Ge Shen

Subsurface structural distribution can be detected using Ground-Penetrating Radar (GPR). The distribution can be considered as road fingerprints for vehicle positioning. Similar to the principle of visual image matching for localization, the position coordinates of the vehicle can be calculated by matching real-time GPR images with pre-constructed reference GPR images. However, GPR images, due to their low resolution, cannot extract well-defined geometric features such as corners and lines. Thus, traditional visual image processing algorithms perform inadequately when applied to GPR image matching. To address this issue, this paper innovatively proposes a GPR image matching and localization method based on a novel feature descriptor, termed as central dense structure context (CDSC) features. The algorithm utilizes the strip-like elements in GPR images to improve the accuracy of GPR image matching. First, a CDSC feature descriptor is designed. By applying threshold segmentation and extremum point extraction to the GPR image, stratified strip-like elements and pseudo-corner points are obtained. The pseudo-corner points are treated as the centers, and the surrounding strip-like elements are described in context to form the GPR feature descriptors. Then, based on the feature description method, feature descriptors for both the real-time image and the reference image are calculated separately. By searching for the nearest matching point pairs and removing erroneous pairs, GPR image matching and localization are achieved. The proposed algorithm was evaluated on datasets collected from urban roads and railway tracks, achieving localization errors of 0.06 m (RMSE) and 1.22 m (RMSE), respectively. Compared to the traditional Speeded Up Robust Features (SURF) visual image matching algorithm, localization errors were reduced by 86.6% and 95.7% in urban road and railway track scenarios, respectively.

Aeromagnetic compensation plays a vital role in geomagnetic navigation and has received considerable attention throughout last few decades. Classical aeromagnetic compensation methods based on the Tolles–Lawson (T-L) model are mainly aimed at permanent, induced, and eddy-current magnetic interferences of aircraft platform, which ignores other stray magnetic field interference on the platform including the interferences caused by on-board electronic (OBE) systems. In order to cooperate with TL model, magnetometers are usually required to be installed on the extension rod outside the cabin, which is widely applied to geophysical magnetic survey. In order to ensure safety and reduce the cost of platform modification in geomagnetic navigation, it’s necessary to place magnetometers inside the cabin. It also further exacerbates the magnetic interferences and improves the difficulty of magnetic compensation. In this paper, a modified aeromagnetic compensation method is proposed, and the in-cabin OBE interferences are respectively modelled to be proportional to the currents and their temporal variations of different electronic devices. To ensure that modified model adapts to strong OBE interference in the cabin, a cut-off frequency determination method based on curvature calculation and a feature selection method based on correlation calculation are proposed. The cut-off frequency determination method helps to select passband filter which suitable for in-cabin OBE interference. The feature selection method can help to effectively select current and voltage inputs for modified model. In addition, principal component analysis (PCA) is adopted to reduce multicollinearity which is intensified by the extension of OBE interferences in coefficient-estimating. Experiments on public dataset are conducted to illustrate the effectiveness of the proposed method, and the best compensation result achieved 1.71nT of root mean square error (RMSE).