Scott D. Hull
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Scott D. Hull has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Miki Nakajima
Department of Earth and Environmental Sciences University of Rochester Rochester NY USA
5 shared publications - Robin M. Canup
Planetary Science Directorate, Southwest Research Institute, Boulder, CO 80302, USA
3 shared publications - Ian Szumila
Department of Earth and Environmental Science University of Rochester Rochester NY USA
2 shared publications - Michael R. Ackerson
Smithsonian Institution, Washington, DC, USA
2 shared publications - Natsuki Hosono
Japan Agcy Marine Earth Sci & Technol, 2-15 Natsushima Cho, Yokosuka, Kanagawa 2370061, Japan
2 shared publications - Channon Visscher
Dordt University
1 shared publication
Latest Publications
- Open Access
- 11 August 2026
- Published by Springer Nature in Nature Communications
- Vol. 17 (1)
A missing continental impact melt sheet signal in the early Earth detrital zircon record
Impact-derived melting has been proposed as a significant process in the formation of Earth’s early crust which could mean that impact melts are a source for Earth’s oldest minerals including ancient zircons. However, the source lithology of many Archean and Hadean zircons is unclear because many grains are detrital. Therefore, in this work, we develop a machine learning model trained on the U/Yb, Th/U, Yb, and Gd/Yb values of zircons from the 1.85 Ga Sudbury impact melt sheet and more typical igneous processes, so that it could distinguish between them. Here, we show that ancient zircons from three >3.2Ga localities did not crystallize from impact melt sheets. Our results support the hypothesis that early earth zircons are not sourced directly from impact melt sheets, especially one produced by impacting continental crust and indicate no evidence for a late heavy bombardment implying a more habitable Hadean.
- 11 August 2026
- Published by Springer Nature in Nature Communications
- Vol. 17 (1)
Open AccessA missing continental impact melt sheet signal in the early Earth detrital zircon record
Impact-derived melting has been proposed as a significant process in the formation of Earth’s early crust which could mean that impact melts are a source for Earth’s oldest minerals including ancient zircons. However, the source lithology of many Archean and Hadean zircons is unclear because many grains are detrital. Therefore, in this work, we develop a machine learning model trained on the U/Yb, Th/U, Yb, and Gd/Yb values of zircons from the 1.85 Ga Sudbury impact melt sheet and more typical igneous processes, so that it could distinguish between them. Here, we show that ancient zircons from three >3.2Ga localities did not crystallize from impact melt sheets. Our results support the hypothesis that early earth zircons are not sourced directly from impact melt sheets, especially one produced by impacting continental crust and indicate no evidence for a late heavy bombardment implying a more habitable Hadean.
- Open Access
- 19 June 2026
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Planets
- Vol. 131 (6)
Impact and Crystallization Modeling of the Sudbury Basin and Its Implications for a Hadean Crust
The 1.85 Ga Sudbury Structure hosts Earth's largest and best-preserved impact-induced melt sheet, the Sudbury Igneous Complex (SIC), which crystallized into distinct noritic, gabbroic, and granophyric layers. We conduct impact simulations with iSALE-2D and crystallization modeling using alphaMELTS 2 to track the formation and evolution of the SIC. Our MELTS simulations indicate that the SIC bulk composition is best reproduced by a mixture of ∼65% Archean Levack Gneiss Complex material and ∼35% lower crust material. iSALE simulations identify an optimal impact scenario involving a 20 km impactor, represented in the model with granite as a practical proxy for a carbonaceous-chondrite-like body, striking the target at 15 km/s, consisting of sedimentary cover over granitic upper and gabbroic lower crust. This configuration produces a melt sheet ( k ) consistent with previous estimates and dominantly sourced from upper and lower crust in a ∼2:1 ratio, with mantle-derived contributions not required by the model results. We also revise previous melt scaling laws to more accurately predict melt volumes and contributions from each target layer for large impacts. Our models show that impact-induced melt sheets derived primarily from crustal material can differentiate into stratified igneous units resembling the Sudbury crust. While developed for the Sudbury Basin, this approach can be used to explore how impact-generated melt sheets may have contributed to the reworking, modification, or possible generation of early crust during the Hadean, although differences in lithosphere rheology and mantle temperature at that time introduce additional uncertainties.- 19 June 2026
