Maria Stella Vanessa Sammito
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Maria Stella Vanessa Sammito has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Salvatore Grasso
Department of Civil Engineering and Architecture, University of Catania, Catania, Italy
16 shared publications - Francesco Castelli
Faculty of Engineering and Architecture, University “Kore” of Enna, 94100 Enna, Italy
9 shared publications - Valentina Lentini
Faculty of Engineering and Architecture, University “Kore” of Enna, 94100 Enna, Italy
9 shared publications - Antonio Cavallaro
CNR-ISPC National Research Council, Catania, Italy
3 shared publications - Maria Rossella Massimino
University of Catania 4 Full Professor, Department of Civil Engineering and Architecture Catania
2 shared publications S. Grasso Grasso
2 shared publications
Latest Publications
- 3 October 2026
- Published by Springer Nature in Bulletin of Engineering Geology and the Environment
- Vol. 85 (10) , 673
Geological features and geotechnical characterization of Aegadian Islands for the evaluation of site effects
- 3 October 2026
- Published by Springer Nature in Bulletin of Engineering Geology and the Environment
- Vol. 85 (10) , 673
Geological features and geotechnical characterization of Aegadian Islands for the evaluation of site effects
- Open Access
Geotechnical Assessment of Differential Settlements Under Asymmetric Loading: Implications for Pipeline Performance
Industrial tanks are key components of process plants. However, they are highly susceptible to foundation settlement under high operating loads. Therefore, reducing settlement is necessary to protect the tank and the associated piping. In this work, Finite Element Method (FEM) analyses were conducted to assess the effects of construction on adjacent pipelines in an industrial plant located on the eastern coast of Sicily (Italy). The biological basin has a longitudinal axis of symmetry and consists of two tanks. The geotechnical model was developed from geological and geotechnical investigations carried out in the investigated area. PLAXIS2D software (Bentley Systems) was employed to perform consolidation analyses. The findings show that the magnitude and application of loads play a key role in the estimated settlements, demonstrating the importance of including the load eccentricity in the analysis. The influence zone following the construction of the biological basin was derived to evaluate the potential impact on adjacent pipelines.
Open AccessGeotechnical Assessment of Differential Settlements Under Asymmetric Loading: Implications for Pipeline Performance
Industrial tanks are key components of process plants. However, they are highly susceptible to foundation settlement under high operating loads. Therefore, reducing settlement is necessary to protect the tank and the associated piping. In this work, Finite Element Method (FEM) analyses were conducted to assess the effects of construction on adjacent pipelines in an industrial plant located on the eastern coast of Sicily (Italy). The biological basin has a longitudinal axis of symmetry and consists of two tanks. The geotechnical model was developed from geological and geotechnical investigations carried out in the investigated area. PLAXIS2D software (Bentley Systems) was employed to perform consolidation analyses. The findings show that the magnitude and application of loads play a key role in the estimated settlements, demonstrating the importance of including the load eccentricity in the analysis. The influence zone following the construction of the biological basin was derived to evaluate the potential impact on adjacent pipelines.
- 2 August 2026
- Published by Springer Nature
- p. 121-128
Liquefaction Resistance of Partially Saturated Soils Based on Undrained Cyclic Triaxial Tests
- 2 August 2026
- Published by Springer Nature
- p. 121-128
Liquefaction Resistance of Partially Saturated Soils Based on Undrained Cyclic Triaxial Tests
- 10 May 2026
- Published by Springer Nature in Geotechnical and Geological Engineering
- Vol. 44 (4)
Role of Seismic Microzonation Studies in Defining Design Response Spectra for Urban Areas
- 10 May 2026
- Published by Springer Nature in Geotechnical and Geological Engineering
- Vol. 44 (4)
Role of Seismic Microzonation Studies in Defining Design Response Spectra for Urban Areas
- 31 October 2025
- Published by Springer Nature in Geotechnical and Geological Engineering
- Vol. 43 (9) , 1-24
Liquefaction Resistance of Sandy Soil in South-Eastern Sicily from Cyclic Direct Simple Shear Testing
- 31 October 2025
- Published by Springer Nature in Geotechnical and Geological Engineering
- Vol. 43 (9) , 1-24
Liquefaction Resistance of Sandy Soil in South-Eastern Sicily from Cyclic Direct Simple Shear Testing
- 23 September 2025
- Published by Springer Nature in Bulletin of Earthquake Engineering
- Vol. 23 (14) , 6013-6046
Assessment of liquefaction potential in the framework of seismic microzonation using different approaches
- 23 September 2025
- Published by Springer Nature in Bulletin of Earthquake Engineering
- Vol. 23 (14) , 6013-6046
Assessment of liquefaction potential in the framework of seismic microzonation using different approaches
- 7 July 2025
- Published by Springer Nature in Bulletin of Earthquake Engineering
- Vol. 23 (10) , 3889-3922
Assessment of 2D site effects for seismic microzonation studies: application to Eastern Sicily (Italy)
- 7 July 2025
- Published by Springer Nature in Bulletin of Earthquake Engineering
- Vol. 23 (10) , 3889-3922
Assessment of 2D site effects for seismic microzonation studies: application to Eastern Sicily (Italy)
- Open Access
- 17 September 2024
- Published by Taylor & Francis
- p. 1142-1145
2D Seismic response analyses from 3rd Level Seismic Microzonation in the Southern Italy: approaches and applications
Seismic Microzonation studies of 3rd Level (SM3) have been performed for the emergency management and the reconstruction of several Municipalities in the eastern flank of Mt. Etna (Southern Italy) hit by the 2018 seismic sequence. The most energetic event (Mw=4.9) occurred on 26th December 2018, causing phenomena of superficial faulting along the Fiandaca Fault (FF), where the most damaged areas are located. In order to define the subsoil model for each seismic homogeneous microzone (SHM) and to perform extensive numerical analyses, intense investigations have been carried out including in situ and laboratory tests. For the estimation of the spatial variability in seismic response, the finite element code PLAXIS 2D has been employed. Moreover, 1143the Hardening Soil model with small-strain stiffness (HS small model), which includes an increased soil stiffness for small strains, has been adopted in order to consider the soil non-linearity. For each SHM, results are presented in terms of acceleration response spectra and amplification factors (AFj). The latter are calculated for three different period intervals linked to the heights of buildings according to the Italian Guidelines and Standards. The results of this work provide important information for the development of urban planning aimed at reducing seismic risk.
