Bigang Jiang

The geometric alignment of highways directly affects the fuel consumption of motor vehicles. To analyze the impact of the road gradient on fuel consumption, actual road tests were conducted in plateau and mountainous areas. Geographic Information Systems (GISs) were used to calculate road gradients, and Vehicle Specific Power (VSP) distributions were obtained through testing, serving as inputs for the motor vehicle emission simulator (MOVES) model. Finally, the simulation results were verified against the experimental results. The findings indicate a strong positive correlation between road gradients ranging from −5% to +5%, the VSP, and fuel consumption. At a constant gradient, the fuel consumption rate increases with the vehicle speed; the fuel consumption factor is lowest at 60 km/h and highest at 40 km/h. Under both constant and actual driving speeds, when the absolute values of uphill and downhill gradients are the same, the average fuel consumption for both uphill and downhill driving shows that, at gradients of 1% to 3%, the fuel savings from downhill driving can offset the additional fuel consumption on uphill driving. At gradients of 4% to 6%, the increase in fuel consumption on uphill driving surpasses the savings from downhill driving. During uphill climbs, lower speeds within the mid-to-low range result in lower fuel consumption and greater reserve power. The MOVES model demonstrates good adaptability in plateau and mountainous areas.

Five typical in-use city buses in Tangshan with different emission standards, fuel power types, and emission control technology routes were selected as the research objects. PEMSs (Portable Emissions Measurement Systems) and OBD (On-Board Diagnostic) remote monitoring technologies were used to conduct research on actual road conditions and emission characteristics. The research aimed to analyze the driving characteristics of different power types of bus engines and after-treatment systems, as well as their impact on emissions. The results indicated that the actual road driving is mainly in the urban and suburban areas of the local region. Additionally, the VSP (Vehicle Specific Power) was found to be distributed in the low- and medium-speed range of mode Bin0~Bin24. The emission rates of each pollutant showed an increasing trend with the increase in VSP. THC and NOx emissions of CNG and LNG buses are significantly higher than those of gas–electric hybrid buses. However, the PM emissions are lower. Therefore, it is necessary to strengthen the NOx emission control of CNG and LNG buses. With the improvement in emission standards and the use of hybrid technology, CO₂ and NOx emissions of China IV buses can be reduced by 13% and 53.5% compared with China III buses of the same tonnage. The CO₂ and NOx emissions of China V buses using natural gas combustion and an electric mixture are 20% and 18.8% lower than those of China V buses of the same tonnage using only natural gas. In the actual operation of the diesel–electric hybrid bus equipped with the SCR (Selective Catalytic Reduction) system, the working time of the engine is about 35.5 ± 5%, and the working time of the SCR system only accounts for 65.5 ± 12%. The low working conditions of the SCR system and the low temperature of SCR system are the reasons for the high NOx concentration at the rear end of the SCR system when the hybrid electric bus is running at low speeds.