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Planets
- Vol. 131 (6)
Open AccessImpact and Crystallization Modeling of the Sudbury Basin and Its Implications for a Hadean Crust
The 1.85 Ga Sudbury Structure hosts Earth's largest and best-preserved impact-induced melt sheet, the Sudbury Igneous Complex (SIC), which crystallized into distinct noritic, gabbroic, and granophyric layers. We conduct impact simulations with iSALE-2D and crystallization modeling using alphaMELTS 2 to track the formation and evolution of the SIC. Our MELTS simulations indicate that the SIC bulk composition is best reproduced by a mixture of ∼65% Archean Levack Gneiss Complex material and ∼35% lower crust material. iSALE simulations identify an optimal impact scenario involving a 20 km impactor, represented in the model with granite as a practical proxy for a carbonaceous-chondrite-like body, striking the target at 15 km/s, consisting of sedimentary cover over granitic upper and gabbroic lower crust. This configuration produces a melt sheet ( k ) consistent with previous estimates and dominantly sourced from upper and lower crust in a ∼2:1 ratio, with mantle-derived contributions not required by the model results. We also revise previous melt scaling laws to more accurately predict melt volumes and contributions from each target layer for large impacts. Our models show that impact-induced melt sheets derived primarily from crustal material can differentiate into stratified igneous units resembling the Sudbury crust. While developed for the Sudbury Basin, this approach can be used to explore how impact-generated melt sheets may have contributed to the reworking, modification, or possible generation of early crust during the Hadean, although differences in lithosphere rheology and mantle temperature at that time introduce additional uncertainties. - Open Access
Hydrodynamic volatile escape and moderately volatile isotope fractionation in giant impact ejecta
- Open Access
- 1 January 2024
- Published by American Astronomical Society in The Planetary Science Journal
- Vol. 5 (1) , 9
Effect of Equation of State and Cutoff Density in Smoothed Particle Hydrodynamics Simulations of the Moon-forming Giant Impact
The amount of vapor in the impact-generated protolunar disk carries implications for the dynamics, devolatilization, and moderately volatile element isotope fractionation during lunar formation. The equation of state (EoS) used in simulations of the giant impact is required to calculate the vapor mass fraction (VMF) of the modeled protolunar disk. Recently, a new version of M-ANEOS (Stewart M-ANEOS) was released with an improved treatment of heat capacity and expanded experimental Hugoniot. Here, we compare this new M-ANEOS version with a previous version (N-SPH M-ANEOS) and assess the resulting differences in smoothed particle hydrodynamics (SPH) simulations. We find that Stewart M-ANEOS results in cooler disks with smaller values of VMF and in differences in disk mass that are dependent on the initial impact angle. We also assess the implications of the minimum “cutoff” density (ρ c ), similar to a maximum smoothing length, that is set as a fast-computing alternative to an iteratively calculated smoothing length. We find that the low particle resolution of the disk typically results in >40% of disk particles falling to ρ c , influencing the dynamical evolution and VMF of the disk. Our results show that the choice of EoS, ρ c , and particle resolution can cause the VMF and disk mass to vary by tens of percent. Moreover, small values of ρ c produce disks that are prone to numerical instability and artificial shocks. We recommend that future giant impact SPH studies review smoothing methods and ensure the thermodynamic stability of the disk over simulated time.