- 17 September 2024
- Published by Taylor & Francis
- p. 1142-1145
Open Access2D Seismic response analyses from 3rd Level Seismic Microzonation in the Southern Italy: approaches and applications
Seismic Microzonation studies of 3rd Level (SM3) have been performed for the emergency management and the reconstruction of several Municipalities in the eastern flank of Mt. Etna (Southern Italy) hit by the 2018 seismic sequence. The most energetic event (Mw=4.9) occurred on 26th December 2018, causing phenomena of superficial faulting along the Fiandaca Fault (FF), where the most damaged areas are located. In order to define the subsoil model for each seismic homogeneous microzone (SHM) and to perform extensive numerical analyses, intense investigations have been carried out including in situ and laboratory tests. For the estimation of the spatial variability in seismic response, the finite element code PLAXIS 2D has been employed. Moreover, 1143the Hardening Soil model with small-strain stiffness (HS small model), which includes an increased soil stiffness for small strains, has been adopted in order to consider the soil non-linearity. For each SHM, results are presented in terms of acceleration response spectra and amplification factors (AFj). The latter are calculated for three different period intervals linked to the heights of buildings according to the Italian Guidelines and Standards. The results of this work provide important information for the development of urban planning aimed at reducing seismic risk.
- Open Access
- 5 April 2024
- Published by MDPI AG in Geosciences
- Vol. 14 (4) , 100
Nonlinear 3D Finite Element Analysis of a Coupled Soil–Structure System by a Deterministic Approach
Fully coupled soil–structure analyses were performed for a building of strategic importance located in the city of Messina (Sicily, Italy). The structure was built after the destructive 1908 earthquake, also known as the ‘Messina and Reggio Calabria earthquake’, which caused severe ground shaking. A parametric study considering three seismograms of this earthquake was performed. Deep in situ and laboratory investigations allowed the definition of the geometric and geotechnical model of the subsoil. Numerical analyses were performed with PLAXIS3D finite element software (Version 21.01.00.479). The Hardening Soil model with small-strain stiffness was accurately calibrated using laboratory and field data. The dynamic response was investigated in terms of accelerations, response spectra, amplification functions, displacements and stress–strain hysteretic loops. The findings show that many aspects must be investigated for the retrofitting of buildings with shallow foundation in areas characterized by a medium to high level of seismic risk: (i) a key role is played by an accurate investigation of the soil; taking into account the specific conditions of the soil, it was possible to investigate its filtering effects; (ii) the dynamic response of the fully-coupled soil–structure system deviates from the free field-site response analysis; (iii) the results reveal the importance of considering the soil nonlinearity in seismic soil–structure interaction problems.
- 5 April 2024
- Published by MDPI AG in Geosciences
- Vol. 14 (4) , 100
Open AccessNonlinear 3D Finite Element Analysis of a Coupled Soil–Structure System by a Deterministic Approach
Fully coupled soil–structure analyses were performed for a building of strategic importance located in the city of Messina (Sicily, Italy). The structure was built after the destructive 1908 earthquake, also known as the ‘Messina and Reggio Calabria earthquake’, which caused severe ground shaking. A parametric study considering three seismograms of this earthquake was performed. Deep in situ and laboratory investigations allowed the definition of the geometric and geotechnical model of the subsoil. Numerical analyses were performed with PLAXIS3D finite element software (Version 21.01.00.479). The Hardening Soil model with small-strain stiffness was accurately calibrated using laboratory and field data. The dynamic response was investigated in terms of accelerations, response spectra, amplification functions, displacements and stress–strain hysteretic loops. The findings show that many aspects must be investigated for the retrofitting of buildings with shallow foundation in areas characterized by a medium to high level of seismic risk: (i) a key role is played by an accurate investigation of the soil; taking into account the specific conditions of the soil, it was possible to investigate its filtering effects; (ii) the dynamic response of the fully-coupled soil–structure system deviates from the free field-site response analysis; (iii) the results reveal the importance of considering the soil nonlinearity in seismic soil–structure interaction problems.