of potential landslides using only SAR data were assessed. The results of this research can be directly applied to landslide hazard mitigation and prevention in the Gaizi Valley section of the Karakorum Highway. In addition, our proposed method can also be used to map potential landslides in other areas with the same complex topography and harsh environment.
- Open Access
- 10 January 2024
- Published by MDPI AG in Remote Sensing
- Vol. 16 (2) , 283
Evaluating and Correcting Temperature and Precipitation Grid Products in the Arid Region of Altay, China
Temperature and precipitation are crucial indicators for investigating climate changes, necessitating precise measurements for rigorous scientific inquiry. While the Fifth Generation of European Centre for Medium-Range Weather Forecasts Atmospheric Reanalysis (ERA5), ERA5 of the Land Surface (ERA5-Land), and China Meteorological Forcing Dataset (CMFD) temperature and precipitation products are widely used worldwide, their suitability for the Altay region of arid and semi-arid areas has received limited attention. Here, we used the Altay region as the study area, utilizing meteorological station data and implementing the residual revision method for temperature and the coefficient revision method for precipitation to rectify inaccuracies in monthly temperature and precipitation records from ERA5-Land, ERA5, and CMFD. We evaluate the accuracy of these datasets before and after correction using bias, Taylor diagrams, and root-mean-square error (RMSE) metrics. Additionally, we employ Tropical Rainfall Measuring Mission satellite precipitation data (TRMM) as a benchmark to assess the performance of ERA5-Land, ERA5, and CMFD monthly precipitation before and after correction. The results revealed significant differences in the temperature and precipitation capture capabilities of ERA5-Land, ERA5, and CMFD in the Altay region. Overall, these data exhibit substantial errors and are not directly suitable for scientific research. However, we applied residual and coefficient revision methods. After this revision, ERA5-Land, ERA5, and CMFD showed significantly improved temperature and precipitation capture capabilities, especially for ERA5-Land. In terms of temperature, post-revision-CMFD (CMFDPR) demonstrated better temperature capture capabilities. All three datasets showed weaker performance in mountainous regions compared to plains. Notably, post-revision-ERA5 (ERA5PR) seemed unsuitable for capturing temperature in the Altay region. Concerning rain, CMFDPR, post-revision-ERA5-Land (ERA5-LandPR) and ERA5PR outperformed TRMM in capturing precipitation. CMFDPR and ERA5-LandPR both outperform ERA5PR. In summary, the revision datasets effectively compensated for the sparse distribution of meteorological stations in the Altay region, providing reliable data support for studying climate change in arid and semi-arid areas.
- 10 January 2024
- Published by MDPI AG in Remote Sensing
- Vol. 16 (2) , 283
Open AccessEvaluating and Correcting Temperature and Precipitation Grid Products in the Arid Region of Altay, China
Temperature and precipitation are crucial indicators for investigating climate changes, necessitating precise measurements for rigorous scientific inquiry. While the Fifth Generation of European Centre for Medium-Range Weather Forecasts Atmospheric Reanalysis (ERA5), ERA5 of the Land Surface (ERA5-Land), and China Meteorological Forcing Dataset (CMFD) temperature and precipitation products are widely used worldwide, their suitability for the Altay region of arid and semi-arid areas has received limited attention. Here, we used the Altay region as the study area, utilizing meteorological station data and implementing the residual revision method for temperature and the coefficient revision method for precipitation to rectify inaccuracies in monthly temperature and precipitation records from ERA5-Land, ERA5, and CMFD. We evaluate the accuracy of these datasets before and after correction using bias, Taylor diagrams, and root-mean-square error (RMSE) metrics. Additionally, we employ Tropical Rainfall Measuring Mission satellite precipitation data (TRMM) as a benchmark to assess the performance of ERA5-Land, ERA5, and CMFD monthly precipitation before and after correction. The results revealed significant differences in the temperature and precipitation capture capabilities of ERA5-Land, ERA5, and CMFD in the Altay region. Overall, these data exhibit substantial errors and are not directly suitable for scientific research. However, we applied residual and coefficient revision methods. After this revision, ERA5-Land, ERA5, and CMFD showed significantly improved temperature and precipitation capture capabilities, especially for ERA5-Land. In terms of temperature, post-revision-CMFD (CMFDPR) demonstrated better temperature capture capabilities. All three datasets showed weaker performance in mountainous regions compared to plains. Notably, post-revision-ERA5 (ERA5PR) seemed unsuitable for capturing temperature in the Altay region. Concerning rain, CMFDPR, post-revision-ERA5-Land (ERA5-LandPR) and ERA5PR outperformed TRMM in capturing precipitation. CMFDPR and ERA5-LandPR both outperform ERA5PR. In summary, the revision datasets effectively compensated for the sparse distribution of meteorological stations in the Altay region, providing reliable data support for studying climate change in arid and semi-arid areas.