S. Terzi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
S. Terzi has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
A.K. Dahle
ARC CoE for Design in Light Metals, Materials Engineering, The University of Queensland, Brisbane, QLD 4072, Australia
1 shared publication- B. A. Szost
European Space Agency, ESTEC, Keplerlaan 1, PO Box 299, NL-2200 AG Noordwijk, The Netherlands
1 shared publication E. Boller
ESRF, 6 Rue Jules Horowitz, BP220, 38043 Grenoble CEDEX, France
1 shared publication- Filomeno Martina
Cranfield University
1 shared publication J. Meyer
Airbus Groups Innovation, 20A1 Building, New Filton House, Bristol BS99 7AR, UK
1 shared publicationL. Salvo
Université de Grenoble, SIMaP/GPM2, UMR CNRS 5266, UJF, BP46, 38402 Saint-Martin d’Hères Cedex, France
1 shared publication
Latest Publications
- Open Access
- 1 September 2016
- Published by SAGE Publications in Materials Science and Technology
- Vol. 32 (14) , 1439-1448
Residual stress of as-deposited and rolled wire+arc additive manufacturing Ti–6Al–4V components
Wire + arc additive manufacturing components contain significant residual stresses, which manifest in distortion. High-pressure rolling was applied to each layer of a linear Ti–6Al–4V wire + arc additive manufacturing component in between deposition passes. In rolled specimens, out-of-plane distortion was more than halved; a change in the deposits' geometry due to plastic deformation was observed and process repeatability was increased. The Contour method of residual stresses measurements showed that although the specimens still exhibited tensile stresses (up to 500 MPa), their magnitude was reduced by 60%, particularly at the interface between deposit and substrate. The results were validated with neutron diffraction measurements, which were in good agreement away from the baseplate. This paper is part of a Themed Issue on Measurement, modelling and mitigation of residual stress.
- 1 September 2016
- Published by SAGE Publications in Materials Science and Technology
- Vol. 32 (14) , 1439-1448
Open AccessResidual stress of as-deposited and rolled wire+arc additive manufacturing Ti–6Al–4V components
Wire + arc additive manufacturing components contain significant residual stresses, which manifest in distortion. High-pressure rolling was applied to each layer of a linear Ti–6Al–4V wire + arc additive manufacturing component in between deposition passes. In rolled specimens, out-of-plane distortion was more than halved; a change in the deposits' geometry due to plastic deformation was observed and process repeatability was increased. The Contour method of residual stresses measurements showed that although the specimens still exhibited tensile stresses (up to 500 MPa), their magnitude was reduced by 60%, particularly at the interface between deposit and substrate. The results were validated with neutron diffraction measurements, which were in good agreement away from the baseplate. This paper is part of a Themed Issue on Measurement, modelling and mitigation of residual stress.
- 1 January 2010
- Published by Elsevier in Acta Materialia
- Vol. 58 (1) , 20-30
Coarsening mechanisms in a dendritic Al–10% Cu alloy
- 1 January 2010
- Published by Elsevier in Acta Materialia
- Vol. 58 (1) , 20-30
Coarsening mechanisms in a dendritic Al–10% Cu alloy