- 1 January 2024
- Published by American Astronomical Society in The Planetary Science Journal
- Vol. 5 (1) , 9
Open AccessEffect of Equation of State and Cutoff Density in Smoothed Particle Hydrodynamics Simulations of the Moon-forming Giant Impact
The amount of vapor in the impact-generated protolunar disk carries implications for the dynamics, devolatilization, and moderately volatile element isotope fractionation during lunar formation. The equation of state (EoS) used in simulations of the giant impact is required to calculate the vapor mass fraction (VMF) of the modeled protolunar disk. Recently, a new version of M-ANEOS (Stewart M-ANEOS) was released with an improved treatment of heat capacity and expanded experimental Hugoniot. Here, we compare this new M-ANEOS version with a previous version (N-SPH M-ANEOS) and assess the resulting differences in smoothed particle hydrodynamics (SPH) simulations. We find that Stewart M-ANEOS results in cooler disks with smaller values of VMF and in differences in disk mass that are dependent on the initial impact angle. We also assess the implications of the minimum “cutoff” density (ρ c ), similar to a maximum smoothing length, that is set as a fast-computing alternative to an iteratively calculated smoothing length. We find that the low particle resolution of the disk typically results in >40% of disk particles falling to ρ c , influencing the dynamical evolution and VMF of the disk. Our results show that the choice of EoS, ρ c , and particle resolution can cause the VMF and disk mass to vary by tens of percent. Moreover, small values of ρ c produce disks that are prone to numerical instability and artificial shocks. We recommend that future giant impact SPH studies review smoothing methods and ensure the thermodynamic stability of the disk over simulated time.
- Open Access
Effect of Equation of State and Cutoff Density in Smoothed Particle Hydrodynamics Simulations of the Moon-Forming Giant Impact
The amount of vapor in the impact-generated protolunar disk carries implications for the dynamics, devolatilization, and moderately volatile element (MVE) isotope fractionation during lunar formation. The equation of state (EoS) used in simulations of the giant impact is required to calculate the vapor mass fraction (VMF) of the modeled protolunar disk. Recently, a new version of M-ANEOS ("Stewart M-ANEOS") was released with an improved treatment of heat capacity and expanded experimental Hugoniot. Here, we compare this new M-ANEOS version with a previous version ("N-SPH M-ANEOS") and assess the resulting differences in smoothed particle hydrodynamics (SPH) simulations. We find that Stewart M-ANEOS results in cooler disks with smaller values of VMF and results in differences in disk mass that are dependent on the initial impact angle. We also assess the implications of the minimum "cutoff" density ($ρ_{c}$), similar to a maximum smoothing length, that is set as a fast-computing alternative to an iteratively calculated smoothing length. We find that the low particle resolution of the disk typically results in $>40\%$ of disk particles falling to $ρ_c$, influencing the dynamical evolution and VMF of the disk. Our results show that choice of EoS, $ρ_{c}$, and particle resolution can cause the VMF and disk mass to vary by tens of percent. Moreover, small values of $ρ_{c}$ produce disks that are prone to numerical instability and artificial shocks. We recommend that future giant impact SPH studies review smoothing methods and ensure the thermodynamic stability of the disk over simulated time.Open AccessEffect of Equation of State and Cutoff Density in Smoothed Particle Hydrodynamics Simulations of the Moon-Forming Giant Impact
The amount of vapor in the impact-generated protolunar disk carries implications for the dynamics, devolatilization, and moderately volatile element (MVE) isotope fractionation during lunar formation. The equation of state (EoS) used in simulations of the giant impact is required to calculate the vapor mass fraction (VMF) of the modeled protolunar disk. Recently, a new version of M-ANEOS ("Stewart M-ANEOS") was released with an improved treatment of heat capacity and expanded experimental Hugoniot. Here, we compare this new M-ANEOS version with a previous version ("N-SPH M-ANEOS") and assess the resulting differences in smoothed particle hydrodynamics (SPH) simulations. We find that Stewart M-ANEOS results in cooler disks with smaller values of VMF and results in differences in disk mass that are dependent on the initial impact angle. We also assess the implications of the minimum "cutoff" density ($ρ_{c}$), similar to a maximum smoothing length, that is set as a fast-computing alternative to an iteratively calculated smoothing length. We find that the low particle resolution of the disk typically results in $>40\%$ of disk particles falling to $ρ_c$, influencing the dynamical evolution and VMF of the disk. Our results show that choice of EoS, $ρ_{c}$, and particle resolution can cause the VMF and disk mass to vary by tens of percent. Moreover, small values of $ρ_{c}$ produce disks that are prone to numerical instability and artificial shocks. We recommend that future giant impact SPH studies review smoothing methods and ensure the thermodynamic stability of the disk over simulated time.